Síntese e caracterização de matrizes híbridas para aplicação em sistemas de liberação controlada

Pós-graduação em Ciência dos Materiais - FEIS

Estudo da relação de ordem-desordem estrutural em nanopartículas de TiO2

Pós-graduação em Química - IQ

Caracterização de filmes de BaxSr1-xTiO3 Sintetizados pelo método hidrotermal assistido por micro-ondas e depositados por eletroforese

Pós-graduação em Ciência e Tecnologia de Materiais - FC

Caracterização da distribuição física dos dolomitos do membro Búzios no Campo de Badejo - Bacia de Campos

In the region of Badejo oil Ffeld (Campos Basin) lies an Lower Albian dolomitic layer that shows reservoir rock and seal conditions, among others and, it is occasionally karstified. This work applies geostatistical techniques of ordinary and indicatior kriging, in an attempt to determine a method that assists the analysis of different scenarios offered for petroleum drilling from a quantitative point of view this fact is justified, because there are different visions and strategies that would be adopted under different dolomite conditions (stable - low porosity and high density; reservoir - high porosity and medium density; instable - high porosity and low dentisty). The main objective is a methodological introduction that has not been tested in dolomites before aiming to characterize the distribution of the three conditions described above by ordinary and indicatior kriging, which was based on the obtained data from the dolomite layer identification through well logs interpretation and correlation, followed by seismic interpretation. In addition, it was generated structural contour maps, based on 2D and 3D seismic data interpretation, and then, seismic attributes maps were calculated, in order to transform them into pseudo-density maps, i.e., maps that correlate the density values with the attribute values. As primary results, structural contour maps and seismic attributes were obtained and ordinary and indicatior kriging maps were done, on which it is possible to interpret the distribution of the main reservoir and risk probability for drilling of exploration wells obtaining trends N35E and N10W direction for areas of stability or reservoir levels, while the central part of the map presents a higher risk for loss of drilling fluid. The cut-off values levels were based on the values of first and third quartiles of cumulative histogram (instable and stable zones, respectively), as well as the reservoir level was set as the interval...

Aplicação de doses de vinhaça sob desenvolvimento vegetativo de pastagem degradada e propriedades físicas do solo

The experiment was conducted in the experimental field of the University of GoiásUEG, UNU Ipameri - GO with the objective of evaluating the effect of different doses of vinasse on the vegetative development of degraded pasture and soil physical properties in two seasons. The pasture used in the experiment was in a state of degradation, and had eight years of formation. The experimental design was randomized blocks consisted of eight treatments and four blocks, totaling 32 experimental units. We evaluated the following soil physical properties: density the soil, particle density, total porosity, infiltration velocity, soil water. We also evaluated the following parameters of vegetative development of grassland: green and dry mass of shoots, effective depth of the root system, the grass height. The results were submitted to analysis of variance at 5% significance level and after we performed regression testing. The vinasse promoted significant effect on all parameters related to vegetative development of both grazing during the rainy season as in the dry. In this case, a model that best fit the dataset vegetative pasture was quadratic. It appeared that the vinasse different doses did not cause changes in the physical properties of the soil.

Cimentos bioativos injetáveis funcionalizados com peptídeo osteogênico para reparação óssea

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Variabilidade espaço-temporal da emissão de CO2 do solo em curto período sob influência de eventos de precipitação

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Testes convencionais e empregando Micro-CT na avaliação de propriedades físico-químicas de materiais retrobturadores e cimentos endodônticos

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Comportamento do carbono orgânico e de atributos químicos, físicos e microbiológicos de um solo arenoso em área de conversão pastagem - Eucalipto

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Concreto permeável para pavimentação urbana com uso de resíduos de construção e demolição produzidos na usina de reciclagem de são josé do Rio Preto

Pós-graduação em Engenharia Civil - FEIS

Análises físico-químicas e biológicas de diferentes scaffolds à base de polihidroxibutirato e polihidroxibutirato-co-valerato

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Propriedades físicas e mecânicas de cimentos de ionômero de vidro encapsulados e não encapsulados

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Desenvolvimento de sensores de gás a partir de óxido semicondutor nanoestruturado

The present work aims to study one-dimensional nanomaterials semiconductors grown via by phase systems Grande oxides Technological Interest for applications in gas sensors. The Used material was tin oxide (SnO2) for their functional properties, and the grow method was the Polymeric Precursors. The films grown were the nanomaterials about substrates of alumina, deposited via spin coating technique, followed by heat treatment at 300C for 1 hour and 650C for 2 hours. Later the films of Performance sensors (sensitivity, speed response, selectivity, and stability) will be in avaliated in a hermetic chamber with controlled atmosphere and temperature. The synthesized materials were its structural and morphological properties characterized in atomic force microscopy (AFM), scanning electron microscopy (SEM), X-ray diffraction (XRD) and transmission electron microscopy (not have this result with Me). We sought to investigate one influence of different conditions for obtaining films (Variation Layers number) in structural and microstructural properties of semiconductors oxides. The synthesis method proved very effective, generating films with micro definitely, uniformity of the nanoparticles and hum high level of porosity, what makes the material of a viable final paragraph applicability

Aplicação de carbono vítreo monolítico para produção de eletrodos a partir da resina furfurílica com diferentes variações de pH

Nowadays, we live in a time of rapid research for technological advances, in a way that this pursuit of new technologies is deeply connected to the diversity of new materials that have been developed by mankind. It deals with issues such as materials with enhanced properties which offer better quality, less cost and high performance, while they are accessible both in their production and moment of operation. In this context, it was required to develop electrodes that were easy to prepare as well as which present high electric conductivity and good mechanic proprieties by using carbonaceous material as basis. For this reason, the best parameters of the furfuryl resin cures were established with different pH variations through viscosimetric measurements and differential scanning calorimetry. By scanning electron microscopy (SEM) was possible to identify an increased porosity in the samples with pH 7 and pH 8, as compared to samples with lower pH content. After carbonization of the material, the characterization of monolithic glassy carbon was held by means of FT-IR techniques, Raman spectroscopy, X-ray diffraction and cyclic voltammetry. The spectra showed that the change in pH does not have significant influence on the crystallographic ordering of the material and its structural characteristics. As for the electrochemical character, the CVM electrodes showed excellent response, with good reversibility and wide potential window. Some voltammetric curve deviations were only observed for the sample with pH 4, which may be related to processing parameters adopted

Análises físico-químicas e biológicas de diferentes scaffolds à base de polihidroxibutirato e polihidroxibutirato-co-valerato

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)