Dimensionality effects in the local density of states of ferromagnetic hosts probed via STM: Spin-polarized quantum beats and spin filtering

We theoretically investigate the local density of states (LDOS) probed by an STM tip of ferromagnetic metals hosting a single adatom and a subsurface impurity. We model the system via the two-impurity Anderson Hamiltonian. By using the equation of motion with the relevant Green's functions, we derive analytical expressions for the LDOS of two host types: a surface and a quantum wire. The LDOS reveals Friedel-like oscillations and Fano interference as a function of the STM tip position. These oscillations strongly depend on the host dimension. Interestingly, we find that the spin-dependent Fermi wave numbers of the hosts give rise to spin-polarized quantum beats in the LDOS. Although the LDOS for the metallic surface shows a damped beating pattern, it exhibits the opposite behavior in the quantum wire. Due to this absence of damping, the wire operates as a spatially resolved spin filter with a high efficiency. © 2013 American Physical Society.

Influence of air abrasion tips and operation modes on enamel-cutting characteristics

Objective: To assess the influence of air abrasion tips and system operation modes on enamel cutting. Methods: Forty bovine teeth were abraded with the air abrasion system Mach 4.1 for 10 and 15 seconds, employing conventional and sonic tips of 0.45-mm inner diameter and a 90° angle, and 27.5-μm aluminum oxide at 5.51 bar air pressure in continuous and pulsed modes. The width and depth of the resulting cuts were measured in SEM. Results: The multivariate analysis of variances revealed that, compared to the sonic tip, the conventional tip produced shallower cuts independent of the operation mode and the application period. Conclusions: The cutting patterns observed in this study suggest that the pulsed mode produced deeper cuts when both the conventional and sonic tips were used, and that the sonic tip cut more dental tissue than the conventional one.

Evaluation of degree of conversion and hardness of dental composites photoactivated with different light guide tips

Objective: The aim of this study was to evaluate the degree of conversion and hardness of different composite resins, photo-activated for 40 s with two different light guide tips, fiber optic and polymer. Methods: Five specimens were made for each group evaluated. The percentage of unreacted carbon double bonds (% C=C) was determined from the ratio of absorbance intensities of aliphatic C=C (peak at 1637 cm-1) against internal standard before and after curing of the specimen: aromatic C-C (peak at 1610 cm-1. The Vickers hardness measurements were performed in a universal testing machine. A 50 gf load was used and the indenter with a dwell time of 30 seconds. The degree of conversion and hardness mean values were analyzed separately by ANOVA and Tukey's test, with a significance level set at 5%. Results: The mean values of degree of conversion for the polymer and fiber optic light guide tip were statistically different (P<.001). The hardness mean values were statistically different among the light guide tips (P<.001), but also there was difference between top and bottom surfaces (P<.001). Conclusions: The results showed that the resins photo-activated with the fiber optic light guide tip promoted higher values for degree of conversion and hardness.

Compressive strength of dental composites photo-activated with different light tips

The aim of this study was to evaluate the compressive strength of microhybrid (Filtek™ Z250) and nanofilled (Filtek™ Supreme XT) composite resins photo-activated with two different light guide tips, fiber optic and polymer, coupled with one LED. The power density was 653 mW cm -2 when using the fiber optic light tip and 596 mW cm-2 with the polymer. After storage in distilled water at 37 ± 2 °C for seven days, the samples were subjected to mechanical testing of compressive strength in an EMIC universal mechanical testing machine with a load cell of 5 kN and speed of 0.5 mm min-1. The statistical analysis was performed using ANOVA with a confidence interval of 95% and Tamhane's test. The results showed that the mean values of compressive strength were not influenced by the different light tips (p > 0.05). However, a statistical difference was observed (p < 0.001) between the microhybrid composite resin photo-activated with the fiber optic light tip and the nanofilled composite resin. Based on these results, it can be concluded that microhybrid composite resin photo-activated with the fiber optic light tip showed better results than nanofilled, regardless of the tip used, and the type of the light tip did not influence the compressive strength of either composite. Thus, the presented results suggest that both the fiber optic and polymer light guide tips provide adequate compressive strength to be used to make restorations. However, the fiber optic light tip associated with microhybrid composite resin may be an interesting option for restorations mainly in posterior teeth. © 2013 Astro Ltd.

Morphology and initial growth in the germination of dictyosperma album (bory) h. wendl. & drude ex scheffer (Arecaceae) seeds

Dictyosperma album, commonly known as Princess Palm, due to its graceful appearance and its ability to withstand strong hurricane force winds is largely used in landscaping areas. The aim of this work was to describe the diaspores (seeds with the stuck endocarp) morphology and the stages of the D. album germination process. Therefore we concluded that the species germination is of the tubular remote type and begins with the opening of a circular operculum in the fruit endocarp, through which emerges a bulbous and hollow structure, named cotyledonal petiole or embryophore. With the embryo growth, the endosperm is being gradually consumed. The embryo grows approximately up to 10 cm, when the dilation begins in its extremity. Starting from this extensive area, it begins the growth of the primary root and the opening of a longitudinal rift, through which emerges the aerial part that is composed by two sheaths that cover the first juvenile leaf. In this phase, the emergence of secondary roots is observed. The first leaves are simple and lance-shaped.

Temperature and scarification on seeds germination of copernicia prunifera (Mill) H.E. Moore (Arecaceae)

Copernicia prunifera, known as carnauba, is native to Brazil and presents great potential to be used in gardens and cultivation in pot. Palms species, with relatively few exceptions, can only be propagated by seeds; even so, there are no reports in the literature about the germination of this palm seeds. Several species of the Arecaceae family present seed physical dormancy in varying degrees, demanding treatments to improve germination. The objective of this work was to study the effects of temperature and mechanical scarification on seed germination of C. prunifera. The experimental design was entirely randomized in a factorial arrangement 6 x 2 (six conditions of temperature with or without mechanical scarification) with 4 replications and 25 seeds each. In accordance with the treatment, lateral scarifications were made on the seeds until appearance of the endosperm. Seeds were sown in moist fine vermiculite. Germination (%) and germination rate (GR) were evaluated. Germination data were arcsine (x/100)1/2 transformed before analysis of variance and germination rate data were not transformed. The means of the resulting values were then compared by the Scott-Knott test at 1% confidence level. It was concluded that the biggest germination percentage were obtained at alternated temperature of 25-35°C (92%) and at constant temperature of 25°C (87%). Seeds germinated faster at alternated temperature of 25- 35°C. Germination percentage was similar for the scarified and non-scarified seeds; however, scarified seeds germinated faster.

Sporophytic apomixis in polyploid Anemopaegma species (Bignoniaceae) from central Brazil

Apomixis and polyploidy have been important in the evolution of the angiosperms, and sporophytic apomixis has been associated with polyembryony and polyploidy in tropical floras. We studied the occurrence of polyembryony in populations of tetraploid Anemopaegma acutifolium, A.arvense and A.glaucum from the Brazilian cerrados, and histological features of sexual and apomictic processes were investigated in A.acutifolium. All populations and species were polyembryonic (68.9-98.4% of seeds). Normal double fertilization occurred in most ovules, with exceptions being that 3% of ovules were penetrated but not fertilized and in 4% of ovules both synergids were penetrated. The penetration of both synergids suggests a continuous attraction of pollen tubes and polyspermy. Adventitious embryo precursor cells (AEPs) arose from nucellar and integumental cells of the ovule in pollinated and unpollinated A.acutifolium, indicating sporophytic apomixis. However, further embryo and endosperm development required pollination and fertilization. This pseudogamy also allows concurrent sexual embryo development. Similar polyembryony rates and polyploidy indicated that A.arvense and A.glaucum are also apomictic, forming an agamic complex similar to that observed for some species of confamilial, but not closely related Handroanthus. The co-occurrence of apomixis and polyploidy in different groups of Bignoniaceae indicates homoplasious origin of these agamic complexes. © 2013 The Linnean Society of London.

Mating in the pseudogamic apomictic Anemopaegma acutifolium DC: Another case of pseudo-self-compatibility in Bignoniaceae?

Self-compatibility in apomictic pseudogamic species is considered fundamental to assure reproduction by seeds in extreme situations, making apomictic species more advantageous than sexual ones in these scenarios. Anemopaegma acutifolium is a polyploidy, apomictic sporophytic species with no endosperm development in ovules of unpollinated pistils, which indicates obligate pseudogamy. Thus, the aim of the present work is to study the breeding system and post-pollination events to test if there is similar pseudogamous development irrespective of pollination treatment. We analysed fruit and seed set obtained in controlled experimental pollinations, as well as embryo number per seed, and the progress of ovule penetration, fertilisation and early endosperm development between self- and cross-pollinated pistils. We found that the species is self-fertile and that spontaneous selfing fruit set is also possible, although emasculated flowers never form fruits. Selfed pistils were as efficient as crossed ones for all parameters analysed, except for a delay in endosperm development observed in the former that may be an effect of the late-acting self-incompatibility. Therefore, the avoidance of selfed pistil abortion seems to be promoted by the presence of adventitious embryos and a normal endosperm. We conclude that A. acutifolium shows apomixis-related pseudo-self-compatibility, as in other self-fertile apomictic species of Bignoniaceae, which confer reproductive assurance and increases fruit-set and persistence ability in fast-changing tropical habitats. © 2012 German Botanical Society and The Royal Botanical Society of the Netherlands.

Volume de aplicação na qualidade da deposição da pulverização na cutura do algodoeiro

Pós-graduação em Agronomia (Agricultura) - FCA

Biomarcadores do estresse em ratos exercitados por natação e corrida em esteira rolante

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Caracterização genotípica microrganismos isolados de infecções da corrente sanguína relacionadas a cateteres em recém-nascidos

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Caracterização molecular do arco da alça V3 da gp 120 do HIV-1

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Monitoramento da qualidade de hemocomponentes produzidos no Hemocecentro da FMB - UNESP

Pós-graduação em Pesquisa e Desenvolvimento (Biotecnologia Médica) - FMB

Avaliação da transferência de imunidade passiva em bezerros de vacas da raça Canchim

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Perfil sanguíneo de fêmeas bovinas em gestação e no periparto e avaliação da transferência de imunidade passiva aos descendentes

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)