Comparative influence of forest management and habitat structural factors on the abundances of hollow-nesting bird species in subtropical Australian eucalypt forest

We examined the impact of single-tree selective logging and fuel reduction bums on the abundance of hollow-nesting bird species at a regional scale in southeastern Queensland, Australia. Data were collected on species abundance and habitat structure of dry sclerophyll production forest at 36 sites with known logging and fire histories. Sixteen bird species were recorded with most being resident, territorial, obligate hollow nesters that used hollows that were either small (18 cm diameter). Species densities were typically low, but combinations of two forest management and three habitat structural variables influenced the abundances of eight bird species in different and sometimes conflicting ways. The results suggest that habitat tree management for biodiversity in production forests cannot depend upon habitat structural characteristics alone. Management histories appear to have independent influence (on some bird species) that are distinguishable from their impacts on habitat structure per se. Rather than managing to maximize species abundances to maintain biodiversity, we may be better off managing to avoid extinctions of populations by identifying thresholds of acceptable fluctuations in populations of not only hollow-nesting birds but other forest dependent wildlife relative to scientifically valid forest management and habitat structural surrogates.

Comparative analysis of genetic diversity in the mangrove species Avicennia marina (Forsk.) Vierh. (Avicenniaceae) detected by AFLPs and SSRs

Avicennia marina is an important mangrove species with a wide geographical and climatic distribution which suggests that large amounts of genetic diversity are available for conservation and breeding programs. In this study we compare the informativeness of AFLPs and SSRs for assessing genetic diversity within and among individuals, populations and subspecies of A. marina in Australia. Our comparison utilized three SSR loci and three AFLP primer sets that were known to be polymorphic, and could be run in a single analysis on a capillary electrophoresis system, using different-colored fluorescent dyes. A total of 120 individuals representing six populations and three subspecies were samplcd. At the locus level, SSRs were considerably more variable than AFLPs, with a total of 52 alleles and an average heterozygosity of 0.78. Average heterozygosity for AFLPs was 0.193, but all of the 918 bands scored were polymorphic. Thus, AFLPs were considerably more efficient at revealing polymorphic loci than SSRs despite lower average heterozygosities. SSRs detected more genetic differentiation between populations (19 vs 9%) and subspecies (35 vs 11%) than AFLPs. Principal co-ordinate analysis revealed congruent patterns of genetic relationships at the individual, population and subspecific levels for both data sets. Mantel testing confirmed congruence between AFLP and SSR genetic distances among, but not within, population comparisons, indicating that the markers were segregating inde- pendently but that evolutionary groups (populations and subspecies) were similar. Three genetic criteria of importance for defining priorities for ex situ collections or in situ conservation programs (number of alleles, number of locally common alleles and number of private alleles) were correlated between the AFLP and SSR data sets. The congruence between AFLP and SSR data sets suggest that either method, or a combination, is applicable to expanded genetic studies of mangroves. The codominant nature of SSRs makes them ideal for further population-based investigations, such as mating-system analyses, for which the dominant AFLP markers are less well suited. AFLPs may be particularly useful for monitoring propagation programs and identifying duplicates within collections, since a single PCR assay can reveal many loci at once.

A comparative ultrastructural study of spermatozoa of the teiid lizards Cnemidophorus gularis gularis, Cnemidophorus ocellifer, and Kentropyx altamazonica (Reptilia, Squamata, Teiidae)

The ultrastructure of the spermatozoa of Cnemidophorus gularis gularis, Cnemidophorus ocellifer, and Kentropyx altamazonica is described for the first time. Mature spermatozoa of Cnemidophorus spp. and K. altamazonica differ in the occurrence of a perforatorial base plate, the enlargement of axonemal fibers 3 and 8, and shape of mitochondria. The comparisons of the ultrastructure sperm of Cnemidophorus spp. and K. altamazonica with Ameiva ameiva [J. Morphol. (2002) in press] suggest that Ameiva and Cnemidophorus are more similar to each other than either is to Kentropyx. Statistical analyses reveal that sperm of all three species studied are significantly different in the following dimensions: head, acrosome, distal centriole length, and nuclear shoulders width. There was no variable statistically different between the Cnemidophorus spp. only. The length of the tail, midpiece, entire sperm, and nuclear rostrum are significantly different between K. altamazonica and Cnemidophorus spp. Our results indicate that sperm ultrastructure presents intra and intergeneric variability. (C) 2002 Elsevier Science Ltd. All rights reserved.

Cross-national comparison of internal migration: issues and measures

Our objectives are to identify the issues that researchers encounter when measuring internal migration in different countries and to propose key indicators that analysts can use to compare internal migration at the 'national' level. We establish the benefits to be gained by a rigorous approach to cross-national comparisons of internal migration and discuss issues that affect such comparisons. We then distinguish four dimensions of internal migration on which countries can be compared and, for each dimension, identify a series of summary measures. We illustrate the issues and measures proposed by comparing migration in Australia and Great Britain.

Comparative evaluation of juvenoids for control of cat fleas (Siphonaptera : Pulicidae) in topsoil

The efficacy of a photostable formulation of methoprene and two photostable juvenoids, fenoxycarb and pyriproxyfen, and their residual activity in inhibiting the emergence of adult cat fleas, Ctenocephalides felis (Bouche), was studied in topsoil. Nursery pots composed of clay, peat, and plastic, and wooden flats were used to hold soil samples. Treated soil samples were exposed to sunlight during the 63-d study period. Methoprene was as effective as fenoxycarb and pyriproxyfen against cat fleas for up to 42 d in clay, peat, and plastic pots at a concentration of 64.56 mg (AI) /m(2) (6 mg [AI] /ft(2)), but its activity declined significantly thereafter. In contrast, fenoxycarb and pyriproxyfen showed strong residual activity for the entire 63 d. The activity of methoprene declined even more rapidly over time in wooden flats, while at the same concentrations the other two juvenoids showed significant residual activity for 63 d. Clay, peat, and plastic pots were therefore considered to be equally effective for evaluating the outdoor efficacy of juvenoids in comparison to the wooden flats. However, results obtained with wooden flats may be more realistic when testing residual activity of volatile chemicals such as methoprene. Fenoxycarb and pyriproxyfen showed strong efficacy and residual activity at concentrations of 8.07, 16.14, and 32.28 mg (AI) /m(2), whereas methoprene did not cause a significant reduction of adult emergence at levels below 64.56 mg (AI) /m(2). LC50 values for methoprene, fenoxycarb, and pyriproxyfen needed for preventing flea emergence when applied to topsoil were estimated to be 0.643, 0.031, and 0.028 ppm, respectively.

Control of chaotic instability in a dual-spin spacecraft with dissipation using energy methods

Control of chaotic instability in a rotating multibody system in the form of a dual-spin spacecraft with an axial nutational damper is achieved using an algorithm derived using energy methods. The control method is implemented on two realistic spacecraft parameter configurations which have been found to exhibit chaotic instability when a sinusoidally varying torque is applied to the spacecraft for a range of forcing amplitudes and frequencies. Such a torque, in practice, may arise under malfunction of the control system or from an unbalanced rotor. Chaotic instabilities arising from these torques could introduce uncertainties and irregularities into a spacecraft's attitude and consequently impair pointing accuracy. The control method is formulated from nutational stability results derived using an energy sink approximation for a dual-spin spacecraft with an asymmetric platform and axisymmetric rotor. The effectiveness of the control method is shown numerically and the results are studied by means of time history, phase space, Poincare map, Lyapunov characteristic exponents and Bifurcation diagrams.

Improvements to peroxide oxidation methods for analysing sulfur in acid sulfate soils

Improvements to peroxide oxidation methods for analysing acid sulfate soils (ASS) are introduced. The soil solution ratio has been increased to 1 : 40, titrations are performed in suspension, and the duration of the peroxide digest stage is substantially shortened. For 9 acid sulfate soils, the peroxide oxidisable sulfur value obtained using the improved method was compared with the reduced inorganic sulfur result obtained using the chromium reducible sulfur method. Their regression was highly significant, the slope of the regression line was not significantly different (P = 0.05) from unity, and the intercept not significantly different from zero. A complete sulfur budget for the improved method showed there was no loss of sulfur as has been reported for earlier peroxide oxidation techniques. When soils were very finely ground, efficient oxidation of sulfides was achieved, despite the milder digestion conditions. Highly sulfidic and organic soils were shown to be the most difficult to analyse using either the improved method or the chromium method. No single analytical method can be universally applied to all ASS, rather a suite of methods is necessary for a thorough understanding of many ASS. The improved peroxide method, in combination with the chromium method and the 4 M HCl extraction, form a sound platform for informed decision making on the management of acid sulfate soils.

Predictor-corrector methods of Runge-Kutta type for stochastic differential equations

In this paper we construct predictor-corrector (PC) methods based on the trivial predictor and stochastic implicit Runge-Kutta (RK) correctors for solving stochastic differential equations. Using the colored rooted tree theory and stochastic B-series, the order condition theorem is derived for constructing stochastic RK methods based on PC implementations. We also present detailed order conditions of the PC methods using stochastic implicit RK correctors with strong global order 1.0 and 1.5. A two-stage implicit RK method with strong global order 1.0 and a four-stage implicit RK method with strong global order 1.5 used as the correctors are constructed in this paper. The mean-square stability properties and numerical results of the PC methods based on these two implicit RK correctors are reported.

An atomistic simulation of solid state sintering using Monte Carlo methods

This paper presents results on the simulation of the solid state sintering of copper wires using Monte Carlo techniques based on elements of lattice theory and cellular automata. The initial structure is superimposed onto a triangular, two-dimensional lattice, where each lattice site corresponds to either an atom or vacancy. The number of vacancies varies with the simulation temperature, while a cluster of vacancies is a pore. To simulate sintering, lattice sites are picked at random and reoriented in terms of an atomistic model governing mass transport. The probability that an atom has sufficient energy to jump to a vacant lattice site is related to the jump frequency, and hence the diffusion coefficient, while the probability that an atomic jump will be accepted is related to the change in energy of the system as a result of the jump, as determined by the change in the number of nearest neighbours. The jump frequency is also used to relate model time, measured in Monte Carlo Steps, to the actual sintering time. The model incorporates bulk, grain boundary and surface diffusion terms and includes vacancy annihilation on the grain boundaries. The predictions of the model were found to be consistent with experimental data, both in terms of the microstructural evolution and in terms of the sintering time. (C) 2002 Elsevier Science B.V. All rights reserved.

Comparative sperm ultrastructure in five genera of the nudibranch family Chromodorididae (Gastropoda : Opisthobranchia)

Sperm ultrastructure is examined in representatives of five genera of the nudibranch gastropod family Chromodorididae: (Chromodoris, Hypselodoris, Glossodoris, Risbecia and Pectenodoris) and the results compared with previous work on other gastropods, especially other nudibranchs. As chromodoridid phylogeny is still incompletely understood, this study partly focuses on the search for new and as yet untapped sources of informative characters. Like spermatozoa of most other heterobranch gastropods, those of the Chromodorididae are elongate, complex cells composed of an acrosomal complex (small, rounded acrosomal vesicle, and columnar acrosomal pedestal), a condensed nucleus, sub-nuclear ring, a highly modified mid-piece (axoneme + coarse fibres surrounded by a glycogen-containing, helically-coiled mitochondrial derivative) and terminally a glycogen piece (or homologue thereof). The finely striated acrosomal pedestal is a synapomorphy of all genera examined here, but interestingly also occurs in at least one dorid (Rostanga arbutus). Substantial and potentially taxonomically informative differences were also observed between genera in the morphology of the nucleus, the neck region of the mid-piece, and also the terminal glycogen piece. The subnuclear ring is shown for the first time to be a segmented, rather than a continuous structure; similarly, the annular complex is shown to consist of two structures, the annulus proper and the herein-termed annular accessory body.