Comportamento de cristalização de lipídios estruturados por interesterificação química de banha e óleo de soja

The aim of this study was to evaluate the crystallization behavior of binary mixtures of lard and soybean oil in different ratios and their respective structured lipids obtained by chemical interesterification. Crystallization kinetics and polarized light microscopy were used to analyze the mixtures before and after interesterification. The addition of soybean oil changed the lard crystallization, by the effect of the dilution. Crystal diameter increased, while the number of crystals decreased, as a function of temperature. Interesterification resulted in the formation of fewer crystals, with larger diameter in comparison with the original mixtures.

Advanced chemometric methods: Applicability on industrial data

Recent years have produced great advances in the instrumentation technology. The amount of available data has been increasing due to the simplicity, speed and accuracy of current spectroscopic instruments. Most of these data are, however, meaningless without a proper analysis. This has been one of the reasons for the overgrowing success of multivariate handling of such data. Industrial data is commonly not designed data; in other words, there is no exact experimental design, but rather the data have been collected as a routine procedure during an industrial process. This makes certain demands on the multivariate modeling, as the selection of samples and variables can have an enormous effect. Common approaches in the modeling of industrial data are PCA (principal component analysis) and PLS (projection to latent structures or partial least squares) but there are also other methods that should be considered. The more advanced methods include multi block modeling and nonlinear modeling. In this thesis it is shown that the results of data analysis vary according to the modeling approach used, thus making the selection of the modeling approach dependent on the purpose of the model. If the model is intended to provide accurate predictions, the approach should be different than in the case where the purpose of modeling is mostly to obtain information about the variables and the process. For industrial applicability it is essential that the methods are robust and sufficiently simple to apply. In this way the methods and the results can be compared and an approach selected that is suitable for the intended purpose. Differences in data analysis methods are compared with data from different fields of industry in this thesis. In the first two papers, the multi block method is considered for data originating from the oil and fertilizer industries. The results are compared to those from PLS and priority PLS. The third paper considers applicability of multivariate models to process control for a reactive crystallization process. In the fourth paper, nonlinear modeling is examined with a data set from the oil industry. The response has a nonlinear relation to the descriptor matrix, and the results are compared between linear modeling, polynomial PLS and nonlinear modeling using nonlinear score vectors.

Determinação quantitativa de TNT e HNS por TG e FT-IR

2,4,6-trinitrotoluene (TNT) is an energetic material that shows scarce crystalline properties that can be improved by addition of 2,2',4,4',6,6'-hexanitrostilbene (HNS) in the crystallization process. HNS is a very important high explosive used in a variety of military, aerospace and industrial formulations owing to its suitable properties. It is an insensitive and thermal stable explosive that can be produced from 2,4,6-trinitrotoluene (TNT). The purpose of this work is the quantitative determination of HNS and TNT in explosives by thermogravimetric analysis (TG) and Fourier transform infrared spectroscopy (FT-IR).

Processamento de pilhas do tipo botão

This work presents hydrometallurgical routes for recovering valuable elements from spent button cells, based on leaching of internal components with sulfuric acid (Li/MnO2 and Zn-air) or nitric acid (Ag-Zn), at 90 ºC for 2h. Slow evaporation of the leachate crystallized MnSO4.H2O, whereas lithium was partially recovered as LiF. Mercury present in Zn-air and Ag-Zn samples was precipitated as HgS. Silver was recovered as AgCl before mercury precipitation. Zinc and iron were precipitated as hydroxides. The amount of iron varied according to the intensity of the corrosion of the external cell case. Final wastes are neutral and colorless sodium sulfate/nitrate solutions.

Analytical procedures for determining Pb and Sr isotopic compositions in water samples by ID-TIMS

Few articles deal with lead and strontium isotopic analysis of water samples. The aim of this study was to define the chemical procedures for Pb and Sr isotopic analyses of groundwater samples from an urban sedimentary aquifer. Thirty lead and fourteen strontium isotopic analyses were performed to test different analytical procedures. Pb and Sr isotopic ratios as well as Sr concentration did not vary using different chemical procedures. However, the Pb concentrations were very dependent on the different procedures. Therefore, the choice of the best analytical procedure was based on the Pb results, which indicated a higher reproducibility from samples that had been filtered and acidified before the evaporation, had their residues totally dissolved, and were purified by ion chromatography using the Biorad® column. Our results showed no changes in Pb ratios with the storage time.

Biodegradação de tolueno e óleo de pescado em solos impactados utilizando surfactantes químico e biológico

The process of biodegradation of soils contaminated by animal (raw fish oil) and mineral (toluene) origin compounds was studied, verifying the influence of adding biosurfactants and chemical surfactants and nutrients in the media. The highest removal rate of fish oil was 59.47% obtained in the experiments containing biosurfactant and biostimulate in 90 days process. The highest removal rate of toluene was achieved in 14 days for experiments containing biosurfactant, chemical spreading and biosurfactant with biostimulation, showing great influence of evaporation on the process. The use of surfactants has shown to increase the contaminant bioavailability due to its higher degradation rate.

Estudo por espectroscopia micro-Raman dos mecanismos de separação de fase em vidros fosfatos de metais de transição

Glass-ceramics are prepared by controlled separation of crystal phases in glasses, leading to uniform and dense grain structures. On the other hand, chemical leaching of soluble crystal phases yields porous glass-ceramics with important applications. Here, glass/ceramic interfaces of niobo-, vanado- and titano-phosphate glasses were studied by micro-Raman spectroscopy, whose spatial resolution revealed the multiphase structures. Phase-separation mechanisms were also determined by this technique, revealing that interface composition remained unchanged as the crystallization front advanced for niobo- and vanadophosphate glasses (interface-controlled crystallization). For titanophosphate glasses, phase composition changed continuously with time up to the equilibrium composition, indicating a spinodal-type phase separation.

Variações de curto prazo nas emissões de CO2 do solo em diferentes sistemas de manejo do cafeeiro

Soil CO2 emissions represent an important component of carbon global cycle. However, information about short-term alterations of CO2 fluxes in soils of tropical regions are scarce. So, the objective of this study was to evaluate such variations in coffee plantations in Latosol (Oxisol). The CO2 emissions were not affected by environmental abiotic factors, such as temperature and soil water evaporation, but they were significantly correlated with the carbon content of microbial biomass (R=0.90, P<0.05). It happens a close relationship between root activity and soil CO2 emission in coffee plantations.

Evolução biomolecular homoquiral: a origem e a amplificação da quiralidade nas moléculas da vida

The fact that biologically relevant molecules exist only as one of the two enantiomers is a fascinating example of complete symmetry breaking of chirality and has long intrigued our curiosity. The origin of this selective chirality has remained a fundamental enigma with regard to the origin of life since the time of Pasteur, 160 years ago. The symmetry breaking processes, which include autocatalytic crystallization, asymmetric autocatalysis, spontaneous crystallization, adsorption and polymerization of amino acids on mineral surfaces, provide new insights into the origin of biomolecular homochirality.

Aplicação do modelo Tucker-3 para a análise da biodegradação de diesel

Tucker-3 model offers several advantages for analysis of environmental data but its interpretation is still challenging. A Tucker-3 model was applied to a biodegradation experiment involving a large number of overlapped chromatographic peaks and a temporal variation. The Tucker-3 model allowed the data to be decomposed in two processes: evaporation and biodegradation. The results suggest that linear hydrocarbons were those biodegraded first and demonstrate that the data analysis can be simplified by interpreting the elements of the core array. The approach discussed in this work can be applied in similar problems involving multi-way data in other areas of chemistry.

Encapsulation of naproxen in nanostructured system: structural characterization and in vitro release studies

Nanoparticles were produced by solvent emulsification evaporation method with the following characteristics: nanometric size (238 ± 3 nm), narrow polydispersity index (0.11), negative zeta potential (-15.1 mV), good yield of the process (73 ± 1.5%), excellent encapsulation efficiency (81.3 ± 4.2%) and spherical shape. X-rays diffraction demonstrated the loss of drug crystallinity after encapsulation; however, the profile of the diffractograms of the poly-ε-caprolactone (PCL) nanoparticles was kept. Differential scanning calorimetry thermograms, correspondingly, exhibited the loss of drug melting peak and the increasing of the melting point of the PCL nanoparticles, evidencing an interaction drug-polymer. Naproxen release was low and sustained obeying the Higuchi´s kinetic. The results show that nanoparticles are promising sustained release system to the naproxen.

Nanopartículas de lipídios sólidos: métodos clássicos de produção laboratorial

Solid lipid nanoparticles have been extensively investigated as drug delivery systems. These colloidal systems have major advantages compared to others more traditional. Reported advantages include sustained release, ability to solubilize lipophilic drugs, increased physical and chemical stability of labile molecules, decreased unwanted side-effects showing lower toxicity, and scale up facilities. This paper aims at reviewing the traditional methods of solid lipid nanoparticles production, such as fusion-emulsification (hot and cold), solvent evaporation-emulsification and microemulsion, dealing with the main technological parameters that influence the quality properties of solid lipid nanoparticles.

Efeitos da história térmica nas propriedades do polímero pet: um experimento para ensino de análise térmica

Polyethilenetherephtalate (PET) is commonly used in manufacturing of beverage bottles representing a didactic appeal in thermal analysis education due to its presence in the student's day life. Additionally such polymer presents well defined thermal analytical curves and a well known thermal behavior. TGA curve is used to present the thermal stability. The thermal history effects in the thermal properties of a PET sample from a soft drink bottle are used to demonstrate the effect of different heating/cooling conditions on glass transition, melting, crystallization and crystalline degree using DSC curves.

Processamento de placas de circuito impresso de equipamentos eletroeletrônicos de pequeno porte

A hydrometallurgical process applicable to printed circuit boards of small electrical and electronic devices was developed. This involved three leaching steps (60 ºC, 2 h): 6 mol L-1 NaOH, 6 mol L-1 HCl and aqua regia. NaOH removed the resin and flame retardant that covered the circuit boards. HCl dissolved the most electropositive metals and a small amount of copper (~0.3 wt%). Aqua regia dissolved the noble metals. Silver precipitated as AgCl. Gold and platinum were quantitatively extracted with pure methyl-isobutylketone and Alamine 336 (10 % vol. in kerosene), respectively. Slow evaporation of the raffinate crystallized CuCl2.4H2O (89% yield).

Influência dos precursores de prata no crescimento de nanopartículas metálicas em vidros óxidos de metais pesados

In this work we report a systematic study on the influence of the chemical nature of silver precursors on the formation of glass-ceramics from oxide glasses. Thermal, structural and optical properties were analyzed as a function of the glass composition. Controlled crystallization was achieved by thermal treatment of the samples above glass transition. The influence of time of treatment on both nanoparticle growth and optical properties of the samples was studied by transmission electron microscopy and UV-Vis spectroscopy, respectively. Results showed that only glasses containing AgCl and AgNO3 led to glass-ceramics growth after thermal treatment.