Influence of some oenological practices on the aromatic and sensorial characteristics of white Verdejo wines

Changes in the aromatic composition as well as sensory characteristics in Verdejo white wines were analysed based on two factors: the winemaking methodology and the storing time of wine in bottles. The volatile components were determined by GLC-MS, and the sensory profile was designed and assessed according to the ISO 11035 standard. The results showed that when wines were made in oak barrels, either completely or partially, which means the wines were in contact with the lees, the levels of 1-octanol, ethyl heptanoate and ethyl decanoate were significantly affected (P menor que 0.05); the softness sensation was also influenced (P menor que 0.05). However, the amount of time the wines were stored in bottles significantly affected (P menor que 0.05) the levels of 1-hexanol, ethyl heptanoate, ethyl octanoate, ethyl decanoate, hexyl acetate, isoamyl acetate and isoamyl lactate and also an odour note (tropical fruit). The compounds with higher OAV values belong to the groups of esters and fatty acids. For these reasons, the composition and the quality of the aroma of Verdejo white wines appear to be significantly affected both by use of oak barrels in winemaking and the time the wines are stored in bottles.

Improvement of compatibility and stability on polyethylene-modified bitumen by use of an aromatic extra as compatibilizer.

Bitumen modification by polyethylene addition usually improves the mechanical properties of the binder and, therefore, the behavior in service of the bituminous mix: thermal susceptibility and rutting can be diminished, whilst the resistance to low temperature cracking may increase. To achieve this improvement it is necessary a good compatibility between the base bitumen and the polyethylene. Low compatibility between bitumen and polyethylene can lead to phase separation: the polymer- asphalt incompatibility translates into a deterioration of ultimate properties. The object of this research project was to determine if these problems can be diminished by using certain compatibilizer agents, e.g. an aromatic extract from the oil refinery. Compatibility and stability of the polyethylene modified bitumen were studied using conventional test methods and dynamic shear reometer (DSR). Blends of bitumen and polyethylene were prepared with neat bitumen (PMB) or bitumen with compatibilizer as component of the binder (PMBC) and then compared. The experimental results show that “colloid instability index”(IC) is a parameter that can be used to control the compatibility between bitumen and polyethylene. From polyethylene point of view, one of the parameters that govern is the “melt flow index” (MFI). Experimental results show that PMBC formulated with low IC bitumen and hi gh MFI lineal polyethylene can be considered as stable binder.

Discovery of ferromanganese hydrocarbon-related nodules associated with the Meknes mud volcano (Western Moroccan margin)

A suite of ferromanganese nodules were sampled during the MVSEIS-2008 cruise aboard of the R/V Hespérides in the flanks of Meknes mud volcano (Moroccan margin, NE Central Atlantic). The nodules were collected at water depths between 750-850 m within a seabed area characterized by high acoustic backscatter values. Debris of cold water corals and hydrocarbon-derived authigenic carbonate crusts were sampled at same time. The nodules show tabular morphology, up to 20 cm in maximum diameter and 2 kg of weight, brown-reddish external color and they are internally composed by a concentric to complex arrangement of laminae. The results of X-ray diffraction analysis show that these ferromanganese nodules are essentially composed of goethite and lepidocrocite, being Mn-oxides, silicates (quartz and clay minerals) and carbonates (calcite, dolomite and siderite) accessory to occasional minerals. All the samples display micritic to micro-sparitic mosaic under the petrographic microscope which forms massive, laminated or dendritic-mottled textures. The nodules show a high abundance of Fe, minor Mn and low contents of trace metals and REEs. Mature hydrocarbons, as n-alkanes derived from marine bacterial activity, and phenanthrene have been detected in all the ferromanganese nodules analyzed. These nodules display analogous characteristics (textural, mineralogical and geochemical) to the nodules studied by González et al (2009) in the carbonate mud-mounds in the Gulf of Cadiz, offshore Iberian margin. In this way, the same preliminary genetic model proposed for these nodules might be applicable to those find in the Meknes mud volcano. Therefore, the anaerobic oxidation of hydrocarbon-rich fluids within the mud-breccia sediments in the flanks of Meknes mud volcano would induce the formation of early diagenetic Fe-(Mn) carbonate nodules. Thus, the nodules were later exhumed by the erosive action of sea bottom currents generating the replacement of ferromanganese carbonates by Fe-Mn oxy-hydroxides. Thus, the hydrocarbon-rich fluid venting from deep seated reservoirs and erosive action of bottom currents must have been essential actors, as mineralization controls, for ferromanganese nodules generation and evolution. These findings imply that this type of nodules must be considered as new product as derived from the anaerobic/aerobic oxidation of hydrocarbons in areas of active seepages.

Increasing the accuracy of positive displacement meters for the measurement of volume in liquid hydrocarbon logistics

Accuracy in the liquid hydrocarbons custody transfer is mandatory because it has a great economic impact. By far the most accurate meter is the positive displacement (PD) meter. Increasing such an accuracy may adversely affect the cost of the custody transfer, unless simple models are developed in order to lower the cost, which is the purpose of this work. PD meter consists of a fixed volume rotating chamber. For each turn a pulse is counted, hence, the measured volume is the number of pulses times the volume of the chamber. It does not coincide with the real volume, so corrections have to be made. All the corrections are grouped by a meter factor. Among corrections highlights the slippage flow. By solving the Navier-Stokes equations one can find an analytical expression for this flow. It is neither easy nor cheap to apply straightforward the slippage correction; therefore we have made a simple model where slippage is regarded as a single parameter with dimension of time. The model has been tested for several PD meters. In our careful experiments, the meter factor grows with temperature at a constant pace of 8?10?5?ºC?1. Be warned

"Sancho" [ [Material gráfico]: ajos morados - producto de España : primera 37/45 : :Antonio Ferrer Sancho: Walnuts - chestnust - aromatic hebs - pulses - garlics : La Roda - Albacete - España.

Tit. en la etiqueta:"Ajos morados - producto de España / Antonio Ferrer Sancho / walnuts - chestnuts - aromatic herbs - pulses - garlics / La Rota - Albacete - España / Sancho / Primera 37/45 "

Ectopic expression of the minimal whiE polyketide synthase generates a library of aromatic polyketides of diverse sizes and shapes

The single recombinant expressing the Streptomyces coelicolor minimal whiE (spore pigment) polyketide synthase (PKS) is uniquely capable of generating a large array of well more than 30 polyketides, many of which, so far, are novel to this recombinant. The characterized polyketides represent a diverse set of molecules that differ in size (chain length) and shape (cyclization pattern). This combinatorial biosynthetic library is, by far, the largest and most complex of its kind described to date and indicates that the minimal whiE PKS does not independently control polyketide chain length nor dictate the first cyclization event. Rather, the minimal PKS enzyme complex must rely on the stabilizing effects of additional subunits (i.e., the cyclase whiE-ORFVI) to ensure that the chain reaches the full 24 carbons and cyclizes correctly. This dramatic loss of control implies that the growing polyketide chain does not remain enzyme bound, resulting in the spontaneous cyclization of the methyl terminus. Among the six characterized dodecaketides, four different first-ring cyclization regiochemistries are represented, including C7/C12, C8/C13, C10/C15, and C13/C15. The dodecaketide TW93h possesses a unique 2,4-dioxaadamantane ring system and represents a new structural class of polyketides with no related structures isolated from natural or engineered organisms, thus supporting the claim that engineered biosynthesis is capable of producing novel chemotypes.