Evaluación de Ulmus pumila L. y Populus spp. como cultivos energéticos en corta rotación

El presente trabajo estudia el empleo del olmo de Siberia (Ulmus Pumila L.) y el chopo (Populus spp.) en corta rotación y alta densidad para la producción de biomasa con fines energéticos. En el área mediterránea las disponibilidades hídricas son limitadas, por lo que la mayoría de los cultivos energéticos utilizados hasta el momento requieren el aporte de agua de riego; por ello resulta fundamental encontrar especies con bajos requerimientos hídricos, analizar la eficiencia en el uso del agua de diferentes materiales genéticos y optimizar la dosis de riego. Las parcelas experimentales se ubicaron en la provincia de Soria. En el ensayo llevado a cabo con olmo de Siberia se ha analizado el efecto en la producción de la disponibilidad de agua mediante el establecimiento de parcelas en secano y con dos dosis de riego (2000 m3 ha-1 año-1 y 4000 m3 ha-1 año-1 aproximadamente); además, al ser una especie poco estudiada hasta el momento, se ha estudiado también el efecto que tiene sobre el rendimiento la densidad de plantación (3.333 plantas ha-1 y 6.666 plantas ha-1), el tipo de suelo (2 calidades diferentes) y el turno de corta (3 y 4 años). En el caso del chopo, se han evaluado cuatro clones (AF-2, I-214, Monviso y Pegaso) establecidos con una densidad de 20.000 plantas por hectárea. Durante el primer ciclo de tres años se aportó el mismo volumen de riego a todas las parcelas, mientras que durante el segundo ciclo se establecieron 8 regímenes hídricos diferentes. Por otra parte, se ha investigado sobre el uso del potencial hídrico de las plantas para evaluar el estrés hídrico de las mismas y se ha estimado la producción de biomasa foliar y el Índice de Área Foliar (LAI) de ambas especies, relacionando los valores obtenidos con la dosis de riego y la producción de biomasa. Los resultados muestran que los suelos inundados reducen la tasa de supervivencia de los olmos durante el periodo de implantación, sin embargo la mortalidad durante los siguientes periodos vegetativos es baja y muestra buena capacidad de rebrote. La productividad (kg ha-1 año-1) obtenida fue mayor con un turno de corta de cuatro años que con turno de tres años. El área basal y la altura fueron variables eficaces para predecir la producción de biomasa del olmo de Siberia, obteniendo una variabilidad explicada de más del 80%. En cuanto a los parámetros que mayor influencia tuvieron sobre el crecimiento, el tipo de suelo resulto ser el más relevante, obteniéndose en un suelo agrícola considerado de buena calidad una producción en condiciones de secano de unos 8.000 kg ha-1 año-1. En condiciones de regadío el rendimiento del olmo de Siberia fue al menos el doble que en secano, pero la diferencia entre las dos dosis de riego estudiadas fue pequeña. La producción de biomasa fue mayor en la densidad de plantación más alta (6.666 plantas ha–1) en las parcelas de regadío, sin embargo no se encontraron diferencias significativas entre las dos densidades en secano. El clon de chopo que presentó un mayor rendimiento durante el primer ciclo fue AF-2, alcanzando los 14.000 kg ha-1 año-1, sin embargo la producción de este clon bajó sustancialmente durante el segundo ciclo debido a su mala capacidad de rebrote, pasando a ser I-214 el clon más productivo llegando también a los 14.000 kg ha-1 año-1. Un aporte adicional de agua proporcionó un incremento de la biomasa recogida, pero a partir de unos 6.500 m3 ha-1 año-1 de agua la producción se mantiene constante. El potencial hídrico foliar ha resultado ser una herramienta útil para conocer el estrés hídrico de las plantas. Los olmos de regadío apenas sufrieron estrés hídrico, mientras que los implantados en condiciones de secano padecieron un acusado estrés durante buena parte del periodo vegetativo, que se acentuó en la parte final del mismo. Los chopos regados con las dosis más altas no sufrieron estrés hídrico o fue muy pequeño, en las dosis intermedias sufrieron un estrés moderado ocasionalmente y únicamente en las dosis más bajas sufrieron puntualmente un estrés severo. El LAI aumenta con la edad de los brotes y oscila entre 2 y 4 m2 m−2 en los chopos y entre 2 y 7 m2 m−2 en los olmos. Se encontró una buena relación entre este índice y la producción de biomasa del olmo de Siberia. En general, puede decirse que el olmo de Siberia podría ser una buena alternativa para producir biomasa leñosa en condiciones de secano, mientras que el chopo podría emplearse en regadío siempre que se haga una buena elección del clon y de la dosis de riego. ABSTRACT This work explores the possibilities of biomass production, for energy purposes, of Siberian elm (Ulmus Pumila L.) and poplar (Populus spp.) in Spain. Irrigation is required for the viable cultivation of many energy crops in Mediterranean areas because of low water availability, for this reason species with low water requirements should be a good alternative for biomass production. Moreover, the optimal amount of irrigation water and the performance of the different genetic material in terms of production and water use efficiency should be studied in order to use water wisely. The experimental plots were established in the province of Soria in Spain. Given the small amount of information available about Siberian elm, besides studying the influence of water availability (rain-fed and two different irrigation doses) on biomass production, two different plantation densities (3,333 plants ha-1 and 6,666 plants ha-1), two different soil type and two cutting cycles (three years and four years) were assessed. In the case of poplar, four clones belonging to different hybrids (I-214, AF2, Pegaso, and Monviso) were included in a high density plantation (20,000 plants ha-1). During the first cycle, the water supplied in all plots was the same, while 8 different watering regimes were used during the second cycle. The suitability of the use of the leaf water potential to assess the water stress situations has also been investigated. Moreover, leaf biomass production and leaf area index (LAI) were estimated in both species in order to analyze the relationship between these parameters, irrigation dose and biomass production. The results shows that flooded soils have an adverse effect on elm survival in the implantation period, but the percentage of mortality is very low during the following vegetative periods and it shows a good ability of regrowth. The annual yield from a four-year cutting cycle was significantly greater than that from the three-year cutting cycle. Basal diameter and height are effective variables for predicting the production of total biomass; equations with R squared higher than 80% were obtained. The analysis of parameters having an influence on elm growth shows that soil type is the most important factor to obtain a good yield. In soils with enough nutrients and higher waterholding capacity, biomass productions of 8,000 kg ha-1 yr-1 were achieved even under rain-fed conditions. In irrigated plots, Siberian elm production was double than the production of biomass under rain-fed conditions; however, small differences were obtained between the 2 different irrigation doses under study. Biomass yield was greater for the highest planting density (6,666 plants ha–1) in irrigated plots, but significant differences were not found between the 2 densities in rain-fed plots. The clone AF-2 showed the highest production (14,000 kg ha-1 yr-1) during the first cycle, however during the second cycle its growth was lower because of a high mortality rate after regrowth and I-214 achieves the greatest production (14,000 kg ha-1 yr-1). An additional water supply provided a greater amount of biomass, but over about 6500 m3 ha-1 yr-1 of water the production is constant. Leaf water potential has been shown to be a useful tool for finding out plant water status. Irrigated elms hardly suffered water stress, while rain-fed elms suffered a pronounced water stress, which was more marked at the end of the vegetative period. Most of poplars did not show water stress; leaf water potentials only showed an important water stress in the plots irrigated with the lowest doses. LAI increases with shoot age and it ranges from 2 to 4 m2 m−2 in poplars and from 2 to 7 m2 m−2 in elms. A good relationship has been found between this index and Siberian elm production. In general, Siberian elm could be a good alternative to produce woody biomass in rainfed plots, while poplar could be used in irrigated plots if a suitable clone and irrigation dose are chosen.

REFLEXOS INDIVIDUAIS DO USO PESSOAL E EXCESSIVO DE COMUNICADORES INSTANTÂNEOS NO AMBIENTE DE TRABALHO

A Internet está inserida no cotidiano do indivíduo, e torna-se cada vez mais acessível por meio de diferentes tipos de dispositivos. Com isto, diversos estudos foram realizados com o intuito de avaliar os reflexos do seu uso excessivo na vida pessoal, acadêmica e profissional. Esta dissertação buscou identificar se a perda de concentração e o isolamento social são alguns dos reflexos individuais que o uso pessoal e excessivo de aplicativos de comunicação instantânea podem resultar no ambiente de trabalho. Entre as variáveis selecionadas para avaliar os aspectos do uso excessivo de comunicadores instantâneos tem-se a distração digital, o controle reduzido de impulso, o conforto social e a solidão. Através de uma abordagem de investigação quantitativa, utilizaram-se escalas aplicadas a uma amostra de 283 pessoas. Os dados foram analisados por meio de técnicas estatísticas multivariadas como a Análise Fatorial Exploratória e para auferir a relação entre as variáveis, a Regressão Linear Múltipla. Os resultados deste estudo confirmam que o uso excessivo de comunicadores instantâneos está positivamente relacionado com a perda de concentração, e a variável distração digital exerce uma influência maior do que o controle reduzido de impulso. De acordo com os resultados, não se podem afirmar que a solidão e o conforto social exercem relações com aumento do isolamento social, devido à ausência do relacionamento entre os construtos.

Antibodies to several conformation-dependent epitopes of gp120/gp41 inhibit CCR-5-dependent cell-to-cell fusion mediated by the native envelope glycoprotein of a primary macrophage-tropic HIV-1 isolate

The β-chemokine receptor CCR-5 is essential for the efficient entry of primary macrophage-tropic HIV-1 isolates into CD4+ target cells. To study CCR-5-dependent cell-to-cell fusion, we have developed an assay system based on the infection of CD4+ CCR-5+ HeLa cells with a Semliki Forest virus recombinant expressing the gp120/gp41 envelope (Env) from a primary clade B HIV-1 isolate (BX08), or from a laboratory T cell line-adapted strain (LAI). In this system, gp120/gp41 of the “nonsyncytium-inducing,” primary, macrophage-tropic HIV-1BX08 isolate, was at least as fusogenic as that of the “syncytium-inducing” HIV-1LAI strain. BX08 Env-mediated fusion was inhibited by the β-chemokines RANTES (regulated upon activation, normal T cell expressed and secreted) and macrophage inflammatory proteins 1β (MIP-1β) and by antibodies to CD4, whereas LAI Env-mediated fusion was insensitive to these β-chemokines. In contrast soluble CD4 significantly reduced LAI, but not BX08 Env-mediated fusion, suggesting that the primary isolate Env glycoprotein has a reduced affinity for CD4. The domains in gp120/gp41 involved in the interaction with the CD4 and CCR-5 molecules were probed using monoclonal antibodies. For the antibodies tested here, the greatest inhibition of fusion was observed with those directed to conformation-dependent, rather than linear epitopes. Efficient inhibition of fusion was not restricted to epitopes in any one domain of gp120/gp41. The assay was sufficiently sensitive to distinguish between antibody- and β-chemokine-mediated fusion inhibition using serum samples from patient BX08, suggesting that the system may be useful for screening human sera for the presence of biologically significant antibodies.

Heterogeneous nuclear ribonucleoprotein A1 binds to the transcription-regulatory region of mouse hepatitis virus RNA

A cellular protein, previously described as p35/38, binds to the complementary (−)-strand of the leader RNA and intergenic (IG) sequence of mouse hepatitis virus (MHV) RNA. The extent of the binding of this protein to IG sites correlates with the efficiency of the subgenomic mRNA transcription from that IG site, suggesting that it is a requisite transcription factor. We have purified this protein and determined by partial peptide sequencing that it is heterogeneous nuclear ribonucleoprotein (hnRNP) A1, an abundant, primarily nuclear protein. hnRNP A1 shuttles between the nucleus and cytoplasm and plays a role in the regulation of alternative RNA splicing. The MHV(−)-strand leader and IG sequences conform to the consensus binding motifs of hnRNP A1. Recombinant hnRNP A1 bound to these two RNA regions in vitro in a sequence-specific manner. During MHV infection, hnRNP A1 relocalizes from the nucleus to the cytoplasm, where viral replication occurs. These data suggest that hnRNP A1 is a cellular factor that regulates the RNA-dependent RNA transcription of the virus.

Unified underpinning of human mobility in the real world and cyberspace

Acknowledgments This work is supported by National Science Foundation of China (Grant No. 61573064, 61074116 and 11547188), the Youth Scholars Program of Beijing Normal University (grant No. 2014NT38), and the Fundamental Research Funds for the Central Universities Beijing Nova Programme, China. XYY acknowledges the support from the National Natural Science Foundation of China (Grant No. 61304177) and the Fundamental Research Funds of BJTU (Grant No. 2015RC042).