Analysis of amorphous indium-gallium-zinc-oxide thin-film transistor contact metal using Pilling-Bedworth theory and a variable capacitance diode model

It is widely reported that threshold voltage and on-state current of amorphous indium-gallium-zinc-oxide bottom-gate thin-film transistors are strongly influenced by the choice of source/drain contact metal. Electrical characterisation of thin-film transistors indicates that the electrical properties depend on the type and thickness of the metal(s) used. Electron transport mechanisms and possibilities for control of the defect state density are discussed. Pilling-Bedworth theory for metal oxidation explains the interaction between contact metal and amorphous indium-gallium-zinc-oxide, which leads to significant trap formation. Charge trapping within these states leads to variable capacitance diode-like behavior and is shown to explain the thin-film transistor operation. © 2013 AIP Publishing LLC.

Z-scan theory based on a diffraction model

Based on Fresnel-Mrchhoff diffraction theory, a diffraction model of nonlinear optical media interacting with a Gaussian beam has been set up that can interpret the Z-scan phenomenon in a new way. This theory not only is consistent with the conventional Z-scan theory for a small nonlinear phase shift but also can be used for larger nonlinear phase shifts. Numerical computations indicate that the shape of the Z-scan curve is greatly affected by the value of the nonlinear phase shift. The symmetric dispersionlike Z-scan curve is valid only for small nonlinear p base shifts (\Deltaphi(0)\ < pi), but, with increasingly larger nonlinear phase shifts, the valley of the transmittance is severely suppressed and the peak is greatly enhanced. The power output through the aperture will oscillate with increasing nonlinear phase shift caused by the input laser power. The aperture transmittance will attenuate and saturate with increasing Kerr constant. (C) 2003 Optical Society of America.

Biomimetic (topological) pattern recognition - A new model of pattern recognition theory and its application

A new theoretical model of Pattern Recognition principles was proposed, which is based on "matter cognition" instead of "matter classification" in traditional statistical Pattern Recognition. This new model is closer to the function of human being, rather than traditional statistical Pattern Recognition using "optimal separating" as its main principle. So the new model of Pattern Recognition is called the Biomimetic Pattern Recognition (BPR)(1). Its mathematical basis is placed on topological analysis of the sample set in the high dimensional feature space. Therefore, it is also called the Topological Pattern Recognition (TPR). The fundamental idea of this model is based on the fact of the continuity in the feature space of any one of the certain kinds of samples. We experimented with the Biomimetic Pattern Recognition (BPR) by using artificial neural networks, which act through covering the high dimensional geometrical distribution of the sample set in the feature space. Onmidirectionally cognitive tests were done on various kinds of animal and vehicle models of rather similar shapes. For the total 8800 tests, the correct recognition rate is 99.87%. The rejection rate is 0.13% and on the condition of zero error rates, the correct rate of BPR was much better than that of RBF-SVM.

Strain gradient theory based on a new framework of non-local model

A new framework of non-local model for the strain energy density is proposed in this paper. The global strain energy density of the representative volume element is treated as a non-local variable and can be obtained through a special integral of the local strain energy density. The local strain energy density is assumed to be dependent on both the strain and the rotation-gradient. As a result of the non-local model, a new strain gradient theory is derived directly, in which the first and second strain gradients, as well as the triadic and tetradic stress, are introduced in the context of work conjugate. For power law hardening materials, size effects in thin metallic wire torsion and ultra-thin cantilever beam bend are investigated. It is found that the result predicted by the theoretical model is well consistent with the experimental data for the thin wire torsion. On the other hand, the calculation result for the micro-cantilever beam bend clearly shows the size effect.

A ionization theory based on united and separated atom model

The direct Coulomb ionization process can be generally well described by the ECPSSR theory, which bases on the perturbed-stationary- state(PSS) and accounts for the energy-loss, Coulomb-deflection, and relativistic effects. But the ECPSSR calculation has significant deviations for heavy projectile at low impinging energies. In this paper we propose a new modified ECPSSR theory, i.e. MECUSAR, in which PSS is replaced by an united and separated atom model, and molecule-orbit effect is considered. The MECUSAR calculations give better agreement with the experimental data at lower impinging energies, and agree with the ECPSSR calculations at high energies. By using OBKN (Oppenheimer-Brinkman-Kramers formulas of Nikolaev) theory to describe the contribution of the electron capture, we further modified the proposed MECUSAR theory, and calculated the target ionization cross sections for different charge states of the projectile.

BRST invariant theory of a generalized 1+1 Dimensional nonlinear sigma model with topological term

We give a generalized Lagrangian density of 1 + 1 Dimensional O( 3) nonlinear sigma model with subsidiary constraints, different Lagrange multiplier fields and topological term, find a lost intrinsic constraint condition, convert the subsidiary constraints into inner constraints in the nonlinear sigma model, give the example of not introducing the lost constraint. N = 0, by comparing the example with the case of introducing the lost constraint, we obtain that when not introducing the lost constraint, one has to obtain a lot of various non-intrinsic constraints. We further deduce the gauge generator, give general BRST transformation of the model under the general conditions. It is discovered that there exists a gauge parameter beta originating from the freedom degree of BRST transformation in a general O( 3) nonlinear sigma model, and we gain the general commutation relations of ghost field.

多分量对偶超导理论和口袋模型；Multi-component Dual Superconductor Theory and Bag Model

基于联络新参数化方案研究了多分量对偶超导模型。给出了多分量Ginzburg-Landau模型中的自对偶解,并研究了磁通量子数趋于无穷大时的墙涡旋解,以及与口袋模型之间的联系。

Deformation Monitoring and Forecasting Model Study Based on Grey System Theory

The grey system theory studies the uncertainty of small sample size problems. This paper using grey system theory in the deformation monitoring field, based on analysis of present grey forecast models, developed the spatial multi-point model. By using residual modification, the spatial multi-point residual model eras developed in further study. Then, combined with the sedimentation data of Xiaolangdi Multipurpose Dam, the results are compared and analyzed, the conclusion has been made and the advantages of the residual spatial multi-point model has been proved.

Application of the Sanchez-Lacombe lattice fluid theory to the system pvme/ps and model calculations

Cloud point curves reported in the literature for five representatives of the system poly(vinyl methyl ether)/polystyrene were evaluated theoretically by means of the Sanchez-Lacombe lattice fluid theory. The measured phase separation behavior can be described within experimental error using only one adjustable parameter (quantifying the interaction between the unlike mers). The Flory-Huggins interaction parameters calculated from this theoretical description depend in good approximation linearly on composition (volume fractions) and on the inverse temperature. An evaluation of these data yields a maximum heat effect which is almost one order of magnitude less (ca. -0.25 J/cm(3)) than obtained via Hess's cycle (dissolution of the components and of the blend) from calorimetric measurements. Model calculations on the basis of the present theory demonstrate that the critical points shift to a different extent upon a certain relative change in the molar mass of the blend components. The sensitivity of the calculated phase diagrams against changes in the scaling parameter decreases in the following order: interaction energies between unlike mers, differences in the scaling temperatures, pressures and densities.

A Statistical Model for Shadowed Body Centric Communications Channels: Theory and Validation

This paper presents a new statistical signal reception model for shadowed body-centric communications channels. In this model, the potential clustering of multipath components is considered alongside the presence of elective dominant signal components. As typically occurs in body-centric communications channels, the dominant or line-of-sight (LOS) components are shadowed by body matter situated in the path trajectory. This situation may be further exacerbated due to physiological and biomechanical movements of the body. In the proposed model, the resultant dominant component which is formed by the phasor addition of these leading contributions is assumed to follow a lognormal distribution. A wide range of measured and simulated shadowed body-centric channels considering on-body, off-body and body-to-body communications are used to validate the model. During the course of the validation experiments, it was found that, even for environments devoid of multipath or specular reflections generated by the local surroundings, a noticeable resultant dominant component can still exist in body-centric channels where the user's body shadows the direct LOS signal path between the transmitter and the receiver.

Finite element modelling of FRP-to-concrete bond behaviour using the concrete damage plasticity theory combined with a plastic degradation model

The technique of externally bonding fibre reinforced polymer (FRP) composites has been becoming popular worldwide for retrofitting existing reinforced concrete (RC) structures. A major failure mode in such strengthened structures is the debonding of FRP from the concrete substrate. The bond behaviour between FRP and concrete thus plays a crucial role in these structures. The FRP-to-concrete bond behaviour has been extensively investigated experimentally, commonly using the pull-off test of FRP-to-concrete bonded joint. Comparatively, much less research has been concerned with the numerical simulation of this bond behaviour, chiefly due to difficulties in accurately modelling the complex behaviour of concrete. This paper proposes a robust finite element (FE) model for simulating the bond behaviour in the entire loading process in the pull-off test. A concrete damage plasticity model based on the plastic degradation theory is proposed to overcome the weakness of the elastic degradation theory which has been commonly adopted in previous studies. The model produces results in very close agreement with test data. © Tsinghua University Press, Beijing and Springer-Verlag Berlin Heidelberg 2011.

Examining sport commitment and intentions to participate in intramural sports : application of the Sport Commitment Model and the Theory of Planned Behaviour in a campus recreational sport setting

Fifty-six percent of Canadians, 20 years of age and older, are inactive (Canadian Community Health Survey, 200012001). Research has indicated that one of the most dramatic declines in population physical activity occurs between adolescence and young adulthood (Melina, 2001; Stephens, Jacobs, & White, 1985), a time when individuals this age are entering or attending college or university. Colleges and universities have generally been seen as environments where physical activity and sport can be promoted and accommodated as a result of the available resources and facilities (Archer, Probert, & Gagne, 1987; Suminski, Petosa, Utter, & Zhang, 2002). Intramural sports, one of the most common campus recreational sports options available for post-secondary students, enable students to participate in activities that are suited for different levels of ability and interest (Lewis, Jones, Lamke, & Dunn, 1998). While intramural sports can positively affect the physical activity levels and sport participation rates of post-secondary students, their true value lies in their ability to encourage sport participation after school ends and during the post-school lives of graduates (Forrester, Ross, Geary, & Hall, 2007). This study used the Sport Commitment Model (Scanlan et aI., 1993a) and the Theory of Planned Behaviour (Ajzen, 1991) with post secondary intramural volleyball participants in an effort to examine students' commitment to intramural sport and 1 intentions to participate in intramural sports. More specifically, the research objectives of this study were to: (1.) test the Sport Commitment Model with a sample of postsecondary intramural sport participants(2.) determine the utility of the sixth construct, social support, in explaining the sport commitment of post-secondary intramural sport participants; (3.) determine if there are any significant differences in the six constructs of IV the SCM and sport commitment between: gender, level of competition (competitive A vs. B), and number of different intramural sports played; (4.) determine if there are any significant differences between sport commitment levels and constructs from the Theory of Planned Behaviour (attitudes, subjective norms, perceived behavioural control, and intentions); (5.) determine the relationship between sport commitment and intention to continue participation in intramural volleyball, continue participating in intramurals and continuing participating in sport and physical activity after graduation; and (6.) determine if the level of sport commitment changes the relationship between the constructs from the Theory of Planned Behaviour. Of the 318 surveys distributed, there were 302 partiCipants who completed a usable survey from the sample of post-secondary intramural sport participants. There was a fairly even split of males and females; the average age of the students was twenty-one; 90% were undergraduate students; for approximately 25% of the students, volleyball was the only intramural sport they participated in at Brock and most were part of the volleyball competitive B division. Based on the post-secondary students responses, there are indications of intent to continue participation in sport and physical activity. The participation of the students is predominantly influenced by subjective norms, high sport commitment, and high sport enjoyment. This implies students expect, intend and want to 1 participate in intramurals in the future, they are very dedicated to playing on an intramural team and would be willing to do a lot to keep playing and students want to participate when they perceive their pursuits as enjoyable and fun, and it makes them happy. These are key areas that should be targeted and pursued by sport practitioners.