948 resultados para Early, John C. (John Chrysostom), 1878-1932


Relevância:

40.00% 40.00%

Publicador:

Resumo:

Introduction Decreased water displacement following increased neural activity has been observed using diffusion-weighted functional MRI (DfMRI) at high b-values. The physiological mechanisms underlying the diffusion signal change may be unique from the standard blood oxygenation level-dependent (BOLD) contrast and closer to the source of neural activity. Whether DfMRI reflects neural activity more directly than BOLD outside the primary cerebral regions remains unclear. Methods Colored and achromatic Mondrian visual stimuli were statistically contrasted to functionally localize the human color center Area V4 in neurologically intact adults. Spatial and temporal properties of DfMRI and BOLD activation were examined across regions of the visual cortex. Results At the individual level, DfMRI activation patterns showed greater spatial specificity to V4 than BOLD. The BOLD activation patterns were more prominent in the primary visual cortex than DfMRI, where activation was localized to the ventral temporal lobe. Temporally, the diffusion signal change in V4 and V1 both preceded the corresponding hemodynamic response, however the early diffusion signal change was more evident in V1. Conclusions DfMRI may be of use in imaging applications implementing cognitive subtraction paradigms, and where highly precise individual functional localization is required.

Relevância:

40.00% 40.00%

Publicador:

Resumo:

This thesis addresses the following broad research question: what did it mean to be a disabled Revolutionary War veteran in the early United States during the period from 1776 to roughly 1840? The study approaches the question from two angles: a state-centred one and an experiential one. In both cases, the theoretical framework employed comes from disability studies. Consequently, disability is regarded as a sociocultural phenomenon rather than a medical condition. The state-centred dimension of the study explores the meaning of disability and disabled veterans to the early American state through an examination of the major military pension laws of the period. An analysis of this legislation, particularly the invalid pension acts of 1793 and 1806, indicates that the early United States represents a key period in the development of the modern disability category. The experiential approach, in contrast, shifts the focus of attention away from the state towards the lived experiences of disabled veterans. It seeks to address the issue of whether or not the disabilities of disabled veterans had any significant material impact on their everyday lives. It does this through a comparison of the situation of 153 disabled veterans with that of an equivalent number of nondisabled veterans. The former group received invalid pensions while the latter did not. In comparing the material conditions of disabled and nondisabled veterans, a wide range of primary sources from military records to memoirs and letters are used. The most important sources in this regard are the pension application papers submitted by veterans in the early nineteenth century. These provide us with a unique insight into the everyday lives of veterans. Looking at the issue of experience through the window of the pension files reveals that there was not much difference in the broad contours of disabled and nondisabled veteran life. This finding has implications for the theorisation of disability that are highlighted and discussed in the thesis. The main themes covered in this study are: the wartime experiences of injured American soldiers, the military pension establishment of the early United States and the legal construction of disability, and the post-war working and family lives of disabled veterans. Keywords: disability, early America, veterans, military pensions, disabled people, Revolutionary War, United States, disability theory.

Relevância:

40.00% 40.00%

Publicador:

Resumo:

Mossbauer effect and X-ray measurements are carried out on product samples of the thermogravimetric analysis (TGA) and isothermal decomposition in hydrogen of homogeneously mixed ferrous nickel oxalates with different iron to nickel ratios. The formation of Fe-Ni alloy is obtained at considerably lower temperatures (z 300 "C) in each case. The Fe-Ni alloys obtained shift from iron-rich to nickel-rich composition as the nickel ratio in the mixed metal oxalates is increased. The formation of Pe-Ni Invar from mixed metal oxalate with Fe:Ni = 1:l is indicated in the early stages but not from those with Fe:Ni = 2: 1 or 64:36. An Produktproben von homogen verteilten Eisen-Nickeloxalaten mit unterschiedlichem Eisen- Nickel-Verhaltnis nach thermogravimetrischer Analyse (TGA) und isothermem Zerfall in Wasserst off werden Mollbauereffekt- und Rontgenmessnngen durchgefuhrt. In allen Fiillen wird die Bildung der Fe-Ni-Legierung bei betriichtlich niedrigeren Temperaturen (= 300 "C) erhalten. Die erhaltenen Fe-Ni-Legierungen verschieben sich von der eisenreichen zur nickelreichen Zusrtmmensetzung, wenn das Nickelverhaltnis in dem BIetall-Mischoxalat erhoht wird. Die Bildung der Fe-Ni-lnvar-Legierung aus dem Metall-Mischoxalat mit Fe:Ni = 1 : 1 wird in fruhen Zu Zustanden beobachtet, iedoch nicht aus Oxalaten mit Fe:Ni = 2:1 oder 64:36.

Relevância:

40.00% 40.00%

Publicador:

Resumo:

The intent of this study was to design, document and implement a Quality Management System (QMS) into a laboratory that incorporated both research and development (R&D) and routine analytical activities. In addition, it was necessary for the QMS to be easily and efficiently maintained to: (a) provide documented evidence that would validate the system's compliance with a certifiable standard, (b) fit the purpose of the laboratory, (c) accommodate prevailing government policies and standards, and (d) promote positive outcomes for the laboratory through documentation and verification of the procedures and methodologies implemented. Initially, a matrix was developed that documented the standards' requirements and the necessary steps to be made to meet those requirements. The matrix provided a check mechanism on the progression of the system's development. In addition, it was later utilised in the Quality Manual as a reference tool for the location of full procedures documented elsewhere in the system. The necessary documentation to build and monitor the system consisted of a series of manuals along with forms that provided auditable evidence of the workings of the QMS. Quality Management (QM), in one form or another, has been in existence since the early 1900's. However, the question still remains: is it a good thing or just a bugbear? Many of the older style systems failed because they were designed by non-users, fiercely regulatory, restrictive and generally deemed to be an imposition. It is now considered important to foster a sense of ownership of the system by the people who use the system. The system's design must be tailored to best fit the purpose of the operations of the facility if maximum benefits to the organisation are to be gained.

Relevância:

40.00% 40.00%

Publicador:

Resumo:

Mossbauer effect and X-ray measurements are carried out on product samples of the thermogravimetric analysis (TGA) and isothermal decomposition in hydrogen of homogeneously mixed ferrous nickel oxalates with different iron to nickel ratios. The formation of Fe-Ni alloy is obtained at considerably lower temperatures (z 300 "C) in each case. The Fe-Ni alloys obtained shift from iron-rich to nickel-rich composition as the nickel ratio in the mixed metal oxalates is increased. The formation of Pe-Ni Invar from mixed metal oxalate with Fe:Ni = 1:l is indicated in the early stages but not from those with Fe:Ni = 2: 1 or 64:36. An Produktproben von homogen verteilten Eisen-Nickeloxalaten mit unterschiedlichem Eisen- Nickel-Verhaltnis nach thermogravimetrischer Analyse (TGA) und isothermem Zerfall in Wasserstoff werden Mollbauereffekt- und Rontgenmessnngen durchgefuhrt. In allen Fiillen wird die Bildung der Fe-Ni-Legierung bei betriichtlich niedrigeren Temperaturen (= 300 "C) erhalten. Die erhaltenen Fe-Ni-Legierungen verschieben sich von der eisenreichen zur nickelreichen Zusrtmmensetzung, wenn das Nickelverhaltnis in dem BIetall-Mischoxalat erhoht wird. Die Bildung der Fe-Ni-lnvar-Legierung aus dem Metall-Mischoxalat mit Fe:Ni = 1 : 1 wird in fruhen Zustanden beobachtet, iedoch nicht aus Oxalaten mit Fe:Ni = 2:1 oder 64:36.

Relevância:

40.00% 40.00%

Publicador:

Resumo:

Bearing capacity factor N-c for axially loaded piles in clays whose cohesion increases linearly with depth has been estimated numerically under undrained (phi=0) condition. The Study follows the lower bound limit analysis in conjunction With finite elements and linear programming. A new formulation is proposed for solving an axisymmetric geotechnical stability problem. The variation of N-c with embedment ratio is obtained for several rates of the increase of soil cohesion with depth; a special case is also examined when the pile base was placed on the stiff clay stratum overlaid by a soft clay layer. It was noticed that the magnitude of N-c reaches almost a constant value for embedment ratio greater than unity. The roughness of the pile base and shaft affects marginally the magnitudes of N-c. The results obtained from the present study are found to compare quite well with the different numerical solutions reported in the literature.

Relevância:

40.00% 40.00%

Publicador:

Resumo:

The aim of this study is to explore by systematic textual analysis the crucial conceptions of constructive alignment and to reconstruct the concept of constructive alignment and examine the relation between conceptual relationships in John Biggs’s texts. In this study, I have also analyzed the presuppositions of the concept of constructive alignment and its possible implications. The research material includes Biggs’s (1996b; 2003) article entitled Enhancing Teaching through Constructive Alignment and book entitled Teaching for Quality Learning at University. The primary purpose of the systematic textual analysis is to reconstruct concepts and gain access to a new or more profound understanding of the concepts. The main purpose of the constructive alignment is to design a teaching system that supports and encourages students to adopt a deep approach learning. At the center of the constructive alignment are two concepts: constructivism in learning and alignment in teaching. A tension was detected between these concepts. Biggs assumes that students’ learning activities are primed by the teaching. Because of this it is not important what the teacher does. At the same time he emphasizes that teaching interacts with learning. The teacher’s task is to support student’s appropriate learning activities. On the basis of the analysis, I conclude these conceptions are not mutually exclusive. Interaction between teaching and learning has an effect on student’s learning activities. The most essential benefit of the model of constructive alignment is that Biggs brings together and considers teaching at the same level with learning. A weakness of Biggs’s model relates to the theoretical basis and positions of the concept of constructive alignment. There are some conflicts between conceptions of epistemology in Biggs’s texts. In addition, Biggs writes about constructivism also as conceptions of epistemology, but doesn’t consider implications of that position or what follows or doesn’t follow from that commitment. On the basis of the analysis, I suggest that constructivism refers in Biggs’s texts rather to constructivism in learning than philosophical constructivism. In light of this study, constructive alignment doesn´t lead to philosophical constructivism. That’s why constructive alignment stays out of idealism. Biggs’s way of thinking about teachers possibility to confronting students’ misconceptions and evaluate and assess students’ constructions support a realist purpose in terms of philosophical stance. Realism does not drift toward general problems of relativism, like lack of criteria for assessing or evaluate these constructions.

Relevância:

40.00% 40.00%

Publicador:

Resumo:

John Ettinger, 1987.

Relevância:

40.00% 40.00%

Publicador:

Resumo:

A detailed analysis of the 1H and 13C NMR spectra of C-2 aryl and alkyl/desalkyl substituted isomeric exo- and endo-5-methylbicyclo[3.2.1]octane-6,8-diones is presented. The chemical shift of the C-5 angular methyl, the C-2 alkyl/olefinic (C-10)/C-2 methine protons, the aromatic proton shieldings and the characteristic AMX and ABX spectral pattern of the ketomethylene and bridgehead protons were found to be sensitive to the phenyl ring orientation (anisotropy). These distinctive features could be used for configurational distinction for this class of compounds. With increasing ortho-methoxy substitution on the phenyl ring, considerable deshilelding of the bridgehead proton was observed (ca. 0.6 ppm). Absence of the C-2 alkyl group in the desalkyl isomers resulted in substantial changes in the chemical shifts of different protons. A study of the NMR spectra of the corresponding bicyclic compounds with C-2 methoxy/hydroxy substitution instead of the aryl group revealed that the anisotropy of the phenyl ring and the electronegative oxygen substituents have opposite effects. The 13C NMR spectral assignment of each carbon resonance of C-2 aryl and alkyl/desalkyl substituted isomeric exo- and endo-5-methylbicyclo[3.2.1]octane-6,8-diones and the corresponding C-2 methoxy/hydroxy/chloro and methyl bicyclic compounds are reported. Additional ortho-methoxy substitution on the phenyl ring was found to produce considerable high field shifts of the C-10 and C-1 carbon resonances. A high-field shift was observed for the C-6 and C-8 carbonyl carbons, presumably due to 1,3-dicarbonyl interactions. The chemical shifts of C-1 aromatic, C-10 alkyl and C-2 carbons, which are sensitive to exo/endo isomerism, could be utilized in differentiating a pair of isomers.

Relevância:

40.00% 40.00%

Publicador:

Resumo:

Aim: Decision-making in weed management involves consideration of limited budgets, long time horizons, conflicting priorities, and as a result, trade-offs. Economics provides tools that allow these issues to be addressed and is thus integral to management of the risks posed by weeds. One of the critical issues in weed risk management during the early stages of an invasion concerns feasibility of eradication. We briefly review how economics may be used in weed risk management, concentrating on this management strategy. Location: Australia. Methods: A range of innovative studies that investigate aspects of weed risk management are reviewed. We show how these could be applied to newly invading weeds, focussing on methods for investigating eradication feasibility. In particular, eradication feasibility is analysed in terms of cost and duration of an eradication programme, using a simulation model based on field-derived parameter values for chromolaena, Chromolaena odorata. Results: The duration of an eradication programme can be reduced by investing in progressively higher amounts of search effort per hectare, but increasing search area will become relatively more expensive as search effort increases. When variation in survey and control success is taken into account, increasing search effort also reduces uncertainty around the required duration of the eradication programme. Main conclusions: Economics is integral to the management of the risks posed by weeds. Decision analysis, based on economic principles, is now commonly used to tackle key issues that confront weed managers. For eradication feasibility, duration and cost of a weed eradication programme are critical components; the dimensions of both factors can usefully be estimated through simulation. © 2013 John Wiley & Sons Ltd.