Effects of ultrasonic, electric, and manual toothbrushes on subgingival plaque composition in orthodontically banded molars

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Antimicrobial activity of disinfectant agents incorporated into type IV dental stone

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Effect of disinfection on adhesion of reline polymers

Cylinders (3.5 x 5.0 mm) of the reline resins Kooliner (K), New Truliner (N), Tokuso Rebase Fast (T), and Ufi Gel Hard (U) were bonded to cylinders (20 x 20 mm) of the denture base resin Lucitone 550 (L), and samples were divided into two controls and four test groups (n = 8). Shear tests (0.5 mm/min) were performed after polymerization or immersion in water (37 degrees C) for 7 days (controls); two or seven cycles of disinfection by immersion in sodium perborate (50 degrees C/10 min) or microwave irradiation (650 W/6 min). Statistical analyses (alpha = 0.05) revealed that two cycles of microwave and chemical disinfection increased the mean bond strengths of materials T (9.08 to 12.93 MPa) and L (18.89 to 23.02 MPa). For resin L, seven cycles of chemical (15.72 MPa) and microwave (17.82 MPa) disinfection decreased the shear bond strength compared with the respective control (21.74 MPa). Resins U (13.12 MPa), K (8.44 MPa), and N (7.98 MPa) remained unaffected.

Diametral tensile strength and film thickness of an experimental dental luting agent derived from castor oil

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Flexural strength of acrylic resin repairs processed by different methods: water bath, microwave energy and chemical polymerization

Denture fractures are common in daily practice, causing inconvenience to the patient and to the dentists. Denture repairs should have adequate strength, dimensional stability and color match, and should be easily and quickly performed as well as relatively inexpensive. Objective: The aim of this study was to evaluate the flexural strength of acrylic resin repairs processed by different methods: warm water-bath, microwave energy, and chemical polymerization. Material and methods: Sixty rectangular specimens (31x10x2.5 mm) were made with warm water-bath acrylic resin (Lucitone 550) and grouped (15 specimens per group) according to the resin type used to make repair procedure: 1) specimens of warm water-bath resin (Lucitone 550) without repair (control group); 2) specimens of warm water-bath resin repaired with warm water-bath; 3) specimens of warm water-bath resin repaired with microwave resin (Acron MC); 4) specimens of warm water-bath resin repaired with autopolymerized acrylic resin (Simplex). Flexural strength was measured with the three-point bending in a universal testing machine (MTS 810 Material Test System) with load cell of 100 kgf under constant speed of 5 mm/min. Data were analyzed statistically by Kruskal-Wallis test (p<0.05). Results: The control group showed the best result (156.04 +/- 1.82 MPa). Significant differences were found among repaired specimens and the results were decreasing as follows: group 3 (43.02 +/- 2.25 MPa), group 2 (36.21 +/- 1.20 MPa) and group 4 (6.74 +/- 0.85 MPa). Conclusion: All repaired specimens demonstrated lower flexural strength than the control group. Repairs with autopolymerized acrylic resin showed the lowest flexural strength.

Changes in roughness of denture base and reline materials by chemical disinfection or microwave irradiation: Surface roughness of denture base and reline materials

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Effect of Incorporation of Disinfectant Solutions on Setting Time, Linear Dimensional Stability, and Detail Reproduction in Dental Stone Casts

Purpose: The aim of this paper was to analyze the influence of incorporation of disinfectants during the cast die stone-setting time. Setting time, linear dimensional stability, and reproduction details on casts were measured.Materials and Methods: Die stone type IV specimens with disinfection solutions (sodium hypochlorite 1%, glutaraldehyde 2%, chlorhexidine 2%) were incorporated in two concentrations (50%, 100%). The detail reproduction, dimensional stability, and setting time were tested in accordance with ADA recommendations.Results: Disinfecting solutions promoted an increase in setting time compared to control; sodium hypochlorite was responsible for the highest setting time. The addition of undiluted sodium hypochlorite 1.0% led to contraction during setting, but the groups with 50% diluted sodium hypochlorite 1.0% and undiluted chlorhexidine 2.0% resulted in intermediate values compared to the other groups, thus matching the control. The others did not demonstrate any effect on expansion. For detail reproduction, it was observed that the control group presented results similar to the others, except those where sodium hypochlorite was added.Conclusions The addition of sodium hypochlorite in both dilutions significantly altered, negatively, all the evaluated properties. But the addition of glutaraldehyde and chlorhexidine did not promote any significant alterations in the evaluated properties.

Color stability of relined dentures after chemical disinfection. A randomised clinical trial

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Comparative scanning electron microscopic study of the effect of different dental conditioners on dentin micromorphology

This study evaluated comparatively by scanning electron microscopy (SEM) the effect of different dental conditioners on dentin micromorphology, when used according to the same protocol. Forty dentin sticks were obtained from 20 caries-free third human molars and were assigned to 4 groups corresponding to 3 conditioners (phosphoric acid 37%, Clearfil SE Bond and iBond) and an untreated control group. After application of the conditioners, the specimens were immersed in 50% ethanol solution during 10 s, chemically fixed and dehydrated to prepare them to SEM analysis. In the control group, dentin surface was completely covered by smear layer and all dentinal tubules were occluded. In the phosphoric acid-etched group, dentin surface was completely clean and presented exposed dentinal tubule openings; this was the only group in which the tubules exhibited the funnel-shaped aspect. In the groups conditioned with Clearfil SE Bond primer and iBond, which are less acidic than phosphoric acid, tubule openings were occluded or partially occluded, though smear layer removal was observed. SE Bond was more efficient in removing the smear layer than iBond. In the Clearfil SE Bond group, the cuff-like aspect of peritubular dentin was more evident. It may be concluded all tested conditioners were able to change dentin morphology. However, it cannot be stated that the agent aggressiveness was the only cause of the micromorphological alterations because a single morphological pattern was not established for each group, but rather an association of different aspects, according to the aggressiveness of the tested conditioner.

Assessing the effects of vector control on dengue transmission

The dengue virus is an arbovirus transmitted to humans through mosquito Aedes aegypti. To describe the dynamics of dengue disease within these two populations we develop a compartment model taking into account chemical controls and mechanical control applied on the mosquitoes, which are the currently available controlling mechanisms to prevent dengue disease. To mimic seasonal variations, some parameters of the model are allowed to depend on time in order to divide a calendar year in favorable and unfavorable periods regarded to the development of vector population. (c) 2007 Elsevier B.V. All rights reserved.

Physico-chemical and harvest time alterations in pineapple fruits Smooth Cayenne caused by paclobutrazol

O objetivo deste trabalho foi avaliar o efeito de um inibidor da diferenciação floral nas características físico-químicas dos frutos do abacaxizeiro, bem como, no período de colheita. Utilizou-se paclobutrazol a 100, 150 e 200 mg L-1 aplicados 2, 3 ou 4 vezes, em plantas de abacaxi cv. Smooth Cayenne. Os tratamentos não influenciaram nas características químicas dos frutos, e mesmo alterando algumas características físicas, os frutos permaneceram dentro dos padrões de qualidade para comercialização. O período de colheita foi ampliado em todos os tratamentos comparando-se com o controle, porém, 150 mg L-1 aplicados 2 vezes promoveu melhor resultado analisando-se em conjunto a época de colheita com a massa fresca do fruto.

alpha(1)-Adrenoceptors in proximal segments of tail arteries from control and reserpinised rats

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Chemical cues related to conspecific size in pintado catfish, Pseudoplatystoma coruscans

The pintado (Pseudoplatystoma coruscans) is a ferocious carnivorous catfish with evident cannibalistic behaviour; its nocturnal habits are related to its ability to use predominately chemical sensorial modalities. This study investigated whether the pintado distinguishes conspecifics of different body sizes using chemical cues, which may reflect different physiological conditions such as hunger or stress. Pintados were observed when receiving water conditioned by either larger or similar-size conspecifics. A control group consisted of pintados receiving unconditioned water. Twelve repetitions were used for each condition. Feeding-like behaviours were investigated in the receiver fish and showed that they responded only to the conditioned water. Furthermore, a higher frequency of responses occurred when the water was conditioned by a similar-size conspecific. Thus, it is concluded that pintados are able to recognize conspecific size by chemical cues related to size and that this ability contributes to the individual's decision making on whether to approach or to avoid the conspecific.

Chemical transfer of warning information in non-injured fish

In this study we describe pacus, Piaractus mesopotamicus, detecting the presence of a predator by conspecific alerting pheromone. Moreover, we investigate whether this chemical information indicates the presence of a specific predator, or whether it indicates general disturbance. We exposed groups of pacus to the view of a predator fish (trahira, Hoplias malabaricus), a non-predator fish (piracanjuba, Brycon orbignyanus) or an aquarium without any fish (control), and then we transferred their water to isolated conspecifics. We set up six trials of each condition in which we analysed the dispersion and the distance from the visual stimulus in water-donor fish and the distance from the chemical stimulus in water-receiver pacus. This study showed that pacus visually identified the presence of another fish and recognised it as predator or non-predator. This is interpreted as an innate response. Such heterospecific detection affects the behaviour of pacus, which release chemicals that induce conspecifics to adopt a similar behavioural response. At least two chemicals might be involved, one of them possibly an alerting pheromone.