Numerical analysis of the current and voltage sharing issues for resistive fault current limiter using YBCO coated conductors

YBaCuO-coated conductors offer great potential in terms of performance and cost-saving for superconducting fault current limiter (SFCL). A resistive SFCL based on coated conductors can be made from several tapes connected in parallel or in series. Ideally, the current and voltage are shared uniformly by the tapes when quench occurs. However, due to the non-uniformity of property of the tapes and the relative positions of the tapes, the currents and the voltages of the tapes are different. In this paper, a numerical model is developed to investigate the current and voltage sharing problem for the resistive SFCL. This model is able to simulate the dynamic response of YBCO tapes in normal and quench conditions. Firstly, four tapes with different Jc 's and n values in E-J power law are connected in parallel to carry the fault current. The model demonstrates how the currents are distributed among the four tapes. These four tapes are then connected in series to withstand the line voltage. In this case, the model investigates the voltage sharing between the tapes. Several factors that would affect the process of quenches are discussed including the field dependency of Jc, the magnetic coupling between the tapes and the relative positions of the tapes. © 2010 IEEE.

Critical current densities of MOCVD tapes for different current directions

The critical current density Jc of an MOCVD/IBAD coated conductor was measured on tracks patterned longitudinally (L) and transversely (T) to the tape direction. Despite the samples' vicinality no dependence J c of on track direction was found for magnetic fields applied perpendicular to the film plane. In angular out-of-plane measurements the previously reported asymmetry due to tilted precipitate planes was observed in an L track, whereas curves from a T track were almost perfectly symmetric with similarly high absolute values of Jc. At low fields the effects of surface pinning were seen. Our results show that in most scenarios the current carrying capability is equally as good parallel and perpendicular to the tape direction, which is highly relevant for ROEBEL cables. In measurements where the magnetic field was swept in the film plane the anisotropy was found to be significantly higher than for MOD/RABiTS samples, which we explain by the different morphology of grain boundaries in the tapes. At low temperatures Jc of a T track exhibited a clear signature of vortex channeling. © 2010 IEEE.

Determination of threshold current densities for different reactions of fishes using a pantostat

The threshold current densities required for first reaction, galvanotaxis and galvanonarcosis of fish depended upon species, length of the body, conductivity of water, nature of current and frequency of impulses. The threshold values and their ratios decreased with increase in length of fish. With rise in conductivity of water in the ratio of 1:4:13, these values increased in the ratio 1: 2:5. Impulse D. C was superior to continuous D. C and the threshold values of current densities for different reactions of fish decreased with rise in impulse frequency reaching minimum at an impulse frequency of 48/sec. Among Salmo irideus, ldus melanotus and Cyprinus carpio, the first one was affected earlier and required minimum current densities to exhibit the reactions, while the last one showed similar reactions only at higher current densities.

Development of an electric shrimp trawl 1. Reaction of shrimps to low volt direct current

Preliminary attempts were made to assess the effect of direct current on shrimps and to see whether the shrimp could be guided in large numbers into the fishing net by using a current of appropriate voltage without scattering them away as it happens at present. This communication is the first in the series of studies and primarily deals with laboratory equipment and experimental procedures followed.

On the behaviour of marine crustaceans in an electrical field of alternating current

The minimum flow of current essential to produce electro-narcosis and fixation in marine crustaceans, Metapenaeus affinis, Parapenaeopsis stylifera, Panulirus ornatus and Neptunus sanguinofentus in an AC field of specific strength varied with the lengths of animals tested, except in case of the last one where the increase in size of animals showed no significant effect on the effective period for different reactions. M. affinis in interrupted AC required threshold pulses for narcosis and fixation, which varied inversely with the length of the organism. Animals subjected to current of higher effective period required longer time for recovery in interrupted AC of 50 c/s. The period for narcosis and recovery of M. affinis did not vary significantly with repeated stimulations on the same organism.

Studies on threshold current densities for convulsion of fish using a square wave stimulator

The threshold current densities and voltage tensions (body voltages) between the head and tail for bringing about distinct reactions in Salmo irideus, Cyprinus Carpio, Tinea tinca, Gasterosteus aculeatus and Salmo fario were studied. In C. carpio and T. tinca, absolute current densities required decreased with increase in length of fish. Threshold current densities for different reactions of fish increased with rise in water temperature and conductivity of surrounding medium except in case of T. tinca where low current densities were sufficient in higher conductivity of water. Impulse D.C. was superior to continuous D.C. Better effect was noticed in fishes in lower current densities when their bodies were parallel to the lines of current conduction.

Liriomyza huidobrensis in Yunnan, China: current distribution and genetic structure of a recently established population

Liriomyza huidobrensis Blanchard (Diptera: Agromyzidae) is a very serious and economically important pest around the world. Liriomyza huidobrensis in China was first reported from Kunming of Yunnan province in 1993. We report here that this pest has recen

Benefits of current percolation in superconducting coated conductors

The critical currents of coated conductors fabricated by metal-organic deposition (MOD) on rolling-assisted biaxially textured substrates (RABiTS) and by pulsed laser deposition (PLD) on ion-beam assisted deposition (IBAD) templates have been measured as a function of magnetic field orientation and compared to films grown on single crystal substrates. By varying the orientation of magnetic field applied in the plane of the film, we are able to determine the extent to which current flow in each type of conductor is percolative. Standard MOD/RABiTS conductors have also been compared to samples whose grain boundaries have been doped by diffusing Ca from an overlayer. We find that undoped MOD/RABiTS tapes have a less anisotropic in-plane field dependence than PLD/IBAD tapes and that the uniformity of critical current as a function of in-plane field angle is greater for MOD/RABiTS samples doped with Ca. (C) 2005 American Institute of Physics.