Alternative saline solutions to float foraminiferal tests

Flotation has been widely used in studies of recent foraminifera in order to concentrate tests and save time during picking. In this paper, four flotation agents with different densities were compared: (1) trichloroethylene, TCE (C2HCl3), with a density of 1.46 g mL(-1); (2) sodium nitrate/sodium thiosulfate solution, SNT (NaNO3 + Na2O3S2 center dot 5H(2)O), with a density of 1.46 g mL(-1); (3) zinc chloride Solution, ZC (ZHCl(2)), with a density of 1.70 g mL(-1); and (4) sodium polytungstate solution, SPT (3Na(2)WO(4) center dot 9WO(3) center dot 5H(2)O), with a density of 2.50 g mL(-1). Comparison was carried out by means of qualitative and quantitative data. Results showed that ZC and SPT were the best flotation agents, recovering 91% and 96% of the total tests, respectively, whereas TCE and SNT recovered 59.1% and 72.8%, respectively. Both quantitative and qualitative results significantly improved with a higher density of the flotation liquid. Therefore, substitution of TCE with ZC or SPT solutions is strongly encouraged, because they are, additionally, less harmful to health and the environment. ZC is the most cost-effective, since its results were not significantly different from those of the SPT treatment. Carbon tetrachloride (CCl4) was not considered in this comparative study, because it has been banned in many countries and it is highly harmful to health and the environment.

Dilatometer tests in a Leda clay crust

The dilatometer test results have been lately applied in foundation design for prediction of settlement and bearing capacity problems. The equipment, its calibration, test procedures and test data interpretation are simple. These advantages seem to explain the increasing use of the dilatometer (DMT) test as a routine technique for subsoil investigation. The DMT test boreholes were carried out on the grounds of the National Research Council (NRC) in Ottawa. Several test results based on laboratory, and other in situ tests available in the literature for the Leda clay deposit in Ottawa area were used to provide correlations between geotechnical properties and soil index parameters as proposed by Marchetti (1980). More appropriated relationships, even though preliminaries, are presented for the crust layer.

Assessment of anaerobic power of swimmers: the correlation of laboratory tests on an arm ergometer with field tests in a swimming fool

The aim of this study was to verify the correlation between the Wingate arm crank test outputs (peak power, mean power, and fatigue index), obtained on a specific ergometer, and the performance in crawl stroke swim sprints of 14, 25, 50, and 400 m. The experiment was conducted with 9 healthy male volunteers (18.1 +/- 2.2 years of age; 172 +/- 0.04 cm; 67.7 +/- 5.92 kg and 15.7 +/- 4.57% body fat). on determined days, all individuals were submitted to the Wingate arm crank test and crawl freestyle sprints of 14, 25, 50, and 400 m as they were timed with a stopwatch. The peak power, the mean power, and the fatigue index, which were obtained during the Wingate arm crank test, were not significantly correlated with the maximum swim velocities during the crawl free-style tests of 14 (r = 0.40; r = 0.64; r = 0.11), 25 (r = 0.28; r = 0.39; r = -0.27), 50 (r = 0.03; r = 0.09; r = -0.31), and 400 (r = -0.52; r = -0.37; r = -0.65) m respectively. Thus, it is possible to conclude that the Wingate arm crank test is not suitable to assess the anaerobic power of swimmers under the described experimental conditions.

Skin hypersensitivity tests in buffaloes parasitized with Toxocara vitulorum.

Skin tests were done using larval extract and excretory-secretory (ES) antigens injected intradermally in the neck area of 30, 11- to 200-day-old buffalo calves and nine 27- to 100-day postparturition buffalo cows, the skin of the buffaloes infected with Toxocara vitulorum, mainly calves, demonstrated a hypersensitive response to antigens, especially to the larval extract antigens. Skin hypersensitivity responses were characterized by the presence of dermal nodules with progressive induration and an increase of up to four times the size of the original area at 30 min (immediate type) and at 72 h (delayed type) after injection, Histological preparations of skin reactions at 72 h showed a typical mononuclear cell infiltration, with eosinophils and perivascular cuffing in most of the animals, Fecal examination of 75 animals showed that 65 (86.7%) buffalo calves (9-115 days old) were parasitized with T. vitulorum. The peak of egg output from these animals occurred when they were approximately 45 days old.

EFFECT OF DROUGHT AND DEFOLIATION STRESS IN THE FIELD ON SOYBEAN SEED-GERMINATION AND VIGOR

Although drought and defoliation stress have been shown to reduce soybean [Glycine max (L.). Merr.] yield, little information has been published regarding their effects on soybean seed quality. Field experiments were conducted in 1986, 1987, and 1989 to evaluate the effect of drought and defoliation (1989 only) stress during soybean seed development on seed germination and vigor. Essex (MG [maturity group] V) and Union (MG III) were grown in 1986 and 1987, and Harper (MG III) and McCall (MG 00) in 1989. Moisture treatments were either well watered or drought stressed during seed development (R5 to R7). In 1989, a total defoliation treatment was also imposed at R6 as an additional stress factor. There were significant reductions in yield and yield components following drought stress in all 3 yr and following defoliation in 1989. Leaf conductance and transpiration also decreased in the drought stress treatments. There was no effect of drought stress on seed germination or seed vigor as measured by accelerated aging germination and the cold test across the four cultivars (determinate and indeterminate) and 3 yr. In 1989 slight changes in 3-d germination and conductivity occurred for some drought stress treatments. Most of this response, however, was related to increased occurrence of hard seed, which does not represent an indication of a change in vigor. Seed germination and vigor were significantly reduced for small, flat, shriveled, and underdeveloped seeds that only occurred following defoliation. These seeds represented a small portion of the seed lot that would normally be removed during conditioning. The data suggest that drought stress would have no effect on seed germination or vigor, unless the stress was severe enough to produce shriveled, flat, underdeveloped seeds.

Evaluation of serological tests for the diagnosis of Neospora caninum infection in dogs: Optimization of cut off titers and inhibition studies of cross-reactivity with Toxoplasma gondii

Diagnosis of Neospora caninum infection in dogs is based on serological assays such as the indirect fluorescent antibody test (IFAT) and enzyme-linked immunosorbent assays (ELISA). This study evaluated two serological tests (IFAT and ELISA) for the detection of IgG antibodies to N. caninum in 300 serum samples of dogs through the optimization of cut off titers by using the two-graph receiveroperating characteristic (TG-ROC) curve. In addition, the identification of major cross-reactive antigens with Toxoplasma gondii was investigated by inhibition ELISA and immunoblotting (IB) assays. IFAT and ELISA results showed 74% agreement, with a good negative concordance (P-neg=0.83), but a poor positive concordance (P-pos=0.42). The great majority (86%) of sera with positive concordant results (IFAT+/ELISA+) recognized at least two out of three N. caninum immunodominant antigens, particularly the 29-32 and 35-37 kDa bands. Optimization of cut off titers in IFAT and ELISA was performed considering the reactivity to at least two out of three N. caninum immunodominant antigens as infection markers, obtaining a titer of 50 for IFAT and 200 for ELISA. Seropositivity to N. caninuin was significantly associated with T gondii-seropositive samples, particularly in ELISA (55.4%). Inhibition ELISA curves for N. caninum showed a partial heterologous inhibition, indicating some degree of cross-reactivity between N. caninum and T gondii antigens. Inhibition IB assays showed a moderate heterologous inhibition for N. caninum antigens above 45-50 kDa. These results indicate that ELISA should be used critically when crude tachyzoite antigen preparations are employed, due to possible cross-reactivity with other related parasites as T gondii. Also, the cut off dilution of 1:50 in IFAT showed to be the most appropriated for N. caninum serology in dogs. Therefore, we suggest that N. caninum immunodominant antigens, specially the 17 and 29-32 kDa proteins, should be selected markers in serological assays for canine neosporosis. (c) 2006 Elsevier B.V. All rights reserved.

Energy efficiency for standard penetration tests

The need for standardization of the measured blow count number N-spt into a normalized reference energy value is now fully recognized. The present paper extends the existing theoretical approach using the wave propagation theory as framework and introduces an analysis for large displacements enabling the influence of rod length in the measured N-spt values to be quantified. The study is based on both calibration chamber and field tests. Energy measurements are monitored in two different positions: below the anvil and above the sampler. Both experimental and numerical results demonstrate that whereas the energy delivered into the rod stem is expressed as a ratio of the theoretical free-fall energy of the hammer, the effective sampler energy is a function of the hammer height of fall, sampler permanent penetration, and weight of both hammer and rods. Influence of rod length is twofold and produces opposite effects: wave energy losses increase with increasing rod length and in a long rod composition the gain in potential energy from rod weight is significant and may partially compensate measured energy losses. Based on this revised approach, an analytical solution is proposed to calculate the energy delivered to the sampler and efficiency coefficients are suggested to account for energy losses during the energy transference process.

Efeitos dos danos mecânicos e fisiológicos na colheita e beneficiamento de sementes de soja

The objective of this study was to evaluate the effect of mechanical damage and physiological events in harvesting and processing of soybean cv. Mosoy RR 8000. The samples were taken during harvest manual, mechanical harvesting and during processing (receipt, pre-cleaning, cleaning, spiral separator, classification and gravity table). The physiological and physical quality was analized through the purity, germination, vigor (first germination count, seedling dry matter, accelerated aging, electrical conductivity, tetrazolium, mechanical damages and seedling field emergence) tests. The statistical design used was a entirely randomized with nine treatments (9 sampling points) with 4 replications, being the means compared by the Tuckey test at 5% probability. In the purity and seedling field emergence were observed highly significative difference between the sampling process, also this differences were obtained the first germination count, seedling dry weight matter, accelerated aging and electrical conductivity which showed smaller results for the mechanical harvesting when compared with the manual harvesting. The germination was obtained differences at 5% for the manual harvesting in relation to the mechanical harvesting were obtained smaller results, being the main cause of reducing the soybean seed quality, when compared with the manual harvesting.

Orthodontic brackets removal under shear and tensile bond strength resistance tests - a comparative test between light sources

We have investigated if a new LEDs system has enough efficient energy to promote efficient shear and tensile bonding strength resistance under standardized tests. LEDs 470 +/- 10 nm can be used to photocure composite during bracket fixation. Advantages considering resistance to tensile and shear bonding strength when these systems were used are necessary to justify their clinical use. Forty eight human extracted premolars teeth and two light sources were selected, one halogen lamp and a LEDs system. Brackets for premolar were bonded through composite resin. Samples were submitted to standardized tests. A comparison between used sources under shear bonding strength test, obtained similar results; however, tensile bonding test showed distinct results: a statistical difference at a level of 1% between exposure times (40 and 60 seconds) and even to an interaction between light source and exposure time. The best result was obtained with halogen lamp use by 60 seconds, even during re-bonding; however LEDs system can be used for bonding and re-bonding brackets if power density could be increased.