An atomistic simulation of solid state sintering using Monte Carlo methods

This paper presents results on the simulation of the solid state sintering of copper wires using Monte Carlo techniques based on elements of lattice theory and cellular automata. The initial structure is superimposed onto a triangular, two-dimensional lattice, where each lattice site corresponds to either an atom or vacancy. The number of vacancies varies with the simulation temperature, while a cluster of vacancies is a pore. To simulate sintering, lattice sites are picked at random and reoriented in terms of an atomistic model governing mass transport. The probability that an atom has sufficient energy to jump to a vacant lattice site is related to the jump frequency, and hence the diffusion coefficient, while the probability that an atomic jump will be accepted is related to the change in energy of the system as a result of the jump, as determined by the change in the number of nearest neighbours. The jump frequency is also used to relate model time, measured in Monte Carlo Steps, to the actual sintering time. The model incorporates bulk, grain boundary and surface diffusion terms and includes vacancy annihilation on the grain boundaries. The predictions of the model were found to be consistent with experimental data, both in terms of the microstructural evolution and in terms of the sintering time. (C) 2002 Elsevier Science B.V. All rights reserved.

On learning context-free and context-sensitive languages

The long short-term memory (LSTM) is not the only neural network which learns a context sensitive language. Second-order sequential cascaded networks (SCNs) are able to induce means from a finite fragment of a context-sensitive language for processing strings outside the training set. The dynamical behavior of the SCN is qualitatively distinct from that observed in LSTM networks. Differences in performance and dynamics are discussed.

Age does not influence the bone response to treadmill exercise in female rats

Purpose: Because it is believed that bone may respond to exercise differently at different ages, we compared bone responses in immature and mature rats after 12 wk of treadmill running. Methods: Twenty-two immature (5-wk-old) and 21 mature (17-wk-old) female Sprague Dawley rats were randomized into a running (trained, N = 10 immature, 9 mature) or a control group (controls, N 12 immature, 12 mature) before sacrifice 12 wk later. Rats ran on a treadmill five times per week for 60-70 min at speeds up to 26 m.min(-1). Both at baseline and after intervention, we measured total body, lumbar spine, and proximal femoral bone mineral, as well as total body soft tissue composition using dual-energy x-ray absorptiometry (DXA) in vivo. After sacrificing the animals, we measured dynamic and static histomorphometry and three-point bending strength of the tibia. Results: Running training was associated with greater differences in tibial subperiosteal area, cortical cross-sectional area, peak load, stiffness, and moment of inertia in immature and mature rats (P < 0.05). The trained rats had greater periosteal bone formation rates (P < 0.01) than controls, but there was no difference in tibial trabecular bone histomorphometry. Similar running-related gains were seen in DXA lumbar spine area (P = 0.04) and bone mineral content (BMC; P = 0.03) at both ages. For total body bone area and BMC, the immature trained group increased significantly compared with controls (P < 0.05), whereas the mature trained group gained less than did controls (P < 0.01). Conclusion: In this in vivo model, where a similar physical training program was performed by immature and mature female rats, we demonstrated that both age groups were sensitive to loading and that bone strength gains appeared to result more from changes in bone geometry than from improved material properties.

Evaluating Australia's National Medicines Policy using geographical mapping

Background: There has been a proliferation of quality use of medicines activities in Australia since the 1990s. However, knowledge of the nature and extent of these activities was lacking. A mechanism was required to map the activities to enable their coordination. Aims: To develop a geographical mapping facility as an evaluative tool to assist the planning and implementation of Australia's policy on the quality use of medicines. Methods: A web-based database incorporating geographical mapping software was developed. Quality use of medicines projects implemented across the country was identified from project listings funded by the Quality Use of Medicines Evaluation Program, the National Health and Medical Research Council, Mental Health Strategy, Rural Health Support, Education and Training Program, the Healthy Seniors Initiative, the General Practice Evaluation Program and the Drug Utilisation Evaluation Network. In addition, projects were identified through direct mail to persons working in the field. Results: The Quality Use of Medicines Mapping Project (QUMMP) was developed, providing a Web-based database that can be continuously updated. This database showed the distribution of quality use of medicines activities by: (i) geographical region, (ii) project type, (iii) target group, (iv) stakeholder involvement, (v) funding body and (vi) evaluation method. At September 2001, the database included 901 projects. Sixty-two per cent of projects had been conducted in Australian capital cities, where approximately 63% of the population reside. Distribution of projects varied between States. In Western Australia and Queensland, 36 and 73 projects had been conducted, respectively, representing approximately two projects per 100 000 people. By comparison, in South Australia and Tasmania approximately seven projects per 100 000 people were recorded, with six per 100 000 people in Victoria and three per 100 000 people in New South Wales. Rural and remote areas of the country had more limited project activity. Conclusions: The mapping of projects by geographical location enabled easy identification of high and low activity areas. Analysis of the types of projects undertaken in each region enabled identification of target groups that had not been involved or services that had not yet been developed. This served as a powerful tool for policy planning and implementation and will be used to support the continued implementation of Australia's policy on the quality use of medicines.

Attitudes and practices of general practitioners in the diagnosis and management of attention-deficit/hyperactivity disorder

Objective: To assess understanding of, and actual and potential roles in management of attention-deficit/hyperactivity disorder (ADHD) among GPs. Methods: A cross-sectional questionnaire survey of Queensland GPs selected randomly from the Royal Australian College of General Practitioners directory of members was carried out. Main outcome measures were knowledge levels of ADHD, current management practices, referral patterns and self-perceived information and training needs. Results: Three hundred and ninety-nine GPs returned a completed questionnaire (response rate 76%). Roles identified by GPs were: the provisional diagnosis of ADHD and referral to specialist services for confirmation of the diagnosis and initiation of management; assistance with monitoring progress once a management plan was in place; education of the child and their family regarding the disorder; and liaison with the school where necessary. Perceived barriers to increased involvement of GPs were: time and resource constraints of general practice; concerns regarding abuse and addiction liability of prescription stimulants; complex diagnostic issues associated with childhood behavioural problems; and lack of training and education regarding ADHD. Conclusions: General practitioners identify a role for themselves in ADHD care that is largely supportive in nature and involves close liaison with specialist services.

Estimation of total body water from bioelectrical impedance analysis in patients with pancreatic cancer - agreement between three methods of prediction

Introduction Bioelectrical impedance analysis (BIA) is a useful field measure to estimate total body water (TBW). No prediction formulae have been developed or validated against a reference method in patients with pancreatic cancer. The aim of this study was to assess the agreement between three prediction equations for the estimation of TBW in cachectic patients with pancreatic cancer. Methods Resistance was measured at frequencies of 50 and 200 kHz in 18 outpatients (10 males and eight females, age 70.2 +/- 11.8 years) with pancreatic cancer from two tertiary Australian hospitals. Three published prediction formulae were used to calculate TBW - TBWs developed in surgical patients, TBWca-uw and TBWca-nw developed in underweight and normal weight patients with end-stage cancer. Results There was no significant difference in the TBW estimated by the three prediction equations - TBWs 32.9 +/- 8.3 L, TBWca-nw 36.3 +/- 7.4 L, TBWca-uw 34.6 +/- 7.6 L. At a population level, there is agreement between prediction of TBW in patients with pancreatic cancer estimated from the three equations. The best combination of low bias and narrow limits of agreement was observed when TBW was estimated from the equation developed in the underweight cancer patients relative to the normal weight cancer patients. When no established BIA prediction equation exists, practitioners should utilize an equation developed in a population with similar critical characteristics such as diagnosis, weight loss, body mass index and/or age. Conclusions Further research is required to determine the accuracy of the BIA prediction technique against a reference method in patients with pancreatic cancer.

Knowledge of the national emergency telephone number and prevalence and characteristics of those trained in CPR in Queensland: baseline information for targeted training interventions

Members of the community contribute to survival from out-of-hospital cardiac arrest by contacting emergency medical services and performing cardiopulmonary resuscitation (CPR) prior to the arrival of an ambulance. In Australia there is a paucity of information of the extent that community members know the emergency telephone number and are trained in CPR. A survey of Queensland adults (n = 4490) was conducted to ascertain current knowledge and training levels and to target CPR training. Although most respondents (88.3%) could state the Australian emergency telephone number correctly, significant age differences were apparent (P < 0.001). One in five respondents aged 60 years and older could not state the emergency number correctly. While just over half the respondents (53.9%) had completed some form of CPR training, only 12.1% had recent training. Older people were more likely to have never had CPR training than young adults. Additional demographic and socio-economic differences were found between those never trained in CPR and those who were. The results emphasise the need to increase CPR training in those aged 40 and over, particularly females, and to increase the awareness of the emergency telephone number amongst older people. (C) 2002 Elsevier Science Ireland Ltd. All rights reserved.

Control of Aedes vectors of dengue in three provinces of Vietnam by use of Mesocyclops (Copepoda) and community-based methods validated by entomologic, clinical, and serological surveillance

We describe remarkable success in controlling dengue vectors, Aedes aegypti (L.) and Aedes albopictus (Skuse), in 6 communes with 11,675 households and 49,647 people in the northern provinces of Haiphong, Hung Yen, and Nam Dinh in Vietnam. The communes were selected for high-frequency use of large outdoor concrete tanks and wells. These were found to be the source of 49.6-98.4% of Ae. aegypti larvae, which were amenable to treatment with local Mesocyclops, mainly M. woutersi Van der Velde, M. aspericornis (Daday) and M. thermocyclopoides Harada. Knowledge, attitude, and practice surveys were performed to determine whether the communities viewed dengue and dengue hemorrhagic fever as a serious health threat; to determine their knowledge of the etiology, attitudes, and practices regarding control methods including Mesocyclops; and to determine their receptivity to various information methods. On the basis of the knowledge, attitude, and practice data, the community-based dengue control program comprised a system of local leaders, health volunteer teachers, and schoolchildren, supported by health professionals. Recycling of discards for economic gain was enhanced, where appropriate, and this, plus 37 clean-up campaigns, removed small containers unsuitable for Mesocyclops treatment. A previously successful eradication at Phan Boi village (Hung Yen province) was extended to 7 other villages forming Di Su commune (1,750 households) in the current study. Complete control was also achieved in Nghia Hiep (Hung Yen province) and in Xuan Phong (Nam Dinh province); control efficacy was greater than or equal to 99.7% in the other 3 communes (Lac Vien in Haiphong, Nghia Dong, and Xuan Kien in Nam Dinh). Although tanks and wells were the key container types of Ae. aegypti productivity, discarded materials were the source of 51% of the standing crop of Ae. albopictus. Aedes albopictus larvae were eliminated from the 3 Nam Dinh communes, and 86-98% control was achieved in the other 3 communes. Variable dengue attack rates made the clinical and serological comparison of control and untreated communes problematic, but these data indicate that clinical surveillance by itself is inadequate to monitor dengue transmission.

Rock fracture mean trace length estimation and confidence interval calculation using maximum likelihood methods

There has been a resurgence of interest in the mean trace length estimator of Pahl for window sampling of traces. The estimator has been dealt with by Mauldon and Zhang and Einstein in recent publications. The estimator is a very useful one in that it is non-parametric. However, despite some discussion regarding the statistical distribution of the estimator, none of the recent works or the original work by Pahl provide a rigorous basis for the determination a confidence interval for the estimator or a confidence region for the estimator and the corresponding estimator of trace spatial intensity in the sampling window. This paper shows, by consideration of a simplified version of the problem but without loss of generality, that the estimator is in fact the maximum likelihood estimator (MLE) and that it can be considered essentially unbiased. As the MLE, it possesses the least variance of all estimators and confidence intervals or regions should therefore be available through application of classical ML theory. It is shown that valid confidence intervals can in fact be determined. The results of the work and the calculations of the confidence intervals are illustrated by example. (C) 2003 Elsevier Science Ltd. All rights reserved.

Stereological and other methods applied to rock joint size estimation - Does Crofton's theorem apply?

A number of authors concerned with the analysis of rock jointing have used the idea that the joint areal or diametral distribution can be linked to the trace length distribution through a theorem attributed to Crofton. This brief paper seeks to demonstrate why Crofton's theorem need not be used to link moments of the trace length distribution captured by scan line or areal mapping to the moments of the diametral distribution of joints represented as disks and that it is incorrect to do so. The valid relationships for areal or scan line mapping between all the moments of the trace length distribution and those of the joint size distribution for joints modeled as disks are recalled and compared with those that might be applied were Crofton's theorem assumed to apply. For areal mapping, the relationship is fortuitously correct but incorrect for scan line mapping.