Distribution of benthos in late Quaternary turbidite layers of sediment cores from the North-West African continental margin

The CaCO3-contents and the fractions > 40 µm have been analysed from 5 kastenloten, one piston core and two kastengreifer taken between Senegal and Cape Verde Islands. Numerous benthonic and planktonic organisms and different terrigenous components have been distinguished. The four cores off Senegal reach middle Wuerm sediments; cores GIK12329-6 and TAG72-1 reach the V-zone and core GIK12331-4 the X-zone (Eem); the two kastengreifer contain sediments of Holocene age. Correlation of the cores has been made. Holocene sedimentation rates decrease from the shallow cores (6-11 cm/1000 years) to the deep-sea (1-2 cm/1000 years). The following climatic variations could be deduced from the sediments off the Senegal: during Holocene climate was in general as today, the Senegal river transporting fine grained material to the sea. The upper Wuerm was arid with no river influence but with red dune sand transported to the continental slope. During middle Wuerm the climate was humid again. The deep-sea cores have been influenced by eolian material from arid regions during glacial and interglacial periods, indicated by relatively high "Wuestenquarz-numbers". However, during Wuerm "Wuestenquarz-numbers" are higher than during Holocene and Eem, indicating that more intensely red coloured sediment was exposed to wind activity on the continent during this period. Varying amounts of terrigenous material and CaCO3-contents indicate varying wind strengths (lower in Holocene and Eem than during Wuerm). The boundary between humid and arid Wuerm climate was at approximately 20 °N. Influence of upwelling is difficult to establish in the sediments off Senegal, because river influence, while increasing fertility also dilutes the diatoms which are typical for upwelling. High amounts of organic carbon, low plankton/benthos ratios of foraminifers and low plankton foraminifer/radiolarian ratios in Holocene sections might be interpreted as influenced by upwelling. Turbidites occur in cores 72 and 31 and at the Holocene/Pleistocene boundary of core GIK12329-6. Their composition indicates provenance from the continental shelf of the Cape Verde Islands for core 31 and the continental shelf and slope off Senegal for core TAG72-1. Volcanic material, rare in the normal pelagic sediment of core GIK12331-4 is more frequent in the turbidites.

(Table 1) Description of structures in cores at DSDP Holes 59-451, 59-448A and 59-447A

Fifteen lengths of Leg 59 cores (primarily from Hole 451 as well as from Holes 447A and 448A) exhibiting macroscopic faults were selected by Dr. R. B. Scott (Co-Chief Scientist, Leg 59) to help us initiate this petrofabric analysis. We proposed to (1) determine what dynamically useful deformation features might be associated with the faults, and (2) infer from these features as much as possible about the physical environment of the deformation (effective pressure, differential stress, temperature, and strain rate), the orientation and relatively magnitudes of the principal stresses at the time of deformation, and the degree of induration of the rocks at the time of deformation. The cores, mainly from Hole 451, had been slabbed on board ship with respect to the trace of bedding so that each cut surface contains the true bedding dip-direction. In general, the cores from Hole 451 are largely calcareous, lithic and vitric, brecciated tuffs, whereas those from Holes 447A and 448A are basalts or basalt breccias.

(Table 1) Mineralogy of veins in basalts at DSDP Hole 61-462A

Numerous veins are present in basalts recovered from Hole 462A, Leg 61 of the Deep Sea Drilling Project. Three mineral assemblages are recognized and stratigraphically controlled. These assemblages are (1) a zeolite-bearing, quartz-poor assemblage which occurs from Core 44 to the bottom of the hole and contains smectite, clinoptilolite, calcite, pyrite, ± chabazite, ± analcime, ± quartz, ± apophyllite, ± talc (?); (2) a quartz-rich, pyrite-bearing assemblage, found between Cores 19 and 29, which contains smectite, calcite, quartz, and pyrite; and (3) a quartz-rich, celadonite-bearing assemblage which occurs from Cores 14 through 17 and contains smectite, calcite, quartz, celadonite, and Fe oxide. These data are interpreted to represent two episodes of vein mineral formation with an oxidative overprint on the more recent. The first episode followed the outpourings of basaltic lavas onto the sea floor. Zeolite-bearing veins were formed at elevated temperatures under low PCO2 while the thermal gradient was high and before a cover of calcareous sediments had formed. The second mineralization episode followed injection of basalt and microdiabase sills into a thick layer of sediments, and produced all the vein minerals now occurring between Cores 14 and 29. These veins formed at lower temperature and higher PCO2 than zeolite-bearing veins. The presence of pyrite indicates a nonoxidative environment. After the initial formation of these veins, oxygenated seawater diffused through the sedimentary cover and oxidized the pyrite and smectite, forming celadonite and Fe oxides.