Time-lapse pressure tomography for characterizing CO2 plume evolution in a deep saline aquifer

A time-lapse pressure tomography inversion approach is applied to characterize the CO2 plume development in a virtual deep saline aquifer. Deep CO2 injection leads to flow properties of the mixed-phase, which vary depending on the CO2 saturation. Analogous to the crossed ray paths of a seismic tomographic experiment, pressure tomography creates streamline patterns by injecting brine prior to CO2 injection or by injecting small amounts of CO2 into the two-phase (brine and CO2) system at different depths. In a first step, the introduced pressure responses at observation locations are utilized for a computationally rapid and efficient eikonal equation based inversion to reconstruct the heterogeneity of the subsurface with diffusivity (D) tomograms. Information about the plume shape can be derived by comparing D-tomograms of the aquifer at different times. In a second step, the aquifer is subdivided into two zones of constant values of hydraulic conductivity (K) and specific storage (Ss) through a clustering approach. For the CO2 plume, mixed-phase K and Ss values are estimated by minimizing the difference between calculated and “true” pressure responses using a single-phase flow simulator to reduce the computing complexity. Finally, the estimated flow property is converted to gas saturation by a single-phase proxy, which represents an integrated value of the plume. This novel approach is tested first with a doublet well configuration, and it reveals a great potential of pressure tomography based concepts for characterizing and monitoring deep aquifers, as well as the evolution of a CO2 plume. Still, field-testing will be required for better assessing the applicability of this approach.

The Decrease in Summer Surface Water Temperature with Altitude in Swiss Alpine Lakes: A Comparison with Air Temperature Lapse Rates

Using miniature thermistors with integrated data loggers, the decrease in summer lake surface water temperature (LSWT) with increasing altitude a.s.l. was investigated in 10 Swiss Alpine lakes located between 613 m a.s.l. and 2339 m a.s.l. The LSWTs exhibit essentially the same short-term structure as regional air temperature, but are about 3 to 5°C higher than the air temperature at the altitude of the lake. LSWTs decrease approximately linearly with increasing altitude at a rate slightly greater than the surface air temperature lapse rate. Diel variations in LSWT are large, implying that single water temperature measurements are un- likely to be representative of the mean. Local factors will affect LSWT more than they affect air temperature, possibly resulting in severe distortion of the empirical relationship between the two. Several implications for paleoclimate reconstruction studies result. (1) Paleolimnologically reconstructed LSWTs are likely to be higher than the air temperatures prevailing at the altitude of the lake. (2) Lakes used for paleoclimate reconstruction should be selected to minimize local effects on LSWT. (3) The calibration of organism-specific quantitative paleotemperature inference models should not be based on single water temperature measurements. (4) Consideration should be given to calibrating such models directly against air temperature rather than water temperature. (5) The primary climate effect on the aquatic biota of high-altitude lakes may be mediated by the timing of the ice cover.

Time lapse sea-bed photos (benthos) with associated current meter data from ROBIO lander deployments during Discovery cruise D297

A baited imaging lander was deployed six times in the Nazare Canyon at depths from 909 to 4361 m during August 2005 to investigate the demersal scavenging fishes. Species observed and lander-derived abundance estimates were similar to previous data from the Porcupine Seabight and abyssal plain, north-east Atlantic Ocean.

Non-conventional provisions in regional trade agreements : do they enhance international trade?

The scope of recent regional trade agreements (RTAs) is becoming much wider in terms of including several provisions such as competition policy or intellectual property. This paper empirically examines how far advanced, non-conventional provisions in RTAs increase trade values among RTA member countries, by estimating the gravity equation with more disaggregated indicators for RTAs. As a result, we find that the provision on competition policy has the largest impacts on trade values, following that on government procurement. Our further analysis reveals that the more significant roles of these two provisions can be also observed in the impacts on the intensive and extensive margins.

Environmental provisions in Japanese regional trade agreements with developing countries

With the growing interest in environmental issues in the global community, recently concluded regional trade agreements (RTAs) have introduced environmental provisions. These RTAs will help achieve sustainable development at the intersection of trade liberalization and ever-increasing environmental concerns. However, environmental provisions are not incorporated into all RTAs. For example, Japanese RTAs often incorporate environmental issues only in the preamble or relevant articles. As the first step in examining the environmental provisions in RTAs, this paper focuses on the RTAs that Japan has concluded with developing countries. The main characteristic of environmental provisions in Japanese RTAs is that there are very few relevant provisions. All Japanese RTAs has neither environmental chapters nor side agreements. However, the attitude toward the environment in Japanese RTAs has gradually changed since the signing of the Japan-Chile EPA in 2007, in which a joint environmental statement was adopted. Although Japanese RTAs have environmental provisions, environmental problems originating from the RTAs may occur. One of the possible causes is a lack of environmental impact assessment. Japanese RTAs need to incorporate an environmental impact assessment system in order to identify environmental problems resulting from its RTAs, and to enable the country to take appropriate measures at the appropriate time.

Time-Lapse Video Microscopy of Gliding Motility in Toxoplasma gondii Reveals a Novel, Biphasic Mechanism of Cell LocomotionV⃞

Toxoplasma gondii is a member of the phylum Apicomplexa, a diverse group of intracellular parasites that share a unique form of gliding motility. Gliding is substrate dependent and occurs without apparent changes in cell shape and in the absence of traditional locomotory organelles. Here, we demonstrate that gliding is characterized by three distinct forms of motility: circular gliding, upright twirling, and helical rotation. Circular gliding commences while the crescent-shaped parasite lies on its right side, from where it moves in a counterclockwise manner at a rate of ∼1.5 μm/s. Twirling occurs when the parasite rights itself vertically, remaining attached to the substrate by its posterior end and spinning clockwise. Helical gliding is similar to twirling except that it occurs while the parasite is positioned horizontally, resulting in forward movement that follows the path of a corkscrew. The parasite begins lying on its left side (where the convex side is defined as dorsal) and initiates a clockwise revolution along the long axis of the crescent-shaped body. Time-lapse video analyses indicated that helical gliding is a biphasic process. During the first 180o of the turn, the parasite moves forward one body length at a rate of ∼1–3 μm/s. In the second phase, the parasite flips onto its left side, in the process undergoing little net forward motion. All three forms of motility were disrupted by inhibitors of actin filaments (cytochalasin D) and myosin ATPase (butanedione monoxime), indicating that they rely on an actinomyosin motor in the parasite. Gliding motility likely provides the force for active penetration of the host cell and may participate in dissemination within the host and thus is of both fundamental and practical interest.

Nonlinear dynamics in discretionary accruals: An analysis of bank loan-loss provisions

Several studies have analyzed discretionary accruals to address earnings-smoothing behaviors in the banking industry. We argue that the characteristic link between accruals and earnings may be nonlinear, since both the incentives to manipulate income and the practical way to do so depend partially on the relative size of earnings. Given a sample of 15,268 US banks over the period 1996–2011, the main results in this paper suggest that, depending on the size of earnings, bank managers tend to engage in earnings-decreasing strategies when earnings are negative (“big-bath”), use earnings-increasing strategies when earnings are positive, and use provisions as a smoothing device when earnings are positive and substantial (“cookie-jar” accounting). This evidence, which cannot be explained by the earnings-smoothing hypothesis, is consistent with the compensation theory. Neglecting nonlinear patterns in the econometric modeling of these accruals may lead to misleading conclusions regarding the characteristic strategies used in earnings management.