It Had to Be You:Clarinet and Computer

World Premiere by Esther Lamneck

‘CLAM’ tests for measuring in-situ permeation properties of concrete

This paper descirbes a simple test measuring the sorptivity (a measure of the absorption property if concrete) and the air and water permeability of concrete on site. Using this test, the decay of pressure is monitired for the air permeability test.whereas water penetrating into the concrete at a constant pressure of 0.01 bar and 1.5 bar are recorded for the sorptivity and the water permeability tests respectively. These tests are essentially non-destructive in nature and a skilled operator is not needed. It is possible to carry out a number of tests quickly and efficiently on site without prior planning. It has been found that statistically satisfactory results can be obtained from a mean of three tests. As the flow lines are largely concentrated within 40 mm from the surface, reasonably reliable results can be obtained by drying the surface even if the surface under test is initially wet.

It Had to Be You Performance at NYCEMF 2014:for Clarinet and Computer

Concert 15: 3:30-5:30 PM: Playhouse

Danny Saul, Glitches/Trajectories
Ethan Greene, Lissajous
Kyong Mee Choi, Ceaseless Cease
Thomas Beverly, Ocotillo

intermission

Paul Wilson, It Had to be You
Kwangrae Kim, Sound Drawing
Steven Kemper, Mythical Spaces
David Durant, FAJI

Microstructure evolution in CLAM steel under low cycle fatigue

In the process of room-temperature low cycle fatigue, the China Low Activation Martensitic steel exhibits at the beginning cyclic hardening and then continuous cyclic softening. The grain size decreased and the martensitic lath transformed to cells/subgrains after the tests. The subgrains increase in size with increasing strain amplitude.

Low cycle fatigue properties of CLAM steel at 823 K

China Low Activation Martensitic (CLAM) steel is considered to be the main candidate material for the first wall components of future fusion reactors in China. In this paper, the low cycle fatigue (LCF) behavior of CLAM steel is studied under fully reversed tension–compression loading at 823 K in air. Total strain amplitude was controlled from 0.14% to 1.8% with a constant strain rate of 2.4×10−3 s−1. The corresponding plastic strain amplitude ranged from 0.023% to 1.613%. The CLAM steel displayed continuous softening to failure at 823 K. The relationship between strain, stress and fatigue life was obtained using the parameters obtained from fatigue tests. The LCF properties of CLAM steel at 823 K followed Coffin–Manson relationship. Furthermore, irregular serration was observed on the stress–strain hysteresis loops of CLAM steel tested with the total strain amplitude of 0.45–1.8%, which was attributed to the dynamic strain aging (DSA) effect. During continuous cyclic deformation, the microstructure and precipitate distribution of CLAM steel changed gradually. Many tempered martensitic laths were decomposed into subgrains, and the size and number of M23C6 carbide and MX carbonitride precipitates decreased with the increase of total strain amplitude. The response cyclic stress promoted the recovery of martensitic lath, while the thermal activation mainly played an important role on the growth of precipitates in CLAM steel at 823 K. In order to have a better understanding of high-temperature LCF behavior, the potential mechanisms controlling stress–strain response, DSA phenomenon and microstructure changes have also been evaluated.

Patient-reported 'ever had' and 'current' long term physical symptoms following prostate cancer treatments

OBJECTIVE: To document prostate cancer patient reported 'ever experienced' and 'current' prevalence of disease specific physical symptoms stratified by primary treatment received.
PATIENTS: 3,348 prostate cancer survivors 2-15 years post diagnosis.
METHODS: Cross-sectional, postal survey of 6,559 survivors diagnosed 2-15 years ago with primary, invasive PCa (ICD10-C61) identified via national, population based cancer registries in Northern Ireland and Republic of Ireland. Questions included symptoms at diagnosis, primary treatments and physical symptoms (impotence/urinary incontinence/bowel problems/breast changes/loss of libido/hot flashes/fatigue) experienced 'ever' and at questionnaire completion ("current"). Symptom proportions were weighted by age, country and time since diagnosis. Bonferroni corrections were applied for multiple comparisons.
RESULTS: Adjusted response rate 54%; 75% reported at least one 'current' physical symptom ('ever':90%), with 29% reporting at least three. Prevalence varied by treatment; overall 57% reported current impotence; this was highest following radical prostatectomy (RP)76% followed by external beam radiotherapy with concurrent hormone therapy (HT); 64%. Urinary incontinence (overall 'current' 16%) was highest following RP ('current'28%, 'ever'70%). While 42% of brachytherapy patients reported no 'current' symptoms; 43% reported 'current' impotence and 8% 'current' incontinence. 'Current' hot flashes (41%), breast changes (18%) and fatigue (28%) were reported more often by patients on HT.
CONCLUSION: Symptoms following prostate cancer are common, often multiple, persist long-term and vary by treatment. They represent a significant health burden. An estimated 1.6% of men over 45 is a prostate cancer survivor currently experiencing an adverse physical symptom. Recognition and treatment of physical symptoms should be prioritised in patient follow-up. This information should facilitate men and clinicians when deciding about treatment as differences in survival between radical treatments is minimal.

Evolution of microstructure and changes of mechanical properties of CLAM steel after long-term aging

The China Low Activation Martensitic (CLAM) steel has been developed as a candidate structural material for future fusion reactors. It is essential to investigate the evolution of microstructure and changes of mechanical properties of CLAM steel during thermal exposure. In this study, the long-term thermal aging of the CLAM steel has been carried out in air at 600 °C and 650 °C for 1100 h, 3000 h and 5000 h. The microstructural evolution with aging time was studied, including characteristics of the growth of M23C6 carbides and the formation of Laves-phase precipitates as well as the evolved subgrains. The microstructural evolution leads to the changes of mechanical properties of the CLAM steel. The Ductile–Brittle Transition Temperature (DBTT) increases significantly during the thermal aging, which is related to the formation of Laves-phase in the steel matrix. The possible mechanism of stabilizing microstructure during the thermal exposure has been analyzed based on the interaction between M23C6 carbides and subgrain boundaries.

Low cycle fatigue properties of CLAM steel at room temperature

The low cycle fatigue (LCF) properties and the fracture behavior of China Low Activation Martensitic (CLAM) steel have been studied over a range of total strain amplitudes from 0.2 to 2.0%. The specimens were cycled using tension-compression loading under total strain amplitude control. The CLAM steel displayed initial hardening followed by continuous softening to failure at room temperature in air. The relationship between strain and fatigue life was predicted using the parameters obtained from fatigue test. The factors effecting on low cycle fatigue of CLAM steel consisted of initial state of matrix dislocation arrangement, magnitude of cyclic stress, magnitude of total strain amplitude and microstructure. The potential mechanisms controlling the stress response, cyclic strain resistance and low cycle fatigue life have been evaluated.

Development and Progress as Historical Phenomena in Tanzania: “Maendeleo? We Had That in the Past”

Academic discussions of development continue to grow, yet critical engagements with communities affected by development interventions remain limited. Drawing from life history interviews conducted in southern Tanzania, this article details the varied experiences of development interventions among older people and how these affect broader understandings of progress. Many juxtapose their negative views of ujamaa villagization with more positive recollections of previous interventions (especially the Groundnut Scheme), which are infused with what is described here as “development nostalgia.” Perceptions of the past clearly inform the social, political, and economic aspirations forwarded today, with the richness of the constructed narratives adding further nuance to existing depictions of Tanzanian historiography.

Polycyclic aromatic hydrocarbons and oxidative stress markers in the clam Ruditapes decussatus from the Ria Formosa (Portugal)

Tese dout., Ciências e Tecnologias do Ambiente, Universidade do Algarve, 2007

Seasonal variations in gross biochemical composition, percent edibility, and condition index of the clam Ruditapes Decussatus cultivated in the Ria Formosa (South Portugal)

The grooved carpet shell clam, Ruditapes decussatus (L. 1758), is one of the most popular and profitable molluscs exploited in rearing plots in the Mediterranean. However, annual catch has been declining steadily since the early nineties. In order to understand the seasonality of its nutritional value, thus providing an improved basis for economical valuation of the resource, gross biochemical composition, percentage edibility and condition index were investigated during a year with monthly periodicity in a commercially exploited population of the clam Ruditapes decussatus in the Ria Formosa, a temperate mesotidal coastal lagoon located in the south of Portugal. Our results show that total and non-protein nitrogen co-varied during the year, resulting in a protein content that peaked in the warmest months. Although complementary in summer, carbohydrate and lipid contents showed irregular annual trends. The observed seasonality was comparable to that shown by studies elsewhere at similar latitudes, and are underpinned by the reproductive cycle of the species. Our results show the clams to be at their prime nutritional value at the beginning of summer, when protein content peaks.