Concentrations and accumulation rates of chemical elements and sediment components in sediments of central equatorial Pacific, DSDP data

Accumulation rates of Mg, Al, Si, Mn, Fe, Ni, Cu, Zn, opal, and calcium carbonate have been calculated from their concentrations in samples from equatorial Deep Sea Drilling Project sites. Maps of element accumulation rates and of Q-mode factors derived from raw data indicate that the flux of trace metals to equatorial Pacific sediments has varied markedly through time and space in response to changes in the relative and absolute influence of several depositional influences: biogenic, detrital, authigenic, and hydrothermal sedimentation. Biologically derived material dominates the sediment of the equatorial Pacific. The distributions of Cu and Zn are most influenced by surface-water biological activity, but Ni, Al, Fe, and Mn are also incorporated into biological material. All of these elements have equatorial accumulation maxima similar to those of opal and calcium carbonate at times during the past 50 m.y. Detritus distributed by trade winds and equatorial surface circulation contributes Al, non-biogenic Si, Fe, and Mg to the region. Detrital sediment is most important in areas with a small supply of biogenic debris and low bulk-accumulation rates. Al accumulation generally increases toward the north and east, indicating its continental source and distribution by the northeast trade winds. Maxima in biological productivity during middle Eocene and latest Miocene to early Pliocene time and concomitant well-developed surface circulation contributed toward temporal maxima in the accumulation rates of Cu, Zn, Ni, and Al in sediments of those ages. Authigenic material is also important only where bulk-sediment accumulation rates are low. Ni, Cu, Zn, and sometimes Mn are associated with this sediment. Fe is almost entirely of hydrothermal origin. Mn is primarily hydrothermal, but some is probably scavenged from sea water by amorphous iron hydroxide floes along with other elements concentrated in hydrothermal sediments, Ni, Cu, and Zn. During the past 50 m.y. all of these elements accumulated over the East Pacific Rise at rates nearly an order of magnitude higher than those at non-rise-crest sites. In addition, factor analysis indicates that some of this material is carried substantial distances to the west of the rise crest. Accumulation rates of Fe in basal metalliferous sediments indicate that the hydrothermal activity that supplied amorphous Fe oxides to the East Pacific Rise areas was most intense during middle Eocene and late Miocene to early Pliocene time.

Methane concentration profiles and isotopic composition of sediment cores from the Black Sea

We present high resolution profiles for the methane concentration and the carbon isotope composition of methane from surface sediments and from the sediment-water transition in the Black Sea. At shallow water sites methane migrates from the sediment into the water column, and the magnitude of this upward migrating flux depends on the depth of the sulfate-methane transition (SMT) in the sediment. The isotope data reveal that the sediments at shallow water sites are a source for methane depleted in 13C relative to the isotope composition of methane in the water column. At deep water sites the methane concentration first decreases with depth in the sediment to reach lowest values at the Unit I to Unit II transition. Below this transition the concentration increases again. Numerical modeling of methane concentration and isotope data shows that high methane oxidation rates occur in the surface sediment layer, indicating that the removal of methane in the surface sediments is not related to the anaerobic oxidation of methane coupled to sulfate reduction that occurs a few meters deep in the sediment, at the SMT. Instead, near-surface methane consumption in the euxinic Black Sea sediments appears to be related to lithological stratification. Furthermore, a map of the diffusive methane fluxes in the Black Sea surface sediments indicates that approximately half of the Black Sea seafloor acts as a sink for methane and thus limits the flux of methane to the atmosphere.

Silicate content in sediment ofthe Santa Monica Basin, California

Seafloor recycling of organic materials in Santa Monica Basin, California was examined through in situ benthic chamber experiments, shipboard whole-core incubations and pore water studies. Mass balance calculations indicate that the data are internally consistent and that the estimated benthic exchange rates compare well with those derived from deep, moored conical sediment traps and hydrographic modeling. Pore water and benthic flux observations indicate that the metabolizable organic matter at the seafloor must be composed of at least two fractions of very different reactivities. While the majority of reactive organic compounds degrade quickly, with a half-life of <=6.5 years, 1/4 of the total metabolizable organic matter appears to react more slowly, with a half-life on the order of 1700 years. Down-core changes in pore water sulfate and titration alkalinity are not explained by stoichiometric models of organic matter diagenesis and suggest that reactions not considered previously must be influencing the pore water concentrations. Measured recycling and burial rates indicate that 43% of the organic carbon reaching the basin seafloor is permanently buried. The results for Santa Monica Basin are compared to those reported for other California Borderland Basins that differ in sedimentation rate and bottom water oxygen content. Organic carbon burial rates for the Borderland Basins are strongly correlated with total organic carbon deposition rate and bulk sedimentation rate. No significant correlation is observed between carbon burial and bottom water oxygen, extent of oxic mineralization and sediment mixing. Thus, for the California Borderlands, it appears that carbon burial rates are primarily controlled by input rates and not by variations in preservation.

Amino acid data of catchment and sediment core samples of four Indian lakes

In the present study, we report the results of comprehensive amino acid (AA) analyses of four Indian lakes from different climate regimes. We focus on the investigation of sediment cores retrieved from the lakes but data of modern sediment as well as vascular plant, soil, and suspended particulate matter samples from individual lakes are also presented. Commonly used degradation and organic matter source indices are tested for their applicability to the lake sediments, and we discuss potential reasons for possible limitations. A principal component analysis including the monomeric AA composition of organic matter of all analysed samples indicates that differences in organic matter sources and the environmental properties of the individual lakes are responsible for the major variability in monomeric AA distribution of the different samples. However, the PCA also gives a factor that most probably separates the samples according to their state of organic matter degradation. Using the factor loadings of the individual AA monomers, we calculate a lake sediment degradation index (LI) that might be applicable to other palaeo-lake investigations.

Hydrocarbons, sterols and alkenones at time series station KERFIX

Hydrocarbons, sterols and alkenones were analyzed in samples collected from a 10 month sediment trap time series deployed in the Indian Ocean sector of the Southern Ocean. Fluxes and within-class distributions varied seasonally. During higher mass and organic carbon (OC) flux periods, which occurred in austral summer and fall, fresh marine inputs were predominant. Vertical fluxes were most intense in January, but limited to one week in duration. They were, however, low compared with other oceanic regions. In contrast, low mass and OC flux periods were characterized by a strong unresolved complex mixture (UCM) in the hydrocarbon fraction and a high proportion of stanols as a result of zooplanktonic grazing. Terrigenous inputs were not detectable. The alkenone compositions were consistent with previous data on suspended particles from Antarctic waters. However, UK'37 values diverged from the linear and exponential fits established by Sikes et al. (1997, doi:10.1016/S0016-7037(97)00017-3) in the low temperature range. The seasonal pattern of alkenone production implied that IPT (integrated production temperature) is likely to be strongly imprinted by austral summer and fall SST (sea surface temperature).