C1-C7 volatile organic compounds in sediments at DSDP Legs 56-57 Holes

Volatile C1-C7 components in sediments were examined for Japan Trench DSDP Sites 438, 439, 435, 440, 434 and 436, proceeding from west to east. Levels of all components are lowest in the highly fractured sediments of Sites 440 and 434. A number of alkenes, furans, and sulfur compounds were detected in concentrations higher than noted in any other DSDP sediments examined to date. The types, amounts, and specificity of occurrence are similar to those for 1-meter gravity cores we have examined which bear a significant biological imprint. Site 436 shows high levels of saturated and aromatic hydrocarbons, as well as olefins, including traces of dimethycyclopentanes and the highest level of cyclohexene detected in any DSDP sediment we have examined to date. The results from Site 436 were unexpected, considering the low organic-carbon content, absence of biogenic methane, and evidence of an aerobic depositional environment at this site.

Carbon isotopic composition of dissolved CO2, CO2 gas and methane in sediments from ODP Leg 172 sites

Carbon isotopic data of interstitial dissolved CO2 (CO2), CO2 gas, and methane show that a variety of microbial diagenetic processes produce the observed isotopic trends. Anaerobic methane oxidation (AMO) is an important process near the sulfate-methane interface (SMI) that strongly influences the isotopic composition of CO2 in the sulfate reduction and upper methanogenic zones, which in turn impacts methane isotopic composition. Dissolved CO2 and methane are maximally depleted in 13C near the SMI, where 13C values are as light as -31.8 and -101 PDB for CO2 and methane, respectively. CO2 reduction links the CO2 and methane pools in the methanogenic zone so that the carbon isotopic composition of both pools evolves in concert, generally showing increasing enrichments of 13C with increasing depth. These isotopic trends mirror those within other methane-rich continental rise sediments worldwide.

Helium isotope ratios and sedimentation rate models of ODP holes

A continuous age model for the brief climate excursion at the Paleocene-Eocene boundary has been constructed by assuming a constant flux of extraterrestrial 3He (3He[ET]) to the seafloor. 3He[ET] measurements from ODP Site 690 provide quantitative evidence for the rapid onset (methane hydrate, as the proximal cause of the event. However, the 3He[ET] technique indicates a previously unrecognized and extreme increase in sedimentation rate coincident with the return of climate proxies to pre-event values. The 3He[ET]-based age model thus suggests a far more rapid recovery from the climatic perturbation than previously proposed or predicted on the basis of the modern carbon cycle, and so may indicate additional or accelerated mechanisms of carbon removal from the ocean-atmosphere system during this period. 3He[ET] was also measured at ODP Site 1051 to test the validity of the Site 690 chronology. Comparison of these data sets seems to require removal of several tens of kyr of sediment within the climatic excursion at Site 1051, an observation consistent with sediment structures and previous age modeling efforts. The Site 1051 age model shows a ~30 kyr period in which climate proxies return toward pre-event values, after which they remain invariant for ~80 kyr. If this rise represents the recovery interval identified at Site 690, then the 3HeET-based age models of the two sites are in good agreement. However, alternative interpretations are possible, and work on less disrupted sites is required to evaluate the reliability of the proposed new chronology of the climate excursion. Regardless of these details, this work shows that the 3HeET technique can provide useful independent evidence for the development and testing of astronomically calibrated age models.

Wet and dry resistivities along three orthogonal directions of ODP Holes 185-801C and 185-1149B

The results of shore-based three-axis resistivity and X-ray computed tomography (CT) measurements on cube-shaped samples recovered during Leg 185 are presented along with moisture and density, P-wave velocity, resistivity, and X-ray CT measurements on whole-round samples of representative lithologies from Site 1149. These measurements augment the standard suite of physical properties obtained during Leg 185 from the cube samples and samples obtained adjacent to the cut cubes. Both shipboard and shore-based measurements of physical properties provide information that assists in characterizing lithologic units, correlating cored material with downhole logging data, understanding the nature of consolidation, and interpreting seismic reflection profiles.