The chemistry of British bituminous coals : an assessment of phase transfer catalysed reactions in the determination of coal structure

Three British bituminous coals, (Gedling, Cresswell, and Cortonwood Silkstone) were selected for study. Procedures were developed, using phase transfer catalysts (PTC's), to degrade the solvent insoluble fractions of the coals. PTC's are of interest because they have the potential to bring about selective high conversion reactions, under mild conditions, (often in the past, severe reaction conditions have had to be used to degrade the coals, this in turn resulted in the loss of much of the structural information). We have applied a variety of physical and chemical techniques to maximise the amount of structural information, these include, elemental analysis, 1H-NMR, 13C-CPMAS-NMR, GPC, GC-MS, FTIR spectroscopy, DRIFT spectroscopy, and gas adsorption measurements. The main conclusions from the work are listed below:- ( 1 ) PTC O-methylation; This reaction removes hydrogen bonds within the coal matrix by 'capping' the phenolic groups. It was found that the polymer-like matrix could be made more flexible, but not significantly more soluble, by O-methylation. I.E. the trapped or 'mobile' phase of the coals could be removed at a faster rate after this reaction had been carried out. ( 2 ) PTC Reductive and Acidic Ether Cleavage; The three coals were found to contain insignificant amounts of dialkyl and alkyl aryl ethers. The number of diaryl ethers could not be estimated, by reductive ether cleavage, (even though a high proportion of all three coals was solublised). The majority of the ethers present in the coals were inert to both cleavage methods, and are therefore assumed to be heterocyclic ethers. ( 3 ) Trif!uoroperacetic Acid Oxidation; This oxidant was used to study the aliphatic portions of the polymer-like macromolecular matrix of the coals. Normally this reagent will only solublise low rank coals, we however have developed a method whereby trifluoroperacetic acid can be used to degrade high rank bituminous coals. ( 4 ) PTC/Permanganate Oxidation; This reagent has been found to be much more selective than the traditional alkaline permanganate oxidation, with a lot more structural information being retained within the various fractions. This degradative method therefore has the potential of yielding new information about the molecular structure of coals.

A study of mechanochemical reactions of spin traps in hydrocarbon polymers

The identification and quantification of spin adducts and their reduction products (>NOH, >NOR) formed from nitroso compounds and nitrones in EPR and PP during spin trapping techniques have been examined. The nitroxyl yield and polymer bound nitroxyl percentage formed from these spin traps were found to be strongly dependent on the nature of spin trap and radical generator, processing temperature, and irradiation time. The nitroxyl yield and % bound nitroxyl of the spin traps improved significantly in the presence of Trigonox 101 and 2-0H benzophenone. The effect of these spin traps used as normal additive and their spin adducts in the form of EPR-masterbatch on the photo and thermal-oxidation of PP have been studied. Aliphatic nitroso compounds were found to have much better photo-antioxidant activity than nitrones and aromatic nitroso compounds, and their antioxidant activity improved appreciably in the presence of, a free radical generator, Trigonox 101, before and after extraction. The effect of heat, light and oxidising agent (meta-dichloro per benzoic acid) on the nitroxyl yield of nitroso tertiary butane in solution as a model study has been investigated and a cyclic regenerative process involving both chain breaking acceptor and chain breaking donor process has been proposed.

Lithium-aluminium casting alloys and their associated metal-mould reactions

Aluminium - lithium alloys are specialist alloys used exclusively by the aerospace industry. They have properties that are favourable to the production of modern military aircraft. The addition of approximately 2.5 percent lithium to aluminium increases the strength characteristics of the new alloys by 10 percent. The same addition has the added advantage of decreasing the density of the resulting alloy by a similar percentage. The disadvantages associated with this alloy are primarily price and castability. The addition of 2.5 weight percent lithium to aluminium results in a price increase of 100% explaining the aerospace exclusivity. The processability of the alloys is restricted to ingot casting and wrought treatment but for complex components precision casting is required. Casting the alloys into sand and investment moulds creates a metal - mould reaction, the consequences of which are intolerable in the production of military hardware. The primary object of this project was to investigate and characterise the reactions occurring between the newly poured metal and surface of the mould and to propose a method of counteracting the metal - mould reaction. The constituents of standard sand and investment moulds were pyrolised with lithium metal in order to simplify the complex in-mould reaction and the products were studied by the solid state techniques of powder X-Ray diffraction and magic angle spinning nuclear magnetic resonance spectroscopy. The results of this study showed that the order of reaction was: Organic reagents> > Silicate reagents> Non silicate reagents Alphaset and Betaset were the two organic binders used to prepare the sand moulds throughout this project. Studies were carried out to characterise these resins in order to determine the factors involved in their reaction with lithium. Analysis revealed that during the curing process the phenolic hydroxide groups are not reacted out and that a redox reaction takes place between these hydroxides and the lithium in the molten alloys. Casting experiments carried out to assess the protection afforded by various hydroxide protecting agents showed that modern effective, protecting chemicals such as bis-trimethyl silyl acetamide and hexamethyldisilazane did not inhibit the metal - mould reaction to a sufficiently high standard and that tri-methylchlorosilane was consistently the best performer. Tri-methyl chlorosilane has a simple functionalizing mechanism compared to other hydroxide protecting reagents and this factor is responsible for its superior inhibiting qualities. Comparative studies of 6Li and 7Li N.M.R. spectra (M.A.S. and `off angle') establish that, for solid state (and even solution) analytical purposes 6Li is the preferred nucleus. 6Li M.A.S.N.M.R. spectra were obtained for thermally treated laponite clay. At temperatures below 800oC both dehydrated and rehydrated samples were considered. The data are consistent with mobility of lithium ions from the trioctahedral clay sites at 600oC. The superior resolution achievable in 6Li M.A.S.N.M.R. is demonstrated in the analysis of a microwave prepared lithium exchanged clay where 6Li spectroscopy revelaed two lithium sites in comparison to 7Li M.A.S.N.M.R. which gave only a single lithium resonance.

Self-esteem moderates affective reactions to briefly presented emotional faces

According to the sociometer hypothesis individuals with low self-esteem experience increased negative affect in response to negative social stimuli, even when these stimuli are not perceived consciously. Using an affective priming paradigm, the present study examined whether trait self-esteem would moderate mood following briefly presented facial expressions. Results from 43 undergraduates revealed that, after controlling for baseline mood, anxiety and depression, the degree of negative affect experienced by the participants following exposure to expressions of anger and disgust varied as a function of their self-esteem. Implications for individuals with low-self esteem and our understanding of the link between self-esteem and negative affect are discussed.

Managing careers and managing fairness : an organisational justice theory perspective on employee evaluations of, and reactions to, organisational career management practices

This thesis presents the results of a multi-method investigation of employee perceptions of fairness in relation to their career management experiences. Organisational justice theory (OJT) was developed as a theoretical framework and data were gathered via 325 quantitative questionnaires, 20 semi-structured interviews and the analysis of a variety of company documents and materials. The results of the questionnaire survey provided strong support for the salience of employee perceptions of justice in regard to their evaluations of organisational career management (OCM) practices, with statistical support emerging for both an agent-systems and interaction model of organisational justice. The qualitative semi-structured interviews provided more detailed analysis of how fairness was experienced in practice, and confirmed the importance of the OJT constructs of fairness within this career management context. Fairness themes to emerge from this analysis included, equity, needs, voice, bias suppression, consistency, ethicality, respect and feedback drawing on many of the central tenants of distributive, procedural, interpersonal and information justice. For the career management literature there is empirical confirmation of a new theoretical framework for understanding employee evaluations of, and reactions to, OCM practices. For the justice literatures a new contextual domain is explored and confirmed, thus extending further the influence and applicability of the theory. For practitioners a new framework for developing, delivering and evaluating their own OCM policies and systems is presented.

Metal binding to transferrin and immune reactions in Parkinson's disease

The binding of iron (59Fe) and gallium (67Ga) to the plasma protein transferrin (Tf) was investigated by G75 gel filtration chromatography in control patients and treated and untreated patients with Parkinson's disease (PD). Fe-Tf binding was 100% in all controls and PD patients suggesting that a defect in Fe-Tf binding was not involved in the aetiology of PD. Ga-Tf binding was significantly reduced in both untreated and treated PD patients compared to controls. In addition, treated PD patients had significantly higher Ga-Tf binding than untreated patients. A reduction in metal binding to Tf could result in the increase of a low molecular weight species which may more readily enter the CNS. Alternatively, it could lead to a decrease in the transport of essential metals into the brain via the Tf receptor system. A significant elevation in neopterin was demonstrated within the plasma of untreated PD patients compared to controls suggesting the activation of a cellular immune response. Furthermore, plasma neopterin was lower in treated compared to untreated PD patients, although the difference was not significant. There was no evidence for the activation of the humoral immune response in untreated or treated PD patients as measured by circulating immune complex (CIC) levels within the plasma. An inverse relationship between Ga-Tf binding and neopterin was observed in untreated PD patients. The addition of oxidants in the form of potassium permanganate and activated manganese dioxide reduced Ga-Tf binding in control plasma. However, relatively little response was observed using monocyte preparations. The results suggest that oxidants produced by activation of the cellular immune system could damage the Tf molecule thereby reducing its ability to bind metals.

The reactions of carbon dioxide with complexes

The studies described in this thesis are concerned with the reaction of carbon dioxide and transition metal complexes of Co, Ir, Rh, Ru. Due to the important role of group VIII transition metals in homogeneous catalytic reactions, the work is mainly concerned with complexes of ruthenium.