Crystal structure of a Pr-III complex with a novel macrocyclic ligand

The crystal structure of a novel macrocyclic ligand complex of Pr-III, C112H178O52N8S4Pr2, [Pr2L2(HL)(2)(H2O)(6)]. 22H(2)O is reported. The macrocyclic ligand has pendant acetic acid through which the ligand is coordinated to the Pr-III ion. For the dimeric unit, [Pr2L2(HL)(2)(H2O)(6)], two Pr-III ions are connected by two bridging-chelating carboxyl groups and two bridging carboxyl groups of the ligands, and each Pr-III ion is also bonded to a unidentate carboxyl group of the ligand and three water molecules. The dimeric units are bridged by four ligands through their carboxyl groups to form an infinite one-dimensional chain. The coordination number of the Pr-III ion is nine, with a distorted tricapped trigonal prismatic configuration. (C) 1997 Elsevier Science Ltd.

Studies on synergistic extraction of rare earths(III) with HBTMPTP and primary amine N1923

The synergistic extraction of rare earths(III) with binary systems containing HBTMPTP and primary amine N1923 from sulfuric acid medium was observed, The syner gistic extraction factor(R) decreased with increasing atomic number of lanthanides. Through the methods of slope analysis, constant mole and saturation titration, the synergistic extraction stoichiometry was obtained, The thermodynamic function was calculated, The IR spectra of the saturated synergistic extraction completely confirmed the mechanism.

The phase transitions of hetero atoms substituted molecular sieves Me-VPI-5(Me=Mg, Ti, Sn, Si) and their influence on spectra structures of Eu(III) ion

The hetero atom substituted aluminophosphate molecular sieves Me-VPI-5(Me = Mgt Ti, Sn, Si) were synthesized hydrothermally. Rare earth ions are originally doped into these microporous materials by aqueous solution ion exchange procedures. The phase transitions of the microporous materials are investigated by high-temperature and high-pressure experimental techniques. The influence of the phase transitions on the rare earth ions' spectral structures is discussed, With the increase of temperature, Eu(II)Mg-VPI-5 is converted into Eu(II)Mg-AIPO(4)-8, then into tridymite phase. The pressure has a notable influence on Eu(II) ion's spectral structures. The spectral structures have changed regularly with the increase of pressure.

Influence of crystal structure on the luminescence properties of bismuth(III), europium(III) and dysprosium(III) in Y2SiO5

The luminescence properties of Bi3+, EU(3+), Dy3+ and energy transfer from Bi3+ to Dy3+ and EU(3+) have been studied in two modifications of Y2SiO5 (low-temperature X(1) type and high-temperature X(2) type) and discussed in relation to their crystal structures. The Bi3+ ion luminesces in the blue region of the spectrum in X(1)-Y2SiO5 but in the UV region in X(2)-Y2SiO5. Two obviously different luminescent centres have been observed for Bi3+ and Eu3+ ill X(1)-Y2SiO5, but only one has been seen in X(2)-Y2SiO5. The Stokes shift (9200 cm(-1)) for Bi3+ in X(1)-Y2SiO5 is much larger than that (5000 cm(-1)) in X(2)-Y2SiO5. This suggests that the host lattice is more rigid in X(2)-Y2SiO5 than in X(1)-Y2SiO5. As a result, the Bi3+, EU(3+) and Dy3+ ions show higher emission intensity in the former than in the latter type. X(1)-Y2SiO5 is more suitable for Bi3+ --> EU(3+) energy transfer and X(2)-Y2SiO5 is more suitable for Bi3+ --> Dy3+ energy transfer.

Studies on organolanthanide complexes .58. Syntheses of 1,1'-(3-oxa-pentamethylene)dicyclopentadienyl divalent organolanthanides (Ln=Sm, Yb) and X-ray molecular structure of O(CH2CH2C5H4)(2)Yb(DME)

The compounds O(CH2CH2C5H4)(2)Ln(THF)(2) [Ln = Sm(1), Yb(2)] were synthesized by the reduction of O(CH2CH2C5H4)(2)LnCl with sodium metal in tetrahydrofuran (THF) at room temperature. Recrystallization of 2 from dimethoxyethane (DME) produced the single-crystal O(CH2CH2C5H4)(2)Yb(DME) (3) whose structure has been determined by an X-ray diffraction study. The crystals are orthorhombic, space group Pcab, with a = 14.168(4), b = 13.541(6), c = 19.314(8) Angstrom, Z = 8, D-calc. = 1.66 g cm(-3).

Kinetics of electrocatalytic ascorbic acid at ultramicroelectrode modified by Eastman-AQ polymer containing tris(2,2-'-bipyridine) osmium(III/II) complexes as electron-transfer centers

The theoretical model[17] of an ultramicroelectrode modified with a redox species film is used as the diagnostic tool to characterize the catalytic oxidation of ascorbic acid at carbon fiber ultramicrodisk electrodes coated with an Eastman-AQ-Os(bpy)(3)(2+) film. The electrocatalytic behavior of ascorbic acid at the ultramicroelectrode modified by an Eastman-AQ polymer containing tris(2,2'-bipyridine) osmium(III/II) as mediators is described. In order to determine the five characteristic currents quantitatively, the radius of the ultramicroelectrode and the concentration of ascorbic acid are varied systematically. The kinetic zone diagram has been used to study the electrocatalytic system. This system with 0.5-2.75 mM ascorbic acid belongs to SR + E case, and the concentration profiles of the catalyst in the film are given in detail. Finally, optimizing the design of catalytic system is discussed.

TETRAKIS(MU-DL-ALANINE-O-O')OCTA-AGUADIERBIUM(III) HEXAPERCHLORATE

The structure of the title compound, [Er-2(C3H7NO2)(4)- (H2O)(8)](ClO4)(6), consists of dimeric [Er-2(DL-alanine)(4)-(H2O)(8)](6+) cations and perchlorate anions. The four alanine molecules act as bridging ligands linking two Er3+ ions through their carboxyl O atoms. Each Er3+ ion is also coordinated by four water molecules to complete eightfold coordination in a square antiprism fashion. The perchlorate anions and the methyl groups of the alanine ligands are disordered.

STUDIES ON THE COORDINATION OF TB(III) AND CA(III) WITH AMINO-ACID UNDER THE PHYSIOLOGICAL CONDITION

Tb(Ca)-glycine, Tb(Ca)-alanine, Tb(Ca)-glycine-alanine systems were studied by potentiometry (37%, I = 0.15 mol/L NaCl). The stability constants of complexes and distribution of species in ternary system were obtained. The results show CaTb for the ternary complexes. The species convert each other with changing pH values.

KINETIC-STUDY OF ELECTROCATALYTIC REDUCTION OF HYDROGEN-PEROXIDE AT IRON(III) PORPHYRIN MODIFIED GLASSY-CARBON ELECTRODE IN ALKALINE-MEDIUM USING THE ROTATION-SCAN METHOD

Reduction of hydrogen peroxide at a glassy carbon (GC) electrode modified with sigma-bonded pyrrole iron(III) octaethylporphyrin complex, (OEP)Fe(Pyr), was studied by cyclic voltammetry and a rotating disk electrode. In 0.1N NaOH solution, it is shown that such an (OEP)Fe(Pyr)/GC electrode has a significant catalytic activity towards hydrogen peroxide reduction (E(D) = -0.80 V, k = 0.066 cm s(-1)); however, the electrode stability is low. The deactivation is observed when the reaction charge (Q) is passing through the (OEP)Fe(Pyr)/GC disk electrode. A linear rotation scan method is applied to study the kinetic process by determining the disk electrochemical response (i(D)) to rotation rate (omega) at a definite disk potential (E(D)). Considering that the number of adsorbed electroreduced catalyst molecules (Red) varies according to the disk potential, a factor theta(= Gamma(Red)/(Gamma(Red) + Gamma(Ox))) is introduced to describe the electrode surface area fraction for electroreduced species. The obtained Koutecky-Levich equation is applicable whatever the potential is.

IN-SITU SCANNING-TUNNELING-MICROSCOPY IMAGE OF A HIGHLY ORIENTED PYROLYTIC-GRAPHITE ELECTRODE MODIFIED WITH POTASSIUM BIS(11-MOLYBDOSILICATO) DYSPROSATE(III) IN SODIUM-SULFATE SOLUTION

The variation in molecule adsorption mode on pretreated highly oriented pyrolytic graphite electrodes, modified with the title complex K10H3[Dy(SiMo11O39)(2)] by cyclic voltammetry in the title complex solution, was observed in situ by electrochemical scanning tunnelling microscopy (ECSTM) with molecular resolution in sodium sulphate solution. According to the ECSTM images and the known molecular structure we conclude that the adsorption mode of the title complex modified electrode changed during potential cycling from ''vertical'' to ''inclined'' and then ''horizontal'' or ''flat'' mode, i.e. the title complex adsorbed on the surface of electrode by one ligand of the complex at first, then began to incline and was finally adsorbed by two ligands of the complex. This result indicates that the adsorption mode on the modified electrode surface changed during potential cycling in the sulphate solution and a much more stable molecular layer was formed. The change in adlattice of adsorbates on the modified electrode surface from hexagonal to rectangular was also observed by ECSTM. A plausible model was given to explain this process.

COMPARATIVE-STUDIES ON PERIODATOCUPRATE(II, III) AND TELLURATOCUPRATE(II, III)

The crystal structures, electronic spectra, and Cu2p XPS of Cu(III) complexes Na4H[Cu(H2TeO6)(2)]. 17H(2)O and Na4K[Cu(HlO(6))(2)]. 12H(2)O have been described. The characterizations of a Cu(III) atom in a complex are as follows: (i) In a square-planar coordination, the average bond length of Cu-O is 0.183 nm, shorter than the 0.190-0.200 nm found for a Cu(II) complex. (2) The ''blue shift'' occurs for d-d transitions in the electronic spectrum of the Cu(III) complex compared to those of its related Cu(II) complex, resulting from the higher valence state. (3) Cu(III) compounds with CuO4 square-planar coordination are expected to be diamagnetic whereas Cu(II) compounds to be paramagnetic. (4) Comprehensive investigations on Cu2p XPS show that the binding energy of Cu2p(3/2) of a pure Cu(III) compound is about 2.0 eV higher than that of its corresponding Cu(II) compound: the shake-up satellites do not appear in the Cu2p XPS for a pure diamagnetic Cu(III) compound, the same as found for a diamagnetic Ni(II) compound: the FWHM of the signal of Cu2p XPS may become broader for Cu(III) compound because its core hole's lifetime shortens due to the higher valence state of copper. (C) 1995 Academic Press, Inc.

SOLVENT-EXTRACTION OF SC(III), ZR(IV), TH(IV), FE(III), AND LU(III) WITH THIOSUBSTITUTED ORGANOPHOSPHINIC ACID EXTRACTANTS

The solvent extraction of Sc(III), Zr(IV), Th(IV), Fe(III) and Lu(III) with Cyanex 302 (bis(2,4,4-trimethylpentyl)monothiophosphinic acid) and Cyanex 301 ( bis(2,4,4-trimethylpentyl) dithiophosphinic acid) in n-hexane from acidic aqueous solutions has been investigated systematically. The effect of equilibrium aqueous acidity on the extraction with these reagents was studied. The separation of Th(IV), Fe(III) and Lu(III) from Sc(III), or the separation of other metals from Lu(III) with Cyanex 302, can be achieved by controlling the aqueous acidity. However, Cyanex 301 exhibited a poor selectivity for the above metals, except for Lu(III). The extraction of these metals with Cyanex 272, Cyanex 302 and Cyanex 301 has been compared. The stripping percentages of Sc(III) for Cyanex 302 and Cyanex 301 in a single stage are near 78% and 75% with 3.5 mol/L and 5.8 mol/L sulphuric acid solutions, respectively. The effects of extractant concentration and temperature on the extraction of Sc(III) were investigated. The stoichiometry of the extraction of Sc(III) with Cyanex 302 was determined. The role of different components of Cyanex 302 in the extraction of Sc(III) was discussed.

SOLVENT-EXTRACTION OF TERBIUM(III,IV) PERIODATE COMPLEXES WITH QUATERNARY AMINE

The differences between the solvent extraction of Tb(III) and Tb(IV) periodate complexes with quaternary amine were studied carefully for the first time. The effects of extractant concentration, phase ratio, the pH value of stock solution, salting-out agent, extractant form, diluent, and extraction time were comprehensively investigated. Under optimal conditions the separation factor between Tb(IV) and Tb(III) periodate complexes is over 5.5.