Effect of dentine surface treatment on leakage of root fillings with a glass ionomer sealer.

The purpose of this study was to observe the quality of seal of the glass ionomer cement, Ketac-Endo, after treatment of the root canal wall. The root canals of 140 extracted human teeth were prepared biomechanically. The root canals were treated with either EDTA or received an intracanal dressing of calcium hydroxide or camphorated paramonochlorphenol. The root canals were filled by the lateral condensation technique with gutta-percha points and the sealer Ketac-Endo, or zinc oxide-eugenol cement or Sealapex. The teeth were placed into a 2% methylene blue dye solution inside a flask, which was attached to a vacuum pump. Leakage was measured linearly. Sealapex exhibited significantly less leakage than Ketac-Endo or zinc oxide-eugenol cement (P<0.01). The use of EDTA and intermediary dressings reduced significantly (P<0.01) the leakage observed with the zinc oxide-eugenol sealer and Ketac-Endo.

Apical leakage following root canal dressing with calcium hydroxide.

The purpose of this study was to analyse the apical leakage in teeth filled by the lateral condensation technique following medication with calcium hydroxide. One hundred and twenty extracted human teeth were biomechanically prepared by using exclusively reaming motion with files up to #40. Half of the teeth received a calcium hydroxide dressing for 3 days. The medication was removed by irrigation and reaming motion with files #40 up to #70. The teeth were divided in 6 experimental groups, according to the dimension of the utilized instrument. The root canals were filled and posteriorly the teeth were placed into a 2% methylene blue dye solution inside a flask, which was attached to a vacuum pump. Leakage was measured linearly, and the results showed significantly (p<0.01) less leakage in the experimental groups that received calcium hydroxide dressings than in the control groups. The results persisted even after the removal of 300 micrometers of dentin from the root canal dentinal walls.

Apical leakage after root canal filling with an experimental calcium hydroxide gutta-percha point

This study was an in vitro analysis of the apical seal of root canals filled with an experimental calcium hydroxide gutta-percha point. One hundred and ten recently extracted human permanent teeth with a single root were used. The root canals were biomechanically prepared, and some received a dressing of calcium hydroxide for 7 days. Root canals not dressed were filled by the lateral condensation technique with either regular gutta-percha or calcium hydroxide gutta-percha points. The dressed root canals were filled with the same sealers and regular gutta-percha points. The specimens were placed into a 2% methylene blue dye solution under vacuum, and the apical leakage was linearly evaluated. The experimental groups with calcium hydroxide dressing and the one with calcium hydroxide gutta-percha points exhibited significantly (p < 0.05) less leakage than the groups filled with regular gutta-percha points. The results obtained indicated that calcium hydroxide guttapercha points produced an improvement in the apical sealing quality of the root canal filling. Copyright © 1996 by The American Association of Endodontists.

Continuous wave ultraviolet frequency upconversion due to triads of Nd3+ ions in fluoroindate glass

We have observed ultraviolet upconversion fluorescence from the 4D3/2 and 2P3/2 levels of Nd3+ in fluoroindate glass under infrared pumping. It was found that the excitation of a large population in the 4F3/2 metastable level allows to achieve strong upconversion emissions at 354 and 382 nm. A simple rate equation model reproduces the temporal behavior of the upconverted emission and allows us to estimate the energy transfer rate among three Nd3+ ions participating in the process. © 1997 American Institute of Physics.

Comparing Particle Emission Scenarios in Hydrodynamics: Continuous Emission vs. Freeze-out

The usual particle emission scenario used in hydrodynamics presupposes that particles instantaneously stop interacting (freeze-out) once they reach some three dimensional surface. Another formalism has been developed recently where particle emission occurs continuously during the whole expansion of thermalized matter. Here we compare both mechanisms in a simplified hydrodynamical framework and show that they lead to a drastically different interpretation of data.

Intrapulpar temperature during continuous CO2 laser irradiation in human molars: An in vitro study

To establish safety parameters, we in vitro studied the increase in intrapulpal temperature caused by the use of a cw CO2 laser. A thermistor was implanted in the inner part of the pulpal chamber of 25 human lower third molars to measure the intrapulpal temperature produced by laser powers between 2-10 W and exposure times of 0.5-25.0 s. The Pearson linear correlation factor applied to the measured values showed there is a direct relationship between the independent variable and the applied power. A variance analysis produced the linear regression equation: T=1.10+(0.127)E where T is the temperature and E the energy. The results showed that, with a power of 4 W and maximum exposure time of 2.5 s (10 J) and a power density of 12738.85 W cm-2, there will be no damaging reactions affecting the pulpal tissues.

Continuous iteration of dynamical maps

A precise meaning is given to the notion of continuous iteration of a mapping. Usual discrete iterations are extended into a dynamical flow which is a homotopy of them all. The continuous iterate reveals that a dynamic map is formed by independent component modes evolving without interference with each other. An application to turbulent flow suggests that the velocity field assumes nonseparable values. © 1998 American Institute of Physics.

Optimization procedures in the design of continuous induction hardening and tempering installations for magnetic steel bars

An inverse problem concerning the industrial process of steel bars hardening and tempering is considered. The associated optimization problem is formulated in terms of membership functions and, for the sake of comparison, also in terms of quadratic residuals; both geometric and electromagnetic design variables have been considered. The numerical solution is achieved by coupling a finite difference procedure for the calculation of the electromagnetic and thermal fields to a deterministic strategy of minimization based on modified Flctcher and Reeves method. © 1998 IEEE.

Importance of early and continuous use of protein restriction on the progression of adriamycin nephropathy

Three experimental protocols were carried out with the aim of evaluating the role of protein restriction on the progression of the established adriamycin-induced nephropathy, and whether the protective effect of the diet persists after the diet is discontinued. The effect of a low protein diet (LPD) was studied for 6 weeks in protocol 1, 16 weeks in protocol 2 and for 28 weeks in protocol 3. In protocol 3, one group (LL) received LPD and another (NN) was given a normal protein diet (NPD). A third group (LN) received LPD for 16 weeks and then NPD for 12 weeks and a fourth group (NL) was fed NPD for 16 weeks and then LPD for 12 weeks. In protocol I the tubulo- interstitial index (TILl) of rats on LPD (Md = 2, P25 = 0.0; P75 = 3.5) after six weeks, was smaller than that of the animals on NPD (Md = 6.0; P25 = 3.0; P75 = 8.0; p < 0.05). In protocol 2, the group taking LPD presented an area of interstitial fibrosis (IF) (Md= 0.5%, P25 0.2%; P75 = 1.9%) smaller than that of the NPD group (Md = 6.8%; P25 = 5.2%; P75 = 7.1%; P < 0.05). No significant difference in the area of glomerulosclerosis (GSA) was observed between the animals on LPD (Md = 0.0%; P25 = 0.0%, P75 = 0.0%) and NPD (Md = 0.37%; P25 = 02% P75 = 1.25%; p > 0.05). In protocol 3, the group LL showed GSA (Md = 1.3%; P25 0.6%, P75 = 2.5%) and IF (Md = 3.60/0; P25 = 1.6%; P75 = 5.9%) smaller that those of LN (GSA Md = 10.1%; P25 = 6.6%; P75 = 14.8%; IF; Md = 17.3%; P25 = 14.1%; P75 = 24,5%), NL (GSA: Md = 9.1%; P25 = 5,8%; P75 = 11.7%; IF; Md = 25.0%; P25 = 20.4%; P75 = 30%), and NN (GSA: Md = 6. 75%; P25 = 4.9%; P75 = 11.7%; IF: Md = 20.9%; P25 = 16.2%; P75 = 32.4%). In conclusion, in order to be effective, LPD must be introduced early and maintained for a long period of tune.

Continuous emission versus freeze-out via hanbury brown-twiss

The effect of the continuous emission hypothesis on the two-pion Bose-Einstein correlation function is discussed and compared with the corresponding results based on the usual freeze-out. Sizable differences in the correlation function appear in these different descriptions of the decoupling process. This means that, when extracting properties of the hot matter formed in high-energy heavy-ion collisions from the data, completely different conclusions may be reached according to the description of the particle emission process adopted.