Influence of brush type as a carrier of adhesive solutions and paper points as an adhesive-excess remover on the resin bond to root dentin

Purpose: To evaluate the influence of the brush type as a earner of priming adhesive solutions and the use of paper points as a remover of the excess of these solutions on the push-out bond strength of resin cement to bovine root dentin. The null hypotheses were that brush type and the use of paper points do not affect the bond strength. Materials and Methods: The canals of 80 single-root bovine roots (16 mm in length) were prepared at 12 mm using the preparation drill (FRC Postec Plus, Ivoclar). Half of each root was embedded in acrylic resin and the specimens were divided into 8 groups, considering the factors brush type (4 levels) and paper point (2 levels) (n = 10): Gr 1: small microbrush (Cavi-Tip, SDI); Gr 2: Microbrush (Dentsply); Gr 3: Endobrush (Bisco); Gr 4: conventional brush (Bisco); Gr 5: Cavi-Tip (SDI) + paper points; Gr 6: Microbrush (Dentsply) + paper points; Gr 7: Endobrush (Bisco) + paper points; Gr 8: conventional brush (Bisco) + paper points. The root dentin was treated with a multistep total-etch adhesive system (All Bond 2). The adhesive system was applied using each microbrush, with and without using paper points. One fiber post was molded with addition silicon and 80 posts were made of resin cement (Duolink), The resin posts were luted (Duolink resin cement), and the specimens were stored for 24 h in water at 37°C. Each specimen was cut into 4 disk-shaped samples (1.8 mm in thickness), which were submitted to the push-out test. Results: The brush type (p < 0.0001) (small microbrush > microbrush = endobrush = conventional brush) and the use of paper points (p = 0.0001) (with > without) influenced the bond strength significantly (two-way ANOVA). The null hypotheses were rejected. Conclusion: The smallest brush (Cavi-Tip) and the use of paper points significantly improved the resin bond to bovine root dentin.

Human interferon B1 ser17: Coding DNA synthesis, expression, purification and characterization of bioactive recombinant protein

A protocol to produce large amounts of bioactive homogeneous human interferon β1 expressed in Escherichia coli was developed. Human interferon β1 ser17 gene was constructed, cloned and subcloned, and the recombinant protein expressed in E. coli cells. Solubilization of recombinant human interferon β1 ser17 (rhIFN-β1 ser17) was accomplished by employing a brief shift to high alkaline pH in the presence of non-ionic detergent. The recombinant protein was purifi ed by three chromatographic steps. N-terminal amino acid sequencing and mass spectrometry analysis provided experimental evidence for the identity of the recombinant protein. Reverse phase liquid chromatography demonstrated that the content of deamidates and sulphoxides was similar to a commercial standard. Size exclusion chromatography demonstrated the absence of high molecular mass aggregates and dimers. The protocol represents an effi cient and high-yield method to obtain bioactive homogeneous monomeric rhIFN-β1 ser17 protein. It may thus represent an important step towards scaling up for rhIFN-β1 ser17 large-scale production. © 2010 Villela AD, et al.

Modeling regional macroeconomic interactions: situation and perspectives for macroeconomic coordination in Latin America. Background paper prepared for the REDIMA workshop on Modeling Macroeconomic Coordination in the Andean Community, (Santiago, Chile 22 October 2003)""

Includes bibliography

Valuing damage and losses in cultural assets after a disaster: concept paper and research options

Includes bibliography

Sustainable development from a human rights perspective and the challenges it represents for the Caribbean SIDS (a discussion paper)

Includes bibliography

Repair of bone cavities in dog's mandible filled with inorganic bovine bone and bioactive glass associated with platelet rich plasma

The aim of this study was to evaluate the effect of platelet rich plasma (PRP) associated to bovine inorganic bone (Bio-Oss®; Geistlich) or bioactive glass (Bio-Gran®; Orthovita, Implant Innovations) on bone healing. Bone cavities were prepared in both sides of the mandible of 4 adult male dogs. The cavities were divided into 4 groups according to the filling material as follows: control, PRP, PRP/Bio-Oss, PRP/Bio-Gran. The animals were sacrificed after 120 days and histological and histomorphometrical analysis was performed. The control group showed 80.6% of bone formation in the longitudinal sections at 6 mm depth and 83.7% at 13 mm depth. The transverse sections displayed 74.2% at both 6 and 13 mm depths. The PRP group showed 21.1% of bone formation in the longitudinal sections at 6 mm depth, and 23.1% at 13 mm depth. The transverse sections presented 28.98% of bone formation at 6 mm depth and 41.2% at 13 mm depth. The PRP/Bio-Gran group showed 25.1% of bone formation in the longitudinal sections at 6 mm depth and 30.4% at 13 mm depth. In the transverse sections, the bone formation was 43.0% at 6 mm depth and 39.7% at 13 mm depth. The PRP/Bio-Oss group showed 35.5% of bone formation in the longitudinal sections at 6 mm depth and 42% at 13 mm depth. In the transversal sections, the bone formation was 26.8% and 31.2% at the depths of 6 and 13 mm, respectively. PRP alone or associated with bovine inorganic bone or bioglass had no significant effect in bone healing.

Evaluating of the activity antioxidant and fatty acids profile of lychee seeds (Litchi chinensis SONN.)

Purpose: The purpose of this paper is to characterize lychee seeds regarding their centesimal composition, and also to evaluate their antioxidant potential and fatty acid profile. Design/methodology/approach: To obtain the extract, dehydrated and grinded seeds were extracted with ethyl alcohol for 30 min, at a proportion of 1:3 of seeds:ethyl alcohol, under continuous agitation, at room temperature. Afterwards, the mixture was filtered and the supernatant subjected to a rotoevaporator at 40oC aiming to determine, by direct weighing, the extract dry matter yield. Findings: The largest found values went to the total carbohydrates (72.75 percent). In the oil from the lychee seeds there was a high percentage of unsaturated fatty acids, the main component being linoleic, considered an essential fatty acid. Research limitations/implications: Implies the identification of compounds biativos extracted from seeds of tropical and subtropical fruits, and to prevent certain types of diseases. Originality/value: The article tries to identify new source of phenolic compounds extracted from fruit. © Emerald Group Publishing Limited.

The challenges of treating a fused tooth

This paper describes and discusses the multidisciplinary treatment involving a permanent maxillary lateral incisor fused to a supernumerary tooth, both presenting pulp necrosis and periapical lesion. A 15-year-old male patient sought treatment complaining of pain, swelling and mobility on the maxillary right lateral incisor. After clinical and radiographic examination, root canal preparation was performed according to the crown-down technique and a calcium hydroxide dressing was placed for 15 days. The patient returned and the definitive endodontic filling was done with thermomechanical compaction of gutta-percha and sealer. After 18 months, clinical and radiographic examinations were carried out and no pain or swelling was reported. Two years after endodontic treatment, the patient returned for periodontal and cosmetic treatments. Nine months later, a cone-beam computed tomography (CBCT) revealed that the previously detected periodontal defect and periapical lesion were persistent. Apical endodontic surgery was indicated. The supernumerary tooth was removed, the communicating distal surface was filled and the surgical site received bioactive glass and demineralized bovine organic bone. The pathological tissue was submitted to histopathological examination and the diagnosis was periapical cyst. One year after the apical endodontic surgery, CBCT showed bone formation at maxillary lateral incisor apical area. Two years after the surgery, the restoration was replaced due to aesthetic reasons and periapical radiograph showed success after 5 years of treatment. A correct diagnosis and establishment of an adequate treatment plan resulted in a successful management of the case.

Comments on the paper by professor Olof Ruin

Comenta sobre las condiciones políticas iniciales que hicieron posible la transformación de la economía y de la sociedad suecas.

Sweden and Latin America: comments on the paper by professor Olof Ruin

Señala las diferencias históricas y estructurales y llama la atención sobre las semejanzas entre el desarrollo sociopolítico de Suecia y el de América Latina.

Analysis of the bioactive surface of Ti-35Nb-7Zr alloy after alkaline treatment and solution body fluid

The purpose of this work was to evaluate the Ti-35Nb-7Zr experimental alloy after surface treatment and soaking in solution body fluid (SBF) to form bonelike apatite. The Ti-35Nb-7Zr alloy was produced from commercially pure materials (Ti, Nb and Zr) by an arc melting furnace. All ingots were submitted to sequences of heat treatment (1100 °C/2 h and water quenching), cold working by swaging procedures and heat treatment (1100 °C/2 h and water quenching). Discs with 13 mm diameter and 3 mm in thickness were cut. The samples were immersed in NaOH aqueous solution with 5 M at 60 °C for 72 h, washed with distilled water and dried at 40 °C for 24 h. After the alkaline treatment, samples were heat treated in both conditions: at 450 and 600 °C for 1 h in an electrical furnace in air. Then, they were soaking in SBF for 24 h to form an apatite layer on the surface. The surfaces were investigated by using scanning electron microscope (SEM), energy dispersive X-ray spectroscopy (EDX), infrared spectroscopy (FTIR) and contact angle measurements. The results indicate that calcium phosphate could form on surface of Ti-35Nb-7Zr experimental alloy. © Springer-Verlag Berlin Heidelberg 2013.

Bioactive substance contents and antioxidant capacity of the lipid fraction of Annona crassiflora Mart. seeds

Annona crassiflora Mart. is a typical fruit of the Brazilian cerrado, considered to be a species of economic interest, mainly for its use in cooking, which is widespread among the inhabitants of that region, and can be found in many typical local dishes, especially sweets, jellies, liqueurs, soft drinks, ice creams and juices. Thus, the objective of this study was to determine the bioactive substance contents and the antioxidant capacity of the lipid fraction of A. crassiflora Mart. seeds in the interest of better identifying the quality of this raw material from the Brazilian cerrado. After the receipt of the fruits, the seeds were removed manually and, then, the lipid fraction was obtained by cold extraction with chloroform:methanol:water (2:1:0.8, v/v/v) and analyzed for the composition of phytosterols, tocopherols, fatty acids, total carotenoids, antioxidant activity and oxidative stability index. The lipid fraction showed significant quantity of bioactive substances, especially phytosterols, tocopherols and unsaturated fatty acids, as well as significant antioxidant capacity and oxidative stability, influenced by the content of phytosterols and the composition of fatty acids present in the analyzed fraction. © 2012 Elsevier B.V.

Pulp and paper advisory group: draft resolution approved by Committee II on 25 May 1957

Incluye Bibliografía