The ecology of paper mill by-product and its evaluation as a casing medium in the culture of Agaricus bisporus (Lange) Pilat

Effluent from pulp and paper production at the Kemsley mill of Bowaters U.K. Paper Company Limited passes through two treatment stages before its discharge into the Swale estuary. Suspended material removed during treatment is deposited on wasteground as a thin sludge. The solids it contains are mainly wood components lost during pulp production, whilst it also has a high salt content, derived from chemicals used in pulping processes. After deposition the sludge undergoes an ageing process during which it dries out and its salt content is reduced. This ageing can be reproduced and accelerated by improved drainage under controlled conditions. The paper mill sludge was investigated as a casing medium in the culture of Agaricus bisporus (Lange) Pilat, the cultivated mushroom. It was unsuitable up to one year from deposition due largely to the inhibitory effect of its salt content on fruiting. Material eighteen months or more in age gave yields comparable to standard peat casing. Before use as a casing the material must be shredded to a satisfactory structure, neutralised with chalk, and pasteurised to eliminate organisms harmful to the crop. The prepared medium has a high water holding capacity and a structure resilient to management procedures, important requirements of a good casing. A passive movement of salts from the compost to the casing was shown to occur during culture, capable of enhancing the natural decline in cropping if sufficiently great. The ions chloride, potassium, sodium and sulphate were shown to be responsible, their damaging effects being due to high conductivity created in the casing. Studies of elements available during culture suggested phosphate availability in the compost could limit crop potential, whilst iron released by mycelium of A.bisporus in the casing may be utilised by associated micro-organisms.

Biomass production in short rotation effluent-irrigated plantations in North-West India

This study estimates above-ground biomass in high density plantations of six important semi-arid tree species at Palwal (70 km from Delhi) irrigated with secondary treated sewage water at the rate of 0, 25, 50 and 100% of daily net evaporation potential (EP). In 2.5 y old plantations (plant spacing, 2 m x 2 m for single stem species and 2 m x 1 m for multi-stem species), Melia azedarach showed fairly high biomass production (38.4 t/ha) followed by Ailanthus excelsa (27.2 t/ha). Order of biomass production (kg / tree) was: Eucalyptus tereticornis (24.1) > A. excelsa (21.8) > M. azedarach (12.6) > Populus deltoides clone G 48 (8.3) > Alstonia scholaris (6.6)> Pongamia pinnata (3.7). Survival of plants after 2.5 y ranged from 25.2% in P. deltoides to 71.7% in P. pinnata, and had a significant effect on biomass production per unit area. ANOVA shows that levels of irrigation (0 - 100%) did not have statistically significant effect on plant growth. Correlation between diameter and biomass was found highly significant (p< 0.01) with R2 nearing to 1.

Responsible management education from across the pond:innovations and experiences in UK business schools

The session draws upon experiences highlighted within a series of ongoing CSR/sustainability teaching days organized through the British Academy of Management CSR Special Interest Group, designed to encourage UK schools to develop new innovative curricula and to engage with the UN PRME initiative. The panel will consist of representatives from UK universities all of which are at different stages of developing responsible management curricula and have adopted different approaches towards these challenges.

Project risk management using multiple criteria decision-making technique and decision tree analysis:a case study of Indian oil refinery

This study proposes an integrated analytical framework for effective management of project risks using combined multiple criteria decision-making technique and decision tree analysis. First, a conceptual risk management model was developed through thorough literature review. The model was then applied through action research on a petroleum oil refinery construction project in the Central part of India in order to demonstrate its effectiveness. Oil refinery construction projects are risky because of technical complexity, resource unavailability, involvement of many stakeholders and strict environmental requirements. Although project risk management has been researched extensively, practical and easily adoptable framework is missing. In the proposed framework, risks are identified using cause and effect diagram, analysed using the analytic hierarchy process and responses are developed using the risk map. Additionally, decision tree analysis allows modelling various options for risk response development and optimises selection of risk mitigating strategy. The proposed risk management framework could be easily adopted and applied in any project and integrated with other project management knowledge areas.

Quantitative risk management aids refinery construction

Conventional project management techniques are not always sufficient to ensure that schedule, cost and quality goals are met on large-scale construction projects. These jobs require complex planning, designing and implementation processes. The main reasons for a project's nonachievement in India's hydrocarbon processing industry are changes in scope and design, altered government policies and regulations, unforeseen inflation, under and/or improper estimation. Projects that are exposed to such an uncertain environment can be effectively managed by applying risk management throughout the project life cycle.

Solar pond powered liquid desiccant evaporative cooling

Liquid desiccant cooling systems (LDCS) are energy efficient means of providing cooling, especially when powered by low-grade thermal sources. In this paper, the underlying principles of operation of desiccant cooling systems are examined, and the main components (dehumidifier, evaporative cooler and regenerator) of the LDCS are reviewed. The evaporative cooler can take the form of direct, indirect or semi-indirect. Relative to the direct type, the indirect type is generally less effective. Nonetheless, a certain variant of the indirect type - namely dew-point evaporative cooler - is found to be the most effective amongst all. The dehumidifier and the regenerator can be of the same type of equipment: packed tower and falling film are popular choices, especially when fitted with an internal heat exchanger. The energy requirement of the regenerator can be supplied from solar thermal collectors, of which a solar pond is an interesting option especially when a large scale or storage capability is desired.

Experimental investigation of the fuel properties of glidfuel, palm oil mill effluent biodiesel and blends

Biofuels derived from industry waste have potential to substitute fossil fuels (Diesel and Gasoline) in internal combustion (IC) engines. Use of waste streams as fuels would help to reduce considerably life-cycle greenhouse gas emissions and minimise waste processing costs. In this study an investigation into the fuel properties of two waste derived biofuels were carried out, they are: (i) Glidfuel (GF) biofuel - a waste stream from paper industry, and (ii) Palm Oil Mill Effluent (POME) biodiesel - biodiesel produced from palm oil industry effluent through various treatment and transesterification process. GF and POME was mixed together at various proportions and separately with fossil diesel (FD) to assess the miscibility and various physical and chemical properties of the blends. Fuel properties such as kinematic viscosity, higher heating value, water content, acid number, density, flash point temperature, CHNO content, sulphur content, ash content, oxidation stability, cetane number and copper corrosion ratings of all the fuels were measured. The properties of GF, POME and various blends were compared with the corresponding properties of the standard FD. Significance of the fuel properties and their expected effects on combustion and exhaust emission characteristics of the IC engine were discussed. Results showed that most properties of both GF and POME biodiesel were comparable to FD. Both GF and POME were miscible with each other, and also separately with the FD. Flash point temperatures of GF and POME biodiesel were 40.7°C and 158.7°C respectively. The flash point temperature of GF was about 36% lower than corresponding FD. The water content in GF and FD were 0.74 (% wt) and 0.01 (% wt) respectively. Acidity values and corrosion ratings of both GF and POME biodiesel were low compared to corresponding value for FD. The study concluded that optimum GF-POME biofuel blends can substitute fossil diesel use in IC engines.

Adam Rosenblatt (PhD student) holding one of his study subjects, an American alligator, in the Shark River estuary

This material is based upon work supported by the National Science Foundation through the Florida Coastal Everglades Long-Term Ecological Research program under Cooperative Agreements #DBI-0620409 and #DEB-9910514. This image is made available for non-commercial or educational use only.

Charles Perry and Man Holding Document

Charles Edward Perry (Chuck), 1937-1999, was the founding president of Florida International University in Miami, Florida. He grew up in Logan County, West Virginia and graduated from Bowling Green State University. He married Betty Laird in 1960. In 1969, at the age of 32, Perry was the youngest president of any university in the nation. The name of the university reflects Perry’s desire for a title that would not limit the scope of the institution and would support his vision of having close ties to Latin America. Perry and a founding corps opened FIU to 5,667 students in 1972 with only one large building housing six different schools. Perry left the office of President of FIU in 1976 when the student body had grown to 10,000 students and the university had six buildings, offered 134 different degrees and was fully accredited. Charles Perry died on August 30, 1999 at his home in Rockwall, Texas. He is buried on the FIU campus in front of the Graham Center entrance.

Charles Perry Holding Microphone at Graduation Ceremony

Charles Edward Perry (Chuck), 1937-1999, was the founding president of Florida International University in Miami, Florida. He grew up in Logan County, West Virginia and received his bachelor's and masters's degrees from Bowling Green State University. He married Betty Laird in 1960. In 1969, at the age of 32, Perry was the youngest president of any university in the nation. The name of the university reflects Perry’s desire for a title that would not limit the scope of the institution and would support his vision of having close ties to Latin America. Perry and a founding corps opened FIU to 5,667 students in 1972 with only one large building housing six different schools. Perry left the office of President of FIU in 1976 when the student body had grown to 10,000 students and the university had six buildings, offered 134 different degrees and was fully accredited. Charles Perry died on August 30, 1999 at his home in Rockwall, Texas. He is buried on the FIU campus in front of the Graham Center entrance.

Extending Holding Time for Hot Foods

Humidifying the air inside a hot holding cabinet can greatly extend the holding time for hot foods by retarding the quality degradation of the food due to moisture loss. Not all cabinets are equally effective in maintaining temperature and humidity. A rudimentary understanding of how heat and moisture are transferred to the food will help operators select the cabinet that best meets operation’s needs. The authors address what works and why.

The status and ecology of the American alligator (Alligator mississippiensis) in Par Pond, Savannah River site

Par Pond is a man-made 1120 ha cooling reservoir located on the Savannah River Site near Aiken, South Carolina. From 1972-1978 a detailed study on the status of the alligator in Par Pond was conducted by Tom Murphy (unpub. MS thesis Univ. of GA, 1977). Murphy estimated that approximately 110 alligators inhabited Par Pond with an adult (> 1.8 m) to juvenile (< 1.8 m) ratio of (1.8:1), an overall sex ratio of 3.2:1, and an average of only 2.3 nests/yr. The purpose of this study (1986-1989) was to determine the current population size and structure, determine how the population has changed in the last 15 years and to examine growth and survival of juvenile alligators. Data were collected by monthly night-time eyeshine counts aerial surveys, capturing animals, and locating and following the fate of nests. There was a strong positive correlation between water temperature and the number of alligators observed during eyeshine counts. Both eyeshine counts and aerial surveys were highest in spring and varied seasonally. A total of 184 different non-hatchling and 157 hatchling alligators were captured between May 1986 and November 1988. Population estimates and size distributions based on capture data indicate that over the last 15 years the population has increased from approximately 110 to 200 alligators, and the size distribution has shifted from one dominated by large adults to one that has a higher proportion of juveniles. The current sex ratio (2.6:1) is not significantly different from that reported by Murphy (1977, 3.2:1). However, the average number of nests/yr has increased from 2.3 to 4.0. Data on juvenile growth and survival show that the growth rate of hatchlings (32.9 cm/yr total length) is greater than that of animals age 1-3 (21.6 cm/yr total length) and survival of all ages is variable between years and between clutches. Results from this study indicate that from 1972-988 the population has increased ac an average exponential rate of 6 % per year. If conditions in Par Pond do not change, the population size should continue to increase.

Jessica Lee holding a largemouth bass (Micropterus salmoides)

http://digitalcommons.fiu.edu/fce_lter_photos/1298/thumbnail.jpg

Ground-based electromagnetic (EM) and drill-hole ice and snow thickness and melt pond depth measurements during Polarstern cruise ARK-IX/4, ARK-XI/1, and ARK-XII

Drillhole-determined sea-ice thickness was compared with values derived remotely using a portable small-offset loop-loop steady state electromagnetic (EM) induction device during expeditions to Fram Strait and the Siberian Arctic, under typical winter and summer conditions. Simple empirical transformation equations are derived to convert measured apparent conductivity into ice thickness. Despite the extreme seasonal differences in sea-ice properties as revealed by ice core analysis, the transformation equations vary little for winter and summer. Thus, the EM induction technique operated on the ice surface in the horizontal dipole mode yields accurate results within 5 to 10% of the drillhole determined thickness over level ice in both seasons. The robustness of the induction method with respect to seasonal extremes is attributed to the low salinity of brine or meltwater filling the extensive pore space in summer. Thus, the average bulk ice conductivity for summer multiyear sea ice derived according to Archie's law amounts to 23 mS/m compared to 3 mS/m for winter conditions. These mean conductivities cause only minor differences in the EM response, as is shown by means of 1-D modeling. However, under summer conditions the range of ice conductivities is wider. Along with the widespread occurrence of surface melt ponds and freshwater lenses underneath the ice, this causes greater scatter in the apparent conductivity/ice thickness relation. This can result in higher deviations between EM-derived and drillhole determined thicknesses in summer than in winter.