Spectral analysis and control to obtain sub-5 fs pulses by femtosecond filamentation

A spectral-filter method is numerically demonstrated to obtain sub-5 fs pulses by using femtosecond filamentation in fused silica. Instead of employing spectral phase compensation, by properly employing a high-pass filter to select the broadened high-frequency spectra that are located almost in phase in the tailing edge of the self-compressed pulses owing to self-steepening, as short as single-cycle pulses can be obtained. For instance, for an input pulse with a duration of 50 fs and energy 2.2 mu J, the minimum pulse duration can reach to similar to 4 fs (about 1.5 cycles) by applying a proper spectral filter. (C) 2008 Optical Society of America

Generation of sub-5 fs pulses through cascade of filamentation and hollow fiber compression

A pulse-compression scheme based on cascade of filamentation and hollow fiber has been demonstrated, Pulses with duration of sub-5 fs and energy of 0.2 mJ near 800 nm have been generated by compressing the similar to 40 fs pulses from a commercial laser system. This method is promising to generate near monocycle high energy pulses. [GRAPHICS] Measured autocorrelation curve of the final compressed pulses with duration of sub-5 fs (black solid) and the simulated autocorrelation curve of 4.6 fs pulse near 800 rim (red dash) (C) 2008 by Astro Ltd. Published exclusively by WILEY-VCH Verlag GmbH & Co. KGaA

Optimization of single attosecond x-ray pulses by genetic algorithm control of the chirp and initial phase of 5 fs laser pulses

We show that the peak intensity of single attosecond x-ray pulses is enhanced by 1 or 2 orders of magnitude, the pulse duration is greatly compressed, and the optimal propagation distance is shortened by genetic algorithm optimization of the chirp and initial phase of 5 fs laser pulses. However, as the laser intensity increases, more efficient nonadiabatic self-phase matching can lead to a dramatically enhanced harmonic yield, and the efficiency of optimization decreases in the enhancement and compression of the generated attosecond pulses. (c) 2006 Optical Society of America.

Generation of 5 fs, 0.7 mJ pulses at 1 kHz through cascade filamentation

Two-cycle optical pulses with duration of 5 fs and energy of 0.7 mJ have been generated at 1 kHz by compressing the 38 fs laser pulses from a carrier-envelope phase (CEP) controlled Ti:sapphire laser system through a cascade filamentation compression technique. A simple and effective method is developed to suppress multiple filament formation and stabilize a single filament by inserting a soft aperture with an appropriate diameter into the driving laser beam prior to focusing, resulting in an excellent compressed beam quality. The good beam quality and potentially higher peak power make this ultrashort laser pulse source a significant tool for high-field physics applications. (C) 2007 Optical Society of America.

Hat sich die Fischbiomasse der Nordsee in den letzten 5 Jahren deutlich verändert?

Die Größe der Fischbestände in der Nordsee unterliegt Schwankungen, die durch sich verändernde Faktoren ihrer Umwelt hervorgerufen werden. Diese Faktoren sind natürlichen (Klima, Nahrungsangebot) wie auch anthropogenen Ursprungs (Fischerei, Verschmutzung).

Análise da região 5 não traduzida (5 utr) em sequências anotadas como trans-sialidase no genoma de Trypanosoma cruzi

A transsialidase é uma glicoproteína de membrana pertencente a uma família de genes de cópia múltipla, envolvida no processo de invasão celular do Trypanosoma cruzi no hospedeiro vertebrado. Esta dissertação foi concebida com um amplo componente analítico que dependia de dados publicamente disponíveis, ou seja, as sequências oriundas do projeto genoma de T. cruzi e cDNAs de trans-sialidase depositadas no Genbank-dbEST. Este componente analítico necessitou ser complementado e ampliado com a obtenção experimental de novas sequências, a partir da metodologia baseada na transcrição reversa acoplada a PCR. Os fragmentos obtidos de cepas de T. cruzi Dm28c (T. cruzi I), Y (T. cruzi II), CL-Brener (T. cruzi II, cepa híbrida), INPA4167 (zimodema III), 3663 (zimodema III) e Colombiana (zimodema III) foram clonados, sequenciados e analisados composicionalmente. Essas sequências foram editadas e alinhadas usando-se o software CLUSTAL X. Em uma seção específica do Genbank, denominada dbEST, buscamos os cDNAs homólogos a trans-sialidase. Esta busca por similaridade foi realizada individualmente com os números de acesso referentes às seqüências supracitadas contra o dbEST utilizando o BLAST a fim de obtermos informações funcionais e evolutivas. Em seguida, desenvolvemos metodologias experimentais que nos permitiu avaliar segmentos da 5 UTR, tais como os sítios de trans-splicing adicionais ou múltiplos em TS e seus respectivos sinais (região rica em polipirimidina), variação composicional e tamanho da região das sequências entre diferentes linhagens de T. cruzi. O resultado dessa averiguação também nos mostrou a quantidade de cDNAs relacionados com a transsialidase no dbEST bem como a relação desses cDNAs com o mini-exon. As cepas do zimodema III apresentaram tamanho médio dos fragmentos de 312 bases, enquanto T. cruzi I e T. cruzi II apresentaram, respectivamente 209 e 218. Trans splicing adicional ou duplicações gênicas com mutações no sítio primário de trans splicing não parece ser um fenômeno exclusivo de algum grupo populacional, embora seja mais evidente em T. cruzi zimodema III.

[A_Labraza_Muralla] Documentación geométrica y restitución fotogramétrica de las fases 1 a 5 de la muralla exterior de Labraza. Álava

[ES] Se han documentado unos 140 metros de muralla que corresponde a los alzados suroeste y sur y que incluye la puerta de acceso principal del casco urbano.

Synthesis and matrix isolated photolysis of 2,3-dimethylbicyclo [2.2.0]hexa-2,5-diene-1,4-dicarboxylic acid anhydride: a potential percursor to 2,3-dimethyl-1,4-dehydrobenzene

The synthesis of the first member of a new class of Dewar benzenes has been achieved. The synthesis of 2,3- dimethylbicyclo[2.2.0]hexa-2,5-diene-1, 4-dicarboxylic acid and its anhydride are described. Dibromomaleic anhydride and dichloroethylene were found to add efficiently in a photochemical [2+2] cycloaddition to produce 1,2-dibromo- 3,4-dichlorocyclobutane-1,2-dicarboxylic acid. Removal of the bromines with tin/copper couple yielded dichloro- cyclobutenes which added to 2-butyne under photochemical conditions to yield 5,6-dichloro-2,3-dimethylbicyclo [2.2.0] hex-2-ene dicarboxylic acids. One of the three possible isomers yielded a stable anhydride which could be dechlorinated using triphenyltin radicals generated by the photolysis of hexaphenylditin.

Photolysis of argon matrix isolated 2,3-dimethylbicyclo [2.2.0]hexa-2, 5-diene-1,4-dicarboxylic acid anhydride produced traces whose strongest bands in the infrared were at 3350 and 600 cm^(-1). This suggested the formation of terminal acetylenes. The spectra of argon matrix isolated E- and Z- 3,4-dimethylhexa-1,5-diyne-3-ene and cis-and trans-octa- 2,6-diyne-4-ene were compared with the spectrum of the photolysis products. Possibly all four diethynylethylenes were present in the anhydride photolysis products. Gas chromatograph-mass spectral analysis of the volatiles from the anhydride photolysis again suggested, but did not confirm, the presence of the diethynylethylenes.

Análisis exergético de una planta de microcogeneración mediante maci de 5 kw eléctricos para la producción de ACS en un edificio de viviendas

[ES]El presente trabajo consiste en el análisis exergético de una planta experimental con microcogeneración diseñada para satisfacer la demanda de agua caliente sanitaria de un bloque de viviendas. El ACS la generan una caldera con producción de energía térmica variable y una unidad de microcogneración que produce 5 kW eléctricos y 12 kW térmicos. El análisis exergético que se realiza en el trabajo permite determinar la eficiencia del uso que se hace del combustible, y compararla con la de una planta convencional.

Mechanism and applications of the photochemistry of Bis(η^5-cyclopentadienyl)titanacyclobutanes

The photochemically induced reductive elimination of cyclopropanes from bis(η⁵-cyclopentadienyl)titanacyclobutanes has been examined. Stereochemical labelling studies indicate that the cyclopropane is initially formed in a 6±1:1, ratio favoring retention of stereochemistry. The starting titanacyclobutane is isomerized during the course of the reaction. The isomerization of the starting material results from metal-carbon bond homolysis to yield a 1,4-biradical, which can either close to give the starting material or generate cyclopropane. The 1,4-biradical can be observed through a cyclopropyl carbinyl rearrangement employing 2-bis(η⁵- cyclopentadienyl)titana-5,5-dimethylbicyclo[2.1.0]pentane, to give the titanium alkylidene, 1-bis(η⁵-cyclopentadienyl)titana-3,3-dimethyl-1,4- pentadiene, which can be observed directly by NMR at low temperature.

The oxidation of titanacyclobutanes by chemical and electrochemical methods also yields cyclopropanes. Reduction of the metal center does not yield cyclopropanes. Depending on the oxidant, stereochemically labelled titanacyclobutanes yield cyclopropanes that are between 7:1 and 100:1 retention:isomerization. The fragmentation reaction resembles the photochemically induced reductive elimination. Both result from formal oxidation of a metal-carbon bond, which then results in very rapid formation of cyclopropane.

The titanocene generated photochemically reacts with a variety of substrates even at low temperature. Titanocene can be generated in a glass at 77 K. The titanocene can be trapped in noncoordinating solvents in high yield with bulky internal acetylenes to give monoacetylene adducts of titanocene. Less bulky acetylenes give the titanacyclopentadienes. The titanocene can be trapped with olefins to give less stable adducts, which appear by NMR analysis to be intermediate in structure between a titanacyclopropane and an η² olefin adduct of titanocene. Reaction of titanocene with butadiene gives a stable product, which appears to be the s-trans butadiene adduct of titanocene. It does not isomerize on heating. Titanocene reacts with epoxides to give titanocene-µ-oxo polymer and olefin. Stereochemically labelled epoxides and episulfides yield isomerized olefin upon deoxygenation by titanocene. The observations are rationalized as a result of a 1,4-biradical formed by stepwise insertion of titanocene into a carbon-oxygen bond.

Key to the identification of the naupliar instars of the genus Cyclops. [Translation from: Arb.biol.Stat.Kossino 5 31-39, 1927. ]

This is a short excerpt of the original paper giving the key to the identification of the naupliar instars of the genus Cyclops.

The predatory feeding of Acanthocyclops viridis (Jur.) (Copepoda, Cyclopoida). [Translation from: Trudy Inst.Biol.Vodokhranil. 2(5) 117-127, 1959. ]

The feeding of freshwater copepods, especially cyclopoida, has been poorly covered in research so far. The majority of existing special works on the feeding of cyclopoida illustrate this question only from the qualitative side. The food content of the nauplius of freshwater cyclops has not been studied at all, as also the feeding of adult entomostracans on bacteria. Moreover the question of the suitability of vegetable food for Cyclops is not clear enough. This article aims to elucidate as fully as possible the nutrition of Acanthocyclops viridis (Jur.) - a large cyclops, inhabiting the mass of demersal layers of the open parts of the Rybinsk reservoir and its foreshore. The present work is devoted only to the predatory feeding of A. viridis, and includes data from the content of the intestines of cyclops, collected in natural conditions, and also the results of experimental observations carried out in a laboratory during 1958.