956 resultados para Corante de vidro


Relevância:

10.00% 10.00%

Publicador:

Resumo:

Pós-graduação em Odontologia - FOA

Relevância:

10.00% 10.00%

Publicador:

Resumo:

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Relevância:

10.00% 10.00%

Publicador:

Resumo:

A energia eólica é uma forma de energia que seu uso encontra-se em expansão, e junto a esse crescimento, tem-se também o aumento da quantidade de resíduos gerados na fabricação das pás eólicas. Uma forma correta de destinação e aproveitamento desses resíduos é a reciclagem. Porém, esses são constituídos de materiais compósitos, geralmente a resina epóxi e a fibra de vidro; e por possuírem um polímero termofixo (a resina epóxi) na sua composição, a reciclagem convencional via fusão não é possível. Desta forma, a reciclagem química via pirólise apresenta-se como uma alternativa para o aproveitamento desses resíduos, em especial da fibra de vidro que o contém. Após caracterização do resíduo de uma indústria de pás eólicas, verificou-se que se tratava de um material com mais de 70% de fibra de vidro e muito densas. Foram realizados ensaios de pirólise a seco e com óleo de babaçu, considerado o mais interessante perante vários possíveis e no qual o resíduo fica totalmente imerso, facilitando o inchamento e a troca de calor. Em um sistema de aquecimento com vácuo, foram obtidas mais de 97% de fibras em 30 minutos a 310 oC, justamente a temperatura em que uma análise termogravimétrica apontou ser a de início de altas taxas de degradação térmica.

Relevância:

10.00% 10.00%

Publicador:

Resumo:

The Brazilian textile industry has been a highlight in the global economy. Connected with this high economic performance there is the water consumption and the generation of great volumes of wastewater which present high concentrations of dyes and chemical substances. One of the main techniques used in the treatment of textile effluents is adsorption, which has the activated carbon as the main adsorbent. Recently, studies have been developed to find alternative materials to activated carbon and exhibiting good adsorption capacity of dyes. The aim of this work is to study the potential of sawdust as adsorbent of low cost to remove the dye Direct Green 26. The results of this type of dye removal were obtained through the study of adsorption isotherms obtained by spectrophotometry in the UV-visible region analyzed by the Langmuir model. Finally, a comparison was made of these results with those of other adsorbents. Results showed that the average removal of dye, using sawdust, was 78.8% for an initial concentration of 500mg / L and the maximum adsorption capacity of 119mg / g. These results demonstrate the great potential of sawdust as an adsorbent for the dye Direct Green 26.

Relevância:

10.00% 10.00%

Publicador:

Resumo:

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

Relevância:

10.00% 10.00%

Publicador:

Resumo:

Pós-graduação em Ciência e Tecnologia de Materiais - FC

Relevância:

10.00% 10.00%

Publicador:

Resumo:

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Relevância:

10.00% 10.00%

Publicador:

Resumo:

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Relevância:

10.00% 10.00%

Publicador:

Resumo:

Pós-graduação em Medicina Veterinária - FCAV

Relevância:

10.00% 10.00%

Publicador:

Resumo:

The aim of this study was to build and validate a low cost reduced-scale wind tunnel for drift evaluation on pesticide application technology. The work was carried out at the NEMPA - Núcleo de Ensaio de Máquinas e Pneus Agroflorestais (NEMPA), FCA/UNESP, Departamento de Engenharia Rural, Botucatu/SP, Brazil. The wind tunnel main characteristics were an open circuit and a closed working section with a fan blowing air into the tunnel. Screens were fitted downstream after the fan in order to stabilize the air flow on the working section. The tunnel was built with 3.0 mm eucalyptus hardboard, with a total length of 4.8 m and a squared section of 0.56 m. The air flow was provided by a 180 W axial fan. The system was adjusted and calibrated to provide a laminar and stable flow at 2.0 m s-1. Validation studies were carried out by using a Teejet XR 8003 flat fan nozzle at 200 kPa (medium droplets) to apply a spray solutions containing water plus a food dye (Blue FDC) at 0,6% m v-1 mixed with two adjuvants: a polymer based anti drift formulation at 0,06% m v-1 and a sodium lauryl ether sulfate based surfactant at 0,2% v v-1. After a 10-second application the drift was collected on nylon strips transversally fixed along the tunnel at different distances from the nozzle and different high from the bottom part of the tunnel. Drift deposits were evaluated by spectrophotometry. The wind tunnel had low levels of turbulence and high repeatability of the data, which means that the flow was uniform and able to be used for carrying out measures to estimate drift. The validation results showed that the tunnel was effective to enable comparative drift measurements on the spray solution used in this work making possible the evaluation of drift risk potential under those spray technologies. The use of an adjuvant based on a polymer reduced the amount of drift from the nozzle compared to the surfactant.

Relevância:

10.00% 10.00%

Publicador:

Resumo:

The aim of this work was to evaluate the effect of the addition of different surfactants in physical and chemical properties of spray solutions, droplets spectra and drift potential on agricultural spraying. The surfactants and concentrations (v v-1) were: Haiten (0.1%), Antideriva and Intec (0.05% and 0.1%). The following characteristics were analyzed: surface tension, viscosity, density and electric conductivity. The droplet size spectrum was determined by a laser particle analyzer (Mastersizer S®, version 2.15) including measurements of volume medium diameter (VMD), the percent of droplets below 50 and 100 μm (V50 e V100) and index span. In order to estimate the drift potential, a series of wind tunnel tests were performed with a Teejet XR 8003 flat fan nozzle at 200 kPa (medium droplets) used to apply the spray solutions containing water, the adjuvants and a food color dye (Brilliant blue FD & C no 1) at 0,6% m v-1. The drift was collected on nylon strips transversally fixed along the tunnel at different distances from the nozzle and different high from the bottom part of the tunnel. Drift deposits were evaluated by spectrophotometry. The results showed that the addition of adjuvants changed physical and chemical properties of spray solutions in different magnitudes according to the surfactant. Surfactants changed the droplet spectrum and drift potential, indicating that higher VMD and smaller V100 induced higher percentage of drift.

Relevância:

10.00% 10.00%

Publicador:

Resumo:

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Relevância:

10.00% 10.00%

Publicador:

Resumo:

The objective of this work was to evaluate the relationship between phenolic compounds and alcoholic fermentation efficiency. The yield of sugarcanebyproducts (glycerol, acidity, and biomass) was determined in a continuous process at SaoManoel Sugarcane Mill, (Sao Paulo, Brazil) during the 2011/2012 harvest period. The Saccharomyces cerevisiae strain used as inoculum was the CAT-1. During the harvest, the endogenous yeast outcompeted the selected strain, hence eliminating it from the process. This research consists of a case of study on the ethanol production facility. FolinCiocauteau and methylene blue method was used to assess phenolic compounds. The efficiencyof the byproducts generated during the fermentation processwas calculated. Statistics analyses were carried out using Pearson correlation and its significance, by thet-test. We concluded that the phenolic compounds within the must could not be correlated to the byproducts’fermentation efficiency calculated during a continuous fermentation process.

Relevância:

10.00% 10.00%

Publicador:

Resumo:

O objetivo deste trabalho foi avaliar diferentes pontas e taxas de pulverização na deposição de calda na cultura do milho e nas plantas daninhas Euphorbia heterophylla e Brachiaria plantaginea, localizadas nas linhas e nas entrelinhas da cultura. O experimento foi conduzido em delineamento de blocos ao acaso, em esquema fatorial 2 x 2 (2 pontas de pulverização DG 11002 VS (jato plano e gotas médias) e TXVK08 (jato cônico e gotas muito finas) x 2 taxas de aplicação, 100 e 200 L ha-1) com quatro repetições. As aplicações ocorreram aos 13 dias após a germinação do milho (3 a 5 folhas expandidas), as plantas de E. heterophylla apresentavam de 2 a 4 folhas e as plantas de B. plantaginea de 2 a 3 folhas. Utilizou-se como marcador o corante Azul Brilhante (FD&C-1) na concentração de 3000 ppm. Conclui-se que os maiores depósitos médios nas plantas de milho foram proporcionados pela ponta TXVK08, independente da taxa utilizada e que os depósitos mais uniformes ocorreram quando utilizou-se a taxa de 200 L ha-1. Para as plantas daninhas localizadas na linha da cultura, as pontas de pulverização promoveram depósitos de calda mais uniformes na B. plantaginea do que na E. heterophylla, em ambas as taxas de aplicação. Para a B. plantaginea localizadas na entrelinha da cultura a ponta DG 11002VS foi a que proporcionou depósitos de gotas mais uniformes, sendo que para E. heterophylla a ponta mais eficiente em depositar gotas foi a TXVK08.