Properties of seawater (partial pressure of carbon dioxide (pCO2)) from a ProOceanus CO2-Pro sensor mounted on the continuous surface water sampling system during the Tara Oceans expedition 2009-2013

The Tara Oceans Expedition (2009-2013) sampled the world oceans on board a 36 m long schooner, collecting environmental data and organisms from viruses to planktonic metazoans for later analyses using modern sequencing and state-of-the-art imaging technologies. Tara Oceans Data are particularly suited to study the genetic, morphological and functional diversity of plankton. The present data set provides continuous measurements of partial pressure of carbon dioxide (pCO2), using a ProOceanus CO2-Pro instrument mounted on the flowthrough system. This automatic sensor is fitted with an equilibrator made of gas permeable silicone membrane and an internal detection loop with a non-dispersive infrared detector of PPSystems SBA-4 CO2 analyzer. A zero-CO2 baseline is provided for the subsequent measurements circulating the internal gas through a CO2 absorption chamber containing soda lime or Ascarite. The frequency of this automatic zero point calibration was set to be 24 hours. All data recorded during zeroing processes were discarded with the 15-minute data after each calibration. The output of CO2-Pro is the mole fraction of CO2 in the measured water and the pCO2 is obtained using the measured total pressure of the internal wet gas. The fugacity of CO2 (fCO2) in the surface seawater, whose difference with the atmospheric CO2 fugacity is proportional to the air-sea CO2 fluxes, is obtained by correcting the pCO2 for non-ideal CO2 gas concentration according to Weiss (1974). The fCO2 computed using CO2-Pro measurements was corrected to the sea surface condition by considering the temperature effect on fCO2 (Takahashi et al., 1993). The surface seawater observations that were initially estimated with a 15 seconds frequency were averaged every 5-min cycle. The performance of CO2-Pro was adjusted by comparing the sensor outputs against the thermodynamic carbonate calculation of pCO2 using the carbonic system constants of Millero et al. (2006) from the determinations of total inorganic carbon (CT ) and total alkalinity (AT ) in discrete samples collected at sea surface. AT was determined using an automated open cell potentiometric titration (Haraldsson et al. 1997). CT was determined with an automated coulometric titration (Johnson et al. 1985; 1987), using the MIDSOMMA system (Mintrop, 2005). fCO2 data are flagged according to the WOCE guidelines following Pierrot et al. (2009) identifying recommended values and questionable measurements giving additional information about the reasons of the questionability.

Growth rate and TRI5 gene expression profiles of Fusarium equiseti strains isolated from Spanish cereals cultivated on wheat and barley media at different environmental conditions

Fusarium equiseti is a toxigenic species that often contaminates ce real crops from diverse climatic regions such as Northern and Southern Europe. Previous results suggested the existence of two distinct populations within this species with differences in toxin pro file which largely corresponded to North and South Europe (Spain). In this work, growth rate profiles of 4 F. equiseti strains isolated from different cereals and distinct Spanish regions were determined on wheat and barley based media at a range of temperatures (15, 20, 25, 30, 35 and 40 °C) and water potentialregimens(−0.7,−2.8,−7.0,and −9.8MPa,correspondingto 0.99,0.98,0.95 and 0.93aw values).Growth was observed at all temperatures except at 40 °C, and at all the solute potential values except at−9.8 MPa when combined with 15 °C. Optimal growth was observed at 20– 30 °C and −0.7/−2.8 MPa. The effect of these factors on trichothecene biosynthesis was examined on a F. equiseti strain using a newly developed real time RT-PCR protocol to quantify TRI5 gene expression at 15, 25 and 35 °C and −0.7, −2.8, − 7.0 and −9.8 MPa on wheat and barley based media. Induction of TRI5 expression was detected between 25 and 35 °C and −0.7 and − 2.8 MPa, with maximum values at 35 °C and −2.8 MPa being higher in barley than in wheat medium. These results appeared to be consistent with a population well adapted to the present climatic conditions and predicted scenarios for Southern Europe and suggested some differences depending on the cereal considered. These are also discussed in relation to other Fusarium species co-occurring in cereals grown in this region and to their significance for prediction and control strategies of toxigenic risk in future scenarios of climate change for this region.

Utilization of ADR Concepts to Bridge the Gap Between the Extractive Industry and Environmental Interests: An Anticipatory Cooperative Effort (ACE)

The extractive industry, more than any other sector of the economy, often finds itself mired in conflicts with various environmental and community interests. As traditional legal avenues of resolution gave way to the collaborative ideas of alternative dispute resolution, the outcomes, especially the relational outcomes, were less than desirable. This capstone project proposes that an Anticipatory Cooperative Effort (ACE) can help to bridge the gap between industry and environmental interests by encouraging a pro-active and pre-emptive engagement. The point of the ACE concept is not that it defines a new set of principles so much as it repositions where established ADR principles are entertained.

Determinants of biological activity of nanomaterials in innate immunity cells: the role of aspect ratio, environmental contaminants and protein corona

As defined by the European Union, “ ’Nanomaterial’ (NM) means a natural, incidental or manufactured material containing particles, in an unbound state or as an aggregate or agglomerate, where, for 50 % or more of the particles in the number size distribution, one or more external dimensions is in the size range 1 nm-100 nm ” (2011/696/UE). Given their peculiar physico-chemical features, nanostructured materials are largely used in many industrial fields (e.g. cosmetics, electronics, agriculture, biomedical) and their applications have astonishingly increased in the last fifteen years. Nanostructured materials are endowed with very large specific surface area that, besides making them very useful in many industrial processes, renders them very reactive towards the biological systems and, hence, potentially endowed with significant hazard for human health. For these reasons, in recent years, many studies have been focused on the identification of toxic properties of nanostructured materials, investigating, in particular, the mechanisms behind their toxic effects as well as their determinants of toxicity. This thesis investigates two types of nanostructured TiO2 materials, TiO2 nanoparticles (NP), which are yearly produced in tonnage quantities, and TiO2 nanofibres (NF), a relatively novel nanomaterial. Moreover, several preparations of MultiWalled Carbon Nanotubes (MWCNT), another nanomaterial widely present in many products, are also investigated.- Although many in vitro and in vivo studies have characterized the toxic properties of these materials, the identification of their determinants of toxicity is still incomplete. The aim of this thesis is to identify the structural determinants of toxicity, using several in vitro models. Specific fields of investigation have been a) the role of shape and the aspect ratio in the determination of biological effects of TiO2 nanofibres of different length; b) the synergistic effect of LPS and TiO2 NP on the expression of inflammatory markers and the role played therein by TLR-4; c) the role of functionalization and agglomeration in the biological effects of MWCNT. As far as biological effects elicited by TiO2 NF are concerned, the first part of the thesis demonstrates that long TiO2 nanofibres caused frustrated phagocytosis, cytotoxicity, hemolysis, oxidative stress and epithelial barrier perturbation. All these effects were mitigated by fibre shortening through ball-milling. However, short TiO2 NF exhibited enhanced ability to activate acute pro-inflammatory effects in macrophages, an effect dependent on phagocytosis. Therefore, aspect ratio reduction mitigated toxic effects, while enhanced macrophage activation, likely rendering the NF more prone to phagocytosis. These results suggest that, under in vivo conditions, short NF will be associated with acute inflammatory reaction, but will undergo a relatively rapid clearance, while long NF, although associated with a relatively smaller acute activation of innate immunity cells, are not expected to be removed efficiently and, therefore, may be associated to chronic inflammatory responses. As far as the relationship between the effects of TiO2 NP and LPS, investigated in the second part of the thesis, are concerned, TiO2 NP markedly enhanced macrophage activation by LPS through a TLR-4-dependent intracellular pathway. The adsorption of LPS onto the surface of TiO2 NP led to the formation of a specific bio-corona, suggesting that, when bound to TiO2 NP, LPS exerts a much more powerful pro-inflammatory effect. These data suggest that the inflammatory changes observed upon exposure to TiO2 NP may be due, at least in part, to their capability to bind LPS and, possibly, other TLR agonists, thus enhancing their biological activities. Finally, the last part of the thesis demonstrates that surface functionalization of MWCNT with amino or carboxylic groups mitigates the toxic effects of MWCNT in terms of macrophage activation and capability to perturb epithelial barriers. Interestingly, surface chemistry (in particular surface charge) influenced the protein adsorption onto the MWCNT surface, allowing to the formation of different protein coronae and the tendency to form agglomerates of different size. In particular functionalization a) changed the amount and the type of proteins adsorbed to MWCNT and b) enhanced the tendency of MWCNT to form large agglomerates. These data suggest that the different biological behavior of functionalized and pristine MWCNT may be due, at least in part, to the different tendency to form large agglomerates, which is significantly influenced by their different capability to interact with proteins contained in biological fluids. All together, these data demonstrate that the interaction between physico-chemical properties of nanostructured materials and the environment (cells + biological fluids) in which these materials are present is of pivotal importance for the understanding of the biological effects of NM. In particular, bio-persistence and the capability to elicit an effective inflammatory response are attributable to the interaction between NM and macrophages. However, the interaction NM-cells is heavily influenced by the formation at the nano-bio interface of specific bio-coronae that confer a novel biological identity to the nanostructured materials, setting the basis for their specific biological activities.

The importance of environmental sustainability in public procurement of medical devices in health care sector

The aim of this thesis was to examine the role of environmental sustainability in the procurement of medical devices in health care sector. Current literature is mainly focused on other product groups and medical devices have been left without sufficient attention. Nevertheless, EU has recently developed green public procurement criteria for medical devices (EU GPP criteria for health care EEE) in order to support and offer guidelines for purchasers in hospitals. In this study, the criteria were used as a framework in order to examine the most significant environmental aspects for medical devices. The empirical research was executed in Finnish public hospitals with mixed method approach; quantitative data was collected by a survey and qualitative data was collected by interviews held for procurement specialists. The focus was on understanding the importance of environmental sustainability in the procurement of medical devices and which environmentally sustainable features would be the most significant. Of interest was also the medical device supplier view and how they could take environmental sustainability into consideration.

Local productive arrangements for biodiesel production in Brazil: Environmental assessment of small-holders integrated oleaginous crops management.

Sustainability assessments were carried out in small-holders? farms in four territories where productive arrangements have been organized for production of minor oleagi- nous crops under the Brazilian biodiesel program. The study aimed at checking local impacts of the biodiesel productive chains at the rural establishment scale, and pro- moting the environmental performance of the selected farms, henceforth proposed as sustainable management demonstration units. Assessments were carried out with the APOIA-NovoRural system, which integrates 62 objective and quantitative indicators re- lated to five sustainability dimensions: i) Landscape Ecology, ii) Environmental Quality (Atmosphere, Water and Soil), iii) Socio-cultural Values, iv) Economic Values and v) Management and Administration. The main results point out that, in general, the eco- logical dimensions of sustainability, that is, the Landscape Ecology and Atmosphere, Water, and Soil quality indicators, show adequate field conditions, seemingly not yet negatively affected by increases in chemical inputs and natural resources use predicted as important potential impacts of the agro-energy sector. The Economic Values indica- tors have been favorably influenced in the studied farms, due to a steadier demand and improved prices for the oleaginous crops. On the other hand, valuable positive conse- quences expected for favoring farmers? market insertion, such as improved Socio-cultural Values and Management & Administration indicators, are still opportunities to be ma-terialized. The Environmental Management Reports issued to the farmers, based on the presented sustainability assessment procedures, offer valuable documentation and com-munication means for consolidating the organizational influence of the local productive arrangements studied. These productive arrangements were shown to be determinant for the selection of crop associations and diversification, as well as for the provision of technical assistance and the stabilization of demand - conditions that promote value aggregation and income improvements, favoring small-holders? insertion in the market. More importantly, these locally organized productive arrangements have been shown to strongly influence the valorization of natural resources and environmental assets, which are fundamental if sustainable rural development is to take place under the emerging agro-energy scenario.

¿Cómo maximizar la utilización de recursos en el proyecto salud para el buen vivir (869) en pro de la disminución de la mortalidad infantil, por causas asociadas a EDA, IRA y Neumonía? Análisis descriptivo del proyecto salud para el buen vivir 869

Éste estudio describe la dinámica del sistema complejo emergente de la salud pública ambiental y su aplicación en el distrito capital, mediante la medición, ajuste, análisis y comparación de actividades y resultados en salud, obtenidos por el componente territorios ambientalmente saludables, en el área de mortalidad infantil asociada a EDA, IRA y neumonía, del proyecto Salud para el Buen Vivir ejecutado en el año 2013. De igual manera realiza aportes, mediante los cuales se proponen alternativas de solución que, por medio de la focalización poblacional, buscan superar las restricciones del sistema en pro del mejoramiento y el avance en la utilización de los recursos públicos de la salud ambiental.

In Situ Observation of the Thermal Decomposition of Weddelite by Heating Stage Environmental Scanning Electron Microscopy

The morphological and chemical changes occurring during the thermal decomposition of weddelite, CaC2O4·2H2O, have been followed in real time in a heating stage attached to an Environmental Scanning Electron Microscope operating at a pressure of 2 Torr, with a heating rate of 10 °C/min and an equilibration time of approximately 10 min. The dehydration step around 120 °C and the loss of CO around 425 °C do not involve changes in morphology, but changes in the composition were observed. The final reaction of CaCO3 to CaO while evolving CO2 around 600 °C involved the formation of chains of very small oxide particles pseudomorphic to the original oxalate crystals. The change in chemical composition could only be observed after cooling the sample to 350 °C because of the effects of thermal radiation.