Dynamic modelling and analysis of hydraulic forces in radial blood pumps

Dissertação de mestrado integrado em Biomedical Engineering Biomaterials, Biomechanics and Rehabilitation

Optical properties of zirconium oxynitride films: the effect of composition, electronic and crystalline structures

tThis work is devoted to the investigation of zirconium oxynitride (ZrOxNy) films with varied opticalresponses prompted by the variations in their compositional and structural properties. The films wereprepared by dc reactive magnetron sputtering of Zr, using Ar and a reactive gas mixture of N2+ O2(17:3).The colour of the films changed from metallic-like, very bright yellow-pale and golden yellow, for low gasflows to red-brownish for intermediate gas flows. Associated to this colour change there was a significantdecrease of brightness. With further increase of the reactive gas flow, the colour of the samples changedfrom red-brownish to dark blue or even to interference colourations. The variations in composition dis-closed the existence of four different zones, which were found to be closely related with the variationsin the crystalline structure. XRD analysis revealed the change from a B1 NaCl face-centred cubic zirco-nium nitride-type phase for films prepared with low reactive gas flows, towards a poorly crystallizedover-stoichiometric nitride phase, which may be similar to that of Zr3N4with some probable oxygeninclusions within nitrogen positions, for films prepared with intermediate reactive gas flows. For highreactive gas flows, the films developed an oxynitride-type phase, similar to that of -Zr2ON2with someoxygen atoms occupying some of the nitrogen positions, evolving to a ZrO2monoclinic type structurewithin the zone where films were prepared with relatively high reactive gas flows. The analysis carriedout by reflected electron energy loss spectroscopy (REELS) revealed a continuous depopulation of thed-band and an opening of an energy gap between the valence band (2p) and the Fermi level close to 5 eV.The ZrN-based coatings (zone I and II) presented intrinsic colourations, with a decrease in brightness anda colour change from bright yellow to golden yellow, red brownish and dark blue. Associated to thesechanges, there was also a shift of the reflectivity minimum to lower energies, with the increase of thenon-metallic content. The samples lying in the two last zones (zone III, oxynitride and zone IV, oxide films)revealed a typical semi-transparent-optical behaviour showing interference-like colourations only dueto the complete depopulation of the d band at the Fermi level. The samples lying in these zones presentedalso an increase of the optical bandgap from 2 to 3.6 eV.

The real economic effects of cross-delistingfrom the united states: evidence on post-operating performance, financial constraints and stock crash risk

Tese de Doutoramento em Ciências Empresariais.

Flood analysis of the clare river catchment considering traditional factors and climate change

The main objective of this thesis on flooding was to produce a detailed report on flooding with specific reference to the Clare River catchment. Past flooding in the Clare River catchment was assessed with specific reference to the November 2009 flood event. A Geographic Information System was used to produce a graphical representation of the spatial distribution of the November 2009 flood. Flood risk is prominent within the Clare River catchment especially in the region of Claregalway. The recent flooding events of November 2009 produced significant fluvial flooding from the Clare River. This resulted in considerable flood damage to property. There were also hidden costs such as the economic impact of the closing of the N17 until floodwater subsided. Land use and channel conditions are traditional factors that have long been recognised for their effect on flooding processes. These factors were examined in the context of the Clare River catchment to determine if they had any significant effect on flood flows. Climate change has become recognised as a factor that may produce more significant and frequent flood events in the future. Many experts feel that climate change will result in an increase in the intensity and duration of rainfall in western Ireland. This would have significant implications for the Clare River catchment, which is already vulnerable to flooding. Flood estimation techniques are a key aspect in understanding and preparing for flood events. This study uses methods based on the statistical analysis of recorded data and methods based on a design rainstorm and rainfall-runoff model to estimate flood flows. These provide a mathematical basis to evaluate the impacts of various factors on flooding and also to generate practical design floods, which can be used in the design of flood relief measures. The final element of the thesis includes the author’s recommendations on how flood risk management techniques can reduce existing flood risk in the Clare River catchment. Future implications to flood risk due to factors such as climate change and poor planning practices are also considered.

Development of an integrated approach to reliability management and operation

The research described in this thesis has been developed as a part of the Reliability and Field Data Management for Multi-component Products (REFIDAM) Project. This project was founded under the Applied Research Grants Scheme administered by Enterprise Ireland. The project was a partnership between Galway-Mayo Institute of Technology and Thermo King Europe. The project aimed to develop a system in order to manage the information required for reliability assessment and improvement of multi-component products, by establishing information flows within the company and information exchange with fleet users.

Development of a new method for the characterisation of bioreactors concerning heat and mass transfer

Since the specific heat transfer coefficient (UA) and the volumetric mass transfer coefficient (kLa) play an important role for the design of biotechnological processes, different techniques were developed in the past for the determination of these parameters. However, these approaches often use imprecise dynamic methods for the description of stationary processes and are limited towards scale and geometry of the bioreactor. Therefore, the aim of this thesis was to develop a new method, which overcomes these restrictions. This new approach is based on a permanent production of heat and oxygen by the constant decomposition of hydrogen peroxide in continuous mode. Since the degradation of H2O2 at standard conditions only takes place by the support of a catalyst, different candidates were investigated for their potential (regarding safety issues and reaction kinetic). Manganese-(IV)-oxide was found to be suitable. To compensate the inactivation of MnO2, a continuous process with repeated feeds of fresh MnO2 was established. Subsequently, a scale-up was successfully carried out from 100 mL to a 5 litre glass bioreactor (UniVessel®)To show the applicability of this new method for the characterisation of bioreactors, it was compared with common approaches. With the newly established technique as well as with a conventional procedure, which is based on an electrical heat source, specific heat transfer coefficients were measured in the range of 17.1 – 24.8 W/K for power inputs of about 50 – 70 W/L. However, a first proof of concept regarding the mass transfer showed no constant kLa for different dilution rates up to 0.04 h-1.Based on this, consecutive studies concerning the mass transfer should be made with higher volume flows, due to more even inflow rates. In addition, further experiments are advisable, to analyse the heat transfer in single-use bioreactors and in larger common systems.

Marxism, social metabolism, and ecologically unequal exchange

Authors working on "industrial metabolism" or "social metabolism" look at the economy in terms of flows of energy and materials. Together with the ecological economists, they see the economy as a subsystem of a larger physical system. Marx and Engels followed with a few years’ delay many of the remarkable scientific and technical novelties of their time.

Environment conditions and biological innovations in the european agrarian growth, 1819-1939

The circumstances that were the driving forces behind Europe's economic growth beginning in the 19th century are diverse, and not easily prioritized. Until the 1970's, specifically, in Economy and Economic History, attention was focused on different institutional and technological variables, and various regularities were proposed. Nevertheless, new studies also underlined that the evolution of economic activity could not be understood considering only the new production possibilities offered by market economies. As a result, today it is also accepted that those processes can not be explained without considering two additional circumstances: the energy flows that sustained them, and the changes undergone in their transformation In this context, a question arises that takes on special importance. Which was the influence of the biological change in the economic growth?. A part of the flows of energy must be made into food, and this transformation can only happen with the participation.

Contractions in the 2-wasserstein lenght space and thermalization of granular media

An algebraic decay rate is derived which bounds the time required for velocities to equilibrate in a spatially homogeneous flow-through model representing the continuum limit of a gas of particles interacting through slightly inelastic collisions. This rate is obtained by reformulating the dynamical problem as the gradient flow of a convex energy on an infinite-dimensional manifold. An abstract theory is developed for gradient flows in length spaces, which shows how degenerate convexity (or even non-convexity) | if uniformly controlled | will quantify contractivity (limit expansivity) of the flow.

Material Flow Accounting in Chile, Ecuador, Mexico and Peru (1980-2000)

In this paper we compare the resource flows of Chile, Ecuador, Mexico and Peru between 1980 and 2000. In this time span, the domestic extraction of materials increased in the four countries, mainly due to the mining sector in Chile and Peru, biomass and oil in Ecuador and construction minerals in Mexico. Imports and exports increased too, due to the increasing integration in the international markets, prompted by the liberalization policies undertaken by the four countries between the late 1970s and the late 1990s. The four countries had a negative physical trade balance for most of the period analyzed, meaning that their exports exceeded their imports in terms of weight. However, the increase of imports reduced the physical deficit in Chile, Mexico and Peru. Ecuador’s physical deficit was the highest and did not decrease in the period analyzed. Also, a diversification of exports away from bulk commodities could be observed in Chile and Mexico, and to a lesser extent in Peru, whereas in Ecuador the export sector remained mainly based on oil and biomass. More research is needed to explore the environmental effects of this phenomenon. Also, the indirect flows associated to the direct physical flows deserve to be subject to further analysis.

Different trajectories of exosomatic energy metabolism for Brazil, Chile and Venezuela: using the MSIASM approach

Economic development goes hand in hand with an increase in the consumption of natural resources. Some analysts use material flows to describe such relationship [Eurostat 2001, Weisz et al., 2006], or exergy [Ayres et al., 2003]. Instead this paper will use a characterisation of the exosomatic energy metabolism based on expected benchmark values to describe possible constraints to economic development posed by available human time and energy. The aim of the paper is to identify types of exosomatic energy metabolism of different societies to interpret its consequences for economic development. This is done with the application of the accounting methodology called Multi-Scale Integrated Analysis of Societal Metabolism (MSIASM) to the particular case of energy metabolism for the analysis of the economies of Brazil, Chile and Venezuela.

The biophysical perspective of a middle income economy: material flows in Mexico

We analyse natural resource use dynamics in the Mexican economy during the last three decades. Despite low and uneven economic growth, the extraction and use of materials in the Mexican economy has continuously increased during the last 30 years. In this period, population growth rather than economic growth was the main driving force for biophysical growth. In addition, fundamental changes have taken place in the primary sectors, in manufacturing, and in household consumption and these are reflected in an increasing emphasis on the use of fossil fuels and construction materials. Mexico’s economy has been strongly influenced by international trade since the country commenced competing in international markets. In the 1970s, Mexico mainly exported primary resources. This pattern has changed and manufactured goods now have a much greater importance due to a boom in assembling industries. In contrast with other Latin American countries, Mexico has achieved a diversification of production, moving towards technology-intensive products and a better mix in its export portfolio. However, crude oil exports still represent the single most important export good. Mexico’s material consumption is still well below the OECD average but is growing fast and the current resource use patterns may well present serious social and environmental problems to the medium and long term sustainability of Mexico’s economy and community. Information on natural resource use and resource productivity could provide valuable guidance for economic policy planning in Mexico.

Immigration and Firm Growth: Evidence from Spanish cities

This article analyses the effect of immigration flows on the growth and efficiency of manufacturing firms in Spanish cities. To date, most studies have tended to focus on the effect immigrants have on labour markets at an aggregate level. Here, however, we undertake an exhaustive analysis at the firm level and report conclusive empirical findings. Ten years ago, Spain began to register massive immigration flows, concentrated above all on its most dynamic and advanced regions. Here, therefore, rather than focusing on the impact this has had on Spain’s labour market (changes to the skill structure of the workforce, increase in labour supply, the displacement of native workers, etc.), we examine the arrival of immigrants in terms of the changes this has meant to the structure of the country’s cities and their amenities. Thus, we argue that the impact of immigration on firm performance should not only be considered in terms of the labour market, but also in terms of how a city’s amenities can affect the performance of firms. Employing a panel data methodology, we show that the increasing pressure brought to bear by immigrants has a positive effect on the evolution of labour productivity and wages and a negative effect on the job evolution of these manufacturing firms. In addition, both small and new firms are more sensitive to the pressures of such immigrant inflows, while foreign market oriented firms report higher productivity levels and a less marked impact of immigration than their counterparts. In this paper, we also present a set of instruments to correct the endogeneity bias, which confirms the effect of local immigration flows on the performance of manufacturing firms.

Innovation, R&D spillovers and productivity: the role of knowledge-intensive services

This paper analyses the performance of companies’ R&D and innovation and the effects of intra- and inter-industry R&D spillover on firms’ productivity in Catalonia. The paper deals simultaneously with the performance of manufacturing and service firms, with the aim of highlighting the growing role of knowledge-intensive services in promoting innovation and productivity gains. We find that intra-industry R&D spillovers have an important effect on the productivity level of manufacturing firms, and the inter-industrial R&D spillovers related to computer and software services also play an important role, especially in high-tech manufacturing industries. The main conclusion is that the traditional classification of manufactured goods and services no longer makes sense in the ‘knowledge economy’ and in Catalonia the regional policy makers will have to design policies that favour inter-industrial R&D flows, especially from high-tech services.