986 resultados para Contact parameters
Resumo:
Uncooled, high-speed modulation of two-contact lasers is presented with ultra-low drive currents. Practical operation at 10Gb/s up to temperatures of 85°C and extinction ratios of 6dB are found for current swings which are less than 40% of conventional lasers.
Resumo:
Data on age and growth of the following species were reviewed and von Bertalanffy's growth curves were fitted: Hilsa kelee, Decapterus russellii, D. macrosoma, Rastrelliger kanagurta, Pellona ditchela, Thryssa vitrirostris and Leiognathus equulus. For the five first species, microstructures in the otoliths were used for ageing. For most species growth curves based on size-frequency distributions are also presented. The reliability of the data presented is discussed.
Resumo:
A ball-on-flat reciprocating micro-tribometer has been used to measure the friction coefficient between aluminium alloy strip and a steel ball. A relatively small ball and correspondingly low contact load is used to give a contact width of the order of 100μm, closer to asperity contact widths than generally found for this type of test. The effects of load, initial strip surface roughness, lubricants and boundary additives are investigated. It is found that the friction coefficient is significantly reduced by the addition of a lubricant. Observations of the wear tracks and ball surface show that the material transfer from aluminium to the ball is reduced in the presence of the lubricant. The initial friction coefficient is further reduced by the addition of a boundary additive, but the friction coefficient after 8 cycles is unchanged. Copyright © 2004 by Springer Science+Business Media, Inc.
Resumo:
Model-based optical motion capture systems require knowledge of the position of the markers relative to the underlying skeleton, the lengths of the skeleton's limbs, and which limb each marker is attached to. These model parameters are typically assumed and entered into the system manually, although techniques exist for calculating some of them, such as the position of the markers relative to the skeleton's joints. We present a fully automatic procedure for determining these model parameters. It tracks the 2D positions of the markers on the cameras' image planes and determines which markers lie on each limb before calculating the position of the underlying skeleton. The only assumption is that the skeleton consists of rigid limbs connected with ball joints. The proposed system is demonstrated on a number of real data examples and is shown to calculate good estimates of the model parameters in each. © 2004 Elsevier B.V. All rights reserved.
Resumo:
The impacts of shrimp farming on water quality and effluent loading of shrimp farms in southwest (Khulna) and southeast (Cox's Bazar) regions of Bangladesh was investigated during March-August and August-October season, respectively. Water salinity fluctuated from 3.0 to 15.0 ppt in the southwest, whereas it was between 2.5 to 20.0 ppt. in southeast region. Total ammonia nitrogen as recorded in most farms of Cox's Bazar region was higher (0. 1160.438 mg/L) than the recommended level of shrimp farming. Mean values of total ammonia nitrogen and total nitrogen at the outlet of shrimp farms were higher than those of inlet in both regions. Mean values of phosphate phosphorus and total phosphorus at outlet were lower than inlet except in harvest time of Penaeus monodon. Total suspended solids were deposited on the bottom of shrimp farms in both regions, which resulted in higher concentration in inlets than outlets in both regions.
Resumo:
In recent years, the ecological degradation, loss of technological sustenance and other multidimensional consequences caused by shrimp farming have made the experts and authorities bound to rethink about the development of the industry. The present study describes the water and sediment quality, and culture and management techniques in five selected shrimp farms at Paikgacha, Khulna throughout a production cycle from March to September 1997. The water quality parameters were found to be more or less suitable throughout the cycle. The concentration of the limiting major nutrients such as nitrogen and phosphorus and minor nutrients such as calcium and magnesium were satisfactorily high, concentrations of the organic matter content were also high. Remarkable negative correlation of shrimp production with secchi depth was observed among the farms. Production per cycle ranged between 273 kg/ha and as low as 63 kg/ha.
Resumo:
Investigation on the seasonal distribution and abundance of various major taxa of phyto and zooplankton and the corresponding physico-chemical characteristics were carried out in four selected stations between the latitude 22°35.494N N-23°23.987 N and longitude 90°35.793 E- 90°49.061 E of the Meghna river system, Bangladesh. Drop count method was followed for the qualitative and quantitative analysis of both phyto- and zooplankton. A total of 41 phytoplankton genera belonging to 17 families and 13 zooplankton genera belonging to 11 families were recorded. Zooplankton growth cycle was noticeably less (3.0%) than the phytoplankton abundance almost throughout the study period. Quantity of plankton registered to increase chronologically from the upper to lower stretches of the river. During summer investigation the load of phytoplankton was recorded maximum (11,300-51,850 No/1). Ratio-wise quantitative difference between zoo- and phytoplankton in composition of the total standing crop fluctuated between 1.0:5.5 and 1:1037. Among the phytoplanktonic groups, Chlorophyceae was found to be dominating (95.0%) in all sampling stations. Protococcus, a single genus of Chlorophyceae played a unique role during summer, contributing the highest density of about 74.0%. The pattern of qualitative and quantitative difference of plankton standing crop in different sampling sites can be attributed to the existing physico-chemical characteristics, mainly water temperature, pH and hardness.
Resumo:
A study was conducted to ascertain the existing farm water, effluent and feed quality of selected giant freshwater prawn farms from major prawn farming areas (Bagerhat Sadar, Noakhali Sadar and Mymensingh) of Bangladesh during July to November 2005. Water quality parameters such as the mean values of dissolved oxygen, alkalinity, nitrite-nitrogen, phosphate-phosphorus and ammoniacal nitrogen did not show any significantly differences among the farming areas. Whereas significant differences (p < 0.05) were observed in the mean values of temperature, secchi disc visibility, pH and chlorophyll a. However, all the water quality parameters in the farming areas were within the suitable range for prawn culture. There was no significant variation in nutrients concentration of discharged effluent among the prawn farming areas. All of the nutrients measured in effluent water were within the acceptable range and did not seem to pose a direct threat to the recipient environment. The analysed crude protein contents of commercial CP, Quality and Saudi-Bangla prawn feeds were 31.84%, 27.21% and 28.97%, respectively, whereas all analysed farm made feeds were less than 25%. The other nutrients of prawn feeds varied largely with the source of feeds and ingredients used to prepare feed. The annual yield of prawn varied from 320.4 to 512.6 kg/ha (mean 412.3 kg/ha) depending on the management system.
Resumo:
Experiments were conducted investigating the interaction between a normal shock wave and a corner boundary layer in a constant area rectangular duct. Active corner suction and passive blowing were applied to manipulate the natural corner flows developing in the working section of the Cambridge University supersonic wind tunnel. In addition robust vane micro-vortex generators were applied to the corners of the working section. Experiments were conducted at Mach numbers of M∞=1.4 and 1.5. Flow visualisation was carried out through schlieren and surface oil flow, while static pressures were recorded via floor tappings. The results indicate that an interplay occurs between the corner flow and the centre line flow. It is believed that corner flow separation acts to induce a shock bifurcation, which in turn leads to a smearing of the adverse pressure gradient elsewhere. In addition the blockage effect from the corners was seen to result in a reacceleration of the subsonic post-shock flow. As a result manipulation of the corner regions allows a separated or attached centre line flow to be observed at the same Mach number. Copyright © 2010 by Babinsky, Burton, Bruce.
Resumo:
Kalyani lake (P sub(1)), a weed infested recreational water body and a weed chocked derelict water body (P sub(2)) in the heart of Kalyani city of West Bengal were studied for a period of one year for their primary productivity and other physicochemical parameters. Very low primary productivity (GPP=360-1237mg C m super(-2) d super(-1); NPP=157-787 mg C m super(-2) d super(-1)) was recorded in P sub(2) in spite of having a high concentration of nutrients (PO sub(4)–P=0.052-0.260mg l super(- 1); NO sub(3)-N=0.110-0.412mg l super(-1)). On the other hand, moderate primary productivity (GPP=1687-3195mg C m super(-2) d super(-1); NPP=900-2700mg C m super(-2) d super(-1)) was found in P sub(1) with comparatively low range of nutrients (P0 sub(4)-P =0.010-0.058mg l super(-1); NO sub(3)-N=0.032-0.118mg l super(-1)). After studying the other physicochemical parameters (temperature, transparency, dissolved oxygen, free carbon dioxide, pH, alkalinity and macrophytic biomass), it was found that the overall hydro-biological conditions of the weed-chocked derelict water body (P sub(2)) is not congenial for biological production as compared to Kalyani Lake (P sub(1)). Kalyani Lake may be used for fish culture with proper management practices.
Resumo:
The behaviour of metals in aquatic ecosystems is dependent on various environmental factors. Experiments were conducted in five different contact times (0.5, 2, 12, 24 and 48h) between soil sediment and mercury on Cyprinus carpio var communis. It was observed that contact time with soil sediment had significant effect in reducing the toxicity of mercury. Higher the time of contact, greater the effect. Medium hard water (150 mg/L CaC0 sub(3) of total hardness) had the highest effect as compared to other water in reducing the toxicity of mercury when combined with underlying soil sediment. With the increase in contact time, complexation and adsorption of inorganic mercury ions with the dissolved and particulate phases of water and soil sediment were increased; thereby bioaccumulation of mercury ions by scale carp was more. Applicability of the result of this experiment in natural ecosystems was also suggested.
Resumo:
This article presents a novel algorithm for learning parameters in statistical dialogue systems which are modeled as Partially Observable Markov Decision Processes (POMDPs). The three main components of a POMDP dialogue manager are a dialogue model representing dialogue state information; a policy that selects the system's responses based on the inferred state; and a reward function that specifies the desired behavior of the system. Ideally both the model parameters and the policy would be designed to maximize the cumulative reward. However, while there are many techniques available for learning the optimal policy, no good ways of learning the optimal model parameters that scale to real-world dialogue systems have been found yet. The presented algorithm, called the Natural Actor and Belief Critic (NABC), is a policy gradient method that offers a solution to this problem. Based on observed rewards, the algorithm estimates the natural gradient of the expected cumulative reward. The resulting gradient is then used to adapt both the prior distribution of the dialogue model parameters and the policy parameters. In addition, the article presents a variant of the NABC algorithm, called the Natural Belief Critic (NBC), which assumes that the policy is fixed and only the model parameters need to be estimated. The algorithms are evaluated on a spoken dialogue system in the tourist information domain. The experiments show that model parameters estimated to maximize the expected cumulative reward result in significantly improved performance compared to the baseline hand-crafted model parameters. The algorithms are also compared to optimization techniques using plain gradients and state-of-the-art random search algorithms. In all cases, the algorithms based on the natural gradient work significantly better. © 2011 ACM.
Resumo:
The Buniyar hydroelectric project and the lower Jhelum Barrier at Gantamulla constructed across river Jhelum are in operation from several years. The two power stations have changed the hydrological features of the area where dam is situated. Therefore, the impact of hydroelectric projects on fishery resources of river Jhelum is a matter of great concern. The treated water from the power house is released through turbines, having cooling effect on them. The change in the hydrological parameters such as increase in temperature, depletion of oxygen etc. might have brought fishes under stress which is the main cause in decreased population of finfishes from site to site. The golden mahseer, Tor putitora which was once an abundant species in river Jhelum has disappeared due to human intervention. The prevailing water quality around hydroelectric projects is unsuitable for finfishes of river Jhelum.
Resumo:
We introduce a new algorithm to automatically identify the time and pixel location of foot contact events in high speed video of sprinters. We use this information to autonomously synchronise and overlay multiple recorded performances to provide feedback to athletes and coaches during their training sessions. The algorithm exploits the variation in speed of different parts of the body during sprinting. We use an array of foreground accumulators to identify short-term static pixels and a temporal analysis of the associated static regions to identify foot contacts. We evaluated the technique using 13 videos of three sprinters. It successfully identifed 55 of the 56 contacts, with a mean localisation error of 1.39±1.05 pixels. Some videos were also seen to produce additional, spurious contacts. We present heuristics to help identify the true contacts. © 2011 Springer-Verlag Berlin Heidelberg.