Population parameters of Oreochromis leucostictus from Lake Naivasha, Kenya

Length-frequency data collected from fish landings on Lake Naivasha were used to estimate the growth parameters: total mortality (Z), growth performance index (Ø’), exploitation rate and recruitment pattern in Oreochromis leucostictus. The asymptotic length (L∞) was 38 cm and K 0.48 yr -1 Z was estimated as 3.5 yr -1, M was 0.19 yr -1, F was 2.6 yr -1 and E of 0.74. Recruitment occurs throughout the year, with a peak in January to March, while entry into the fishery occurs at a mean length of 15.9 cm. Existing restriction on the maximum number of gill nets allowed per fishing licence (10 per boat) and a minimum mesh size (10 cm) in the lake are not adhered to. Poaching using illegal mesh size nets as small as 5 cm and use of more than 10 nets per boat are common in the lake.

Parameters influencing the performance of an IGBT gate drive

This paper presents an improvement of an IGBT gate drive implementing Active Voltage Control (AVC), and investigates the impact of various parameters affecting its performance. The effects of the bandwidths of various elements and the gains of AVC are shown in simulation and experimentally. Also, the paper proposes connecting a small Active Snubber between the IGBT collector and its gate integrated within the AVC. The effect of this snubber on enhancing the stability of the gate drive is demonstrated. It will be shown that using a wide bandwidth operational amplifier and integrating the Active Snubber within the gate drive reduces the minimum gate resistor required to achieve stability of the controller. Consequently, the response time of the IGBT to control signals is significantly reduced, the switching losses then can be minimised and, hence, the performance of gate drive as whole is improved. This reflects positively on turn-off and turn-on transitions achieving voltage sharing between the IGBTs connected in series to construct a higher voltage switch, making series IGBTs a feasible practice. ©2008 IEEE.

Parameters identification by a single point free response measurement

When a thin rectangular plate is restrained on the two long edges and free on the remaining edges, the equivalent stiffness of the restraining joints can be identified by the order of the natural frequencies obtained using the free response of the plate at a single location. This work presents a method to identify the equivalent stiffness of the restraining joints, being represented as simply supporting the plate but elastically restraining it in rotation. An integral transform is used to map the autospectrum of the free response from the frequency domain to the stiffness domain in order to identify the equivalent torsional stiffness of the restrained edges of the plate and also the order of natural frequencies. The kernel of the integral transform is built interpolating data from a finite element model of the plate. The method introduced in this paper can also be applied to plates or shells with different shapes and boundary conditions. © 2011 Elsevier Ltd. All rights reserved.

Murine MyaK, a member of a family of yeast YAK1-related genes, is highly expressed in hormonally modulated epithelia in the reproductive system and in the embryonic central nervous system

We have cloned a mouse homologue (designated Myak) of the yeast protein kinase YAK1. The 1210 aa open reading frame contains a putative protein kinase domain, nuclear localization sequences and PEST sequences. Myak appears to be a member of a growing family of YAK1-related genes that include Drosophila and human Minibrain as well as a recently identified rat gene ANPK that encode a steroid hormone receptor interacting protein. RNA blot analysis revealed that Myak is expressed at low levels ubiquitously but at high levels in reproductive tissues, including testis, epididymis, ovary, uterus, and mammary gland, as well as in brain and kidney. In situ hybridization analysis on selected tissues revealed that Myak is particularly abundant in the hormonally modulated epithelia of the epididymis, mammary gland, and uterus, in round spermatids in the testis, and in the corpora lutea in the ovary, Myak is also highly expressed in the aqueduct of the adult brain and in the brain and spinal cord of day 12.5 embryos, Mol. Reprod. Dev. 55:372-378, 2000. (C) 2000 Wiley-Liss, Inc.

Effects of testosterone undecanoate as a male contraceptive candidate on rat immunological features

Testosterone undecanoate (TU) is under phase III clinical trial as a hormonal male contraceptive in China. Sex hormones can modulate the immune system. Female hormonal contraceptives may affect SIV/HIV-1 transmission. To evaluate the safety of TU and to understand whether long-term use of TU for a male contraceptive affects users' immunological features, adult male rats were treated for a 32-week TU-treated phase at the dose of 20 mg TU/kg body weight and a 24-week recovery phase. The reproductive and immunological parameters of 4-6 rats in each subgroup were examined at the stated time point. The mean sperm count and viability in the treated rats were significantly suppressed (p < 0.01). In the TU-treated group: the mean blood leukocyte and lymphocyte counts; the proliferation indexes of T cells from peripheral blood mononuclear cells (PBMC) and spleen; and, of B cells from spleen, as well as the mean counts of blood T, NK, and B cells decreased in comparison with those of control group. These decreases were not significant (p > 0.01). Similarly, the mean serum IgM, IgG, and IgA levels and complement activity in TU-treated rats were lower than those in control group (p > 0.01), and the changes in the antibody levels of the examined genital secretions were not significant (p > 0.01). The changes in the thickness of urethra epithelium, and in secretory component (SC) expression in genitals were not observed in the treated group. These results demonstrated that long-term supraphysiological TU injection did not obviously affect the examined rat immunological parameters.

The reproductive strategies of an endemic Tibetan fish, Gymnocypris selincuoensis

The reproductive traits of Gymnocypris selincuoensis from Selincuo Lake and its tributaries were investigated in 1997 and 1998. The youngest mature male was age 7 with a standard length (SL) of 172.0 mm, and the youngest mature female was age 8 with a SL of 194.0 mm. The L(50)s Of SL and age at first maturity were respectively 250.32 mm and age 9 for males and 224.71 mm and age 8 for females. The gonadosomatic index (GSI) significantly changed with seasons for mature individuals but not for immature individuals. GSIs of mature females at stages IV and V of ovary development increased with SL and reached a maximum value at the SL range from 370 mm to 390 mm; the GSIs of mature males were negatively correlated with SL. The breeding season lasted from early April to early August. Egg size did not significantly change with SL but increased with the delay of spawning. The individual absolute fecundity varied from 1,341 to 28,002 eggs (mean 12,607+/-7,349), and the individual relative fecundity varied from 6.4 to 42.0 eggs.g(-1) (mean 25.5+/-9.7). The individual fecundity increased with total body weight; it also increased with SL for those of SL less than 370 mm. There was a rest of spawning for mature individuals.

The energy required to produce materials: constraints on energy-intensity improvements, parameters of demand.

In this paper, we review the energy requirements to make materials on a global scale by focusing on the five construction materials that dominate energy used in material production: steel, cement, paper, plastics and aluminium. We then estimate the possibility of reducing absolute material production energy by half, while doubling production from the present to 2050. The goal therefore is a 75 per cent reduction in energy intensity. Four technology-based strategies are investigated, regardless of cost: (i) widespread application of best available technology (BAT), (ii) BAT to cutting-edge technologies, (iii) aggressive recycling and finally, and (iv) significant improvements in recycling technologies. Taken together, these aggressive strategies could produce impressive gains, of the order of a 50-56 per cent reduction in energy intensity, but this is still short of our goal of a 75 per cent reduction. Ultimately, we face fundamental thermodynamic as well as practical constraints on our ability to improve the energy intensity of material production. A strategy to reduce demand by providing material services with less material (called 'material efficiency') is outlined as an approach to solving this dilemma.

The effects of operational and design parameters on the tolerance of ADSR fuel pin cladding to beam interruptions

This paper investigates the effects of design parameters, such as cladding and coolant material choices, and operational phenomena, such as creep and fission product decay heat, on the tolerance of Accelerator Driven Subcritical Reactor (ADSR) fuel pin cladding to beam interruptions. This work aims to provide a greater understanding of the integration between accelerator and nuclear reactor technologies in ADSRs. The results show that an upper limit on cladding operating temperature of 550 °C is appropriate, as higher values of temperature tend to accelerate creep, leading to cladding failure much sooner than anticipated. The effect of fission product decay heat is to reduce significantly the maximum stress developed in the cladding during a beam-trip-induced transient. The potential impact of irradiation damage and the effects of the liquid metal coolant environment on the cladding are discussed. © 2013 Elsevier Ltd. All rights reserved.

Phase perfection in zinc Blende and Wurtzite III-V nanowires using basic growth parameters.

Controlling the crystallographic phase purity of III-V nanowires is notoriously difficult, yet this is essential for future nanowire devices. Reported methods for controlling nanowire phase require dopant addition, or a restricted choice of nanowire diameter, and only rarely yield a pure phase. Here we demonstrate that phase-perfect nanowires, of arbitrary diameter, can be achieved simply by tailoring basic growth parameters: temperature and V/III ratio. Phase purity is achieved without sacrificing important specifications of diameter and dopant levels. Pure zinc blende nanowires, free of twin defects, were achieved using a low growth temperature coupled with a high V/III ratio. Conversely, a high growth temperature coupled with a low V/III ratio produced pure wurtzite nanowires free of stacking faults. We present a comprehensive nucleation model to explain the formation of these markedly different crystal phases under these growth conditions. Critical to achieving phase purity are changes in surface energy of the nanowire side facets, which in turn are controlled by the basic growth parameters of temperature and V/III ratio. This ability to tune crystal structure between twin-free zinc blende and stacking-fault-free wurtzite not only will enhance the performance of nanowire devices but also opens new possibilities for engineering nanowire devices, without restrictions on nanowire diameters or doping.