The use of cashew apple residue as source of fiber in low fat hamburgers

The main purpose of this study was to produce hamburgers with partial substitution of the meat with cashew apple residue powder. The powder residue was obtained after the extraction of the pulp and dehydration in stove with air circulation. Three formulations of hamburgers with increasing concentration of the residue as well as a control sample were prepared. The formulated products with cashew apple residue powder presented lower humidity and proteins and 35% lipid reduction. However, there was an increase in carbohydrates and pH with the addition of the powder from the cashew apple residue. Some formulations showed an improvement of the final product yield. The total dietary fiber value was between 0 and 7.66%, with higher content of insoluble dietary fiber. The addition of up to 10.70% of the residue did not cause significant sensory changes in the flavor of the samples. The production of hamburgers with a partial substitution of cow meat with the cashew apple residue could be a feasible option since it resulted in product with high nutritional quality that is rich or have high dietary fiber content and is low in fat.

Carbon isotope analysis in apple nectar beverages

The aims of this study were to use the isotope analysis method to quantify the carbon of C3 photosynthetic cycle in commercial apple nectars and to determine the legal limit to identify the beverages that do not conform to the safety standards established by the Brazilian Ministry of Agriculture, Livestock and Food Supply. These beverages (apple nectars) were produced in the laboratory according to the Brazilian legislation. Adulterated nectars were also produced with an amount of pulp juice below the permitted threshold limit value. The δ13C values of the apple nectars and their fractions (pulp and purified sugar) were measured to quantify the C3 source percentage. In order to demonstrate the existence of adulteration, the values found were compared to the limit values established by the Brazilian Law. All commercial apple nectars analyzed were within the legal limits, which enabled to identify the nectars that were in conformity with the Brazilian Law. The isotopic methodology developed proved efficient to quantify the carbon of C3 origin in commercial apple nectars.

Effect of treatment with adsorbent resin on the volatile profile and physicochemical characteristics of clarified cashew apple juice

Increased preference for healthy and functional foods could be an opportunity to increase the consumption of clarified cashew apple juice. Given its level of fructose, glucose, and vitamin C, it can be used as a base in blends. However, its characteristic odor can interfere with the acceptance of these formulations, especially by consumers who are not familiar with cashew aroma. The aim of this study was to evaluate the effect of treatment with macroporous resins (FPA54, FPX66, XAD761, and XAD4) on the volatile profile and physicochemical characteristics of clarified cashew apple juice. After the treatment with the resins, the volatile profile was evaluated using solid-phase microextraction (SPME) and gas chromatography/mass spectrometry (GC/MS). The physicochemical analyses performed were: pH, soluble solids (ºBrix), total titrable acidity, reducing sugars, and vitamin C. Gas chromatography analyses showed that XAD4 and FPX66 led to a reduction of the initial amount of volatile compounds to 14.05% and 15.72%, respectively. These two resins also did not affect the physicochemical characteristics of the clarified cashew apple juice.

Development and optimization of a HPLC-RI method for the determination of major sugars in apple juice and evaluation of the effect of the ripening stage

The sugars in apple juice prove its authenticity and its sensory and nutritional properties. The aim of this study was to develop and validate a simple analytical method using high performance liquid chromatography with refractive index detection (HPLC-RI) to determinate and quantify the sugars sucrose, D-glucose, D-fructose, and D-sorbitol polyol in apple juices, as well as to analyze the juices from the Fuji suprema and Lis Gala cultivars at three ripening stages. The analytical performance parameters evaluated indicated that the method was specific for the compounds analyzed, and the linearity of the calibration curves of sugars showed high correlation coefficients (close to 1.0). The limits of detection and quantification are consistent with recommendations available in the literature for this type of matrix. Sample preparation is simple and generates small amount of residues. Over 70% of the sugars were determined in the juices of apples at the pre-ripe stage, with an increase during senescence. This method is applicable for the determination of sugars in juices and evaluation of apple ripening.

Vinegar rice (Oryza sativa L.) produced by a submerged fermentation process from alcoholic fermented rice

Considering the limited availability of technology for the production of rice vinegar and also due to the potential consumer product market, this study aimed to use alcoholic fermented rice (rice wine (Oryza sativa L.)) for vinegar production. An alcoholic solution with 6.28% (w/v) ethanol was oxidized by a submerged fermentation process to produce vinegar. The process of acetic acid fermentation occurred at 30 ± 0.3°C in a FRINGS® Acetator (Germany) for the production of vinegar and was followed through 10 cycles. The vinegar had a total acidity of 6.85% (w/v), 0.17% alcohol (w/v), 1.26% (w/v) minerals and 1.78% (w/v) dry extract. The composition of organic acids present in rice vinegar was: cis-aconitic acid (6 mg/L), maleic acid (3 mg/L), trans-aconitic acid (3 mg/L), shikimic + succinic acid (4 mg/L), lactic acid (300 mg/L), formic acid (180 mg/L), oxalic acid (3 mg/L), fumaric acid (3 mg/L) and itaconic acid (1 mg/L).

Optimization of the extraction process of polyphenols from cashew apple agro-industrial residues

The goal of this study was to determine the chemical composition of cashew apples agro-industrial residue and optimize the process of polyphenols extraction in this residue. The extraction process conditions were defined using a 24-1 fractional factorial experimental design using acetone and methanol as solvents. The independent variables were: time (30 to 90 min), temperature (30 to 50 °C), solvent concentrations (50% to 90%), agitation speed (100 to 300 rpm); the dependent variables were: total phenolic content and DPPH scavenging capacity. The optimized process was carried out by applying the Central Composite Rotational Design (CCRD) considering the results obtained with the 24-1 fractional factorial experimental design. The residue presented bioactive compounds in its composition, with emphasis on the content of total phenolic compounds (1975.64 mg/ 100 g). The extraction process was not affected by methanol; however, acetone affected the amounts of extracted phytochemicals. Extracts with high levels of polyphenols and strong DPPH scavenging capacity (> 80%) were obtained using 55% acetone, 30 minutes, 30 °C, and 150 rpm. The results showed that cashew apple residue is a potential natural source of bioactive compounds with strong antioxidant capacity. These compounds could be used partially or totally to replace synthetic antioxidants.

Energy efficiency and moisture diffusivity of apple slices during convective drying

Abstract The present study aimed at investigating the influences of drying air temperature and flow rate on energy parameters and dehydration behaviour of apple slices. For this purpose, apple slices were dried in a convective dryer at air temperatures of 50, 60 and 70 °C, and air velocities of 1, 1.5 and 2 m s–1. Dehydration rate increased as the air temperature and flow rate increased from 50 to 70 °C and 1 to 2 m s–1, respectively. The effective moisture diffusivity was determined to be in the range of 6.75×10–10-1.28×10–9 m2 s–1. Results of data analysis showed that the maximum energy consumption (23.94 kW h) belonged to 50 °C and 2 m s–1 and the minimum (13.89 kW h) belonged to 70 °C and 1 m s–1 treatment. Energy efficiency values were in the range of 2.87-9.11%. Moreover, the results indicated that any increment in the air temperature increases thermal and drying efficiencies while any increment in the air flow rate decreases both of them.

An HPLC method for simultaneous determination of residual benomyl and MBC on apple foliage without cleanup

A simple High Performance Liquid Chromatograph (HPLC) method has been developed to identify benamyl (methyl 1- (butylcarbamoyl)-2-benzimidazole carbamate) and MBC (methyl 2-benzimidazole carbamat~ residues on apple leaves without cleanup. Sample leaves are freeze dried in a Mason jar and residues are then extracted by tumbling them in chloroform containing 5,000 microgram per milliliter of n-propyl isocyanate (PIC) at 10 C. To the extract, n-butyl isocyanate (BIC) was added at 5,000 microgram per milliliter and 20 microliter of this mixture injected onto the HPLC system. Separation is accomplished by the use of a Brownlee LiChrosorb silica gel column with a guard column and' operated with a mixed mobile phase consisting of chloroform and hexane (4:1) saturated with water. MBC, a degradation product of benomyl is identified if present as methyl l-(npropyl carbamoyl)-2-benzimidazole carbamate (MBC-n-PIC). Both benomyl and MBC-n-PIC can be detected with aKUltraviolet (UV) detector (280nm) at a concentration as low as 0.2 microgram per milliliter in apple leaves. The fate of benomyl on apple foliage after spray application of benomyl (Ben late 50 per cent wettable powder) was investigated by the method thus described. Benomyl quickly dissipated during the first 3-7 days, but the dissipatio'n sltowed down thereafter. In contrast, the concentration of MBC in leaves gradually increased after repeated applications of Benlate.

Taylor & Bates Brewery & Vinegar Manufactory - Vignette

A vignette of Taylor and Bate's Brewery and Manufactory, St. Catharines.. "Manufacturers of Taylor's Celebrated Amber Ale, Porter, also, White Wine Vinegar, Dealers in Malt, Hops, Barley, &c. &c." The names listed are James Taylor and Thomas B. Bate.

Happy growers! Relationship quality in the German organic apple chain

Relational factors between supply chain actors have been acknowledged to contribute significantly to competitiveness. With the example of the German market for organic apples the suitability of the concept of the Relational View for explaining competitiveness was investigated. Structured interviews were conducted with selected actors of the supply chain. Actors at all levels of the supply chain proved to be highly committed and described their business relations as satisfying and trustful. Strong vertical and horizontal collaboration was found. Thus, the Relational View proved to be highly suitable to explain competitiveness in the market for organic apples.

Tools to use when writing a thesis using Word 2011 (for Apple computers)

A collection of videos on time saving features when using MS Word 2011 to write a thesis. Learn how to use styles, make table of contents, make table of figures, use the document map, use the browse object tool and keep a count of the words in your file and many more useful features of Word 2011. Word 2011 is for Apple computers, there is a collection of similar video for use with the PC version Word 2010.

University of Southampton thesis template for use with MS Word 2003 (PC) and 2004 (Apple)

This template is for use with both Word 2003 (PC) and Word 2004 (Apple Mac). It provides a structure and format that meets with the University's Quality requirements for a thesis. The template has mirror margins set up to allow for double-sided printing. It is not compulsory to use the template when writing a thesis. but it's use will make your thesis well presented and should save you a lot of time and effort. Since Office 2003/2004 are no longer the supported versions of Office used at the University there are no supporting videos.

Creating a Table of Contents to cover only part of a file's content using MS Word 2011 for Apple computers

A Table of Contents can be tweaked so that it picks up the content from only part of a file (such as an Appendix). This video shows you how to make such a change to a Table of Contents that is based upon Heading Styles. For best viewing Download the video.