O emprego de técnicas de qualidade de serviço em redes sem fio aplicado à automação predial

Pós-graduação em Engenharia Elétrica - FEIS

Constrained least square pre-distortion scheme for multiuser ultra-wideband

The study proposes a constrained least square (CLS) pre-distortion scheme for multiple-input single-output (MISO) multiple access ultra-wideband (UWB) systems. In such a scheme, a simple objective function is defined, which can be efficiently solved by a gradient-based algorithm. For the performance evaluation, scenarios CM1 and CM3 of the IEEE 802.15.3a channel model are considered. Results show that the CLS algorithm has a fast convergence and a good trade-off between intersymbol interference (ISI) and multiple access interference (MAI) reduction and signal-to-noise ratio (SNR) preservation, performing better than time-reversal (TR) pre-distortion.

Comparison of multiple-input single-output single-user ultra-wideband systems with pre-distortion

This paper presents a performance analysis of a baseband multiple-input single-output ultra-wideband system over scenarios CM1 and CM3 of the IEEE 802.15.3a channel model, incorporating four different schemes of pre-distortion: time reversal, zero-forcing pre-equaliser, constrained least squares pre-equaliser, and minimum mean square error pre-equaliser. For the third case, a simple solution based on the steepest-descent (gradient) algorithm is adopted and compared with theoretical results. The channel estimations at the transmitter are assumed to be truncated and noisy. Results show that the constrained least squares algorithm has a good trade-off between intersymbol interference reduction and signal-to-noise ratio preservation, providing a performance comparable to the minimum mean square error method but with lower computational complexity. Copyright (C) 2011 John Wiley & Sons, Ltd.

Relationship Between Occlusion and Lisping in Children With Cleft Lip and Palate

Introduction: The literature suggests that individuals with history of cleft lip and palate who present with midfacial growth deficiency are at higher risk of presenting lisping. The relationship between distortions during production of linguoalveolar fricative sounds and the severity of malocclusion, however, has not been established for the population with cleft. Objective: To study the association between lisping and dental arch relationship. Methodology: Speech samples and dental arch casts were obtained from 106 children with operated unilateral cleft lip and palate (UCLP) during the stage of mixed dentition and before orthodontic treatment. Videotaped productions of the phrase/u saci saiw sedu/were rated by speech-language pathologists for the identification of lisping during [s]. Dental arch casts were rated by orthodontists using the Goslon Yardstick and the Five-Year Index to establish dental arch relationship. Results: Multiple logistic regression showed no significant association between lisping and dento-occlusal index (p = .802) and age (p = .662). Substantial interjudge agreement during auditory-perceptual ratings was found (kappa = .63). Almost perfect agreement was found between orthodontists while establishing the dental arch relationship (kappa = .81). Discussion: This study failed to reveal an association between lisping and dental arch relationship in children with operated UCLP. Multiple variables may play a role in determining occurrence of lisping, warranting further investigation.

O processo de revisão por pares: uma revisão integrativa de literatura

OBJETIVO: Avaliar as evidências disponíveis na literatura sobre o processo de revisão por pares de artigos científicos na área da saúde. MÉTODOS: Revisão integrativa de literatura, na qual foram realizadas buscas nas bases de dados da Literatura Latino-Americana e do Caribe em Ciências da Saúde, National Library of Medicine, Medical Literature Analysis and Retrieval System Online e Cumulative Index to Nursing and Allied Health Literature. Um total de 12 estudos foi analisado. RESULTADOS: Foi demonstrado que existem muitas críticas ao processo em razão de sua subjetividade, porém acredita-se na necessidade dos mesmos. CONCLUSÃO: Este processo é imprescindível para a difusão do conhecimento, sendo uma etapa essencial no julgamento de manuscritos científicos, no entanto, considera-se importante que se façam mudanças no sentido de reduzir a subjetividade para garantir credibilidade ao processo.

L’impatto degli incentivi sull’efficienza delle imprese manifatturiere

Produttività ed efficienza sono termini comunemente utilizzati per caratterizzare l’abilità di un’impresa nell’utilizzazione delle risorse, sia in ambito privato che pubblico. Entrambi i concetti sono legati da una teoria della produzione che diventa essenziale per la determinazione dei criteri base con i quali confrontare i risultati dell’attività produttiva e i fattori impiegati per ottenerli. D’altronde, le imprese scelgono di produrre e di investire sulla base delle proprie prospettive di mercato e di costi dei fattori. Quest’ultimi possono essere influenzati dalle politiche dello Stato che fornisce incentivi e sussidi allo scopo di modificare le decisioni riguardanti l’allocazione e la crescita delle imprese. In questo caso le stesse imprese possono preferire di non collocarsi nell’equilibrio produttivo ottimo, massimizzando produttività ed efficienza, per poter invece utilizzare tali incentivi. In questo caso gli stessi incentivi potrebbero distorcere quindi l’allocazione delle risorse delle imprese che sono agevolate. L’obiettivo di questo lavoro è quello di valutare attraverso metodologie parametriche e non parametriche se incentivi erogati dalla L. 488/92, la principale politica regionale in Italia nelle regioni meridionali del paese nel periodo 1995-2004, hanno avuto o meno effetti sulla produttività totale dei fattori delle imprese agevolate. Si è condotta una ricognizione rispetto ai principali lavori proposti in letteratura riguardanti la TFP e l’aiuto alle imprese attraverso incentivi al capitale e (in parte) dell’efficienza. La stima della produttività totale dei fattori richiede di specificare una funzione di produzione ponendo l’attenzione su modelli di tipo parametrico che prevedono, quindi, la specificazione di una determinata forma funzionale relativa a variabili concernenti i fattori di produzione. Da questa si è ricavata la Total Factor Productivity utilizzata nell’analisi empirica che è la misura su cui viene valutata l’efficienza produttiva delle imprese. Il campione di aziende è dato dal merge tra i dati della L.488 e i dati di bilancio della banca dati AIDA. Si è provveduto alla stima del modello e si sono approfonditi diversi modelli per la stima della TFP; infine vengono descritti metodi non parametrici (tecniche di matching basate sul propensity score) e metodi parametrici (Diff-In-Diffs) per la valutazione dell’impatto dei sussidi al capitale. Si descrive l’analisi empirica condotta. Nella prima parte sono stati illustrati i passaggi cruciali e i risultati ottenuti a partire dalla elaborazione del dataset. Nella seconda parte, invece, si è descritta la stima del modello per la TFP e confrontate metodologie parametriche e non parametriche per valutare se la politica ha influenzato o meno il livello di TFP delle imprese agevolate.

Cross-layer optimizations in multi-hop ad hoc networks

Unlike traditional wireless networks, characterized by the presence of last-mile, static and reliable infrastructures, Mobile ad Hoc Networks (MANETs) are dynamically formed by collections of mobile and static terminals that exchange data by enabling each other's communication. Supporting multi-hop communication in a MANET is a challenging research area because it requires cooperation between different protocol layers (MAC, routing, transport). In particular, MAC and routing protocols could be considered mutually cooperative protocol layers. When a route is established, the exposed and hidden terminal problems at MAC layer may decrease the end-to-end performance proportionally with the length of each route. Conversely, the contention at MAC layer may cause a routing protocol to respond by initiating new routes queries and routing table updates. Multi-hop communication may also benefit the presence of pseudo-centralized virtual infrastructures obtained by grouping nodes into clusters. Clustering structures may facilitate the spatial reuse of resources by increasing the system capacity: at the same time, the clustering hierarchy may be used to coordinate transmissions events inside the network and to support intra-cluster routing schemes. Again, MAC and clustering protocols could be considered mutually cooperative protocol layers: the clustering scheme could support MAC layer coordination among nodes, by shifting the distributed MAC paradigm towards a pseudo-centralized MAC paradigm. On the other hand, the system benefits of the clustering scheme could be emphasized by the pseudo-centralized MAC layer with the support for differentiated access priorities and controlled contention. In this thesis, we propose cross-layer solutions involving joint design of MAC, clustering and routing protocols in MANETs. As main contribution, we study and analyze the integration of MAC and clustering schemes to support multi-hop communication in large-scale ad hoc networks. A novel clustering protocol, named Availability Clustering (AC), is defined under general nodes' heterogeneity assumptions in terms of connectivity, available energy and relative mobility. On this basis, we design and analyze a distributed and adaptive MAC protocol, named Differentiated Distributed Coordination Function (DDCF), whose focus is to implement adaptive access differentiation based on the node roles, which have been assigned by the upper-layer's clustering scheme. We extensively simulate the proposed clustering scheme by showing its effectiveness in dominating the network dynamics, under some stressing mobility models and different mobility rates. Based on these results, we propose a possible application of the cross-layer MAC+Clustering scheme to support the fast propagation of alert messages in a vehicular environment. At the same time, we investigate the integration of MAC and routing protocols in large scale multi-hop ad-hoc networks. A novel multipath routing scheme is proposed, by extending the AOMDV protocol with a novel load-balancing approach to concurrently distribute the traffic among the multiple paths. We also study the composition effect of a IEEE 802.11-based enhanced MAC forwarding mechanism called Fast Forward (FF), used to reduce the effects of self-contention among frames at the MAC layer. The protocol framework is modelled and extensively simulated for a large set of metrics and scenarios. For both the schemes, the simulation results reveal the benefits of the cross-layer MAC+routing and MAC+clustering approaches over single-layer solutions.

Caracterización y modelado de prestaciones en redes inalámbricas para aplicaciones con calidad de servicio

Programa de doctorado: Tecnologías de las Telecomunicaciones (bienio 98/00). La fecha de publicación es la fecha de lectura

Enabling Blocks for Integrated CMOS UWB Transceivers

The last decades have seen an unrivaled growth and diffusion of mobile telecommunications. Several standards have been developed to this purposes, from GSM mobile phone communications to WLAN IEEE 802.11, providing different services for the the transmission of signals ranging from voice to high data rate digital communications and Digital Video Broadcasting (DVB). In this wide research and market field, this thesis focuses on Ultra Wideband (UWB) communications, an emerging technology for providing very high data rate transmissions over very short distances. In particular the presented research deals with the circuit design of enabling blocks for MB-OFDM UWB CMOS single-chip transceivers, namely the frequency synthesizer and the transmission mixer and power amplifier. First we discuss three different models for the simulation of chargepump phase-locked loops, namely the continuous time s-domain and discrete time z-domain approximations and the exact semi-analytical time-domain model. The limitations of the two approximated models are analyzed in terms of error in the computed settling time as a function of loop parameters, deriving practical conditions under which the different models are reliable for fast settling PLLs up to fourth order. Besides, a phase noise analysis method based upon the time-domain model is introduced and compared to the results obtained by means of the s-domain model. We compare the three models over the simulation of a fast switching PLL to be integrated in a frequency synthesizer for WiMedia MB-OFDM UWB systems. In the second part, the theoretical analysis is applied to the design of a 60mW 3.4 to 9.2GHz 12 Bands frequency synthesizer for MB-OFDM UWB based on two wide-band PLLs. The design is presented and discussed up to layout level. A test chip has been implemented in TSMC CMOS 90nm technology, measured data is provided. The functionality of the circuit is proved and specifications are met with state-of-the-art area occupation and power consumption. The last part of the thesis deals with the design of a transmission mixer and a power amplifier for MB-OFDM UWB band group 1. The design has been carried on up to layout level in ST Microlectronics 65nm CMOS technology. Main characteristics of the systems are the wideband behavior (1.6 GHz of bandwidth) and the constant behavior over process parameters, temperature and supply voltage thanks to the design of dedicated adaptive biasing circuits.

Progetto e valutazione di un protocollo MAC per reti wireless ad-hoc

Per dare supporto al traffico multimediale in una rete totalmente distribuita come le reti ad-hoc, il protocollo MAC deve fornire garanzie di QoS. L'IEEE ha sviluppato un standard per supportare le QoS chiamato 802.11e, facente parte della famiglia 802.11. Per dare supporto al QoS viene proposto un nuovo protocollo chiamato PAB che consiste in un accesso al canale preceduto da una serie di invii di burst, inviati alla stessa frequenza dei dati, che inibiscono la trasmissione di stazioni avente minore priorità. Lo scopo di questo protocollo è fornire servizi QoS, evitare starvation e fornire un accesso equo tra le stazioni.

Sistemi OFDM: prestazioni di livello fisico

I primi studi su Orthogonal Frequency Division Multiplexing (OFDM) sono stati fatti fin dal 1960, ma negli ultimi anni la modulazione OFDM è emersa come una tecnica di modulazione chiave commerciale per i sistemi di comunicazione ad alta velocità. La ragione principale di questo crescente interesse è dovuto alla sua capacità di fornire dati ad alta velocità impiegando sistemi con complessità bassa e contrastando l'interferenza intersimbolo (ISI) e quella intercanale (ICI). Per questo motivo la modulazione OFDM è stata adottata da diversi sistemi digitali wireline e wireless standard, come Digital Audio Broadcasting (DAB), Asymmetric Digital Subscriber Line (ADSL), Wireless Local Area Network (IEEE 802.11 a,g,n) oppure per WiMAX e LTE.