Energy Reduction in SRAM using Dynamic Voltage and Frequency Management

This paper describes a dynamic voltage frequency control scheme for a 256 X 64 SRAM block for reducing the energy in active mode and stand-by mode. The DVFM control system monitors the external clock and changes the supply voltage and the body bias so as to achieve a significant reduction in energy. The behavioral model of the proposed DVFM control system algorithm is described and simulated in HDL using delay and energy parameters obtained through SPICE simulation. The frequency range dictated by an external controller is 100 MHz to I GHz. The supply voltage of the complete memory system is varied in steps of 50 mV over the range of 500 mV to IV. The threshold voltage range of operation is plusmn100 mV around the nominal value, achieving 83.4% energy reduction in the active mode and 86.7% in the stand-by mode. This paper also proposes a energy replica that is used in the energy monitor subsystem of the DVFM system.

An Efficient and Optimized Bluetooth Scheduling Algorithm for Scatternets

Bluetooth is a short-range radio technology operating in the unlicensed industrial-scientific-medical (ISM) band at 2.45 GHz. A scatternet is established by linking several piconets together in ad hoc fashion to yield a global wireless ad hoc network. This paper proposes a polling policy that aims to achieve increased system throughput and reduced packet delays while providing reasonably good fairness among all traffic flows in a Bluetooth Scatternet. Experimental results from our proposed algorithm show performance improvements over a well known existing algorithm.

Halogen Bonding and Structural Modularity in 2,3,4-and 3,4,5-Trichlorophenol

The crystal structure of 3,4,5-trichlorophenol contains hydrogen bonded domains that occur respectively in the structures of 4-chlorophenol and 3,5-dichlorophenol. Such modularity is also seen in 2,3,4-trichlorophenol. These structures, and those of the six isomeric dichlorophenols, illustrate the importance of halogen bonding as a structure determining interaction.

(2E)-1-(5-Chlorothiophen-2-yl)-3-(2,4,5-trimethoxyphenyl)prop-2-en-1-one

In the title molecule, C(16)H(15)ClO(4)S, the chlorothiophene and trimethoxyphenyl rings make a dihedral angle of 31.12 (5)degrees. The C = C double bond exhibits an E conformation. In the crystal, C-H center dot center dot center dot O interactions generate bifurcated bonds, linking the molecules into chains along the b axis.

4-(4-Chlorophenyl)-N-[(E)-4-(dimethylamino)benzylidene]-1,3-thiazol-2- amine

The title compound, C(18)H(16)ClN(3)S, adopts an extended molecular structure. The thiazole ring is inclined by 9.2 (1) and 15.3 (1)degrees with respect to the chlorophenyl and 4-(dimethylamino)phenyl rings, respectively, while the benzene ring planes make an angle of 19.0 (1)degrees. A weak intermolecular C-H center dot center dot center dot pi contact is observed in the crystal structure.

3-Ethyl-4-methyl-1H-pyrazol-2-ium-5-olate

The title compound, C(6)H(10)N(2)O, is a zwitterionic pyrazole derivative. The crystal packing is predominantly governed by a three-center iminium-amine N(+)-H center dot center dot center dot O(-)center dot center dot center dot H-N interaction, leading to an undulating sheet-like structure lying parallel to (100).

Synthesis and Antileukemic Activity of Novel 4-(3-(Piperidin-4-yl) Propyl)Piperidine Derivatives

To explore the anticancer effect associated with the piperidine framework, several (substituted phenyl) {4-[3-(piperidin-4-yl)propyl]piperidin-1-yl} methanone derivatives 3(a-i) were synthesized. Variation in the functional group at N-terminal of the piperidine led to a set of compounds bearing amide moiety. Their chemical structures were confirmed by (1)H NMR, IR and mass spectra analysis. Among these, compounds 3a, 3d and 3e were endowed with antiproliferative activity. The most active compound among this series was 3a with nitro and fluoro substitution on the phenyl ring of aryl carboxamide moiety, which inhibited the growth of human leukemia cells (K562 and Reh) at low concentration. Comparison with other derivative (3h) results shown by LDH assay, cell cycle analysis and DNA fragmentation suggested that 3a is more potent to induce apoptosis.

Model track studies on fouled ballast using ground penetrating radar and multichannel analysis of surface wave

Ballast fouling is created by the breakdown of aggregates or outside contamination by coal dust from coal trains, or from soil intrusion beneath rail track. Due to ballast fouling, the conditions of rail track can be deteriorated considerably depending on the type of fouling material and the degree of fouling. So far there is no comprehensive guideline available to identify the critical degree of fouling for different types of fouling materials. This paper presents the identification of degree of fouling and types of fouling using non-destructive testing, namely seismic surface-wave and ground penetrating radar (GPR) survey. To understand this, a model rail track with different degree of fouling has been constructed in Civil engineering laboratory, University of Wollongong, Australia. Shear wave velocity obtained from seismic survey has been employed to identify the degree of fouling and types of fouling material. It is found that shear wave velocity of fouled ballast increases initially, reaches optimum fouling point (OFP), and decreases when the fouling increases. The degree of fouling corresponding after which the shear wave velocity of fouled ballast will be smaller than that of clean ballast is called the critical fouling point (CFP). Ground penetrating radar with four different ground coupled antennas (500 MHz, 800 MHz, 1.6 GHz and 2.3 GHz) was also used to identify the ballast fouling condition. It is found that the 800 MHz ground coupled antenna gives a better signal in assessing the ballast fouling condition. Seismic survey is relatively slow when compared to GPR survey however it gives quantifiable results. In contrast, GPR survey is faster and better in estimating the depth of fouling. (C) 2011 Elsevier B.V. All rights reserved.

A Low Power Frequency Multiplication Technique for Zigbee Transceiver

A low-power frequency multiplication technique, developed for ZigBee (IEEE 802.15.4) like applications is presented. We have provided an estimate for the power consumption for a given output voltage swing using our technique. The advantages and disadvantages which determine the application areas of the technique are discussed. The issues related to design, layout and process variation are also addressed. Finally, a design is presented for operation in 2.405-2.485-GHz band of ZigBee receiver. SpectreRF simulations show 30% improvement in efficiency for our circuit with regard to conversion of DC bias current to output amplitude, against a LC-VCO. To establish the low-power credentials, we have compared our circuit with an existing technique; our circuit performs better with just 1/3 of total current from supply, and uses one inductor as against three in the latter case. A test chip was implemented in UMC 0.13-mum RF process with spiral on-chip inductors and MIM (metal-insulator-metal) capacitor option.

Hexa-arm star shaped hydrazone derivatives from hexakis(4-formylphenoxy)-cyclotriphosphazene core

A series of novel hexasubstituted cyclophosphazene hydrazones [N(3)P(3)(-OC(6)H(4)-p-CH=N-NH-C(O)-C(6)H(4)-p-X)(6)] (X = H, Br, Cl, F, OH, OCH(3), CH(3), NO(2), NH(2)) were prepared by a sixfold condensation reaction of [N(3)P(3)(-OC(6)H(4)-p-CHO)(6)] with para-substituted benzoic hydrazides [NH(2)-NH-C(O)-C(6)H(4)-p-X] with excellent yields (91-98%). The structures of the compounds were confirmed by elemental analysis, FT-IR, (1)H, (13)C, (31)P, 2D-HSQC NMR and mass spectrometry (MALDI-TOF). All the synthesized cyclophosphazene hydrazones exhibit high thermal stability. The crystal structure of a homogeneously substituted hexakis(4-formylphenoxy)-cyclotriphosphazene was determined by X-ray diffraction analysis. The compound crystallizes in the monoclinic system, space group P2(1)/n with a = 16.558(3) angstrom, b = 10.250(2) angstrom, c = 23.429(5) angstrom, alpha = gamma = 90.00 degrees, beta = 90.461(4)degrees, V = 3976.5(14) angstrom(3) and Z = 4. The R value is 0.0823 for 4290 observed reflections. The conformations of the 4-formylphenoxy-groups are different at the three phosphorus atoms. (C) 2011 Elsevier B.V. All rights reserved.

Ethyl 6-methyl-2-sulfanylidene-4-[4(trifluoromethyl)phenyl]-1,2,3,4-tetrahyd ropyrimidine-5-carboxylate

The title compound, C(15)H(15)F(3)N(2)O(2)S, adopts a conformation with an intramolecular C-H center dot center dot center dot pi interaction. The dihedral angles between the planes of the 4-(trifluoromethyl) phenyl and ester groups with the plane of the six-membered tetrahydropyrimidine ring are 81.8 (1) and 16.0 (1)degrees, respectively. In the crystal structure, intermolecular N-H center dot center dot center dot S hydrogen bonds link pairs of molecules into dimers and N-H center dot center dot center dot O interactions generate hydrogen-bonded molecular chains along the crystallographic a axis.