Two-magnon bound state causes ultrafast thermally induced magnetisation switching

There has been much interest recently in the discovery of thermally induced magnetisation switching using femtosecond laser excitation, where a ferrimagnetic system can be switched deterministically without an applied magnetic field. Experimental results suggest that the reversal occurs due to intrinsic material properties, but so far the microscopic mechanism responsible for reversal has not been identified. Using computational and analytic methods we show that the switching is caused by the excitation of two-magnon bound states, the properties of which are dependent on material factors. This discovery allows us to accurately predict the onset of switching and the identification of this mechanism will allow new classes of materials to be identified or designed for memory devices in the THz regime.

Permutationally invariant state reconstruction

Feasible tomography schemes for large particle numbers must possess, besides an appropriate data acquisition protocol, an efficient way to reconstruct the density operator from the observed finite data set. Since state reconstruction typically requires the solution of a nonlinear large-scale optimization problem, this is a major challenge in the design of scalable tomography schemes. Here we present an efficient state reconstruction scheme for permutationally invariant quantum state tomography. It works for all common state-of-the-art reconstruction principles, including, in particular, maximum likelihood and least squares methods, which are the preferred choices in today's experiments. This high efficiency is achieved by greatly reducing the dimensionality of the problem employing a particular representation of permutationally invariant states known from spin coupling combined with convex optimization, which has clear advantages regarding speed, control and accuracy in comparison to commonly employed numerical routines. First prototype implementations easily allow reconstruction of a state of 20 qubits in a few minutes on a standard computer

Fault-tolerant almost exact state transmission

We show that a category of one-dimensional XY-type models may enable high-fidelity quantum state transmissions, regardless of details of coupling configurations. This observation leads to a fault-tolerant design of a state transmission setup. The setup is fault-tolerant, with specified thresholds, against engineering failures of coupling configurations, fabrication imperfections or defects, and even time-dependent noises. We propose an experimental implementation of the fault-tolerant scheme using hard-core bosons in one-dimensional optical lattices.

Effects of beach remourishment on the benthic macrofauna and the fishes of the nearshore zone at Sebastian Inlet State Recreation Area

Approximately 100,000 cubic yards of sand was transported to the ocean beach to renourish the eroded beach front during the period December 1985 through May 1986. The ocean beach at Sebastian Inlet SRA was previously studied in a project examining the benthic macrofauna and the fishes of the nearshore zone during 1981-1982 (Allenbaugh, 1984; Peters, 1984; Nelson, unpublished). In view of the existing data, the US Army Corps of Engineers provided funding to study the effects of the beach renourishment activities at Sebastian Inlet SRA on the benthic macrofauna and the fishes of the nearshore zone. This is the report on the results of this study.

State of Technology for In Situ Measures of Salinity Using Conductive Temperature Sensors, Savannah, Georgia, December 3-5, 2007: workshop proceedings

This Alliance for Coastal Technologies (ACT) workshop was convened to assess the availability and state of development of conductivity-temperature sensors that can meet the needs of coastal monitoring and management communities. Rased on the discussion, there are presently a number of commercial sensor options available, with a wide range of package configurations suitable for deployment in a range of coastal environments. However, some of the central questions posed in the workshop planning documents were left somewhat unresolved. The workshop description emphasized coastal management requirements and, in particular, whether less expensive, easily deployed, lower-resolution instruments might serve many management needs. While several participants expressed interest in this class of conductivity-temperature sensors, based on input from the manufacturers, it is not clear that simply relaxing the present level of resolution of existing instruments will result in instruments of significantly lower unit cost. Conductivity-temperature sensors are available near or under the $1,000 unit cost that was operationally defined at the workshop as a breakpoint for what might be considered to be a "low cost" sensor. For the manufacturers, a key consideration before undertaking the effort to develop lower cost sensors is whether there will be a significant market. In terms of defining "low cost," it was also emphasized that the "life cycle costs" for a given instrument must be considered (e.g., including personnel costs for deployment and maintenance). An adequate market survey to demonstrate likely applications and a viable market for lower cost sensors is needed. Another topic for the workshop was the introduction to the proposed ACT verification for conductivity-temperature sensors. Following a summary of the process as envisioned by ACT, initial feedback was solicited. Protocol development will be pursued further in a workshop involving ACT personnel and conductivity-temperature sensor manufacturers.[PDF contains 28 pages]

Introduction of collection and distribution programme for the small-scale fisheries in Ondo State

Details are given of a programme for fresh fish collection and distribution in Ondo State, Nigeria. Collection centers, organization and managerial structure, collection scheme, trade system, price determination, management and distribution are described

Problems of industrial fisheries development in the Cross River State

The industrial fisheries as opposed to artisanal fisheries in Cross River State, Nigeria, is discussed, considering the prospect of industrial fisheries in the State and identifying the major fish and shrimp resources within the coastal waters. Industrial fishing was introduced in 1973 when the state government invited a Japaneese company to carry out a joint exploratory shrimp fishing venture. The contributions made by the Seastate Seafoods Company, the Eyib's Nutritional Food and the Arawak Fishing Companies towards the increase in the number of fishing fleet in the state are noted.

A review of the crayfish fishery of Nigeria with special reference to the Cross River State

The fishery for crayfish is of considerable importance in the maritime region of the Cross River State, Nigeria, where it forms an important occupation of a host of fishermen. Crayfish landings from this State contributed 11% to the national marine fish landings within the period 1980 to 1984 and also in the same period the volume of crayfish alone formed 26% of the marine fish landings within the State. The species exploited as crayfish include Palaemon hastatus; Hippolysmata hastatoides, and Macrobrachium sp; mixed with the larval, and juveniles of pink shrimp Panaeus dourarum. They are generally small in size ranging from 7 cm (maximum) to 2.5 cm. Crayfish are caught all year round along the Niger Delta, but particularly along the river estuaries and littoral waters of the Cross River State with the highest production occurring in March to May. Crayfish are usually smoked, and occasionally sun-dried, and they form an indispensable food item in the diet of the people of the entire southern States in particular and Nigeria in general. It appears that crayfish landings could be substantially increased without depleting the stock, if a proper exploratory survey is undertaken of the Niger delta, and the Cross River estuaries to chart potentially rich grounds of this resource