Active Voltage Control on series connection of IGBTs and diode recovery optimization

In this paper an Active Voltage Control (AVC) technique is presented, for series connection of insulated-gate-bipolar-transistors (IGBT) and control of diode recovery. The AVC technique can control the switching trajectory of an IGBT according to a pre-set reference signal. In series connections, every series connected IGBT follows the reference and so that the dynamic voltage sharing is achieved. Another key advantage for AVC is that by changing the reference signal at turn-on, the diode recovery can be optimised. © 2010 IEEE.

Soft turn-on of NPT IGBT under Active Voltage Control

In this paper the soft turn-on of NPT IGBT under Active Voltage Control (AVC) is presented. The AVC technique is able to control the IGBT switching trajectory according to a pre-defined reference signal generated by a FPGA chip. By applying a special designed reference signal at turn-on, the IGBT turn-on current overshoot and diode recovery can be optimized. Experiments of soft turn-on with different reference signal are presented in this paper. This technique can be used to reduce the switching stress on the device and on other components of the circuit. © 2011 IEEE.

Numerical analysis of the current and voltage sharing issues for resistive fault current limiter using YBCO coated conductors

YBaCuO-coated conductors offer great potential in terms of performance and cost-saving for superconducting fault current limiter (SFCL). A resistive SFCL based on coated conductors can be made from several tapes connected in parallel or in series. Ideally, the current and voltage are shared uniformly by the tapes when quench occurs. However, due to the non-uniformity of property of the tapes and the relative positions of the tapes, the currents and the voltages of the tapes are different. In this paper, a numerical model is developed to investigate the current and voltage sharing problem for the resistive SFCL. This model is able to simulate the dynamic response of YBCO tapes in normal and quench conditions. Firstly, four tapes with different Jc 's and n values in E-J power law are connected in parallel to carry the fault current. The model demonstrates how the currents are distributed among the four tapes. These four tapes are then connected in series to withstand the line voltage. In this case, the model investigates the voltage sharing between the tapes. Several factors that would affect the process of quenches are discussed including the field dependency of Jc, the magnetic coupling between the tapes and the relative positions of the tapes. © 2010 IEEE.

Voltage programmable dual-band bandpass/bandstop filter response in a single micro-electro-mechanical device

This paper reports on a switchable multi-band filter response achieved within a single micro-electro-mechanical device. A prototype device fabricated in a SOI process demonstrates a voltage programmable and tunable, dual-band, band-pass/band-stop response. Both analytical and finite element models are introduced in this paper to elucidate the operating principle of the filter and to guide filter design. Voltage programmability of the filter characteristic is demonstrated with the ability to independently tune the centre frequency and bandwidth for each band. A representative measurement shows that the minimum 3 dB-bandwidth (BW) is 155 Hz, 140Hz, and 20 dB-BW is 216 Hz, 203Hz for the upper-band and lower-band center frequencies located at 131.5 kHz and 130.7 kHz, respectively. © 2011 IEEE.

Angular dependence of domain wall resistivity in artificial magnetic domain structures.

We exploit the ability to precisely control the magnetic domain structure of perpendicularly magnetized Pt/Co/Pt trilayers to fabricate artificial domain wall arrays and study their transport properties. The scaling behavior of this model system confirms the intrinsic domain wall origin of the magnetoresistance, and systematic studies using domains patterned at various angles to the current flow are excellently described by an angular-dependent resistivity tensor containing perpendicular and parallel domain wall resistivities. We find that the latter are fully consistent with Levy-Zhang theory, which allows us to estimate the ratio of minority to majority spin carrier resistivities, rho downward arrow/rho upward arrow approximately 5.5, in good agreement with thin film band structure calculations.

EEG activities in the orbitofrontal cortex and dorsolateral prefrontal cortex during the development of morphine dependence, tolerance and withdrawal in rhesus monkeys

Investigating the activities of the prefrontal cortex (PFC) in the process of addiction is valuable for understanding the neural mechanism underlying the impairments of the PFC after drug abuse. However, limited data are obtained from primate animals and few studies analyze Electroencephalogram (EEG) in the gamma band, which plays an important role in cognitive functions. In addition, it is yet unclear whether drug abuse affects the orbitofrontal cortex (OFC) and dorsolateral PFC (DLPFC) - the two most important subregions of the PFC - in similar ways or not. The aim of this study is to address these issues. We recorded EEG in the OFC and DLPFC in three rhesus monkeys. All animals received a course of saline (NaCl 0.9%, 2 ml) injection (5 days) followed by 10 days of morphine injection (every 12 h), and then a further series of saline injection (7 days). A main finding in the present study was that morphine decreased EEG power in all frequency bands in a short period after injection in both the OFC and DLPFC in monkeys. And gamma power decreased not just in short period after morphine injection but lasted to 12 h after injection. Moreover, we found that although the changes in EEG activities in the OFC and DLPFC at 30-35 min after injection were similar, the DLPFC was more sensitive to the effect of morphine than the OFC. (c) 2005 Elsevier B.V. All rights reserved.

The dynamics of hippocampal sensory gating during the development of morphine dependence and withdrawal in rats

The effects of morphine on hippocampal sensory gating (N40) during the development of morphine dependence and withdrawal were investigated in the double click auditory evoked potential (EP) suppression paradigm. Rats were made dependent upon morphine hydrochloride by a series of injections (every 12h) over 6 days, followed by withdrawal after stopping morphine administration. Hippocampal gating was examined during the development of dependence and withdrawal. Moreover, the DA antagonist haloperidol was used to assess the contribution of dopamine to hippocampal gating induced by morphine. Our results showed that the morphine-treated rats exhibited significantly disrupted hippocampal gating during the development of morphine dependence and this disrupted gating was partially reversed by haloperidol pretreatment. In contrast, there was significantly enhanced hippocampal gating at the fifth and sixth days of withdrawal. The dynamics of hippocampal gating during the development of morphine dependence and withdrawal suggests the interaction between the hippocampus and opioids. (c) 2005 Elsevier Ireland Ltd. All rights reserved.

Frontal and cingulate gray matter volume reduction in heroin dependence: Optimized voxel-based morphometry

Aims: Repeated exposure to heroin, a typical opiate, causes neuronal adaptation and may result in anatomical changes in specific brain regions, particularly the frontal and limbic cortices. The volume changes of gray matter (GM) of these brain regions, ho

Photo-assisted hydrosilylation of silicon nanoparticles: Dependence of particle size on grafting chemistry

Silicon nanoparticles between 2.5 nm and 30 nm in diameter were functionalized by means of photoassisted hydrosilylation reactions in the aerosol phase with terminal alkenes of varying chain length. Using infrared spectroscopy and nuclear magnetic resonance, the chemical composition of the alkyl layer was determined for each combination of particle size and alkyl chain length. The spectroscopic techniques were used to determine that smaller particles functionalized with short chains in the aerosol phase tend to attach to the interior (β) alkenyl carbon atom, whereas particles >10 nm in diameter exhibit attachment primarily with the exterior (α) alkenyl carbon atom, regardless of chain length. © 2011 American Chemical Society.