Structural study of aged saturated silica gels obtained from tetramethoxysilane sonohydrolysis with different water/tetramethoxysilane molar ratio

The structural characteristics of saturated silica sonogels were studied by means of small-angle x-ray scattering (SAXS) and thermogravimetric analysis (TG), after a long time of aging in saturated conditions. The sonogels were obtained by a sol-gel routine from ultrasound stimulated tetramethoxysilane (TMOS) hydrolysis carried out with the initial water/TMOS molar ratio (r) ranging from 2 to 10. The saturated sonogel structure can be described as composed by mass fractal-like aggregates (clusters) of primary silica particles, all imbibed in a liquid phase. The values of the mass fractal dimension (D) of the clusters was found all around 2.5, while the characteristic size of the clusters (ξ) was found generally increasing with r, going from approximately 2.3 nm (r = 2) to 4.5 nm (r = 10). The volume fraction of the clusters was estimated from the SAXS data. The results were compared to the values of weight loss fraction at the inflection point that has been found in the derivative of the TG curve, which should accounts for the instant in which the meniscus of the liquid phase penetrates into the clusters under a rapid evaporation process as in a TG test.

Biometric analysis of the maxillary permanent molar teeth and its relation to furcation involvement.

A high rate of root exposure and consequently the exposure of the furcation area is usually observed in multirooted teeth. In maxillary molar teeth, this fact may endanger the three existent furcations (buccal, mesial and distal), causing serious problems. In this research, distance measures from the buccal furcation to the mesial (F1M) and distal (F1D) surfaces of the mesio-buccal and disto-buccal roots; from the mesial furcation to the buccal (F2B) and palatal (F2P) surfaces of the mesio-buccal and palatal roots and from the distal furcation to the buccal (F3B) and palatal (F3P) surfaces of the disto-buccal and palatal roots, respectively were established. One hundred maxillary first molar teeth were used, 50 of the right and 50 of the left side. Reference marks and demarcations were determined on the furcations and also on the root surfaces involved in the measures. We concluded that these measurements are important because they may effectivelly contribute to diagnosis, prevention and treatment of periodontal problems.

Quirópteros da Estação Ecológica da Serra das Araras, Mato Grosso, Brasil, com o primeiro registro de Artibeus gnomus e A. anderseni para o cerrado

We present the results of the first bat inventory at the 'Serra das Araras' Ecological Station, MT, in the northwestern portion of the Cerrado domain. We captured bats using the traditional ground-level mist netting and, occasionally, high nets placed 3 m above the ground, and hand nets for hoosting bats. We recorded 23 species distributed in six families (Emballonuridae, Noctilionidae, Mormoopidae, Phyllostomidae, Molossidae, and Vespertilionidae), including Artibeus gnomus and A. anderseni, which had never been recorded in the Cerrado domain. © 2004 Instituto de Ciências Biológicas - UFMG.

Primeiro registro documentado de Alectrurus tricolor para o Pantanal, Brasil

The Cock-tailed Tyrant (Alectrurus tricolor, Vielliot 1816) is reported here for the first time in the Brazilian Pantanal. The species was seen twice (August and September 2005) in the northern portion of Fazenda Rio Negro, in the region of Nhecolândia. Sexual displays were observed, suggesting that reproduction is occuring in this area.

Articaine and mepivacaine efficacy in postoperative analgesia for lower third molar removal: a double-blind, randomized, crossover study

Objective: Comparison of the clinical efficacy of 4% articaine in relation to 2% mepivacaine, both with 1:100,000 epinephrine, in the prevention of postoperative pain after lower third molar removal. Study design: Twenty patients underwent removal of bilateral lower third molars under local anesthesia (articaine or mepivacaine) in 2 separate appointments, in a double-blind, randomized, and crossed manner. Objective and subjective parameters were recorded for paired comparison of postoperative courses. Results: Duration of analgesia provided by articaine and mepivacaine was 198.00 ± 25.86, and 125.40 ± 13.96 min, respectively (P = .02), whereas the duration of anesthesia was 273.80 ± 15.94 and 216.85 ± 20.15 min, respectively (P = .06). Both solutions exerted no important effects upon arterial pressure, heart rate, or oxygen saturation (P > .05). Conclusions: Articaine provides a longer period of analgesic effect and a tendency for a longer period of anesthesia as compared to mepivacaine. The presence of a vasoconstrictor agent in local anesthetic solutions does not seem to influence hemodynamic parameters during lower third molar removal in healthy subjects. © 2006 Mosby, Inc. All rights reserved.

Utilização do primeiro ciclo ovulatório da estação reprodutiva para produção de embriões em éguas sob condições tropicais

The efficacy of the first ovulation of the breeding season was determined through the response of first pre-ovulatory follicle of the breeding season to hCG, embryo recovery rate, viability of recovered embryos, serum concentrations of progesterone, and response of first CL to PGF 2α. Thirteenth mares that were in vernal transition were accompanied until the first pre-ovulatory follicle was detected. At this moment, the ovulation was induced with 2,500 IU hCG (IV) and the mares were inseminated every other day until ovulation. Seven days after the ovulation, embryo recovery was performed and the progesterone concentration was determined. After detection of the first pre-ovulatory follicle of breeding season with ≥ 25mm, it took 14.92 ± 10.80 days for the follicle to reach the preovulatory size and 18.00 ± 11.08 days to ovulation. After administration of hCG, 11/13 mares ovulated in 48 hours. These follicles growth 2.19 ± 0.86 mm/day on average. Nine of 13 mares (69.2%) produced embryos and all were considered viable after morfological evaluation and fluorescence exams. The CL appeared competent producing 7.39 ± 2.11 ng/ml P 4 on average, and responding to PGF 2α. According to these results the first ovulatory cycle of the year can be utilized to produce viable embryos.

Transformação cística como consequência de terceiro molar inferior incluso

The permanence of impacted third molar in the jaws can cause many pathological alterations, amongst them the appearance of odontogenic cysts. The paradental cyst appearance and evolution next to a mandibular included third molar was diagnosised in radiograph routine follow-up, and its evolution and treatment are described. Are discussed the aspects related with the preventive removal to the impacted third molars and the necessity to institution a plan of treatment based in clinical history and radiograph in order to establish a preventive protocol the alterations caused by these impactions. The indication of extraction of impacted third enclosed can be a way to preventing the appearance of these and otherspathologies associates to these lesions.

Bilateral lower second molar impaction in teenagers: An emergent problem

The frequency of simultaneously impacted second and third molars in teenagers is increasing and becoming a common occurrence in adolescent oral surgery practice. The traditional treatment is the removal of the third molar by conventional access but repositioning of the surgical flap to the distal face of the first molar can predispose to complications such as pericoronitis and delayed healing of the attached gingiva. We present a case in which we use the germectomy approach to remove the impacted third molar for the eruption of the second molar through a vestibular incision. This incision offers excellent bone exposure and exit route for the third molar without disturbing the gingiva attached architecture on the distal face of the first molar providing good healing environment.

Espaços Ibero-Americanos

Incluye Bibliografía

Diagnóstico das áreas de preservação permanente na bacia hidrográfica do rio Tijuco, Ituiutaba - MG, utilizando tecnologia SIG

The present work had the objective to elaborate the map of land use and vegetation covering from Tijuco river watershed, Ituiutaba-MG, based on digital images obtained by satellite from CBERS 2, through automatic delimitation of permanent preservation areas followed by identification of land use conflict based on the Brazilian Forest Code (Law no 4771/1965) and National Council of Environment's Resolution no 303/02. This paper analyzes, through quantitative parameters and the use of Geographic Information System, the maintenance tracks of width recommended by the legislation for permanent preservation areas over water bodies. The results showed a deficit of conserved areas along the riverbanks of 2334 ha that are not in compliance with the legislation. The pasture occupies unduly 0.97% of the area of the basin in the permanent preservation areas at the riverbanks, while agriculture occupies 0.38%.

Flexibilidade do mercado de trabalho, proteçao aos trabalhadores e treinamento vocacional de força de trabalho: a experiência de América Latina e perspectivas (análise do caso brasileiro)

Incluye Bibliografía

O novo cenário laboral latino-americano: regulaçao, proteçao e políticas ativas nos mercados de trabalho

Prólogo de Alicia Bárcena

La pobreza rural, una preocupación permanente en el pensamiento de la CEPAL

Incluye Bibliografía

Hacia una educación permanente en Chile

Incluye Bibliografía

Conversor CA-CA de elevado fator de potência para aplicações com geradores de Ímã permanente

This paper proposes and describes a high power factor AC-AC converter for naval applications using Permanent Magnet Generator (PMG). The three-phase output voltages of the PMG vary from 260 Vrms (220 Hz) to 380 Vrms (360 Hz), depending on load conditions. The proposed converter consists of a Y-/ΔY power transformer, which provides electrical isolation between the PMG and remaining stages, and a twelve-pulse uncontrolled rectifier stage directly connected to a single-phase inverter stage, without the use of an intermediary DC-DC topology. This proposal results in more simplicity for the overall circuitry, assuring robustness, reliability and reduced costs. Furthermore, the multipulse rectifier stage is capable to provide high power factor and low total harmonic distortion for the input currents of the converter. The single-phase inverter stage was designed to operate with wide range of DC bus voltage, maintaining 120 Vrms, 60 Hz output. The control philosophy, implemented in a digital signal processor (DSP) which also contains protection routines, alows series connections between two identical converters, achieving 240 Vrms, 60 Hz total output voltage. Measured total harmonic distortion for the AC output voltage is lower than 2% and the input power factor is 0.93 at 3.6kW nominal load. © 2010 IEEE.