991 resultados para 140
Resumo:
Fil: Sorgentini, Hernán Antonio. Universidad Nacional de La Plata. Facultad de Humanidades y Ciencias de la Educación; Argentina.
Resumo:
Fil: Sorgentini, Hernán Antonio. Universidad Nacional de La Plata. Facultad de Humanidades y Ciencias de la Educación; Argentina.
Resumo:
Seismic velocities have been measured at confining pressures of 100 MPa and 600 MPa for sheeted dike samples recovered during Ocean Drilling Program Legs 137 and 140. The compressional- and shear-wave velocities show an increase with depth at Hole 504B, which is in sharp contrast to the atmospheric pressure velocity measurements performed as part of the shipboard analyses. Rocks exposed to different types of alteration and fracture patterns show distinct changes in their physical properties. The seismic reflectors observed on the vertical seismic profile (VSP) experiment performed during Leg 111 may have been caused by low velocity zones resulting from alteration. The amount of fracturing and hydrothermal alteration in several zones also may have contributed to the acoustic impedance contrast necessary to produce the E5 reflector. Poisson's ratios calculated from laboratory velocity measurements show several low values at depths ranging from 1600 mbsf to 2000 mbsf, which tends to follow similar trends obtained from previous oceanic refraction experiments. A comparison of physical properties between samples recovered from Hole 504B and ophiolite studies in the Bay of Islands and Oman shows a good correlation with the Bay of Islands but significant differences from the measurements performed in the Oman complex.
Resumo:
Primary chemical heterogeneity in the sheeted dike complex in Deep Sea Drilling Project Hole 504B makes these rocks unsuitable for conventional mass balance calculations in determining element mobility associated with hydrothermal alteration. Due to the original heterogeneity and variable degrees of fractionation in the dikes, an appropriate reference sample on which calculations can be based is difficult to find. Therefore, the use of incompatible element ratios is developed to evaluate geochemical changes during alteration(s). For example, on a Zr/Yb-La/Yb plot, scatter along a straight line suggests tapping of a variably depleted mantle source and deviation from the line suggests element mobility (gain or loss). Using this method, our data indicates that the hydrothermal evolution of the sheeted dike complex was accompanied by significant loss of Cu, Zn, and Ti and some loss of La. The sheeted dike complex has low platinum group element (PGE) concentrations and steep PGE patterns, typical of mid-ocean ridge basalts (MORBs) on the global scale. We propose that the unusual PGE patterns of MORBs cannot be entirely generated by a partial melting and sulfide segregation model; instead, these patterns in part must have been inherited from their mantle source. The Au data show no evidence for mobilization during hydrothermal alteration of the dikes.
Resumo:
Samples recovered from Hole 504B during Leg 140 include a number of medium-grained, holocrystalline diabases that appear to represent the cores of thick dikes. The plagioclase and pyroxene in these samples occur in a variety of crystal morphologies. Plagioclase occurs as phenocrysts, microphenocrysts, elongate crystals, skeletal crystals, and branching radial clusters. Pyroxene occurs as phenocrysts, microphenocrysts, ophitic crystals, and poikilitic crystals. Plagioclase compositions became progressively poorer in anorthite and MgO and progressively richer in FeO as crystallization proceeded, while the average grain volume decreased and the aspect ratio of individual grains increased. Pyroxene compositions are largely independent of crystal morphology. The diabase dikes recovered from Hole 504B during Leg 140 appear to have crystallized in situ. Crystal compositions and morphologies are consistent with a rapid cooling rate and solidification times for individual dikes on the order of hours or days. The crystallization rate and nucleation rate of plagioclase lagged behind the cooling rate so that the degree of undercooling progressively increased as crystallization proceeded. Plagioclase crystal morphologies indicate much greater degrees of supersaturation than do pyroxene or olivine crystal morphologies. The 504B diabase magmas appear to have been emplaced with abundant preexisting pyroxene and olivine nuclei, but with few preexisting plagioclase nuclei. The suppression of plagioclase nucleation and crystallization relative to that of pyroxene and olivine could provide a mechanism by which the actual fractionation assemblage is more pyroxene-rich and plagioclase-poor than that predicted from thermodynamic models, or that observed in isothermal crystallization experiments.