High-temperature superconductivity in bismuth-copper oxides of the type BimMnCupOx (M=Mg, Ca, Sr, Ba, Bi)

Several oxides of the Bi m M n Cu p O x family (m=2, 3;n=2, 3, 4;p=1, 2, 3 and M=alkaline earth or Bi), possessing structures similar to the Aurivillius family of oxides, show highT c superconductivity.

In situ surface modification of molybdenum-doped organic-inorganic hybrid TiO2 nanoparticles under hydrothermal conditions and treatment of pharmaceutical effluent

Molybdenum-doped TiO2 organic-inorganic hybrid nanoparticles were synthesized under mild hydrothermal conditions by in situ surface modification using n-butylamine. This was carried out at 150 degrees C at autogeneous pressure over 18 h. n-Butylamine was selected as a surfactant since it produced nanoparticles of the desired size and shape. The products were characterized using powder X-ray diffraction, Fourier transform infrared spectrometry, dynamic light-scattering spectroscopy, UV-Vis spectroscopy and transmission electron microscopy. Chemical oxygen demand was estimated in order to determine the photodegradation efficiency of the molybdenum-doped TiO2 hybrid nanoparticles in the treatment of pharmaceutical effluents. It was found that molybdenum-doped TiO2 hybrid nanoparticles showed higher photocatalytic efficiency than untreated TiO2 nanoparticles.

Laser Surface Alloying of a Creep Resistant Magnesium Alloy MRI 230D with Al and Al2O3

A creep resistant permanent mould cast Mg alloy MRI 230D was laser surface alloyed with Al and a mixture of Al and Al2O3 using pulsed Nd:YAG laser irradiation at four different scan speeds in order to improve the corrosion and wear resistance. The microstructure, corrosion and wear behavior of the laser surface alloyed material is reported in this manuscript. The coating comprised of a featureless microstructure with cellular-dendritic microstructure near the interface and exhibited good interfacial bonding. A few solidification cracks reaching down to substrate were also observed. The two step coating with Al followed by a mixture of Al and Al2O3 exhibited a slightly better corrosion resistance than the single step coating with Al. In the long run, however, corrosion resistance of both the coatings became comparable to the as-cast alloy. The corroded surface of the laser surface alloyed specimens revealed a highly localized corrosion. The laser surface alloyed specimens exhibited an improvement in wear resistance. The laser scan speed did not exhibit a monotonic trend either in corrosion or wear resistance.

HNbWO6 and HTaWO6: Novel layered oxides related to the rutile structure. Synthesis and investigation of ion-exchange and intercalation behaviour

New protonated layered oxides, HMWO6·1.5H2O (M=Nb or Ta), have been synthesized by topotactic exchange of lithium in trirutile LiMWO6 with protons by treatment with dilute HNO3. The tetragonal cell constants are a=4.71 (2) and c=25.70 (8)Å for HNbWO6·1.5H2O and a=4.70 (2) and c=25.75 (9) Å for HTaWO6·1.5H2O. Partially hydrated compounds, HMWO6·0.5H2O and anhydrous compounds, HMWO6 retain the layered structure. The structure of these oxides consists of MWO6 sheets built up of M/W-oxygen octahedra with rutile type corner- and edge-sharing. Interlayer protons in HMWO6 are exchanged with Li+, Na+, K+ and Tl+. HMWO6 exhibit Brønsted acidity intercalating n-alkylamines and pyridine.

PES studies of semiconductor - metal transitions in metal oxides

Semiconductor-Metal transitions in Ti2O3, VO2, V2O3 and Ti3O5 have been investigated employing X-ray and UV Photoelectron spectroscopy. The transitions are accompanied by significant changes in the 3d band of the transition metals as well as some of the core levels.

Interannual Variations of Sea Surface Temperature over the Arabian Sea and the Indian Monsoon: A New Perspective

The interannual variation of surface fields over the Arabian Sea and Bay of Bengal are studied using data between 1900 and 1979. It is emphasized that the monthly mean sea surface temperature (SST) over the north Indian Ocean and monsoon rainfall are significantly affected by synoptic systems and other intraseasonal variations. To highlight the interannual signals it is important to remove the large-amplitude high-frequency noise and very low frequency long-term trends, if any. By suitable spatial and temporal averaging of the SST and the rainfall data and by removing the long-term trend from the SST data, we have been able to show that there exists a homogeneous region in the southeastern Arabian Sea over which the March�April (MA) SST anomalies are significantly correlated with the seasonal (June�September) rainfall over India. A potential of this premonsoon signal for predicting the seasonal rainfall over India is indicated. It is shown that the correlation between the SST and the seasonal monsoon rainfall goes through a change of sign from significantly positive with premonsoon SST to very small values with SST during the monsoon season and to significantly negative with SST during the post-monsoon months. For the first time, we have demonstrated that heavy or deficient rainfall years are associated with large-scale coherent changes in the SST (although perhaps of small amplitude) over the north Indian 0cean. We also indicate possible reasons for the apparent lack of persistence of the premonsoon SST anomalies.

Lack of Cu3+, Pb4+, and Bi5+ ions in metallic and superconducting oxides

With a view to understand the oxidation states of metal ions involved in oxide superconductors, oxidation behavior of Cu, Pb, and Bi metals have been studiedi employing x-ray-photoemission and ultraviolet-photoemission spectroscopy. Pb and Bi have distinct 6p (0 to 4 eV) and 6s (7.5 to 10 eV) bands and upon oxidation, only the 6p electrons are ionized forming PbO and Bi2O3 with the simultaneous development of the O2-(2p) band (3 to 7 eV). We show that the 6s band of metals lies below the O2-(2p) band, and hence 6s electrons cannot be ionized to form Pb4+ and Bi4+ as expected in PbO2, BaPbO3, BaBiO3, and BaPb0.75Bi0.25O3. Instead these oxides are stabilized with lower valent O22- along with O2- ions with metals remaining in +2 and +3 states. Similarly, it is shown that the Cu2+(3d) band overlaps with the O2-(2p) band in the YBa2Cu3O6.95 completely and the excess oxygen can be stabilized through lower valent oxide ions instead of Cu3+.

Magnetic susceptibility studies on ternary oxides of copper(II)

The magnetic susceptibilities of a large number of ternary oxides of copper having structural features common to the presently identified phases of high-temperature superconductors have been studied in the temperature range 14-300 K. The systems studied are Ln2CuOP( Ln = La, Pr, Nd, etc.), Sr2CuO2CI2,B i2Cu0,, Ca2Cu03,S r2Cu03,S rCu02, MgCu203,B a2Cu3O4CI2Y, 2Cu205,Y2BaCu0,, BaCu02, Li2Cu02, etc. Cu2+ ions take different coordinations, like isolated square planar, square pyramidal or distorted-tetrahedral and octahedral, in these compounds. These compounds also exhibit different varieties of possible magnetic superexchange interactions like 180' or 90' Cu-0-Cu or Cu-0-0-Cu types as well as direct Cu-Cu interactions. Compounds in which there are extended 180' Cu-0-Cu interactions show a low, nearly temperature-independent susceptibility (100 X lod emu/mol). The estimated value of J for the Cu-0-Cu interaction is between 800 and 1500 K in these compounds. Isolated Cu2+ ions in which there are no 180' or close to 180" Cu-0-Cu interactions show Curie-Weiss susceptibility behavior. Compounds with only Cu-0-0-Cu interaction show evidence for the onset of antiferromagnetic coupling between 30 and 50 K. The superexchange rules are useful for explaining the qualitative features of the results. The possibility of disproportionation of Cu2+ ion when there are short Cu-Cu distances as in Bi2Cu04 is discussed. The extended geometry of the copper-oxygen framework seems to be more important than the local geometry around the Cu2+ ion in determining the magnetic properties.

Modeling of the sea surface for daylight imagery studies

Plastic-coated paper is shown to possess reflectivity characteristics quite similar to those of the surface of water. This correspondence has been used with a conversion factor to model a sea surface by means of plastic-coated paper. Such a paper model is then suitably illuminated and photographed, yielding physically simulated daylight imagery of the sea surface under controlled conditions. A simple example of sinusoidal surface simulation is described.

Superconductivity in the 100–120 K region in oxides of the Tl-Ca-Ba-Cu-O system

Oxides with different cation ratios 2122, 2212, 2213 and 2223 in the Ti-Ca-Ba-Cu-O system exhibit onset of superconductivity in the 110–125 K range with zero-resistance in the 95–105 K range. Electron microscopic studies show dislocations, layered morphology and other interesting features. These oxides absorb electromagnetic radiation (9.11 GHz) in the superconducting phase.

Coupling of surface acoustic waves propagating in two separated piezoelectric media

The coupling of surface acoustic waves propagating in two separated piezoelectric media is studied using the perturbation theory of Auld. The results of the analysis are applied to two configurations using Bi12GeO20 and CdS crystals. It is found that the loss due to coupling is about 7 dB at 50 MHz in the cases of (111)-cut, [110]-prop. Bi12GeO20 and Y-cut, 60°-X prop. CdS combination. On étudie le couplage des ondes acoustiques de surface se propageant sur deux milieux piezo-eléctriques par la théorie de perturbation de Auld. Les resultats d'analyse sont appliqué's aux deux configurations des cristanx Bi12GeO20 et CdS. On trouve que la perte par couplage est environ de 7 dB a 50 MHz dans le cas de combination de (111)-coupe, [110]-prop. Bi12GeO20 et Y-coupe, 60°-X prop. CdS.