Fungicide resistance: the dose rate debate

It makes economic sense to use as little fungicide as possible on a crop. In many settings, it is common to apply less than the manufacturer's recommended dose. If sources of disease are scarce, or conditions are unsuitable for it to increase, the reduced control from a low dose may be adequate. In other cases, a big reduction in dose may cause little reduction in control, again permitting savings - especially for growers prepared to run a little risk. But the label recommendations for most fungicides state that to avoid resistance, a full dose must always be used. Are individual cost-savings therefore endangering everyone's access to an exceptionally useful tool? The emergence of fungicide resistance is evolution in action. In all cases, it involves the genetic replacement of the original susceptible population of the pathogen by a new population with genetically distinct biochemistry, which confers resistance. The resistant biochemistry originates in rare genetic mutations, so rare that initially the population is hardly altered. Replacement of susceptible forms by resistant ones happens because, with fungicide present, the resistant form multiplies more rapidly than the susceptible form. The key point to notice is that only the relative rates of multiplication of the resistant and susceptible types are involved in the evolution of resistance. The absolute rates are irrelevant.

Characterization of recombinant influenza B viruses with key neuraminidase inhibitor resistance mutations

Objectives and methods: An influenza B virus plasmid-based rescue system was used to introduce site-specific mutations, previously observed in neuraminidase (NA) inhibitor-resistant viruses, into the NA protein of six recombinant viruses. Three mutations observed only among in vitro selected zanamivir-resistant influenza A mutants were introduced into the B/Beijing/1/87 virus NA protein, to change residue E116 to glycine, alanine or aspartic acid. Residue E116 was also mutated to valine, a mutation found in the clinic among oseltamivir-resistant viruses. An arginine to lysine change at position 291 (292 N2 numbering) mimicked that seen frequently in influenza A N2 clinical isolates resistant to oseltamivir. Similarly, an arginine to lysine change at position 149 (152 in N2 numbering) was made to reproduce the change found in the only reported zanamivir-resistant clinical isolate of influenza B virus. In vitro selection and prolonged treatment in the clinic leads to resistance pathways that require compensatory mutations in the haemagglutinin gene, but these appear not to be important for mutants isolated from immunocompetent patients. The reverse genetics system was therefore used to generate mutants containing only the NA mutation. Results and conclusions: With the exception of a virus containing the E116G mutation, mutant viruses were attenuated to different levels in comparison with wild-type virus. This attenuation was a result of altered NA activity or stability depending on the introduced mutation. Mutant viruses displayed increased resistance to zanamivir, oseltamivir and peramivir, with certain viruses displaying cross-resistance to all three drugs.

A new species of Myosotis L. (Boraginaceae) from Cameroon, with a key to the Tropical African species of the genus

Myosotic cameroonensis Cheek & R Becker (Boraginacene) is described from Cameroon. Its conservation status and taxonomic affinities are assessed and an updated key to the Tropical African species of the genus is presented.

Insights into the effects on metal binding of the systematic substitution of five key glutamate ligands in the ferritin of Escherichia coli

Ferritins are nearly ubiquitous iron storage proteins playing a fundamental role in iron metabolism. They are composed of 24 subunits forming a spherical protein shell encompassing a central iron storage cavity. The iron storage mechanism involves the initial binding and subsequent O-2-dependent oxidation of two Fe2+ ions located at sites A and B within the highly conserved dinuclear "ferroxidase center" in individual subunits. Unlike animal ferritins and the heme-containing bacterioferritins, the Escherichia coli ferritin possesses an additional iron-binding site (site C) located on the inner surface of the protein shell close to the ferroxidase center. We report the structures of five E. coli ferritin variants and their Fe3+ and Zn2+ (a redox-stable alternative for Fe2+) derivatives. Single carboxyl ligand replacements in sites A, B, and C gave unique effects on metal binding, which explain the observed changes in Fe2+ oxidation rates. Binding of Fe2+ at both A and B sites is clearly essential for rapid Fe2+ oxidation, and the linking of Fe-B(2+) to Fe-C(2+) enables the oxidation of three Fe2+ ions. The transient binding of Fe2+ at one of three newly observed Zn2+ sites may allow the oxidation of four Fe2+ by one dioxygen molecule.

Purification and molecular cloning of antimicrobial peptides from Scots pine seedlings

A novel protocol for rapid and efficient purification of antimicrobial peptides from plant seedlings has been developed. Two peptides with antimicrobial activity, designated p1 and p2, were purified nearly to homogeneity from Scots pine seedlings by a combination of sulfuric acid extraction, ammonium sulfate precipitation, heat-inactivation and ion-exchange chromatography on phosphocellulose. Purified proteins had molecular masses of 11 kDa (p1) and 5.8 kDa (p2) and were identified by mass spectrometry as defensin and lipid-transfer protein, respectively. We demonstrated their growth inhibitory effects against a group of phytopathogenic fungi. Furthermore, we report for the first time molecular cloning and characterization of defensin I cDNA from Scots pine. A cDNA expression library from 7 days Scots pine seedlings was generated and used to isolate a cDNA clone corresponding to Scots pine defensin, termed PsDef1. The full-length coding sequence of PsDef1 is 252 bp in length and has an open reading frame capable to encode a protein of 83 amino residues. The deduced sequence has the typical features of plant defensins, including an endoplasmic reticulum signal sequence of 33 aa, followed by a characteristic defensin domain of 50 amino acids representing its active form. The calculated molecular weight of the mature form of PsDef1 is 5601.6 Da, which correlates well with the results of SDS-PAGE analysis. Finally, the antimicrobial properties of PsDef1 against a panel of fungi and bacteria define it as a member of the morphogenic group of plant defensins. (C) 2009 Elsevier Inc. All rights reserved.

Key performance indicators (KPIs) and priority setting in using the multi-attribute approach for assessing sustainable intelligent buildings

The main objectives of this paper are to: firstly, identify key issues related to sustainable intelligent buildings (environmental, social, economic and technological factors); develop a conceptual model for the selection of the appropriate KPIs; secondly, test critically stakeholder's perceptions and values of selected KPIs intelligent buildings; and thirdly develop a new model for measuring the level of sustainability for sustainable intelligent buildings. This paper uses a consensus-based model (Sustainable Built Environment Tool- SuBETool), which is analysed using the analytical hierarchical process (AHP) for multi-criteria decision-making. The use of the multi-attribute model for priority setting in the sustainability assessment of intelligent buildings is introduced. The paper commences by reviewing the literature on sustainable intelligent buildings research and presents a pilot-study investigating the problems of complexity and subjectivity. This study is based upon a survey perceptions held by selected stakeholders and the value they attribute to selected KPIs. It is argued that the benefit of the new proposed model (SuBETool) is a ‘tool’ for ‘comparative’ rather than an absolute measurement. It has the potential to provide useful lessons from current sustainability assessment methods for strategic future of sustainable intelligent buildings in order to improve a building's performance and to deliver objective outcomes. Findings of this survey enrich the field of intelligent buildings in two ways. Firstly, it gives a detailed insight into the selection of sustainable building indicators, as well as their degree of importance. Secondly, it tesst critically stakeholder's perceptions and values of selected KPIs intelligent buildings. It is concluded that the priority levels for selected criteria is largely dependent on the integrated design team, which includes the client, architects, engineers and facilities managers.

Contractor key competitiveness indicators: A China study

A proper method to assess contractor competitiveness is important both for assisting clients in the selection of proper contractors and for assisting contractors in the development of more competitive bidding strategies. Previous studies have identified various indicators for assessing contractor competitiveness, and several assessment methods have been introduced. Nevertheless, these studies are limited because they are unable to tell which indicators are more important in different market environments. This paper identifies the key competitiveness indicators �KCIs� for assessing contractor competitiveness in the Chinese construction market. An index value is used to indicate the relative significance of various competitiveness indicators based on which KCIs are identified. The data applied in this study are from a survey of the construction industry in mainland China. The research findings provide valuable information for both existing businesses and the construction professionals who plan to compete for construction works in the Chinese market. The study provides useful references for further studies that compare the KCIs used in the Chinese construction industry and those used in other construction industries.

Assessing reading at Key Stage 2: SATs as measures of children's inferential abilities

This article describes two studies. The first study was designed to investigate the ways in which the statutory assessments of reading for 11-year-old children in England assess inferential abilities. The second study was designed to investigate the levels of performance achieved in these tests in 2001 and 2002 by 11-year-old children attending state-funded local authority schools in one London borough. In the first study, content and questions used in the reading papers for the Standard Assessment Tasks (SATs) in the years 2001 and 2002 were analysed to see what types of inference were being assessed. This analysis suggested that the complexity involved in inference making and the variety of inference types that are made during the reading process are not adequately sampled in the SATs. Similar inadequacies are evident in the ways in which the programmes of study for literacy recommended by central government deal with inference. In the second study, scripts of completed SATs reading papers for 2001 and 2002 were analysed to investigate the levels of inferential ability evident in scripts of children achieving different SATs levels. The analysis in this article suggests that children who only just achieve the 'target' Level 4 do so with minimal use of inference skills. They are particularly weak in making inferences that require the application of background knowledge. Thus, many children who achieve the reading level (Level 4) expected of 11-year-olds are entering secondary education with insecure inference-making skills that have not been recognised.