Design of NRAs having higher aperture opening ratio and autocorrelation compression ratio by means of a global optimization method

When noises considerations are made, nonredundant arrays (NRAs) are endowed with many advantages which other arrays e.g., uniformly redundant arrays (URAs) do not possess in applications of coded aperture imaging. However, lower aperture opening ratio limits the applications of NRA in practice. In this paper, we present a computer searching method based on a global optimization algorithm named DIRECT to design NRAs. Compared with the existing NRAs e.g., Golay's NRAs, which are well known and widely used in various applications, NRAs found by our method have higher aperture opening ratio and auto correlation compression ratio. These advantages make our aperture arrays be very useful for practical applications especially for which of aperture size are limited. Here, we also present some aperture arrays we found. These aperture arrays have an interesting property that they belong to both NRA and URA. (C) 2006 Elsevier GmbH. All rights reserved.

Numerical simulation of wavefronts diffracted by apertures with circular symmetry

The numerical simulation of the wavefronts diffracted by apertures with circular symmetry is realized by a numerical method. It is based on the angular spectrum of plane waves, which ignored the vector nature of light. The on-axial irradiance distributions of plane wavefront and Gauss wavefront diffracted by the circular aperture have been calculated along the propagation direction. Comparisons of the simulation results with the analytical results and the experimental results tell us that it is a feasible method to calculate the diffraction of apertures. (c) 2006 Published by Elsevier GmbH.

Analysis of dispersion compensation by chirped fiber grating in directly and externally modulated CATV systems

The dispersion compensation effect of the chirped fiber grating (CFG) is analyzed theoretically, and analytic expressions are derived for composite second-order (CSO) distortion in analog modulated sub-carrier multiplexed (AM-SCM) cable television (CATV) systems with externally and directly modulated transmitters. Simulations are given for the two kinds of modulations and for standard single mode fiber and non-zero dispersion shift fiber (NZDSF) systems. The results show that CFG could be used as a dispersion compensator in directly modulated systems, but its dispersion coefficient should be adjusted much more precisely than the externally modulated system. The requirements for the NZDSF system could be loosened much. It is proposed that directly modulated source may be used as a transmitter in CATV systems combined with tunable CFG dispersion compensator being adjusted precisely, which may be more cost-effective than externally modulation technology. (c) 2006 Elsevier GmbH. All rights reserved.

Finite element analysis on a circular wedge prism with 400 mm diameter

The paper comprehensively analyzes the distortions of a circular wedge prism with 400 mm diameter in a scanner by method of optical-mechanical-thermal integrating analysis. The structure and intensity of the prism assembly is verified and checked, and the surface deformations of the prism under gravity load, as well as the thermo-elastic distortions of the prism, are analyzed in detail and evaluated, which is finally contrasted with the measured values of Zygo Mark interferometer. The results show: the maximal distortion of the prism assembly is 10 nm magnitude and the maximal stress is 0.441 Mpa, which has much tolerance to the precision requirement of structure and the admissible stress of material; the influence of heat effect on the surface deformations of prism is proved to be far greater than the influence of gravity load, so some strict temperature-controlled measures are to be considered when the scanner is used. (c) 2006 Elsevier GmbH. All rights reserved.

The geochronology of the plutonic and metamorphic rocks of New Zealand

Extensive Rubidium-Strontium age determinations on both mineral and total rock samples of the crystalline rocks of New Zealand, which almost solely crop out in the South Island, indicate widespread plutonic and metamorphic activity occurred during two periods, one about 100-118 million years ago and the other about 340-370 million years ago. The former results date the Rangitata Orogeny as Cretaceous. They associate extensive plutonic activity with this orogeny which uplifted and metamorphosed the rocks of the New Zealand Geosyncline, although no field association between the metamorphosed geosynclinal rocks and plutonic rocks has been found. The Cretaceous plutonic rocks occur to the west in the Foreland Province in Fiordland, Nelson, and Westland, geographically separated from the Geosynclinal Province. Because of this synchronous timing of plutonic and high pressure metamorphic activity in spatially separated belts, the Rangitata Orogeny in New Zealand is very similar to late Mesozoic orogenic activity in many other areas of the circum-Pacific margin (Miyashiro, 1961).

The 340-370 million year rocks, both plutonic and metamorphic, have been found only in that part of the Foreland Province north of the Alpine Fault. There, they are concentrated along the west coast over a distance of 500 km, and appear scattered inland from the coast. Probably this activity marks the outstanding Phanerozoic stratigraphic gap in New Zealand which occurred after the Lower Devonian.

A few crystalline rocks in the Foreland Province north of the Alpine Fault with measured ages intermediate between 340 and 120 million years have been found. Of these, those with more than one mineral examined give discordant results. All of these rocks are tentatively regarded as 340-370 million year old rocks that have been variously disturbed during the Rangitata Orogeny, 100-120 million years ago.

In addition to these two periods, plutonic activity, dominantly basic and ultrabasic, but including the development of some rocks of intermediate and acidic composition, occurred along the margin of the Geosynclinal Province at its border with the Foreland Province during Permian times about 245 million years ago, and this activity possibly extended into the Mesozoic.

Evidence from rubidium-strontium analyses of minerals and a total rock, and from uranium, thorium, and lead analyses of uniform euhedral zircons from a meta-igneous portion of the Charleston Gneiss, previously mapped as Precambrian, indicate that this rock is a 350-370 million year old plutonic rock metamorphosed 100 million yea rs ago during the Rangitata Orogeny. No crystalline rocks with primary Precambrian ages have been found in New Zealand. However, Pb²⁰⁷/Pb₂₀₆ ages of 1360 million years and 1370 million years have been determined for rounded detrital zircons separated from each of two hornfels samples of one of New Zealand's olde st sedimentary units, the Greenland Series. These two samples were metamorphosed 345- 370 million years ago. They occur along the west coast, north of the Alpine Fault, at Waitaha River and Moeraki River, separated by 135 km. The Precambrian measured ages are most likely minimum ages for the oldest source area which provided the detrital zircons because the uranium, thorium and lead data are highly discordant. These results are of fundamental importance for the tectonic picture of the Southwest Pacific margin and demonstrate the existence of relatively old continental crust of some lateral extent in the neighborhood of New Zealand.

K9玻璃薄膜对离子交换磷酸盐玻璃波导表面保护的优化研究

采用镀K9玻璃薄膜方法来解决离子交换掺铒磷酸盐玻璃波导表面的侵蚀问题,对K9玻璃薄膜的厚度进行了优化研究。测量分析了样品的荧光光谱和荧光寿命,采用光学显微镜和棱镜耦合技术对不同K9玻璃薄膜厚度下制备波导的表面形貌和导光特性进行了表征和测试。结果表明,与掺铒磷酸盐玻璃原材料相比,镀K9玻璃薄膜后荧光光谱保持不变,荧光寿命稍有下降(约0.2 ms);K9玻璃薄膜的厚度在60~80 nm的范围内保护效果最佳。为下一步制备掺铒有源玻璃光波导器件奠定了良好的实验基础。

Development of trophic state and phytoplankton in an oligo-mesotrophic reservoir (Kleine Kinzig) in Black Forest, Germany

Since 1989, intensive studies have been made on a relatively new (1983-84) oligotrophic reservoir and its pre-reservoir in the Black Forest. This paper briefly reports on the hydrochemistry, especially annual variations in phosphorus loadings, and the seasonal development of phytoplankton in 1989 and 1990.

System error removal and structure optimization based on Fizeau interferometer

In the process of interferometric testing, the measurement result is influenced by the system structure, which reduces the measurement accuracy. To obtain an accurate test result, it is necessary to analyze the test system, and build the relationship between the measurement error and the system parameters. In this paper, the influences of the system elements which include the collimated lens and the standard surface on the interferometric testing are analyzed, the expressions of phase distribution and wavefront error on the detector are obtained, the method to remove some element errors is introduced, and the optimization structure relationships are given. (C) 2006 Elsevier GmbH. All rights reserved.

Smoothing the side lobes of a focused pattern by spectral dispersion in the broadband laser

Starting from the Huygens-Fresnel diffraction integral, the propagation equations of a broadband laser passing through a dispersive lens and a dispersive wedge are derived. Smoothing effect on the side lobes of the focused pattern is achieved as the broadband laser passes through the lens because of the spectral dispersion of the lens. By inserting a dispersive wedge behind the lens, better smoothing effect is realized because a relative position shift between focused patterns of different frequency components is generated due to the spectral dispersion of the wedge. Smoothing effect on the side lobe is obtained even with small bandwidth of the broadband laser as the wedge is used. (c) 2006 Elsevier GmbH. All rights reserved.

Measuring the influence of customer-based store brand equity in the purchase intention

[EN] Store brands account for and important market share in the Spain and a further increase in expected in the next years due to the downturn. However, there is lack of research on store brand customer-based Brand Equity. This study attempts to propose an integrated model of Brand Equity in store or retailer brands, based on Aaker s well-known conceptual model. We propose a consumer-based model, including the main sources or dimensions of Brand Equity and considering the intention to purchase as a consequence. Based on a sample of 362 consumers and 5 store brands, structural equation modeling is used to test research hypotheses. The results obtained reveal that store brand awareness, loyalty along with store brand perceived quality have a significant influence on consumers intention to purchase store brands. Our study suggests that marketers and marketing managers from retailing companies should carefully consider the Brand Equity components when designing their brand strategies, and develop marketing activities in order to enhance their brands awareness.

Condições de saúde bucal em atletas dos XV Jogos Pan-Americanos e III Jogos Parapan-Americanos, Rio de Janeiro, Brasil, 2007

O estudo epidemiológico transversal randomizado objetivou avaliar condições de saúde bucal nos competidores dos XV Jogos Pan-Americanos (JPA) e III Jogos Parapan-Americanos (JPPA), 2007. Foram enviados convites para 5.662 atletas (JPA) e 1.300 (JPPA). Radiografias panorâmicas digitais (RPD) foram utilizadas para o exame de triagem nos 2 eventos, e nos JPPA, os atletas também foram submetidos à avaliação do sangramento gengival interdental (SI) através de uma versão modificada do Índice de Sangramento Interdental de Eastman (EIBI). Foram obtidas RPDs de 410 atletas dos JPA, média de idade 24,38 (dp5,35), 55% homens; e de 118 dos atletas dos JPPA, média de idade de 32,3 (dp9,53), 77,97% homens. 121 competidores (JPPA) foram avaliados para SI: 78,51% homens, média de idade 32,6(dp9,6), e foram separados em grupos (G), conforme sua deficiência física: GI c/ deficiência visual (DV), com 2 subgrupos: GI-a: DV tardia e GI-c-: DV congênita/precoce; GII- deficiência de membro superior; com 1 subgrupo: GII-t: deficiência/ausência bilateral; GIII- deficiência de membro inferior (grupo controle). As RPDs foram examinadas por 1 examinador com o Kodak Dental Imaging(v6.7). A frequência e a distribuição do SI foram calculadas, e os grupos foram comparados. Resultados da triagem com RPDs, representados por número de observações(média por atleta) JPA//número de observações(média por atleta JPPA: Dentes erupcionados/ hígidos: 9097(22,19)//2451(20,77); Ausentes: 803(1,96 //405(3,43); Não erupcionados ou impactados: 330(0,80)//52(0,44); Parcialmente erupcionados e/ou hígidos: 109(0,27)//20(0,17); Cárie extensa: 261(0,64)//62(0,53); Cárie extensa e lesão periapical: 96(0,23)//50(0,42); Tratamento endodôntico e lesão periapical: 24(0,06)//13(0,11); Restaurados: 2298(5,60)//670(5,68); Imagens radiolúcidas patológicas circunscritas: 23(0,06)//0; Raízes-residuais: 27(0,07)//22(0,19); Implantes:6(0,01)//5(0,04); Dentes anteriores fraturados: 13 (0,03)//3(0,03); Molares bandados: 26(0,06)//11(0,09); Dentes anômalos: 7(0,02)//12(0,10). Resultados para SI: G-I>G-III (p=0.0002);GI-c>GI-a (p=0,042). Homens exibiram > freqüência de SI (3,6%+1,7) que mulheres (0,8%+0,5), p<0,01. Conclusões: Os dados das 2 populações de atletas mostraram que há uma grande variação na saúde bucal entre os indivíduos avaliados. Diversas condições com potencial de influenciar o desempenho esportivo dos atletas foram detectadas através de radiografias panorâmicas digitais, sugerindo que um programa de saúde bucal deve ser incluído como parte da preparação destes indivíduos.A avaliação da frequência e distribuição de sangramento gengival interdental em uma população de atletas que competiu nos III Jogos Parapan-Americanos, revelou que o tipo de deficiência ou limitação física dos competidores é um fator que influencia na saúde gengival desses indivíduos. O planejamento de um programa de saúde bucal para esta população deve ser adaptado às diferentes limitações de cada atleta.