Estimating the underwater shape of tuna longlines with micro-bathythermographs

An estimation method for the three-dimensional underwater shape of tuna longlines is developed, using measurements of depth obtained from micro-bathythermographs (BTs) attached to the main line at equally spaced intervals. The shape of the main line is approximated by a model which consists of a chain of unit length lines (folding-rule model), where the junction points are placed at the observed depths. Among the infinite number of possible shapes, the most likely shape is considered to be the smoothest one that can be obtained with a numerical optimization algorithm. To validate the method, a series of experimental longline operations were conducted in the equatorial region of the eastern Pacific Ocean, using 13 or 14 micro-BTs per basket of main line. Concurrent observations of oceanographic conditions (currents and temperature structure) were obtained. The shape of the main line can be calculated at arbitrary times during operations. Shapes were consistent with the current structure. On the equator, the line was elevated significantly by the Equatorial Undercurrent. It is shown that the shape of main line depends primarily upon the vertical shear and direction of the current relative to the gear. Time sequences of calculated shapes reveals that observed periodic (1-2 hours) oscillations in depth of the gear was caused by swinging movements of the main line. The shortening rate of the main line is an important parameter for formulating the shape of the longline, and its precise measurement is desirable.

Genetic and morphological differences between Sebastes vulpes and S. zonatus (Teleostei: Scorpaeniformes: Scorpaenidae)

The taxonomic status of Sebastes vulpes and S. zonatus were clarified by comprehensive genetic (amplif ied fragment length polymorphisms [AFLP] and mitochondrial DNA [mtDNA] variation) and morphological analyses on a total of 65 specimens collected from a single locality. A principal coordinate analysis based on 364 AFLP loci separated the specimens completely into two genetically distinct groups that corresponded to S. vulpes and S. zonatus according to body coloration and that indicated that they are reproductively isolated species. Significant morphological differences were also evident between the two groups; 1) separation by principal component analysis based on 31 measurements, and 2)separation according to differences in counts of gill rakers and dorsal-fin spines without basal scales, and in the frequencies of specimens with small scales on the lower jaw. Restriction of gene flow between the two groups was also indicated by the pairwise ΦST values estimated from variations in partial sequences from the mtDNA control region, although the minimum spanning network did not result in separation into distinct clades. The latter was likely due to incomplete lineage sorting between S. vulpes and S. zonatus owing to their recent speciation.

Fish assemblages associated with three types of artificial reefs: density of assemblages and possible impacts on adjacent fish abundance

We evaluated the effectiveness of wooden artificial reefs (ARs) as fish habitat. Three types of ARs, made of cedar logs, broadleaf tree logs, and PVC pipes, respectively, were deployed in triplicate at 8-m depth off Maizuru, Kyoto Prefecture, Sea of Japan, in May 2004. Fish assemblages associated with each of the nine ARs were observed by using SCUBA twice a month for four years. Fish assemblages in the adjacent habitat were also monitored for two years before and four years after reef deployment. In the surveyed areas (ca. 10 m2) associated with each of the cedar, broadleaf, and PVC ARs, the average number of fish species was 4.14, 3.49, and 3.00, and the average number of individuals was 40.7, 27.9, and 20.3, respectively. The estimated biomass was also more greater when associated with the cedar ARs than with other ARs. Visual censuses of the habitat adjacent to the ARs revealed that the number of fish species and the density of individuals were not affected by the deployment of the ARs. Our results support the superiority of cedar as an AR material and indicate that deployment of wooden ARs causes no reduction of fish abundance in adjacent natural reefs.

TOPS (Task optimization in the presence of signal-dependent noise) model

This paper proposes a movement trajectory planning model, which is a maximum task achievement model in which signal-dependent noise is added to the movement command. In the proposed model, two optimization criteria are combined, maximum task achievement and minimum energy consumption. The proposed model has the feature that the end-point boundary conditions for position, velocity, and acceleration need not be prespecified. Consequently, the method can be applied not only to the simple point-to-point movement, but to any task. In the method in this paper, the hand trajectory is derived by a psychophysical experiment and a numerical experiment for the case in which the target is not stationary, but is a moving region. It is shown that the trajectory predicted from the minimum jerk model or the minimum torque change model differs considerably from the results of the psychophysical experiment. But the trajectory predicted from the maximum task achievement model shows good qualitative agreement with the hand trajectory obtained from the psychophysical experiment. © 2004 Wiley Periodicals, Inc.

Phase behavior of rare earth manganites

Among complex oxides containing rare earth and manganese BaLn(2)Mn(2)O(7)( Ln = rare earth) with the layered perovskite type and Ln(2)(Mn, M)O-7 with pyrochlore-related structure were studied since these compounds show many kinds of phases and unique phase transitions. In BaLn(2)Mn(2)O(7) there appear many phases, depending on the synthetic conditions for each rare earth. The tetragonal phase of so-called Ruddlesden-Popper type is the fundamental structure and many kinds of deformed modification of this structure are obtained. For BaEu2Mn2O7 at least five phases have been identified from the results of X-ray diffraction analysis with the space group P4(2)/mnm, Fmmm, Immm and A2/m in addition to the fundamental tetragonal I4/mmm phase. In the pyrochlore-related type compounds, Ln(2)Mn(2-x)M(x)O(7)(M = Ta, Nb, W etc), there also appear several phases With different crystal structures. With regard to every rare earth, Ln(2)MnTaO(7) phase is stable only for excess Ta and can be obtained under high oxygen partial pressure process. This group has trigonal structure with zirkelite type ( P3(1)21 space group).

Temperature influence on the spawning performance of artificially-matured Japanese eel, Anguilla japonica, in captivity

We studied the influence of temperature on the spawning performance of artificially matured Japanese eels, Anguilla japonica, in captivity. We used routine hormone injections to bring females and males to maturity in separate aquaria. We recorded the behavior of three pairs of such hormone-treated matured eels in an aquarium (2 replicates) at four temperatures: 14, 18, 22, and 27 degrees C, respectively. They became active and frequently left the bottom swimming in the water column, and spawning events occurred. Females released eggs in the water column around the activity peaks. Males preceded females in reaching activity peaks (presumably the timing of sperm ejection and egg release), possibly resulting in the low fertilization we observed in this experiment. Males and females returned back to the aquarium bottoms and became quiet after spawning. On several occasions, male-female or female-female pairs were observed to 'cruise together' in the water column for several to tens of seconds prior to egg releasing, but no courtship behavior indicative of spawning such as pairing and chasing was observed in the eels in our study. Our results suggest that 18-22 degrees C might be the thermal preference for spawning for Japanese eels, which approximates the temperature range of the 500 m deep water layer around the Mariana Islands seamount area, the presumed spawning site for the Japanese eel.

A uniform, quality controlled Surface Ocean CO2 Atlas (SOCAT)

A well documented, publicly available, global data set of surface ocean carbon dioxide (CO2) parameters has been called for by international groups for nearly two decades. The Surface Ocean CO2 Atlas (SOCAT) project was initiated by the international marine carbon science community in 2007 with the aim of providing a comprehensive, publicly available, regularly updated, global data set of marine surface CO2, which had been subject to quality control (QC). Many additional CO2 data, not yet made public via the Carbon Dioxide Information Analysis Center (CDIAC), were retrieved from data originators, public websites and other data centres. All data were put in a uniform format following a strict protocol. Quality control was carried out according to clearly defined criteria. Regional specialists performed the quality control, using state-of-the-art web-based tools, specially developed for accomplishing this global team effort. SOCAT version 1.5 was made public in September 2011 and holds 6.3 million quality controlled surface CO2 data points from the global oceans and coastal seas, spanning four decades (1968–2007). Three types of data products are available: individual cruise files, a merged complete data set and gridded products. With the rapid expansion of marine CO2 data collection and the importance of quantifying net global oceanic CO2 uptake and its changes, sustained data synthesis and data access are priorities.

A uniform, quality controlled Surface Ocean CO2 Atlas (SOCAT)

A well-documented, publicly available, global data set of surface ocean carbon dioxide (CO2) parameters has been called for by international groups for nearly two decades. The Surface Ocean CO2 Atlas (SOCAT) project was initiated by the international marine carbon science community in 2007 with the aim of providing a comprehensive, publicly available, regularly updated, global data set of marine surface CO2, which had been subject to quality control (QC). Many additional CO2 data, not yet made public via the Carbon Dioxide Information Analysis Center (CDIAC), were retrieved from data originators, public websites and other data centres. All data were put in a uniform format following a strict protocol. Quality control was carried out according to clearly defined criteria. Regional specialists performed the quality control, using state-of-the-art web-based tools, specially developed for accomplishing this global team effort. SOCAT version 1.5 was made public in September 2011 and holds 6.3 million quality controlled surface CO2 data points from the global oceans and coastal seas, spanning four decades (1968–2007). Three types of data products are available: individual cruise files, a merged complete data set and gridded products. With the rapid expansion of marine CO2 data collection and the importance of quantifying net global oceanic CO2 uptake and its changes, sustained data synthesis and data access are priorities.

Surface Ocean CO2 Atlas (SOCAT) gridded data products

As a response to public demand for a well-documented, quality controlled, publically available, global surface ocean carbon dioxide (CO2) data set, the international marine carbon science community developed the Surface Ocean CO2 Atlas (SOCAT). The first SOCAT product is a collection of 6.3 million quality controlled surface CO2 data from the global oceans and coastal seas, spanning four decades (1968–2007). The SOCAT gridded data presented here is the second data product to come from the SOCAT project. Recognizing that some groups may have trouble working with millions of measurements, the SOCAT gridded product was generated to provide a robust, regularly spaced CO2 fugacity (fCO2) product with minimal spatial and temporal interpolation, which should be easier to work with for many applications. Gridded SOCAT is rich with information that has not been fully explored yet (e.g., regional differences in the seasonal cycles), but also contains biases and limitations that the user needs to recognize and address (e.g., local influences on values in some coastal regions).

Form Follows Media::What is The Matrix as Film, Animation, Game and Comics?

In the digital age, the hyperspace of virtual reality systems stands out as a new spatial notion creating a parallel world to the space we live in. In this alternative realm, the body transforms into a hyperbody, and begins to follow the white rabbit. Not only in real world but also in the Matrix world. The Matrix project of Andy and Larry Wachowski started with a feature film released in 1999. However, The Matrix is not only a film (trilogy). It is a concept, a universe that brings real space and hyperspace together. It is a world represented not only in science fiction films but also in The Animatrix that includes nine animated Matrix films directed by Peter Chung, Andy Jones, Yoshiaki Kawajiri and others, four of which are written by the Wachowskis. The same universe is used in Enter the Matrix, a digital game whose script was written and directed by the brothers and a comic book, The Matrix Comics, which includes twelve different stories by artists like Neil Gaiman and Goef Darrow. The Wachowskis played an active role in the creation and realization of all these “products” of different media. The comic book came last (November 2003), however it is possible to argue that everything came out of comics – the storyboards of the original film. After all the Wachowskis have a background in comics.

In this study, I will focus on the formal analysis of the science fiction world of The Matrix - as a representation of hyperspace - in different media, feature film, animated film, digital game and comic book, focusing on diverse forms of space that come into being as a result of medium differences. To unfold the different formal characters of film, animation, game and comics, concepts and features including framing, flattening, continuity, movement, montage, sound/text, light and color will be discussed. An analysis of these products will help to open up a discussion on the relation of form, media and representation.