Assessment of quality defects in macadamia kernels using NIR spectroscopy

Spectral data were collected of intact and ground kernels using 3 instruments (using Si-PbS, Si, and InGaAs detectors), operating over different areas of the spectrum (between 400 and 2500 nm) and employing transmittance, interactance, and reflectance sample presentation strategies. Kernels were assessed on the basis of oil and water content, and with respect to the defect categories of insect damage, rancidity, discoloration, mould growth, germination, and decomposition. Predictive model performance statistics for oil content models were acceptable on all instruments (R2 > 0.98; RMSECV < 2.5%, which is similar to reference analysis error), although that for the instrument employing reflectance optics was inferior to models developed for the instruments employing transmission optics. The spectral positions for calibration coefficients were consistent with absorbance due to the third overtones of CH2 stretching. Calibration models for moisture content in ground samples were acceptable on all instruments (R2 > 0.97; RMSECV < 0.2%), whereas calibration models for intact kernels were relatively poor. Calibration coefficients were more highly weighted around 1360, 740 and 840 nm, consistent with absorbance due to overtones of O-H stretching and combination. Intact kernels with brown centres or rancidity could be discriminated from each other and from sound kernels using principal component analysis. Part kernels affected by insect damage, discoloration, mould growth, germination, and decomposition could be discriminated from sound kernels. However, discrimination among these defect categories was not distinct and could not be validated on an independent set. It is concluded that there is good potential for a low cost Si photodiode array instrument to be employed to identify some quality defects of intact macadamia kernels and to quantify oil and moisture content of kernels in the process laboratory and for oil content in-line. Further work is required to examine the robustness of predictive models across different populations, including growing districts, cultivars and times of harvest.

The fishery and reproductive biology of Barking crayfish, Linuparus trigonus (Von Siebold, 1824) along Queenslands east coast

This paper describes the fishery and reproductive biology for Linuparus trigonus obtained from trawl fishermen operating off Queensland’s east coast, Australia. The smallest mature female lobster measured 59.8 mm CL, however, 50% maturity was reached between 80 and 85 mm CL. Brood fecundity (BF) was size dependent and ranged between 19,287 and 100,671 eggs in 32 females from 59.8 to 104.3 mm CL. The relationship was best described by the power equation BF = 0.1107*CL to the power of 2.9241 (r to the power of 2 = 0:74). Egg size ranged from 0.96 to 1.12 mm in diameter (mean = 1:02 (+or-) 0:01 mm). Egg weight and size were independent of lobster size. Length frequencies displayed multi-modal distributions.The percentage of female to male lobsters was relatively stable for small size classes (30 to 70 mm CL; 50.0 to 63.6% females), but female proportions rose markedly between 75 and 90 mm (72.2 to 85.4%) suggesting that at the onset of sexual maturity female growth rates are reduced. In size classes greater than 95 mm, males were numerically dominant. A description of the L. trigonus fishery in Queensland is also detailed.

Pesticide residues in food - acute dietary exposure

Consumer risk assessment is a crucial step in the regulatory approval of pesticide use on food crops. Recently, an additional hurdle has been added to the formal consumer risk assessment process with the introduction of short-term intake or exposure assessment and a comparable short-term toxicity reference, the acute reference dose. Exposure to residues during one meal or over one day is important for short-term or acute intake. Exposure in the short term can be substantially higher than average because the consumption of a food on a single occasion can be very large compared with typical long-term or mean consumption and the food may have a much larger residue than average. Furthermore, the residue level in a single unit of a fruit or vegetable may be higher by a factor (defined as the variability factor, which we have shown to be typically ×3 for the 97.5th percentile unit) than the average residue in the lot. Available marketplace data and supervised residue trial data are examined in an investigation of the variability of residues in units of fruit and vegetables. A method is described for estimating the 97.5th percentile value from sets of unit residue data. Variability appears to be generally independent of the pesticide, the crop, crop unit size and the residue level. The deposition of pesticide on the individual unit during application is probably the most significant factor. The diets used in the calculations ideally come from individual and household surveys with enough consumers of each specific food to determine large portion sizes. The diets should distinguish the different forms of a food consumed, eg canned, frozen or fresh, because the residue levels associated with the different forms may be quite different. Dietary intakes may be calculated by a deterministic method or a probabilistic method. In the deterministic method the intake is estimated with the assumptions of large portion consumption of a ‘high residue’ food (high residue in the sense that the pesticide was used at the highest recommended label rate, the crop was harvested at the smallest interval after treatment and the residue in the edible portion was the highest found in any of the supervised trials in line with these use conditions). The deterministic calculation also includes a variability factor for those foods consumed as units (eg apples, carrots) to allow for the elevated residue in some single units which may not be seen in composited samples. In the probabilistic method the distribution of dietary consumption and the distribution of possible residues are combined in repeated probabilistic calculations to yield a distribution of possible residue intakes. Additional information such as percentage commodity treated and combination of residues from multiple commodities may be incorporated into probabilistic calculations. The IUPAC Advisory Committee on Crop Protection Chemistry has made 11 recommendations relating to acute dietary exposure.

On Systems Thinking, Systems Biology, and the in Silico Plant

The recent summary report of a Department of Energy Workshop on Plant Systems Biology (P.V. Minorsky [2003] Plant Physiol 132: 404-409) offered a welcomed advocacy for systems analysis as essential in understanding plant development, growth, and production. The goal of the Workshop was to consider methods for relating the results of molecular research to real-world challenges in plant production for increased food supplies, alternative energy sources, and environmental improvement. The rather surprising feature of this report, however, was that the Workshop largely overlooked the rich history of plant systems analysis extending over nearly 40 years (Sinclair and Seligman, 1996) that has considered exactly those challenges targeted by the Workshop. Past systems research has explored and incorporated biochemical and physiological knowledge into plant simulation models from a number of perspectives. The research has resulted in considerable understanding and insight about how to simulate plant systems and the relative contribution of various factors in influencing plant production. These past activities have contributed directly to research focused on solving the problems of increasing biomass production and crop yields. These modeling approaches are also now providing an avenue to enhance integration of molecular genetic technologies in plant improvement (Hammer et al., 2002).

Prospects for predicting insect mortality in relation to changing phosphine concentrations

Typically, in bag-stack or silo fumigations the concentration of phosphine is not constant, and yet most of what is known about phosphine efficacy against grain insects comes from studies with fixed concentrations. Indeed, where changing concentration experiments have been performed, researchers have been unable to explain observed efficacy on the basis of data from fixed concentrations. The ability to predict insect mortality in relation to changing phosphine concentrations would facilitate the development of effective fumigation protocols. In this paper, we explore the prospects for making such predictions. After reviewing published and new results, we conclude that the commonly used concentration x time (Ct) product is unreliable for this purpose. New results, for a strongly resistant strain of Rhyzopertha dominica from Australia, suggest that the relationship Cnt = k may be useful for predicting mortality of this type of insect in changing concentrations. However, in the case of a strain of Sitophilus oryzae with a type of resistance common in Australian S. oryzae, the relationship Cnt = k proved to be less reliable.

Effect of fumigation temperature on the efficacy of phosphine against strongly resistant psocids liposcelis bostrychophila (Pscodoptera: Liposcelididae)

Species of Liposcelis psocids have emerged as major pests of stored grain in Australia in recent years. Several populations have been detected with high resistance to phosphine, the major chemical treatment. Highest resistance has been detected in the cosmopolitan species Liposcelis bostrychophila. As part of a national resistance management strategy to maintain the viability of phosphine, we are developing minimum effective dosage regimes (concentration x time) required to control all life stages of resistant L. bostrychophila at a range of grain temperatures. Four concentrations of phosphine, 0.1, 0.17, 0.3 aid 1 mg/L, were evaluated for their effectiveness against strongly resistant L. bostrychophila at a series of fumigation temperatures: 20, 25, 30 and 35°C. Results were recorded as the least number of days taken to achieve population extinction. We found that, at any fixed concentration of phosphine, time to population extinction decreased as fumigation temperature increased from 20 to 30°C. For example, at 0.1 mg/L, it took more than 14 days at 20°C to completely control these insects, whereas at 30°C it took only seven days. Increase in fumigation temperature from 25OC to 30°C dramatically reduced the exposure period needed to achieve population extinction of resistant psocids. For example, a dose of 0.17 mg/L over six days at 30°C completely controlled strongly resistant L. bostrychophila populations that can survive at 1 mg/L and 25°C over the same exposure period. Findings from our study will be used to formulate recommendations for registered dosage rates and fumigation periods for use in Australia.

Developments in phosphine resistance in China and possible implications for Australia

Resistance to phosphine was characterised in strains of rice weevil, Sirophilus oryzae, and the psocids Liposcelis entomophila and L. decolor from China and Australia. Mixed-age cultures (containing all life stages) of insects were tested using a flow-through apparatus. The criterion of response was 'time to population extinction' defined as the exposure period, in days, at which 100% mortality of adults and no live progeny were achieved. Chinese S. oryzae took 11 and 7 days for population extinction at 200 and 700 ppm phosphine, respectively, compared with the Australian strain, which was controlled in 7 and 5 days, respectively. Similarly, the Chinese strains L. Enfornophila and L. decolor were generally more difficult to control than the corresponding Australian strains. The Chinese strains of L. decolor showed resistance levels stronger than any grain storage insect pest species so far detected in Australia. This research allows us to evaluate the likely significance of potential new resistance to the Australian grain industry and to prepare effective fumigation dosages and resistance management strategies to combat new strong resistances before they emerge here.

Redescription of adult and larva of Colasposoma sellaturn Baly (Coleoptera: Chrysomelidae: Eumolpinae): a pest of sweet potato in Australia

The genus Colasposorna Laporte is shown to be represented in Australia by a single species, C. sellaturn Baly (= C. barbaturn Harold, syn. conf.; = C. regulare Jacoby, syn. nov.). The adult and larva are described and lectotypes designated for C. sellaturn and C. regulare. Colasposoma sellaturn is recorded from the Northern Territory, northern Queensland and New Guinea. This species is a pest of Ipomoea batatas (sweet potato) in northern Queensland, where the adults damage stems and foliage and larvae may cause considerable damage to tubers. Its pest status is assessed and control measures discussed.

Cane Weevil Borer, Rhabdoscelus obscurus (Coleoptera: Curculionidae), a pest of palms in Northern Queensland, Australia

In recent years the cultivation of ornamental palms (Arecaceae) has increased markedly in northern Queensland. Consequently, several insects have become important pests, particularly Rhabdoscelus obscurus (Boisduval), the cane weevil borer. The larvae of this beetle feed on various species of palms, making the plants unsaleable. Death or lodging of the trees may also result. This paper documents its pest status, derived from information in the literature and from consultation with local growers.

Nocturnal Perching of Scarabaeine Dung Beetles (Coleoptera, Scarabaeidae) in an Australian Tropical Rain Forest

Wongabel, a northeastern Queensland tropical, wet, evergreen forest, contains 22 species of Scarabaeinae dung beetles. Five of these species were observed to perch commonly on leaves at night. Length of the beetle and the height of its perch were recorded for each of 56 1 specimens. Unlike the New World tropical dung beetle perchers, no clear evidence was found that small species perched closer to the ground than larger species. The evidence gathered, at least for the four most common perchers, supports the hypothesis that perching is one type of foraging strategy. The similarities and differences between the Australian and New World perchers are discussed.

Lepidopterous Pests Of The Litchi In North Queensland

A list is given of 34 species of Lepidoptera feeding on litchi in northern Queensland, including notes on type of damage and months of activity. Records from outside of Australia are also reviewed.

The life history of Phalacrognathus Muelleri (Macleay) (Coleoptera: Lucanidae)

The life history of Phalacrognathus muelleri (Macleay) is described and aspects of its biology discussed. The species is restricted to the wet tropics of northern Queensland where it breeds in rotting wood in rainforest. Larvae have been extracted from the wood of 27 tree species in 13 families. All larvae found were in wood attacked by white rot fungi. The final instar larva is described. Larva, pupa, and parasites are figured.

A positive locality record or Lepidiota Contigua Britton (Coleoptera: Scarabaeidae: Melolonthinae)

Lepidiota contigua Britton is recorded from Windsor Tableland, northern Queensland.

Six new species of Onthophagus Latreille (Coleoptera: Scarabaeidae) from Australia

Six new species of Onthophagus are described from Queensland and Northern Territory: 0. kiambram. 0. yarrumba, 0. kora, O.punthari, 0. terrara and 0. wanappe. All six species are related to the Australian 0. rubescens Macleay, and a key is given to separate the 14 species in that group.

Risk management strategies using seasonal climate forecasting in irrigated cotton production: a tale of stochastic dominance.

Decision-making in agriculture is carried out in an uncertain environment with farmers often seeking information to reduce risk. As a result of the extreme variability of rainfall and stream-flows in north-eastern Australia, water supplies for irrigated agriculture are a limiting factor and a source of risk. The present study examined the use of seasonal climate forecasting (SCF) when calculating planting areas for irrigated cotton in the northern Murray Darling Basin. Results show that minimising risk by adjusting plant areas in response to SCF can lead to significant gains in gross margin returns. However, how farmers respond to SCF is dependent on several other factors including irrigators’ attitude towards risk.