Interpretation of measured profile losses in unsteady wake-turbine blade interaction studies

The interaction of wakes shed by a moving bladerow with a downstream bladerow causes unsteady flow. The meaning of the freestream stagnation pressure and stagnation enthalpy in these circumstances has been examined using simple analyses, measurements and CFD. The unsteady flow in question arises from the behaviour of the wakes as so-called negative-jets. The interactions of the negative-jets with the downstream blades lead to fluctuations in static pressure which in turn generate fluctuations in the stagnation pressure and stagnation enthalpy. It is shown that the fluctuations of the stagnation quantities created by unsteady effects within the bladerow are far greater than those within the incoming wake. The time-mean exit profiles of the stagnation pressure and stagnation enthalpy are affected by these large fluctuations. This phenomenon of energy separation is much more significant than the distortion of the time-mean exit profiles that is caused directly by the cross-passage transport associated with the negative-jet, as described by Kerrebrock and Mikolajczak. Finally, it is shown that if only time-averaged values of loss are required across a bladerow, it is nevertheless sufficient to determine the time-mean exit stagnation pressure.

Nutrient profile of pond water in north-eastern state of Tripura and impact of water acidity on aquaculture productivity

Physicochemical parameters of 31 fish pond water samples of Tripura were studied to ascertain the nutrient profile of acidic soil zone and the impact of water acidity towards aquaculture productivity. The pH was acidic (mean 6.63±0.44) with high Fe (mean1.04±0.40 mglˉ¹) and AI (mean 2.67±2.41 mglˉ¹) contents. These were mostly responsible for pond water acidity and poor productivity with low nitrogen, phosphate and total alkalinity. The study also showed strong negative relationship between water pH and redox potential (R²=0.5251). However, pH was positively significant with electrical conductivity. The roles of redox potential and electrical conductivity in water acidity were found highly important. Available calcium content was also found low (mean 2.91±2.96 mglˉ¹). Elevating level of pH of pond water could be the possible management practices in acidic water so that such unproductive water might be productive enough with higher phosphate and nitrogen levels for better biological production.

Effect of dietary supplementation of tocoferol acetate alone and with varying combinations on growth, survival and fatty acids profile of Macrobrachium rosenbergii larvae through Moina micrura enrichment

A study was carried out to determine the effect of tocopherol acetate along with cod liver oil astaxanthin enriched Moina micrura (MC- control, Ml- tocopherol acetate enriched, M2-tocopherol acetate combined with cod liver oil (CLO) enriched and M3- tocopherol acetate combined with astaxanthin enriched) on growth, survival and fatty acid composition of M. rosenbergii (de Man) larvae (TC- unenriched Moina fed larvae, Tl- tocopherol acetate enriched Moina fed larvae, T2- tocopherol acetate + CLO enriched Moina fed larvae to T3 – tocopherol acetate+ astaxanthin enriched Moina fed larvae). Growth was expressed as the time taken in to the settlement of 95% post larvae. Maximum growth i.e., the lowest time taken to the 95% PL settlement (40 days) and the maximum survival percentage (61%) was observed in both T2 and T3 treatments fed with M2 and M3 Moina respectively. Minimum growth and survival was observed in unenriched Moina fed larvae (TC). In larval treatments T2, (larvae fed with (M2) vitamin E + CLO enriched Moina), showed a higher percentage of EPA, DHA and higher HUFA level than other treatments.

Supply of Astaxanthin and its combinations through live feed (Moina micrura) enrichment affects the growth, survival and fatty acid profile of Macrobrachium rosenbergii larvae

A study was carried out with three replicates to determine the effects of feeding Moina micrura enriched with astaxanthin alone (M1) or astaxanthin in combination with either vitamin E (M2), vitamin D (M3) or Cod Liver oil (M4) on the growth, survival and fatty acid composition of giant fresh water prawn Macrobrachium rosenbergii (de Man) larvae. Growth rate was expressed as the time taken to the settlement of 95% post larvae. Maximum growth, the lowest time taken to the 95% PL settlement (38.5±0.50 days), was observed in larvae fed with M3 Moina. The highest survival rate (66.0±1.00%) was observed in those fed with M4 Moina and the second highest survival (61.0±1.00%) and growth rates (40.0±0.00 days) were shown with M2 Moina. The minimum values for both growth (42.5±0.50 days) and survival (33.0±1.50%) were observed in the group fed un-enriched Moina. Results also showed that the survival of prawn larvae increased as the quantities of eicosapentaenoic acid (EPA) and docosahexaenoic acid (DHA) increased in the dietary Moina. The highest levels of EPA (5.57±0.21%), DHA (3.50±0.21%) and highest total Highly Unsaturated Fatty Acids (HUFA) (13.87±0.68%) were seen in the Moina fed on astaxanthin and Cod Liver Oil (CLO). The results of the study showed that the nutritive quality of Moina, with respect to important fatty acids, can be increased by enrichment and will influence the growth, survival and the fatty acid composition of fresh water prawn larvae fed on them.

Fisheries profile mapping of coastal districts in Maharashtra state through GIS

In recent times, GIS is being increasingly used as a decision support system for management of fisheries and aquaculture. It provides new innovative approaches of the dynamic relations that characterize this sector. In this context, a study is conducted based on the secondary data of a major maritime state, Maharashtra, where mapping of fisheries profile of coastal districts in the state is performed through GIS tool having critical geographic dimensions. This paper aims to map information of the state which can be used for the purpose of planning and decision making as each aspect of map has a different component involved. For this purpose, at the core of the system, the data were accessed and integrated from different sources mainly from the five coastal districts of Maharashtra state. Data were brought in tabular form through Microsoft Excel and then joined to Map info Professional version 8.0 GIS software was used with the digitized map of Maharashtra state to enable mapping. This was further synchronized and integrated to generate four thematic maps searchable on several criteria. Map 1 contains the searchable criteria as regards to the fish growth for the year 1997-2004 and fish seed production for the year 2003-04. Map 2 contains fisher population along with their occupation for the year 1992. Map 3 contains brackish water and shrimp farming production and culture area. Map 4 contains infrastructural facilities which include type of boats etc. With this mapping, planners and various stakeholders have accessible information as regards to the various components of fisheries in the state of Maharashtra.

Changes in the Mg profile and in dislocations induced by high temperature annealing of blue LEDs

The efficiency of the injection and recombination processes in InGaN/GaN LEDs is governed by the properties of the active region of the devices, which strongly depend on the conditions used for the growth of the epitaxial material. To improve device quality, it is very important to understand how the high temperatures used during the growth process can modify the quality of the epitaxial material. With this paper we present a study of the modifications in the properties of InGaN/GaN LED structures induced by high temperature annealing: thermal stress tests were carried out at 900 °C, in nitrogen atmosphere, on selected samples. The efficiency and the recombination dynamics were evaluated by photoluminescence measurements (both integrated and time-resolved), while the properties of the epitaxial material were studied by Secondary Ion Mass Spectroscopy (SIMS) and Rutherford Backscattering (RBS) channeling measurements. Results indicate that exposure to high temperatures may lead to: (i) a significant increase in the photoluminescence efficiency of the devices; (ii) a decrease in the parasitic emission bands located between 380 nm and 400 nm; (iii) an increase in carrier lifetime, as detected by time-resolved photoluminescence measurements. The increase in device efficiency is tentatively ascribed to an improvement in the crystallographic quality of the samples. © 2013 SPIE.