Estudo da deposição de filmes finos de BaTi(1-X)Zr(X)O3 por meio de planejamento Box-Behnken

Ferroelectric ceramics with perovskite structure (ABO3) are widely used in solid state memories (FeRAM’s and DRAM's) as well as multilayered capacitors, especially as a thin films. When doped with zirconium ions, BaTiO3-based materials form a solid solution known as barium zirconate titanate (BaTi1-xZrxO3). Also called BZT, this material can undergo significant changes in their electrical properties for a small variation of zirconium content in the crystal lattice. The present work is the study of the effects of deposition parameters of BaTi0,75Zr0,25O3 thin films by spin-coating method on their morphology and physical properties, through an experimental design of the Box-Behnken type. The resin used in the process has been synthesized by the polymeric precursor method (Pechini) and subsequently split into three portions each of which has its viscosity adjusted to 10, 20 and 30 mPa∙s by means of a rotary viscometer. The resins were then deposited on Pt/Ti/SiO2/Si substrates by spin-coating method on 15 different combinations of viscosity, spin speed (3000, 5500 and 8000 rpm) and the number of deposited layers (5, 8 and 11 layers) and then calcined at 800 ° C for 1 h. The phase composition of the films was analyzed by X-ray diffraction (XRD) and indexed with the JCPDS 36-0019. Surface morphology and grain size were observed by atomic force microscopy (AFM) indicating uniform films and average grain size around 40 nm. Images of the cross section of the films were obtained by scanning electron microscopy field emission (SEM-FEG), indicating very uniform thicknesses ranging from 140-700 nm between samples. Capacitance measurements were performed at room temperature using an impedance analyzer. The films presented dielectric constant values of 55-305 at 100kHz and low dielectric loss. The design indicated no significant interaction effects between the deposition parameters on the thickness of the films. The response surface methodology enabled better observes the simultaneous effect of variables.

Study of the calibration method of pressure-velocity probes and its application in a field of progressive plane waves

This dissertation presents a calibration procedure for a pressure velocity probe. The dissertation is divided into four main chapters. The first chapter is divided into six main sections. In the firsts two, the wave equation in fluids and the velocity of sound in gases are calculated, the third section contains a general solution of the wave equation in the case of plane acoustic waves. Section four and five report the definition of the acoustic impedance and admittance, and the practical units the sound level is measured with, i.e. the decibel scale. Finally, the last section of the chapter is about the theory linked to the frequency analysis of a sound wave and includes the analysis of sound in bands and the discrete Fourier analysis, with the definition of some important functions. The second chapter describes different reference field calibration procedures that are used to calibrate the P-V probes, between them the progressive plane wave method, which is that has been used in this work. Finally, the last section of the chapter contains a description of the working principles of the two transducers that have been used, with a focus on the velocity one. The third chapter of the dissertation is devoted to the explanation of the calibration set up and the instruments used for the data acquisition and analysis. Since software routines were extremely important, this chapter includes a dedicated section on them and the proprietary routines most used are thoroughly explained. Finally, there is the description of the work that has been done, which is identified with three different phases, where the data acquired and the results obtained are presented. All the graphs and data reported were obtained through the Matlab® routine. As for the last chapter, it briefly presents all the work that has been done as well as an excursus on a new probe and on the way the procedure implemented in this dissertation could be applied in the case of a general field.

Application of a new method in the study of pelvic floor muscle passive properties in continent women

The aim of this study was to present a new methodology for evaluating the pelvic floor muscle (PFM) passive properties. The properties were assessed in 13 continent women using an intra-vaginal dynamometric speculum and EMG (to ensure the subjects were relaxed) in four different conditions: (1) forces recorded at minimal aperture (initial passive resistance); (2) passive resistance at maximal aperture; (3) forces and passive elastic stiffness (PES) evaluated during five lengthening and shortening cycles; and (4) percentage loss of resistance after 1 min of sustained stretch. The PFMs and surrounding tissues were stretched, at constant speed, by increasing the vaginal antero-posterior diameter; different apertures were considered. Hysteresis was also calculated. The procedure was deemed acceptable by all participants. The median passive forces recorded ranged from 0.54 N (interquartile range 1.52) for minimal aperture to 8.45 N (interquartile range 7.10) for maximal aperture while the corresponding median PES values were 0.17 N/mm (interquartile range 0.28) and 0.67 N/mm (interquartile range 0.60). Median hysteresis was 17.24 N∗mm (interquartile range 35.60) and the median percentage of force losses was 11.17% (interquartile range 13.33). This original approach to evaluating the PFM passive properties is very promising for providing better insight into the patho-physiology of stress urinary incontinence and pinpointing conservative treatment mechanisms.

Empirical aspects of a mixed method approach to economic network analysis

We discuss the interactions among the various phases of network research design in the context of our current work using Mixed Methods and SNA on networks and rural economic development. We claim that there are very intricate inter-dependencies among the various phases of network research design - from theory and formulation of research questions right through to modes of analysis and interpretation. Through examples drawn from our work we illustrate how choices about methods for Sampling and Data Collection are influenced by these interdependencies.

Preparation of Boron by Pyrolytic Decomposition of Boron Tribromide

The national shortage of helium-3 has made it critical to develop an alternative to helium-3 neutron detectors. Boron-10, if it could be produced in macroscopic alpha-rhombohedral crystalline form, would be a viable alternative to helium-3. This work has determined the critical parameters needed for the preparation of alpha-rhombohedral boron by the pyrolytic decomposition of boron tribromide on tantalum wire. The primary parameters that must be met are wire temperature and feedstock purity. The minimum purity level for boron tribromide was determined to be 99.999% and it has been found that alpha-rhombohedral boron cannot be produced using 99.99% boron tribromide. The decomposition temperature was experimentally tested between 830°C and 1000°C. Alpha-rhombohedral boron was found at temperatures between 950°C and 1000°C using 99.999% pure boron tribromide.

Application of a new method in the study of pelvic floor muscle passive properties in continent women

The aim of this study was to present a new methodology for evaluating the pelvic floor muscle (PFM) passive properties. The properties were assessed in 13 continent women using an intra-vaginal dynamometric speculum and EMG (to ensure the subjects were relaxed) in four different conditions: (1) forces recorded at minimal aperture (initial passive resistance); (2) passive resistance at maximal aperture; (3) forces and passive elastic stiffness (PES) evaluated during five lengthening and shortening cycles; and (4) percentage loss of resistance after 1 min of sustained stretch. The PFMs and surrounding tissues were stretched, at constant speed, by increasing the vaginal antero-posterior diameter; different apertures were considered. Hysteresis was also calculated. The procedure was deemed acceptable by all participants. The median passive forces recorded ranged from 0.54 N (interquartile range 1.52) for minimal aperture to 8.45 N (interquartile range 7.10) for maximal aperture while the corresponding median PES values were 0.17 N/mm (interquartile range 0.28) and 0.67 N/mm (interquartile range 0.60). Median hysteresis was 17.24 N∗mm (interquartile range 35.60) and the median percentage of force losses was 11.17% (interquartile range 13.33). This original approach to evaluating the PFM passive properties is very promising for providing better insight into the patho-physiology of stress urinary incontinence and pinpointing conservative treatment mechanisms.

The Geography of Borders: The Method

This text is a first that the author would develop later. It is illustrated with case studies and original terminology. It begins with a brief conceptual contribution on the difference in approach between the German and French geographical schools, and continues with a reflection on the historical and geographical relativity of the boundary. Subsequently, at its greatest extent, the article provides a taxonomy of states: amorphous states, in three cases, that of the "savage peoples" without boundaries, of black Africa; that of semi-civilized peoples of northwest Africa, and the particular case of European civilized nomads, called ―terranovas‖. Framed states, with borders undergoing processes of emergence or extension, especially the case of Yugoslavia. And, in addition, some references to stable boundaries of Albania and the Netherlands

Analyzing Gene Centres with the Help of the Checklist Method – the Case of Syria

The present survey of species diversity of cultivated plants is the first for Syria. Some cultivated species will be added in the future, because due to the civil war in Syria, it was not possible to visit the country in the frame of the present work, as initially planned. Checklists proved to be a useful tool for overviewing the cultivated plants of selected areas and allow a characterization of the state of plant genetic resources of Syria. Syria has experienced several civilizations. Man settled in this productive land since ancient times and used its resources. However, such use has led to changes in vegetation and decline of wildlife through the country, in seashore areas, interior, mountains, and grassland. Plant domestication and growing started more than 10,000 years ago in West Asia. Since then, plentiful of economic plant species were present and used by man and his domesticated animals. Forming a part of the Fertile Crescent, where many of the world’s agricultural plants have evolved, Syria is extremely rich in agrobiodiversity. Wild progenitors of wheat and barley and wild relatives of many fruit trees such as almonds and pistachio as well as forage species are still found in marginal lands and less disturbed areas. These are threatened by a wide range of human activities, notably modern, extensive agriculture, overgrazing, overcutting and urban expansion. Syria is also considered as part of one of the main centres of origin, according to Vavilov, who had collected in Syria in 1926. The first expeditions to crop fields showed the exclusive nature of cultivated plants in Syria with a high number of endemic forms. Furthermore, Syria is a part of a biodiversity hotspot. Several studies have been performed to study agrobiodiversity in different parts of Syria, but usually on wild species. Many collections have been carried out; however, they focussed preferably on cereals and pulses, and particularly on wheat, like Vavilov’s expedition. Only 30 crops make up the major part of the conserved Syrian crop plant material in the genebank, indicating that most of the remaining 7,000 species of cultivated plants and many other valuable genetic resources species have only been included on a limited scale in the genebank collections. Although a small country (185,180 km2), Syria accommodates numerous ecosystems that allow for a large diversity of plant genetic resources for agriculture ranging from cold-requiring to subtropical crops to live and thrive. Only few references are available in this respect. The aim of the present study was to complete a checklist of Syria’s cultivated plants of agriculture and horticulture excluding plants only grown as ornamental or for forestry. Furthermore, plants taken for reforestation have not been included, if they do not have also agricultural or horticultural uses. Therefore, the inclusion of plants into the checklist follows the same principles as “Mansfeld’s Encyclopedia”. Main sources of information were published literature, floras of Syria, Lebanon and the Mediterranean, as well as Syrian printed sources in Arabic and/or English, reports from FAO on agricultural statistics in Syria, and data from ICARDA and Bioversity International. In addition, personal observations gathered during professional work in the General Commission for Scientific Agricultural Research (GCSAR) in Syria (since 1989) and participation in projects were taken into account. These were: (1) A project on “Conservation and Sustainable Use of Dry Land Agrobiodiversity in the Near East” with participation of Jordan, Lebanon, Syria, and the Palestinian Authority, focussing on landraces and wild relatives of barley, wheat, lentil, alliums, feed legumes, and fruit trees (1999–2005). (2) A project for vegetable landraces (1993–1995) in collaboration with the former International Plant Genetic Resources Institute and the UN Development Programme, in which 380 local vegetable accessions were evaluated. For medicinal plants and fruit trees I was in personal contact with departments of GCSAR and the Ministry of Agriculture and Agrarian Reform, as well as with private organizations. The resulting checklist was compared with the catalogues of crop plants of Italy and a checklist of cultivated plants of Iraq. The cultivated plant species are presented in alphabetical order according to their accepted scientific names. Each entry consists of a nomenclatural part, folk names, details of plant uses, the distribution in Syria (by provinces), a textual description, and references to literature. In total, 262 species belonging to 146 genera and 57 families were identified. Within-species (intraspecific) diversity is a significant measure of the biodiversity. Intraspecific diversity for wild plants has been and remains to be well studied, but for crop plants there are only few results. Mansfeld’s method is an actual logical contribution to such studies. Among the families, the following have the highest number of crop species: Leguminosae (34 spp.), Rosaceae (24), Gramineae (18), Labiatae (18), Compositae (14), Cruciferae (14), Cucurbitaceae (11), Rutaceae (10), Malvaceae (9), Alliaceae (7), and Anacardiaceae (7). The establishment of an effective programme for the maintenance of plant genetic resources in Syria started in the mid-1970s. This programme considered ex situ and in situ collection of the genetic resources of various field crops, fruit trees and vegetables. From a plant genetic resources viewpoint, it is clear that the homegarden is an important location for the cultivation of so-called neglected and underutilized species (neglected from a research side and underutilized from a larger economic side). Such species have so far not received much care from ecologists, botanists and agronomists, and they are considerably under-represented in genebanks.

Adoption of catamaran fishing method for mukene (Rastrineobola argentea) in off shore waters of Lake Victoria

This report presents information on the development of a system for commercial harvesting of Rastrineobola argentea (Mukene) in Lake Victoria. The objective of this work is to develop a system for commercial Harvesting of Mukene with: •Targeted output above 1,000 kg per working night per boat. •Target area to be off shore waters of Lake Victoria. •Drying under hygienic conditions for production of high quality poultry and animal feeds. •Supply to be continuous with predicable prices