Stability of cassava flour-based food bars

The consumption of Brazilian cassava has been reduced due to a lack of adjustment to the modern lifestyle. To reverse this trend, new products could be developed specifically targeted to high-value niche markets. Cereal bars stand out as fast food high in nutritional value. A bar formula mimicking cereal bars was prepared using a mixture of Brazilian cassava flour, hydrogenated vegetable fat, dried bananas, ground cashew nuts, and glucose syrup. After being pressed, the bars were dried for 1 hour at 65 °C, packaged in films, and stored under ambient conditions. Its stability was continuously monitored for 210 days in order to ensure its safety and enable its introduction to the market. Texture loss was observed in the packed bars after 90 days of storage, but the sensory characteristics allowed the testers to perceive this tendency after only 30 days of storage. However, chemical, physical, and microbial analyses confirmed that the bars were safe for consumption for 180 days. The results showed that a 45 g cassava flour-based bar enriched with nuts and dried fruits can meet 6% of the recommended daily fiber intake with a caloric value between that of the common cereal bar and that of an energy bar. Adapting the formula with ingredients (fruits, nuts) from different regions of Brazil may add value to this traditional product as a fast food.

Citotoxicity of food dyes sunset yellow (E-110), bordeaux red (E-123), and tatrazine yellow (E-102) on Allium cepa L. root meristematic cells

The objective of this study was to evaluate the cytotoxic effect of the food dyes sunset yellow, bordeaux red, and tartrazine yellow on the cellular cycle of Allium cepa L. Each dye was evaluated at the doses of 0.4 and 4.0 mL, at the exposure times of 24 and 48 hours in root tip cells of Allium cepa L. Slides were prepared and cells were analyzed during the whole cell cycle for cellular aberrations totaling 5,000 total cells for each dose evaluated. The mitotic index was calculated, and statistical analysis was performed using the Chi-squared test (p < 0.05). The results showed that the three dyes used under the evaluated doses and exposure times were cytotoxic to the cells of the system-test used. Further cytotoxicity studies should be conducted for additional results and a proper evaluation of the effect of these three dyes on a cellular level.

Comparative analysis of vitamin A and iron content in food according to different food composition tables and nutritional evaluation software programs

The objective of this study was to analyze retinol equivalent and iron content in different food composition tables and nutritional evaluation software programs. A literature search was conduct to identify tables and software available in Brazil containing information about retinol equivalent and iron content that are currently used by nutritionists. Ten tables and five software programs were selected for this study. The methodology used to present the retinol equivalent and iron content was evaluated and no pattern to obtain such content was found in the tables and software programs analyzed. Only one of the tables had enough information for the calculation of retinol equivalents; this table is recommended to all Latin America As for the iron content, three of the tables analyzed stand out and therefore should be used; two of them are based on national foods and the other is recommended for use in all Latin America countries. None of the software programs evaluated use the conversion factors suggested by IVACG to assess the vitamin A content in foods. Special attention should be given to the content of iron provided in the software programs since they use tables as international sources and fortified foods.

Effects of the mechanical damage on the water absorption process by corn kernel

The purpose of this study was to investigate and model the water absorption process by corn kernels with different levels of mechanical damage Corn kernels of AG 1510 variety with moisture content of 14.2 (% d.b.) were used. Different mechanical damage levels were indirectly evaluated by electrical conductivity measurements. The absorption process was based on the industrial corn wet milling process, in which the product was soaked with a 0.2% sulfur dioxide (SO2) solution and 0.55% lactic acid (C3H6O3) in distilled water, under controlled temperatures of 40, 50, 60, and 70 ºC and different mechanical damage levels. The Peleg model was used for the analysis and modeling of water absorption process. The conclusion is that the structural changes caused by the mechanical damage to the corn kernels influenced the initial rates of water absorption, which were higher for the most damaged kernels, and they also changed the equilibrium moisture contents of the kernels. The Peleg model was well adjusted to the experimental data presenting satisfactory values for the analyzed statistic parameters for all temperatures regardless of the damage level of the corn kernels.

Detection of genetically modified maize events in Brazilian maize-derived food products

The Brazilian government has approved many transgenic maize lines for commercialization and has established a threshold of 1% for food labeling, which underscores need for monitoring programs. Thirty four samples including flours and different types of nacho chips were analyzed by conventional and real-time PCR in 2011 and 2012. The events MON810, Bt11, and TC1507 were detected in most of the samples, and NK603 was present only in the samples analyzed in 2012. The authorized lines GA21, T25, and the unauthorized Bt176 were not detected. All positive samples in the qualitative tests collected in 2011 showed a transgenic content higher than 1%, and none of them was correctly labeled. Regarding the samples collected in 2012, all positive samples were quantified higher than the threshold, and 47.0% were not correctly labeled. The overall results indicated that the major genetically modified organisms detected were MON810, TC1507, Bt11, and NK603 events. Some industries that had failed to label their products in 2011 started labeling them in 2012, demonstrating compliance with the current legislation observing the consumer rights. Although these results are encouraging, it has been clearly demonstrated the need for continuous monitoring programs to ensure consumers that food products are labeled properly.

Chemical evaluation and effect of bagging new peach varieties introduced in southern Minas Gerais - Brazil

Brazilian peach production is insufficient for domestic supply. Aiming to increase production in the state of Minas Gerais, 16 new peach tree varieties were introduced in the Serra da Mantiqueira region and their fruit were analyzed for sugar, total phenol and total carotenoid contents by colorimetric methods, and for organic acid content by high-performance liquid chromatography. In addition, we examined the effect of fruit bagging on the levels of such constituents. To do so, the fruit of half the trees of each variety were bagged. The levels of sugars, phenols, carotenoids and organic acids are genotypic characteristics and significantly differed among varieties. Despite being a good form of fruit protection, providing better aspect and reducing the need for pesticides, bagging leads to lower contents of components such as sugars, phenols and organic acids in most varieties. However, it cannot be stated that this practice interferes with sensory characteristics. Knowledge of the chemical constituents of these new varieties allows determining those ideal for fresh consumption (e.g., "Maciel", "Diamante", "T. Beauty", "Ouromel 2" and "C.1056", among others) and those more suitable for industrial processing (e.g., "A. Gold", "C.1122" and "C.1050"), as well as those which serve both purposes.

Quality characteristics of Moroccan sweet paprika (Capsicum annuum L.) at different sampling times

"La Niora" is a red pepper variety cultivated in Tadla Region (Morocco) which is used for manufacturing paprika after sun drying. The paprika quality (nutritional, chemical and microbiological) was evaluated immediately after milling, from September to December. Sampling time mainly affected paprika color and the total capsaicinoid and vitamin C contents. The commercial quality was acceptable and no aflatoxins were found, but the microbial load sometimes exceeded permitted levels.

Biochemical characteristics of composite flours: influence of fermentation

The purpose of this study was to introduce yam in the development of two new composite flours containing soy and cassava. Two composite flours were obtained after fermentation of yam, soybean, and cassava in respectively 60, 30, and 10% proportions. Two varieties of yam were used: Dioscorea alata (variety "Bete bete") and Dioscorea cayenensis (variety "Lokpa"). Proximate composition, mineral content, some anti-nutritional factors (oxalates, phenols), microbiological quality, and α-amylase digestibility were determined for the fermented and unfermented composite flours. The results indicated that for the composite flours made of D. alata and D. cayenensis, fermentation increased ash and titrable acidity. Carbohydrates, pH, and energy decreased. Crude fat content was not affected by the fermentation process. Anti-nutritional factors such as oxalates and phenols were found to decrease significantly after the fermentation of the composite flours. Fermentation increased the mineral content (Mg, K, Fe, and Ca) of the composite flours. A decrease in P and Na was observed after fermentation. The microbiological study showed that safety flours contain no potential pathogenic germs. The in vitro α-amylase digestibility of the composite flours was significantly improved after fermentation. The biochemical characteristics and good hygienic quality of the obtained flours suggest that these flours can be considered as a feeding alternative for children in poor areas where yam is produced.

The effect of acid hydrolysis on the technological functional properties of pinhão (Araucaria brasiliensis) starch

Technological functional properties of native and acid-thinned pinhão (seeds of Araucária angustifolia, Brazilian pine) starches were evaluated and compared to those of native and acid-thinned corn starches. The starches were hydrolyzed (3.2 mol.L-1 HCl, 44 ºC, 6 hours) and evaluated before and after the hydrolysis reaction in terms of formation, melting point and thermo-reversibility of gel starches, retrogradation (in a 30-day period and measurements every three days), paste freezing and thawing stability (after six freezing and thawing cycles), swelling power, and solubility. The results of light transmittance (%) of pastes of native and acid-thinned pinhão starches was higher (lower tendency to retrogradation) than that obtained for corn starches after similar storage period. Native pinhão starch (NPS) presented lower syneresis than native corn starch (NCS) when submitted to freeze-thaw cycles. The acid hydrolysis increased the syneresis of the two native varieties under storage at 5 ºC and after freezing and thawing cycles. The solubility of NPS was lower than that of native corn starch at 25, 50, and 70 ºC. However, for the acid-thinned pinhão starch (APS), this property was significantly higher (p < 0.05) when compared to that of acid-thinned corn starch (ACS). From the results obtained, it can be said that the acid treatment was efficient in producing a potential fat substitute from pinhão starch variety, but this ability must be further investigated.

Volatile profile and sensory quality of new varieties of Capsicum chinense pepper

The objective of this study was to compare the sensory quality and the volatile compound profile of new varieties of Capsicum chinense pepper (CNPH 4080 a strain of'Cumari-do-Pará' and BRS Seriema) with a known commercial variety (Biquinho). Volatiles were isolated from the headspace of fresh fruit by SPME and identified by GC-MS. Pickled peppers were produced for sensory evaluation. Aroma descriptors were evaluated by Check-All-That-Apply (CATA) method, and the frequency data were submitted to Correspondence Analysis. Flavor acceptance was assessed by hedonic scale and analyzed by ANOVA. BRS Seriema showed the richest volatile profile, with 55 identified compounds, and up to 40% were compounds with sweet aroma notes. CNPH 4080 showed similar volatile profile to that of Biquinho pepper, but it had higher amounts of pepper-like and green-note compounds. The samples did not differ in terms of flavor acceptance, but they showed differences in aroma quality confirming the differences found in the volatile profiles. The C. chinense varieties developed by Embrapa proved to be more aromatic than Biquinho variety, and were well accepted by the judges.

Estimate of dietary intake of chloropropanols (3-MCPD and 1,3-DCP) and health risk assessment

Chloropropanols, including 3-monochloropropane-1,2-diol (3-MCPD) and 1,3-dichloropropan-2-ol (1,3-DCP), comprise a group of chemical contaminants with carcinogenic and genotoxic properties. They have been found in a variety of processed foods and food ingredients, such as hydrolyzed vegetable protein, soy sauce, cereal-based products, malt-derived ingredients, and smoked foods. This study aimed to assess the dietary exposure to 3-MCPD and 1,3-DCP in Brazil and verify whether the presence of these substances in foods could represent health risks. The intake was calculated by combining data on food consumption, provided by the Consumer Expenditure Survey 2008-2009, with the levels of contaminant occurrence determined by gas chromatography-mass spectrometry. The exposure to 3-MCPD ranged from 0.06 to 0.51 µg.kg bw-1.day-1 considering average and high consumers, while the intake of 1,3-DCP was estimated to be 0.0036 µg.kg bw-1.day-1 in the worst case scenario evaluated. Based on these results, it was verified that the Brazilians' exposure to chloropropanols does not present a significant health risk. However, the consumption of specific foods containing high levels of 3-MCPD could exceed the provisional maximum tolerable daily intake of 2 µg.kg bw-1 established for this compound and, therefore, represent a potential concern.

Ideal sweetness of mixed juices from Amazon fruits

Ready-to-drink fruit juices represent a large share of the market and are an important target for product development. The mixture of fruits can bring about improvements to nutritional and sensory aspects of these beverages while making used of the wide variety of exotic fruits from the Amazon region. Therefore, it is necessary to select mixed fruits and determine their ideal sweetness according to consumer acceptance. Consumers in the city of Belém (Brazil) evaluated five different concentrations of sugar using the just-about-right scale in two blends selected by preference ranking. For the cupuassu-acerola-açai blend, the optimum concentration of sugar was 9.5 g/100 mL, and for the soursop-camucamu-yellow mombin blend, it was 10.7 g/100 mL.

Application of fats in some food products

Fats and oils are very important raw materials and functional ingredients for several food products such as confectionery, bakery, ice creams, emulsions, and sauces, shortenings, margarines, and other specially tailored products. Formulated products are made with just about every part of chemistry, but they are not simple chemicals. In general, they consist of several, and often many, components. Each of these components has a purpose. Most formulated products have a micro- or nano-structure that is important for their function, but obtaining this structure is often the big challenge. Due to a rise in overweight or obesity, health concerns have increased. This fact has led to the need to the develop products with low fat content, which have become a market trend. In addition, the development of new products using fat substitutes can be a good option for companies that are always trying to reduce costs or substitute trans fat or saturated fat. However, the successful development of these products is still a challenge because fat plays multiple roles in determining the desirable physicochemical and sensory attributes, and because the consumers who want or need to replace these ingredients, seek products with similar characteristics to those of the original product. Important attributes such as smooth, creamy and rich texture; milky and creamy appearance; desirable flavor; and satiating effects are influenced by the droplets of fat, and these characteristics are paramount to the consumer and consequently crucial to the success of the product in the market. Therefore, it is important to identify commercially viable strategies that are capable of removing or reducing fat content of food products without altering their sensory and nutritional characteristics. This paper intended to provide an overview about the role of fat in different food systems such as chocolate, ice cream, bakery products like biscuits, breads, and cakes considering the major trends of the food industry to meet the demands of modern society.