侵蚀细沟水力学特性及细沟侵蚀与形态特征的试验研究

本文进行了一系列水槽试验 ,研究不同长度的侵蚀细沟在坡度及入流量影响下的浅水水流水力学特性、侵蚀量及细沟的形态特征 .所采用的土壤材料为砂壤土 ,试验使用四种入流流量 ,四种坡度 ,四种细沟长度 .记录水流速度、沟宽及径流中的泥沙含量 ,并用多元回归方法分析了它们与坡度、入流量或它们的交互项之间的关系 .提出了一种数学模型来描述试验中沟宽的周期性形态变化 .提出了通过试验得出的不同细沟长度的产沙量来确定水流输沙能力的方法 ,并得出出测定输沙能力的采样长度为 2～ 4m ,通过对细沟形态变化分析进一步说明了所确定的水流输沙能力采样长度的正确性

细沟侵蚀过程与细沟水流水力学参数的关系研究

利用供沙土槽和试验土槽的双土槽径流小区 ,定量研究了在不同降雨强度下上方来水来沙对陡坡地细沟侵蚀产沙过程和细沟水流水力学参数的影响及其细沟水流水力学特征参数与细沟侵蚀产沙量的关系。结果表明 :坡面细沟侵蚀过程以侵蚀—搬运过程为主 ,坡上方来沙不仅被径流全部搬运 ,且上方来水在坡下方引起了另外的侵蚀产沙量 ,其值随上方来水含沙量的减少和降雨强度的增加而增大。上方来水的汇入或降雨强度的增大可使细沟水流流态由层流转化为紊流。上方来水对细沟水流水力学参数 (流速、水力半径、雷诺数、弗劳德数和阻力系数 )有重要影响。定量分析了细沟水流水力学特征参数 (流速、雷诺数和阻力系数 )与上坡来水引起坡下方净侵蚀产沙量的关系 ,建立了净侵蚀产沙量与细沟水流流速、雷诺数和阻力系数统计模型。

PCM控制的新型气液位置伺服系统的研究

本文提出了一种新型气液缸和气液位置伺服系统。该系统采用气液连动控制，充分发挥液压与气动各自的优点，大大提高了位置控制精度，同时克服单纯气动的特点。在气液回路上，利用两位三通阀、“ＰＣＭ”阀组及油开关阈实现分区控制和准确定位，解决了快速性和定位精度之间的矛盾，通过分析和实验研究表明，此方案是可行的。

溶蚀岩体渗透水力学特性研究

Seepage control in karstic rock masses is one of the most important problems in domestic hydroelectric engineering and mining engineering as well as traffic engineering. At present permeability assessment and leakage analysis of multi-layer karstic rock masses are mainly qualitative, while seldom quantitative. Quantitative analyses of the permeability coefficient and seepage amount are conducted in this report, which will provide a theoretical basis for the study of seepage law and seepage control treatment of karstic rocks. Based on the field measurements in the horizontal grouting galleries of seepage control curtains on the left bank of the Shuibuya Hydropower Project on the Qingjiang river, a hydraulic model is established in this report, and the computation results will provide a scientific basis for optimization of grouting curtain engineering. Following issues are addressed in the report. (1) Based on the in-situ measurements of fissures and karstic cavities in grouting galleries, the characteristics of karstic rock mass is analyzed, and a stochastic structural model of karstic rock masses is set up, which will provide the basis for calculation of the permeability and leakage amount of karstic rock mass. (2) According to the distribution of the measured joints in the grouting galleries and the stochastic results obtained from the stochastic structural model of karstic rock mass between grouting galleries, a formula for computation of permeability tensor of fracturing system is set up, and a computation program is made with Visual Basic language. The computation results will be helpful for zoning of fissured rock masses and calculation of seepage amount as well as optimization of seepage control curtains. (3) Fractal theory is used to describe quantitatively the roughness of conduit walls of karstic systems and the sinuosity of karstic conduits. It is proposed that the roughness coefficient of kastic caves can be expressed by both fractal dimension Ds and Dr that represent respectively the extension sinuosity of karstic caves and the roughness of the conduit walls. The existing formula for calculating the seepage amount of karstic conduits is revised and programmed. The seepage amount of rock masses in the measured grouting galleries is estimated under the condition that no seepage control measures are taken before reservoir impoundment, and the results will be helpful for design and construction optimization of seepage curtains of the Shuibuya hydropower project. This report is one part of the subject "Karstic hydrogeology and the structural model and seepage hydraulics of karstic rock masses", a sub-program of "Study on seepage hydraulics of multi-layer karstic rock masses and its application in seepage control curtain engineering", which is financially supported by the Hubei Provincial key science and technology programme.

Predicting axial velocity profiles within a diffusing marine propeller jet

A full understanding of the hydrodynamic processes within the jet produced by a manoeuvring ship’s propeller is essential in the development and maintenance of ports, docks and harbours. In this study the predominant axial velocity component of a diffusing propeller jet was studied. The flow fields formed by four propellers, each operating at four power levels (speeds of rotation), were investigated under bollard pull conditions within a large free surface tank using Laser Doppler Anemometry. Comparison were made to existing methodologies by which a prediction of the magnitudes of the axial velocity can be made, and where deficient modifications to the methodologies have been developed. The jets were found to produce a maximum axial velocity along the initial efflux plane at a location near the blade mid-span. The position and magnitude of the axial velocity was seen to decrease as the jet entrained more flow and transitioned from the zone of flow establishment into the zone of established flow.

Hydrodynamic and sediment fluxes through the inlets of the Ria Formosa

Tese de dout., Ciências do Mar, da Terra e do Ambiente (Ciências do Mar-Oceanografia Física), Faculdade de Ciências e Tecnologia, Univ. do Algarve, 2011

Spatial variability of macroinvertebrate assemblages and the influence of hydrological and environmental variables along the Sigi River, Tanzania-East Africa

The study of investigating the spatial and temporal variability of macroinvertebrate and their relation to hydrology, hydraulic and environmental factors was done along the Sigi River during two sampling periods in the dry (March) and wet (May) periods of 2012. The river was demarcated based on slope ranges and five river zones were identified as mountains streams (MS), upper foothills (UF), lower foothills (LF), rejuvenated foothills (REJ) and mature lower river (MR). Samples of macroinvertebrate were collected from the five river zones and measurements of hydrological (discharge), hydraulics (Depth, velocity and Froude number) and Environmental (pH, Temperature, substrate, conductivity) parameters were done in each zone. In characterizing the macroinvertebrate assemblages along the Sigi River diversity indices (number of taxa, total abundances, Margalef richness index and ShannonWiener index) were calculated and the most representative species for the spatial and temporal variation were identified. Melanoides and Afronurous showed differences in abundance in two samplings periods while Cleopatra, Potamonautes, Ephemerythus, Neoperla, Caenis, Ceratogomphus and Cheumatopsyche showed significant difference among the river zones. Spearman rank correlation and Distance Linear Model (DistLM) used to revealed physical factors governing the macroinvertebrate assemblages distribution. The study demonstrated that the variation of physical factors like discharge, temperature, conductivity and pH have an important role in the spatial distribution of macroinvertebrate assemblages along the river and the life cycle of macroinvertebrate (Afronurus) is important in determining the temporal variability.

Quantifying Submerged Fluvial Topography Using Hyperspatial Resolution UAS Imagery and Structure From Motion Photogrammetry.

Quantifying the topography of rivers and their associated bedforms has been a fundamental concern of fluvial geomorphology for decades. Such data, acquired at high temporal and spatial resolutions, are increasingly in demand for process-oriented investigations of flow hydraulics, sediment dynamics and in-stream habitat. In these riverine environments, the most challenging region for topographic measurement is the wetted, submerged channel. Generally, dry bed topography and submerged bathymetry are measured using different methods and technology. This adds to the costs, logistical challenges and data processing requirements of comprehensive river surveys. However, some technologies are capable of measuring the submerged topography. Through-water photogrammetry and bathymetric LiDAR are capable of reasonably accurate measurements of channel beds in clear water. Whilst the cost of bathymetric LiDAR remains high and its resolution relatively coarse, the recent developments in photogrammetry using Structure from Motion (SfM) algorithms promise a fundamental shift in the accessibility of topographic data for a wide range of settings. Here we present results demonstrating the potential of so called SfM-photogrammetry for quantifying both exposed and submerged fluvial topography at the mesohabitat scale. We show that imagery acquired from a rotary-winged Unmanned Aerial System (UAS) can be processed in order to produce digital elevation models (DEMs) with hyperspatial resolutions (c. 0.02 m) for two different river systems over channel lengths of 50-100 m. Errors in submerged areas range from 0.016 m to 0.089 m, which can be reduced to between 0.008 m and 0.053 m with the application of a simple refraction correction. This work therefore demonstrates the potential of UAS platforms and SfM-photogrammetry as a single technique for surveying fluvial topography at the mesoscale (defined as lengths of channel from c.10 m to a few hundred metres). This article is protected by copyright. All rights reserved.

Law, technology and water conflicts in developing societies: a case study of tank systems in Tamil Nadu

The study examines the relationship between law, technology and water conflicts from colonial days to the present in traditional (water) tank systems in the south Indian state of Tamil Nadu. Tanks are man-made water systems developed for irrigation and many other purposes in semi-arid areas. The thesis adopts a historical approach to study the development of law, particularly property rights, and takes an empirical approach to investigate the tank conflicts. Archival documents on irrigation development, Case laws, Focus Group Discussions, Open ended Interviews and Field visits to selected tank chains are used as source material for the discussion. Case studies of conflicts are described and analyzed at three levels - Vaigai river basin for a macro level, Kothai Anicut system in Cauvery basin for a meso level, and twenty other interconnected tanks for a micro-level. The thesis deviates from the conventional understanding that tanks as traditional systems as simple and local technologies but considers them to be complex. It argues that the use of commonly held systems such as tanks within the colonial and post colonial laws as state ownership has been the source of many conflicts. In particular, it finds most tank conflicts are a product of progressive and absolute state control over water and the systems established using colonial land revenue administrative law. The law continues to treat tanks as pieces of landed property held by state and the individuals rather than as technology systems that presupposed the regime of property rights introduced after the colonial times. The modern interventions in water including the reservoir building, and altering the hydraulics of rivers and streams aggravate tank conflicts and lead to their further detriment. The study brings the focus to ground realities, and offers new perspectives on understanding tank systems in dynamic ways.

Coletores de distribuição e sua otimização hidráulica, aplicados a uma instalação de produção de água arrefecida em sistemas de AVAC ( Fórum Picoas)

Trabalho Final de Mestrado para obtenção do grau de Mestre em Engenharia Mecânica

Redes de rega de campos de golfe

Trabalho Final de Mestrado para obtenção do grau de Mestre em Engenharia Mecânica

Acompanhamento da III fase do aterro sanitário da Meia Serra

Trabalho Final de Mestrado para obtenção do grau de Mestre em Engenharia Civil na Área de Especialização de Hidráulica

Dimensionamento de redes hidráulicas prediais

Relatório de Estágio para obtenção do grau de Mestre em Engenharia na Área de Especializção em Edificações