Controlled growth of zinc nanowires

Zinc nanowires have been synthesized by heating a mixture of boron and zinc oxide (ZnO) powders at 1050 °C under a nitrogen atmosphere. The influences of the gas flow rate and the substrate character on the nanowire formation were investigated. It was found that higher-flow rate of gas led to the formation of thinner nanowires; while lower-flow rate of gas produced thicker nanowires and even particles due to the higher partial pressure of Zn vapor in this case. Zn nanowires can be produced on alumina and quartz substrates, but not on a stainless-steel substrate under the same or different synthetic conditions. Photoluminescence measurements were conducted on Zn nanowires and particles and weak emission bands at 482 and 493 nm were observed, which may be contributed by the thin ZnO film on the nanowire surface.

Microstructure evolution in hot worked and Annealed Magnesium Alloy AZ31

The present work examines the microstructure that evolves during the annealing of hot worked magnesium alloy AZ31. First, the influences of deformation and annealing conditions on the microstructures are assessed. It is found that the annealing behaviour is consistent with what one would expect for a recrystallization type reaction. Whilst both the deformation and annealing conditions influence the time required to reach a stable annealed microstructure, the grain size attained is governed solely by the prior deformation conditions employed. At the highest temperature and strain rate examined, the rate of recrystallization is quite high and the grain size was found to be approximately double when annealed for only 1 s prior to quenching. Finally, semi-empirical equations are developed to predict the kinetics of recrystallization, as well as the evolution of grain size, during annealing.

Non-Schmid behaviour during secondary twinning in a polycrystalline magnesium alloy

The present work combines electron backscattering diffraction and Schmid analysis to investigate secondary twinning in the magnesium alloy Mg–3Al–1Zn. Inspection of the misorientations between the parent and ^{{1011} - {1012}} doubly twinned volumes reveals that there are four possible variants. One of these variants (the one that forms a misorientation with the matrix characterized by 38°^⟨1210⟩ ) is favoured much more than the others. This variant involves the activation of secondary twinning systems quite inconsistent with Schmid-type behaviour. For the secondary twin to grow significantly it must take on a shape enforced by the primary twin. This is non-optimal for strain compatibility. It is argued that the 38°^⟨1210⟩ variant occurs most because it provides the closest match between the primary and secondary twinning planes, thus minimizing the compatibility strain.

Effect of microalloying with rare-earth elements on the texture of extruded magnesium-based alloys

A series of alloys have been produced with microalloying additions of rare-earth (RE) elements in the range of 0.1–0.4 wt.%. The alloys have been extruded to produce grain sizes of 23 ± 5 μm. The texture of the extruded alloys was measured, and it was found that the extrusion texture was weakened by the addition of RE elements. The samples with weakened extrusion textures exhibited an increase in the tensile elongation.

Intracellular zinc homeostasis in leukocyte subsets is regulated by different expression of zinc exporters ZnT-1 to ZnT-9

Intracellular zinc homeostasis is strictly regulated by zinc binding proteins and zinc transporters. In the present study, we quantified in a first global view the expression of all characterized human zinc exporters (hZnT-1-9) in different leukocyte subsets in response to zinc supplementation and depletion and analyzed their influence on alterations in the intracellular zinc concentration. We found that hZnT-1 is the most regulated zinc exporter. Furthermore, we discovered that hZnT-4 is localized in the plasma membrane similar to hZnT-1. hZnT-4 is most highly expressed in Molt-4, up-regulated after treatment with PHA and is responsible for the measured decrease of intracellular zinc content after high zinc exposure. In addition, we found that hZnT-5, hZnT-6, and hZnT-7 in Raji as well as hZnT-6 and hZnT-7 in THP-1 are up-regulated in response to cellular zinc depletion. Those zinc exporters are all localized in the Golgi network, and this type of regulation explains the observed zinc increase in both cell types after up-regulation of their expression during zinc deficiency and, subsequently, high zinc exposure. Furthermore, we detected, for the first time, the expression of hZnT-8 in peripheral blood lymphocytes, which varied strongly between individuals. While hZnT-2 was not detectable, hZnT-3 and hZnT-9 were expressed at low levels. Further on, the amount of expression was higher in primary cells than in cell lines. These data provide insight into the regulation of intracellular zinc homeostasis in cells of the immune system and may explain the variable effects of zinc deficiency on different leukocyte subsets.

Nano zinc oxide for UV protection of textiles

This paper describes the effect on the fading of dyed polyester fabrics in artificial sunlight, when the Ultra Violet (UV) component of the radiation was blocked by coating the fabric with zinc oxide nanoparticles, dispersed in an acrylic polymer. Zinc oxide is photoactive and generates superoxide and hydroxyl radicals (Reactive Oxygen Species; ROS) when irradiated with UV in the presence of oxygen and water. The results for the four dyes studied show that different dye chromophores interact differently with ROS. Selection of dyes with anti oxidant properties or addition of other anti oxidants may reduce the adverse effects of ROS

Magnesium alloy applications in automotive structures

The energy absorbed by magnesium alloys (high-pressure die-cast (HPDC) AM20, AM50, AM60, and extruded AZ31) in a buckling test was significantly greater than the aluminum alloy 6061 T6 and particularly mild steel of a similar weight, but was less than that of the aluminum alloy and steel for the same thickness (Figure 6).26 This indicates that mass savings can be achieved by the substitution with magnesium alloys to achieve similar energy-absorbing characteristics.

Texture and mechanical anisotropy in three extruded magnesium alloys

One ZM61 alloy (6·2%Zn, 1·2%Mn) and two magnesium alloys containing nominally 3% of neodymium and yttrium respectively have been prepared in the form of hot extruded flat strips. Their textures and microstructures have been quantified and series of mechanical tests were carried out to determine plane stress yield loci in both the solution treated and aged conditions. The ZM61 alloy had a sharp texture and marked anisotropy of strength that could be rationalised in terms of deformation by basal <a> slip and {1012}<1011> twinning. This material was much weaker in compression than in tension. Precipitation hardening on aging caused a greater impedance to twinning than to slip with the result that the anisotropy was somewhat reduced. The Mg–3Nd alloy had a very weak and different texture but nevertheless demonstrated a pronounced anisotropy of strength. Aging increased the yield stress by about 80% and also inhibited twinning to some extent although the degree of anisotropy remained almost unaffected. The Mg–3Y alloy which showed a texture of intermediate strength was different in type from either of the others. Its strength behaviour was close to isotropic; in particular, no difference existed between tensile and compressive loading, and aging produced only a marginal increase in strength. Twins were relatively infrequent in the deformed Mg–3Y alloy but its mechanical behaviour could not be rationalised according to simple models.

Identification and rationalization of secondary twin variants in a magnesium alloy

The present work combines electron backscatter diffraction, transmission electron microscopy and Schmid analysis to investigate secondary twinning in the magnesium alloy Mg-3AI-1Zn. Inspection of the misorientations between the parent matrix and {1011} - {1012} doubly twinned volumes reveals that there are four possible variants. One of these variants characterized by 38°< 1210 > misorientation with the matrix is favoured much more than the others. This variant involves activation of the secondary twinning systems that are quite inconsistent with the Schmid-type behaviour. For the secondary twin to grow significantly it must take on a shape enforced by the primary twin, however, this is not optimal for strain compatibility. It is argued that the 38° < 1210 > variant occurs most frequently because it provides the closest match between the primary and secondaty twinning planes, thus minimizing the compatibility strain. This conjecture is confirmed by the simulations of twin activity m ellipsoidal grains performed using the visco-plastic self-consistent crystal plasticity model.

Some issues relating to the ductility of wrought magnesium alloys

The present work is concerned with gaining a better understanding of the factors that control the ductility of wrought magnesium alloys. The ultimate aim is to develop alloys with vastly improved room temperature formability. It is shown that 3D tomography of fractured tensile specimens reveals disk shaped voids aligned more or less at 45 deg. to the tensile axis. These voids are consistent with twin induced void formation. It is also shown that the double twins that produce such voids form in contradiction to Schmid predictions. Finally, it is demonstrated that low levels of rare-earth additions leads to vastly improved texture and ductility in extrusions, as they do in rolled sheet.

Copper and zinc mediated oligomerisation of Aß peptides

The accumulation of senile plaques composed primarily of aggregated amyloid β-peptide (Aβ), is the major characteristic of Alzheimer’s disease. Many studies correlate plaque accumulation and the presence of metal ions, particularly copper and zinc. The metal binding sites of the amyloid Aβ peptide of Alzheimer’s disease are located in the N-terminal region of the full-length peptide. In this work, the interactions with metals of a model peptide comprising the first 16 amino acid residues of the amyloid Aβ peptide, Aβ(1–16), were studied. The effect of Cu²⁺ and Zn²⁺ binding to Aβ(1–16) on peptide structure and oligomerisation are reported. The results of ESI-MS, gel filtration chromatography and NMR spectroscopy demonstrated formation of oligomeric complexes of the peptide in the presence of the metal ions and revealed the stoichiometry of Cu²⁺ and Zn²⁺ binding to Aβ(1–16), with Cu²⁺ showing a higher affinity for binding the peptide than Zn²⁺.

Effect of zinc supplementation on the immune status of healthy older individuals aged 55–70 years : the ZENITH Study

Aging is associated with alterations in the immune system, effects which may be exacerbated by inadequate zinc (Zn) status. We examined the relationship between Zn status and markers of immunity and the effect of supplementation with 15 mg or 30 mg Zn/d for 6 months on immune status in healthy individuals. Zn status was assessed by dietary intake and biochemical indices. Immune status was assessed by multiple flow cytometric methods. At baseline, Zn concentration was positively associated with lymphocyte subpopulation counts and T-lymphocyte activation. Zn supplementation of 30 mg/d significantly lowered B-lymphocyte count, albeit at month 3 only. Lower doses of Zn (15 mg Zn/d) significantly increased the ratio of CD4 to CD8 T lymphocytes at month 6. Overall, these findings suggest that total Zn intake (diet plus supplementation) of up to 40 mg Zn/d do not have significant long-term effects on immune status in apparently healthy persons aged 55–70 years.

Production and bioavailability of calcium and magnesium salts of omega-3 fatty acids

In order to provide an alternative to traditional liquid fish oil gelatin capsules, we developed a solid, powdered form of omega-3 fish oil concentrate by forming calcium- and magnesium-fatty acid salts. These salts were produced using a concentrated fish oil ethyl ester that contained in excess of 60% omega-3 fatty acids. The bioavailability of these omega-3 salts was compared with that of fish oil ethyl ester in mice. Animals were given 8 mg of omega-3 fatty acid ethyl ester concentrate (control), calcium- or magnesium-omega-3 salts daily for three weeks. The omega-3 salt products resulted in omega-3 fatty acid content in serum and red blood cell membranes comparable to that produced by the ethyl ester supplementation. In addition, fecal excretion of omega-3 fatty acids was not increased by the presence of calcium or magnesium. In fact, there was a tendency for less omega-3 fatty acids to be excreted.

Reducing the photocatalytic activity of zinc oxide quantum dots by surface modification

The use of zinc oxide (ZnO) nanoparticles as ultraviolet (UV) absorbers for many organic substrates is limited because of the high photocatalytic activity of ZnO. In this study, a facile and efficient technique for the preparation of a hybrid material of silica-coated ZnO nanoparticles was used to reduce the photocatalytic activity of ZnO. Monodispersed ZnO nanopartcles were prepared by wet chemistry and the particle surface was modified by tetraethylorthosilicate to form a silica coating via the Sto¨ ber method. ZnO samples, both before and after the coating process, were investigated by transmission electron microscopy, X-ray diffraction, dynamic light scanning, infrared, and UV-Vis absorption spectroscopy. The effect of the surface modification on the photocatalytic activity of ZnO was studied by monitoring the degradation of Rhodamine B caused by photo-generated free radicals. The results implied that the photo-generation of free-radicals was strongly quenched by the presence of silica on the particle surface.