Soil injections of carbohydrates improve fine root growth of established urban trees

Four established mature tree species (Aesculus hippocastanum L., Betula pendula Roth., Primus avium L. and Quercus rohur L.) commonly planted in UK urban landscapes were subjected to soil injections of the carbohydrate sucrose at 25, 50 and 70g per litre of water. Fine root dry weight was recorded at month 5 following soil injections. Soil injections of sucrose significantly increased fine root dry weight compared to controls, however; growth responses were influenced by species and the concentration of sucrose applied. Results indicate soil injections of sucrose ≥ 50g litre of water may be able to improve root growth of established mature trees. Such a response is desirable as root damage following construction is a frequent problem encountered by established trees growing in UK towns and cities.

The influence of biostimulants on growth and vitality of three urban tree species following transplanting

Four commercially available, biostimulants sold under the trade names ‘Generate’, ‘Crop Set’, ‘Fulcrum’ and ‘Redicrop 2000’ were applied either as a root drench or foliar spray to three transplant-sensitive tree species, red oak(Quercus rubra), birch(Betula pendula) and beech (Fagus sylvatica) post transplanting. The short and long-term efficacy of the biostimulants on growth was quantified by recording root and shoot vigour at week 8 and 20. In addition, improvements in tree vitality were assessed by measurement of a chlorophyll a performance index based on leaf chlorophyll fluorescence emissions. Irrespective of species, no significant effect of mode of application (foliar spray versus root drench) was recorded on growth and vitality. The biostimulants Generate and Fulcrum increased growth of all three tree species. No significant effects on growth and chlorophyll fluorescence of birch and beech were recorded following applications of the biostimulants Crop Set and Redicrop 2000, however, significant increase in growth of red oak was recorded. Only the biostimulant Generate increased chlorophyll fluorescence values of all test species. Results show use of biostimulants can improve root and shoot vigour following transplanting. However, selection of an appropriate biostimulant is critical as effects on growth and vitality can vary widely between tree species possibly as a result of the differing active ingredient used in the formulation of the product.

The role of retailing in urban regeneration

Recent ‘best practice’ research and guidance has emphasised the important role that can be played by retail-led urban regeneration projects, particularly in ‘under-served markets’ in the UK. This builds on ideas first formulated in the USA by Michael Porter through his close relationship with the Initiative for the Competitive Inner City (ICIC). This paper critically examines the role of retailing in urban regeneration nationally and locally in the UK, focusing on in-town shopping centres located in inner city areas of the UK. The paper is based on case study research in these centres, and was completed during 2003 for The Office of Science and Technology. The paper examines how employment impact in retail-led regeneration is commonly measured, and calls for more research to determine the real impact of retail in deprived communities using other, relevant measures.

Briefing: re-engineering the city 2020–2050 – urban foresight and transition management

Cities may be responsible for up to 70% of global carbon emissions and 75% of global energy consumption and by 2050 it is estimated that 70% of the world's population could live in cities. The critical challenge for contemporary urbanism, therefore, is to understand how to develop the knowledge, capacity and capability for public agencies, the private sector and multiple users in city regions systemically to re-engineer their built environment and urban infrastructure in response to climate change and resource constraints. Re-Engineering the City 2020–2050: Urban Foresight and Transition Management (Retrofit 2050) is a major new interdisciplinary project funded under the Engineering and Physical Science Research Council's (EPSRC) Sustainable Urban Environments Programme which seeks to address this challenge. This briefing describes the background and conceptual framing of Retrofit 2050 project, its aims and objectives and research approach.

Retrofit city futures: visions for urban sustainability

This report (which is part of the EPSRC Retrofit 2050 project) sets out three contrasting long term (2050) visions for retrofit city-regional futures, developed through an in-depth participatory backcasting and foresight process. These contextual scenarios are intended as a tool which can be adapted and used by a wide variety of stakeholders and organisations to stimulate discussion and inform future policy and long-term planning.

Rural-urban disparities in child nutrition in Bangladesh and Nepal

Background The persistence of rural-urban disparities in child nutrition outcomes in developing countries alongside rapid urbanisation and increasing incidence of child malnutrition in urban areas raises an important health policy question - whether fundamentally different nutrition policies and interventions are required in rural and urban areas. Addressing this question requires an enhanced understanding of the main drivers of rural-urban disparities in child nutrition outcomes especially for the vulnerable segments of the population. This study applies recently developed statistical methods to quantify the contribution of different socio-economic determinants to rural-urban differences in child nutrition outcomes in two South Asian countries – Bangladesh and Nepal. Methods Using DHS data sets for Bangladesh and Nepal, we apply quantile regression-based counterfactual decomposition methods to quantify the contribution of (1) the differences in levels of socio-economic determinants (covariate effects) and (2) the differences in the strength of association between socio-economic determinants and child nutrition outcomes (co-efficient effects) to the observed rural-urban disparities in child HAZ scores. The methodology employed in the study allows the covariate and coefficient effects to vary across entire distribution of child nutrition outcomes. This is particularly useful in providing specific insights into factors influencing rural-urban disparities at the lower tails of child HAZ score distributions. It also helps assess the importance of individual determinants and how they vary across the distribution of HAZ scores. Results There are no fundamental differences in the characteristics that determine child nutrition outcomes in urban and rural areas. Differences in the levels of a limited number of socio-economic characteristics – maternal education, spouse’s education and the wealth index (incorporating household asset ownership and access to drinking water and sanitation) contribute a major share of rural-urban disparities in the lowest quantiles of child nutrition outcomes. Differences in the strength of association between socio-economic characteristics and child nutrition outcomes account for less than a quarter of rural-urban disparities at the lower end of the HAZ score distribution. Conclusions Public health interventions aimed at overcoming rural-urban disparities in child nutrition outcomes need to focus principally on bridging gaps in socio-economic endowments of rural and urban households and improving the quality of rural infrastructure. Improving child nutrition outcomes in developing countries does not call for fundamentally different approaches to public health interventions in rural and urban areas.

Greater Amman: metropolitan growth and scenarios for sustainable urban development

This paper reviews the development of Greater Amman, Jordan noting that the vast urban expansion that has occurred over the last fifty years has led to the desertification of rare fertile lands, following the fragmented and scattered territorial expansion of the city. The future scenario for planning in Greater Amman is analyzed in respect of proposals outlined in the Metropolitan Growth Plan of 2008, which assumes a rapid population growth from 2,200,000 persons in 2006, to approximately 6,500,000 by 2025. The concentration of more than 39 per cent of the national population of Jordan in Greater Amman threatens the transformation of former distinct settlement pattern into a distinctive continuous urban zone, aggravating problems of infrastructural provision, water needs, agricultural lands, and leaving unresolved problems of land inflation, poor urban standards and housing shortages. In conclusion, the environmental implications of the Amman Metropolitan Growth Plan are analysed, and it is suggested that an alternative approach is needed, based on clear principles of sustainable urban development.

An assessment of a three-beam Doppler lidar wind profiling method for use in urban areas

Currently there are few observations of the urban wind field at heights other than rooftop level. Remote sensing instruments such as Doppler lidars provide wind speed data at many heights, which would be useful in determining wind loadings of tall buildings, and predicting local air quality. Studies comparing remote sensing with traditional anemometers carried out in flat, homogeneous terrain often use scan patterns which take several minutes. In an urban context the flow changes quickly in space and time, so faster scans are required to ensure little change in the flow over the scan period. We compare 3993 h of wind speed data collected using a three-beam Doppler lidar wind profiling method with data from a sonic anemometer (190 m). Both instruments are located in central London, UK; a highly built-up area. Based on wind profile measurements every 2 min, the uncertainty in the hourly mean wind speed due to the sampling frequency is 0.05–0.11 m s−1. The lidar tended to overestimate the wind speed by ≈0.5 m s−1 for wind speeds below 20 m s−1. Accuracy may be improved by increasing the scanning frequency of the lidar. This method is considered suitable for use in urban areas.

City futures: exploring urban retrofit and sustainable transitions

Cities are responsible for up to 70% of global carbon emissions and 75% of global energy consumption. By 2050 it is estimated that 70% of the world's population will live in cities. The critical challenge for contemporary urbanism, therefore, is to understand how to develop the knowledge, capacity and capability for public agencies, the private sector and multiple users in city-regions (i.e. the city and its wider hinterland) to re-engineer systemically their built environment and urban infrastructure in response to climate change and resource constraints. To inform transitions to urban sustainability, key stakeholders' perceptions were sought though a participatory backcasting and scenario foresight process in order to illuminate challenging but realistic socio-technical scenarios for the systemic retrofit of core UK city-regions. The challenge of conceptualizing complex urban transitions is explored across multiple socio-technical ‘regimes’ (housing, non-domestic buildings, urban infrastructure), scales (building, neighbourhood, city-region), and domains (energy, water, use of resources) within a participatory process. The development of three archetypal ‘guiding visions’ of retrofit city-regional futures developed through this process are discussed, along with the contribution that such foresight processes might play in ‘opening up’ the governance and strategic navigation of urban sustainability.

Characterization of energy flux partitioning in urban environments: links with surface seasonal properties

A better understanding of links between the properties of the urban environment and the exchange to the atmosphere is central to a wide range of applications. The numerous measurements of surface energy balance data in urban areas enable intercomparison of observed fluxes from distinct environments. This study analyzes a large database in two new ways. First, instead of normalizing fluxes using net all-wave radiation only the incoming radiative fluxes are used, to remove the surface attributes from the denominator. Second, because data are now available year-round, indices are developed to characterize the fraction of the surface (built; vegetation) actively engaged in energy exchanges. These account for shading patterns within city streets and seasonal changes in vegetation phenology; their impact on the partitioning of the incoming radiation is analyzed. Data from 19 sites in North America, Europe, Africa, and Asia (including 6-yr-long observation campaigns) are used to derive generalized surface–flux relations. The midday-period outgoing radiative fraction decreases with an increasing total active surface index, the stored energy fraction increases with an active built index, and the latent heat fraction increases with an active vegetated index. Parameterizations of these energy exchange ratios as a function of the surface indices [i.e., the Flux Ratio–Active Index Surface Exchange (FRAISE) scheme] are developed. These are used to define four urban zones that characterize energy partitioning on the basis of their active surface indices. An independent evaluation of FRAISE, using three additional sites from the Basel Urban Boundary Layer Experiment (BUBBLE), yields accurate predictions of the midday flux partitioning at each location.

Identification of micro-scale anthropogenic CO2, heat and moisture sources – processing eddy covariance fluxes for a dense urban environment

Anthropogenic emissions of heat and exhaust gases play an important role in the atmospheric boundary layer, altering air quality, greenhouse gas concentrations and the transport of heat and moisture at various scales. This is particularly evident in urban areas where emission sources are integrated in the highly heterogeneous urban canopy layer and directly linked to human activities which exhibit significant temporal variability. It is common practice to use eddy covariance observations to estimate turbulent surface fluxes of latent heat, sensible heat and carbon dioxide, which can be attributed to a local scale source area. This study provides a method to assess the influence of micro-scale anthropogenic emissions on heat, moisture and carbon dioxide exchange in a highly urbanized environment for two sites in central London, UK. A new algorithm for the Identification of Micro-scale Anthropogenic Sources (IMAS) is presented, with two aims. Firstly, IMAS filters out the influence of micro-scale emissions and allows for the analysis of the turbulent fluxes representative of the local scale source area. Secondly, it is used to give a first order estimate of anthropogenic heat flux and carbon dioxide flux representative of the building scale. The algorithm is evaluated using directional and temporal analysis. The algorithm is then used at a second site which was not incorporated in its development. The spatial and temporal local scale patterns, as well as micro-scale fluxes, appear physically reasonable and can be incorporated in the analysis of long-term eddy covariance measurements at the sites in central London. In addition to the new IMAS-technique, further steps in quality control and quality assurance used for the flux processing are presented. The methods and results have implications for urban flux measurements in dense urbanised settings with significant sources of heat and greenhouse gases.