Reducing uncertainty in the assessment of the Australian spanner crab fishery

In collaboration with the New South Wales Department of Primary Industries we compared the effectiveness of the spanner crab monitoring systems used by New South Wales and Queensland and developed a fishery-independent survey protocol acceptable to both states. The objectives of this project were to: 1. Determine the age at which spanner crabs (Ranina ranina) recruit to the fishery 2. Develop a common methodology for monitoring and assessing the Australian spanner crab stock 3. Investigate sources of variability in apparent population density.

The August 2007 equine influenza response management framework.

This section outlines the most important issues addressed in the management of the response in the two infected states, New South Wales and Queensland. There were differences in the management of the response between the states for logistic, geographic and organisation structural reasons. Issues included the use of control centres, information centres, the problems associated with the lack of trained staff to undertake all the roles, legislative issues, controls of horse movements, the availability of resources for adequate surveillance, the challenges of communication between disparate groups and tracing the movements of both humans and horses.

Two varieties of the invasive liana, cat’s claw creeper, Macfadyena unguis-cati (Bignoniaceae) in Queensland, Australia

The invasive liana cat’s claw creeper, Macfadyena unguis-cati, native to tropical Central and South America, is a major environmental weed in Queensland and New South Wales (NSW). Two morphologically distinct cat’s claw creeper varieties occur in Australia, a ‘short-pod’ variety that is widespread through Queensland and NSW and a ‘long-pod’ variety restricted to a few sites in southeast Queensland. In this study we report the differences in the above-ground morphological, phenological and reproductive traits between the two varieties. The ‘long-pod’ variety has significantly larger leaves, larger pods, and larger number of seeds per pod than the ‘short-pod’ variety. The ‘short-pod’ variety has a slightly wider pods, and thicker leaves than the ‘long-pod’ variety. Both varieties have a yellow trumpet shaped flower, but the flower of the ‘long-pod’ variety has a deeper hue of yellow than the ‘short-pod’ flower. The fruits of the ‘short-pod’ variety mature in late summer to early autumn while the fruits of ‘long-pod’ variety mature in late winter to early spring. The more widespread nature of the ‘short-pod’ variety could potentially be due to a preference for this variety as an ornamental plant, due to its more presentable foliage characteristics and shorter pods, in contrast to the ‘long-pod’ variety.

Significant features of the epidemiology of equine influenza in Queensland, Australia, 2007.

An outbreak of equine influenza (EI) caused by influenza A H3N8 subtype virus occurred in the Australian states of Queensland and New South Wales in August 2007. Infection in the Australian horse population was associated with the introduction of infection by horses from overseas. The first case of EI in Queensland was detected on 25 August 2007 at an equestrian sporting event. Infection subsequently spread locally and to other clusters through horse movements prior to the implementation of an official standstill. There were five main clusters of infected properties during this outbreak and several outliers, which were investigated to find the potential mechanism of disease spread. To contain the outbreak, Queensland was divided into infection status zones, with different movement controls applied to each zone. Vaccination was implemented strategically in infected areas and within horse subpopulations. Control and eventual eradication of EI from Queensland was achieved through a combination of quarantine, biosecurity measures, movement control, rapid diagnostic testing and vaccination.

Rotary veneering of plantation-grown spotted gum (Corymbia citriodora subsp. variegata) and Dunn's white gum (Eucalyptus dunnii)

This report evaluates the wood and veneer properties of plantation-grown spotted gum (Corymbia citriodora subsp. variegata, or CCV) and Dunn's white gum (Eucalyptus dunnii), grown at different stockings, in thinning trials near Ellangowan in north-east New South Wales (mean annual rainfall 1050 mm) and Kingaroy in south-east Queensland (mean annual rainfall 873 mm). Thinning trials were established at age seven years. Both species showed a significant increase in stem diameter growth of the dominant trees in response to thinning. At age 10 years, trees from the unthinned (950–1270 stems ha-1) and 300 stems ha-1 treatments were selected for veneering. Five dominant trees were felled from each combination of species x sites x thinning treatment. Diameter at breast height over bark of the selected trees ranged from 20 cm to 27 cm at Ellangowan, and 19 cm to 26 cm at Kingaroy. From each tree, 1.5 m long billets were removed at two positions: a butt billet from 0.3–1.8 m above ground and a top billet from approximately 5.5–7.0 m. Log end splitting was assessed 24 hours after harvesting and again after steaming, approximately four days after harvesting. Disks from just above both billets were collected for assessment of wood properties. Billets were peeled on a spindleless veneer lathe to produce a full veneer ribbon with a target green thickness of 2.8 to 3.0 mm. The 1.55 m wide (tangential dimension) veneer sheets were dried and graded according to AS/NZ Standard 2269:2008, which describes four veneer grades. Veneer samples taken along the length of the veneer ribbon, at regular intervals of 1.55 m, were tested for stiffness, shrinkage and density. Veneer length measurements were used to calculate the radial distance of each sample from the central axis of the billet. Overall veneer gross recoveries ranged from 50% to 70%. They were significantly lower at the Kingaroy site, for both species. The veneer recoveries achieved were 2–3 times higher than typical green off saw recoveries from small plantation hardwood logs of similar diameter. Most of the veneer recovered was classified as D-grade. CCV trees from the Ellangowan site yielded up to 38% of the better C-grade and higher grade veneers. The main limiting factors that prevented veneer from meeting higher grades were the presence of kino defects and encased knots. Splits in E. dunnii veneer also contributed to reduced grade quality. Log end splits were higher for E. dunnii than for CCV, and logs from Ellangowan exhibited more severe splitting. Split index was generally higher for top than for butt billets. Split index was strongly correlated with the average veneer grade from corresponding billets. The Ellangowan site, where rainfall was higher and trees grew faster, yielded significantly denser and stiffer veneers than did the drier sites near Kingaroy, where tree growth was slower. The difference was more pronounced for E. dunnii than for CCV. Differences in measured wood properties between thinned and unthinned treatments were generally small and not significant. On average, 10% of billet volume was lost during the peeling rounding-up process. Much of the wood laid down following thinning was removed during rounding-up, meaning the effect of thinning on veneer properties could not be effectively assessed. CCV was confirmed as having high veneer density and very good veneer stiffness, exceeding 15 GPa, making it very suitable for structural products. E. dunnii also demonstrated good potential as a useful structural plywood resource, achieving stiffness above 10 GPa. Veneer stiffness and density in CCV increased from pith to bark at both sites, while for E. dunnii there was a radial increase in these properties at the Ellangowan site only. At the drier Kingaroy site, veneer stiffness and density declined from mid-radius to the log periphery. This may be associated with prolonged drought from 2005 to 2009, corresponding to the later years of tree growth at the Kingaroy site. CCV appeared to be less sensitive to drought conditions. Standing tree acoustic velocity, determined by the Fakopp time-of-flight method, provided a reliable prediction of average veneer stiffness for both species (R2=0.78 for CCV and R2=0.90 for E. dunnii) suggesting that the Fakopp method may be a useful indicator of tree and stand quality, in terms of veneer stiffness in standing trees.

Processing small diameter logs from sub-tropical species

Small spindleless veneer lathe technology was used to produce veneer sheets as an alternative processing option to optimise the use of small log plantation resource. Thinned (300 spha) and unthinned control (1000 spha) plantings of 10.5-year-old Corymbia citriodora ssp. variegata (CCV) and E. dunnii (Dunn’s white gum) grown in two contrasting sites from climatic regions with large annual rainfall differences were studied. Overall veneer gross recoveries ranged from 50% to 70%, which were up to 3 times higher than typical sawn green-off saw recoveries from small plantation hardwood logs of similar diameter. Major limiting factors preventing veneer from meeting higher grades were the presence of kino defects and encased knots. Splits in E. dunnii veneer also contributed to reduced grade quality. Differences between two thinning treatments for veneer properties and grade recovery were generally small. There was significant evidence of site and species differences on veneer quality. The good quality site with higher rainfall in northern New South Wales produced denser and stiffer veneers with higher grade recoveries. CCV is a superior structural veneer species with high wood density and hardness as well as very good veneer stiffness exceeding 15,000 MPa but Dunn’s white gum has also demonstrated good potential as a useful structural plywood resource. Results indicate that relatively high veneer recoveries were achieved for the sub-tropical plantation hardwoods combined with very superior mechanical properties which suggest that veneer production have suitable attributes for a range of engineered wood products including plywood and laminated veneer lumber.

Cat's claw creeper leaf-mining jewel beetle Hylaeogena jureceki Obenberger (Coleoptera: Buprestidae), a host-specific biological control agent for Dolichandra unguis-cati (Bignoniaceae) in Australia

Cat's claw creeper, Dolichandra unguis-cati (L.) L.G. Lohman (syn: Macfadyena unguis-cati (L.) A.H. Gentry) (Bignoniaceae), a major environmental weed in Queensland and New South Wales, is a Weed of National Significance and an approved target for biological control. A leaf-mining jewel beetle, Hylaeogena jureceki Obenberger (Coleoptera: Buprestidae), first collected in 2002 from D. unguis-cati in Brazil and Argentina, was imported from South Africa into a quarantine facility in Brisbane in 2009 for host-specificity testing. H. jureceki adults chew holes in leaves and lay eggs on leaf margins and the emerging larvae mine within the leaves of D. unguis-cati. The generation time (egg to adult) of H. jureceki under quarantine conditions was 55.4 ± 0.2 days. Host-specificity trials conducted in Australia on 38 plant species from 11 families supplement and support South African studies which indicated that H. jureceki is highly host-specific and does not pose a risk to any non-target plant species in Australia. In no-choice tests, adults survived significantly longer (>32 weeks) on D. unguis-cati than on non-target test plant species (<3 weeks). Oviposition occurred on D. unguis-cati and one non-target test plant species, Citharexylum spinosum (Verbenaceae), but no larval development occurred on the latter species. In choice tests involving D. unguis-cati, C. spinosum and Avicennia marina (Avicenniaceae), feeding and oviposition were evident only on D. unguis-cati. The insect was approved for field release in Australia in May 2012.

Quantifying northward movement rates of eastern king prawns along eastern Australia

Movement rates of eastern king prawns, Melicertus plebejus (Hess), were estimated from historical and recent conventional tag-recapture information collected across eastern Australia. Data from three studies and 2,656 tag recaptures were used. Recaptured males and females both moved east–north-east in central Queensland and north–north-east in southern Queensland and New South Wales. Over a period of one year, the estimated transition matrix reflected the species strong northerly movement and the more complex longitudinal movement, showing a very high probability of eastern movement in central Queensland and almost negligible eastern or western movement in northern New South Wales. The high exchange probability between New South Wales and Queensland waters indicated that spatial assessment models with movement rates between state jurisdictions would improve the management of this single-unit stock.