琼东南盆地新生代发育机制的模拟研究

琼东南盆地是南海西北陆缘上一个北东走向的伸展裂陷带,向西与北西走向的莺

“第七届全国绿色环保肥料(农药)新技术、新产品交流会”专题报告

本次会议有27个专题报告,各具特色、异彩纷呈,突出展现了腐植酸肥料(农药)领域开发应用的最新研究和开发进展。为了让读者了解本次会议取得的成果,本栏目按会议专题报告顺序,将报告提要、报告中具有代表性的图或表、报告人简介和报告评价等内容编辑刊出。见21～45页。

长白山赤杨丛枝菌根真菌多样性的半巢式LP-PCR-SSCP检测分析

利用半巢式LP PCR SSCP技术 ,对中国吉林长白山不同海拔生境下 3种赤杨共生丛枝菌根真菌的多样性进行检测分析 .结果表明 ,该地区赤杨属东北赤杨、西伯利亚赤杨及色赤杨共生丛枝菌根真菌在科乃至种的水平上并未随宿主的变化表现出丰富的多样性 ;3个树种在自身属的水平上与共生的球囊霉科 (Glomaceae)至少 1种AMF ,即G .intraradix ,在种的水平上表现出不相关于宿主海拔高度的某种相互选择性 .

Anodic Stripping Voltammetry at Bismuth-Coated and Uncoated Carbon Microdisk Electrodes:Application to Trace Metals Analysis in Flood Samples

This article reports on the performance of a bismuth-coated carbon microdisk electrode (BiFμE) for the determination of trace heavy metals by anodic stripping voltammetry (ASV). The BiFμE was prepared by electrodeposition of a metallic bismuth film onto the microdisk, by applying an in-situ electroplating procedure. To test the performance of the BiFμE, ASV measurements were performed on synthetic solutions containing Cd2+, Pb2+, and Cu2+ as target ions. The results indicated that cadmium and lead gave well-defined ASV peaks with no interference, and their quantitative determination could be carried out straightforwardly. In particular, linear calibration curves over the range 5.0 x 10-8-1.0 x 10-6M for both ions, and detection limits of 7.8 and 2.9 nM, for cadmium and lead, respectively, after applying a 60 sec preconcentration step, were obtained. The reproducibility was also satisfactory, the relative standard deviation (RSD) being within 2.5% for both ions. Copper, instead, gave an ASV response that. in most experimental conditions, overlapped with that of bismuth. This circumstance made the determination of copper at the BiFμE difficult. Since the latter element could be detected reliably at the uncoated carbon microdisk electrode (CμE), both BiFμE and CμE were employed, respectively, for the determination of lead and copper ions in drinking water, wine, and tomato sauce.

Effect of core structure on the fluorescence properties of hyperbranched poly(phenylene sulfide)

We functionalize the focal group of hyperbranched poly(phenylene sulfide) (HPPS) with benzyl, phenyl, and naphthyl group, respectively. DSC analysis shows that T-g of HPPS is increased from 55 to 93 degrees C by functionalization of the focal group with a conjugated naphthyl group. The fluorescence properties of the three core-functionalized HPPS' are studied under the comparison with the original HPPS.

Synthesis, characterization and assembly of BiOCl nanostructure and their photocatalytic properties

In this article, a two-dimensional (2D) nanoplate and a 3D hierarchical structure of BiOCl were synthesized through a simple sonochemical route. Compared with previous preparation methods, the 2D nanoplates can be prepared at a relatively short time (about 30 min) with low energy used. Additionally, these 2D nanoplates can easily assemble into a 3D hierarchical structure with the surfactant reagents. The obtained products were well crystallized and subsequently characterized by a range of methods, such as X-ray powder diffraction (XRD), scanning electron microscopy (SEM), transmission electron microscopy (TEM), high-resolution transmission microscopy (HRTEM), selected area electron diffraction (SAED) and Raman spectroscopy.

聚氨基黑10B/Nafion修饰电极上多巴胺的检测

用电化学聚合法制备了聚氨基黑10B/Nafion修饰电极,利用循环伏安法研究了多巴胺在此修饰电极上的电化学行为。在磷酸盐缓冲溶液(pH6.0)中,多巴胺在修饰电极上呈现可逆的氧化还原峰。其峰电位都随pH值的增加而负移。多巴胺氧化还原峰电流与其浓度在0.2～30μmol/L范围内呈良好的线性关系;检出限为1.0×107mol/L。实验结果表明:本修饰电极具有良好的重现性、稳定性和较强的抗干扰能力。将此修饰电极用于多巴胺注射液和小牛血清中多巴胺的检测,结果令人满意。

Solvent Vapor-Induced Self Assembly and its Influence on Optoelectronic Conversion of Poly(3-hexylthiophene): Methanofullerene Bulk Heterojunction Photovoltaic Cells

Nanoscale-phase separation of electron donor/acceptor blends is crucial for efficient charge generation and collection in Polymer bulk heterojunction photovoltaic cells. We investigated solvent vapor annealing effect of poly(3-hexylthiophene) (P3HT)/methanofullerene (PCBM) blend oil its morphology and optoelectronic properties. The organic solvents of choice for the treatment have a major effect oil the morphology of P3HT/PCBM blend and the device performance. Ultraviolet-visible absorption spectro,;copy shows that specific solvent vapor annealing can induce P3HT self-assembling to form well-ordered structure; and hence, file absorption in the red region and the hole transport are enhanced. The solvent that has a poor Solubility to PCBM Would cause large PCBM Clusters and result in a rough blend film. By combining an appropriate solvent vapor treatment and post-thermal annealing of the devices, the power conversion efficiency is enhanced.