Silicate content in sediment ofthe Santa Monica Basin, California

Seafloor recycling of organic materials in Santa Monica Basin, California was examined through in situ benthic chamber experiments, shipboard whole-core incubations and pore water studies. Mass balance calculations indicate that the data are internally consistent and that the estimated benthic exchange rates compare well with those derived from deep, moored conical sediment traps and hydrographic modeling. Pore water and benthic flux observations indicate that the metabolizable organic matter at the seafloor must be composed of at least two fractions of very different reactivities. While the majority of reactive organic compounds degrade quickly, with a half-life of <=6.5 years, 1/4 of the total metabolizable organic matter appears to react more slowly, with a half-life on the order of 1700 years. Down-core changes in pore water sulfate and titration alkalinity are not explained by stoichiometric models of organic matter diagenesis and suggest that reactions not considered previously must be influencing the pore water concentrations. Measured recycling and burial rates indicate that 43% of the organic carbon reaching the basin seafloor is permanently buried. The results for Santa Monica Basin are compared to those reported for other California Borderland Basins that differ in sedimentation rate and bottom water oxygen content. Organic carbon burial rates for the Borderland Basins are strongly correlated with total organic carbon deposition rate and bulk sedimentation rate. No significant correlation is observed between carbon burial and bottom water oxygen, extent of oxic mineralization and sediment mixing. Thus, for the California Borderlands, it appears that carbon burial rates are primarily controlled by input rates and not by variations in preservation.

Interstitial water chemistry, Deep Sea Drilling Project, Leg 96

On Leg 96 of the Deep Sea Drilling Project (DSDP), holes were drilled in Orca and Pigmy basins on the northern Gulf of Mexico continental slope and on the Mississippi Fan. The holes on the fan encountered interbedded sand, silt, and mud deposited extremely rapidly, most during late Wisconsin glacial time. Pore-water chemistry in these holes is variable, but does not follow lithologic changes in any simple way. Both Ca and SO4 are enriched in the pore water of many samples from the fan. Two sites drilled in the prominent central channel of the middle fan show rapid SO4 reduction with depth, whereas two nearby sites in overbank deposits show no sulfate reduction for 300 m. Calcium concentration decreases as SO4 is depleted and Li follows the same pattern. Strontium, which like Li, is enriched in samples enriched in Ca, does not decrease with SO4 and Ca. Potassium in the pore water decreases with depth at almost all sites. Sulfate reduction was active at the two basin sites and, as on the fan, this resulted in calcium carbonate precipitation and a lowering of pore water Ca, Mg, and Li. The Orca Basin site was drilled through a brine pool of 258? salinity. Pore-water salinity decreases smoothly with depth to 50 m and remains well above normal seawater values to the bottom of the hole at about 90 m. This suggests constant sedimentation under anoxic hypersaline conditions for at least the last 50,000 yr.

Silicate in marine sediments from the Emerland Basin, North Atlantic

A method was developed to measure porosity and dissolved interstitial silicate at millimeter intervals or less in a sediment core. In cores from Emerald Basin (Scotian Shelf), interstitial concentrations near the sediment surface did not drop rapidly to bottom-water concentrations as measured in bottle casts (28 µM) but remained as high as 166 µM in the upper 0.5 mm of sediment High rates of benthic silicate release were measured which could not be accounted for by interstitial concentration gradients or by ventilation of macro-invertebrate burrows. The silicate discontinuity observed between the sediments and water column suggests that a diffusive sublayer exists in a zone of viscous flow above the sediment surface. This is possible only if a surface reaction is primarily responsible for silicate release. By assuming a linear concentration gradient across this diffusive sublayer, the silicate release rates were used to estimate the thickness of the sublayer to be about 2 mm.