阵列光栅压缩器的空域特性

引入角度偏差、位移偏差作为拼接光栅系统的物理参数，定义了拼接光栅的孔径函数，利用傅里叶角谱理论研究了高斯脉冲入射拼接光栅压缩器后的远场分布特性。研究表明；出射脉冲仍然是高斯型脉冲，但包络中心发生偏移，偏移量由角度偏差量和光束口径决定；位移偏差引入的相位随着拼接光栅压缩器传递，其对远场焦斑的影响，取决于每片子光栅的非整数倍光栅常数的横向位移偏差和纵向位移偏差的综合作用。通过数值计算得到了各维偏差对阵列光栅压缩器空域特性的影响，计算表明：光栅面外角度偏差（俯仰左右）和条纹平行度偏差都必须控制在1μrad以内，

板条热容激光器的二维热特性

固体热容激光器（SSHCL）作为高功率固体激光器的一个重要发展方向,引起人们广泛关注。数值模拟激光介质板条在热容方式下工作的温度和应力分布是了解该类激光器工作特性的一种有效手段,采用平面应力近似法导出了半导体激光器抽运热容激光介质板的二维温度和应力分布公式,同时也对二维抽运光吸收密度、介质板温度分布和折射率变化进行了分析与讨论。数值计算的结果表明二维效应的温度分布和应力分布要比一维效应给出的分布更均匀。

掺镱双包层光纤放大器的放大特性

从掺镱(Yb)光纤放大器的功率传输方程出发,利用有限差分法对小模场面积(SMA)和大模场面积(LMA)掺镱双包层光纤放大器的放大特性进行了分析比较。采用模场直径(MFD)6.5 μm和20 μm的双包层掺镱光纤作为放大器增益介质进行窄线宽连续信号的放大,在915 nm激光抽运下模拟计算了大、小模场面积输出功率随输入信号功率、抽运光功率和光纤长度的变化特性,特别是对于大模场面积光纤放大器,最优光纤长度的选择至关重要;讨论了模场直径不同时的最优抽运功率和光纤长度的选择,得出4 m光纤放大时的临界抽运功率为4

有限尺寸光栅压缩器的优化设计

分析了超短超强激光系统中有限尺寸光栅压缩器设计的关键物理参数及约束条件,得到了压缩器优化的三项基本变量。给出了一种输出能量最大化的压缩器优化方法,进而确定了有限尺寸光栅压缩器的最大工作能力。针对传统的圆光束方案提出了改进的椭圆光束方案,增大了聚焦能量,减小了焦斑尺寸,提高了峰值聚焦功率密度。通过数值模拟对500 mm曝光口径介质膜光栅在圆光束和椭圆光束两种方案下的最大输出能力进行分析比较,指出单块光栅在椭圆光束方案下可以实现500 fs,500 J,1 PW的脉冲输出。

Highly stable, diode-pumped Nd : YLF regenerative amplifier

We present the design and experimental results for a diode pumped Nd:YLF regenerative amplifier applied to amplify a nanosecond laser pulse. Numerical simulation shows that the maximum output energy and the best stability can be obtained when the regenerative amplifier operates in a saturated mode for all pulse duration and temporal profiles. Using extra post-pulse is a good method to decrease the square-pulse distortion caused by gain saturation effect. The amplifier shows output energy of 4.2mJ with a total energy gain of more than 107 and output energy stability of better than 1% rms. When extra post-pulse is added, square-pulse distortion is decreased from 1.33 to 1.17 for the amplifier that is seeded with an optical pulse of 3 ns.

Effect of elliptical manufacture error of an axicon on the diffraction-free beam patterns

Based on the generalized Huygens-Fresnel diffraction integral theory and the stationary-phase method, we analyze the influence on diffraction-free beam patterns of an elliptical manufacture error in an axicon. The numerical simulation is compared with the beam patterns photographed by using a CCD camera. Theoretical simulation and experimental results indicate that the intensity of the central spot decreases with increasing elliptical manufacture defect and propagation distance. Meanwhile, the bright rings around the central spot are gradually split into four or more symmetrical bright spots. The experimental results fit the theoretical simulation very well. (C) 2008 Society of Photo-Optical Instrumentation Engineers.

数值模拟探针诱导表面等离子体共振耦合纳米光刻

采用有损耗介质和色散介质的二维时域有限差分方法,数值模拟了以光波长514.5 nm的p偏振基模高斯光束为入射光源,激发Kretschmann型表面等离子体共振,并通过探针的局域场增强效应实现纳米光刻的新方法——探针诱导表面等离子体共振耦合纳米光刻.分别就探针与记录层的间距以及探针针尖大小,模拟分析了不同情况下探针的局域场增强效应和记录层表面的相对电场强度振幅分布.结果表明,探针工作在接触模式时,探针的局域场增强效应最明显,记录层表面的相对电场强度振幅的对比度最大;当探针针尖距记录层5 nm时,针尖下方记录层表面的相对电场强度振幅大于光刻临界值的分布宽度与针尖尺寸相近.

光谱稳定性对直接探测多普勒测风激光雷达的影响研究

The wind error of the double-edge technique Doppler lidar due to the instability of injection-seeding solid laser and the drift of interferometer s spectrum was analyzed. Corresponding numerical simulation indicated that if the wind error of 1 m/s was achieved, the unsuccessful injection-seeding pulses should be less than 0.06% in integration time of 5 min. (30000 pulses). In the respect of spectrum drift of the interferometer, double temperature control systems were used and the accuracy of minus or plus 0.002°C was obtained, corresponding to the wind error of minus or plus 0.226 m/s. Monitoring of buildup time of the injection-seeding laser and temperature of the interferometer was significantly to improve the invertion accuracy of wind error by rejecting the data with frequency jumping and drifting. Researches of injection-seeding and spectrum stability of the interferometer were practical for the development of double-edge wind lidar.}

Dynamic analysis of V-folded cavity for TEM00 operation of end-pumped solid-state laser

Based on graphic analysis design method of optical resonator, a simple design expression of V-folded cavity of end-pumped solid-state lasers with TEM00 operation is described, which satisfies two criterias of the resonator design. We give numerical simulation of spot size as a function of thermal focal length using this design approach whose advantages are validated experimentally.

基于菲佐干涉仪与多通道光电倍增管阵列的多普勒频移检测技术

提出了基于菲佐干涉仪和多通道光电倍增管(PMT)阵列探测器组合的多普勒频移检测的方案, 适用于风速测量的直接探测多普勒激光雷达。首先介绍了工作原理, 再根据菲佐干涉仪光谱特征对频移检测用干涉仪进行了优化设计, 优化设计的菲佐干涉仪腔长150mm、平板反射率0.755。对提出的菲佐干涉仪和多通道光电倍增管阵列探测器组合的方案进行了数值模拟, 以分子散射作为背景噪声, 计算了该方法的风速测量误差。模拟结果表明, 设计的基于菲佐干涉仪的直接探测多普勒测风激光雷达, 在30 s的积分时间内、探测高度5 km以下,

硬边非稳腔平面波导激光器的光束特性

基于衍射理论和坐标变换,采用数值模拟的方法分析了硬边非稳腔平面波导激光器的光束特性,研究了存在非均匀抽运和增益饱和时,输出激光的光束质量.在端面抽运和边缘抽运时,比较了正支和负支非稳腔的输出光束特性.结果表明：利用优化的离轴硬边非稳腔可以得到近衍射极限的输出.在相同的抽运不均匀性情况下,对于边缘抽运和端面抽运,正支非稳腔的光束质量因子M^2分别为3.9和2.3,而相同条件下负支非稳腔的M^2因子为1.8和1.7.

环形非稳腔倒向波抑制镜抑制效果的数值模拟

对环形非稳腔激光器做数值计算模拟，给带有倒向波抑制(RWS)镜的环形非稳腔激光器的设计提供了数值参考。通过自洽方程，用Matlab计算带有倒向波抑制镜的环形非稳腔正、倒向波的稳定过程。改变腔长、放大率等参数来计算，发现使用倒向波抑制镜能明显提高正向波的输出，并能抑制倒向波。气体分子的多普勒频移导致正、倒向波的频率变化。频率分开的越小，竞争越大，抑制效果越好，正向波输出功率则有所下降。对于特定的结构，存在最佳的放大率，使正向波的输出最大。计算结果表明，倒向波抑制镜的引入能增大环形非稳腔输出功率。计算结果对实

时变带限信道中光通信的均衡与去噪技术

A semi-blind equalization method is proposed based on combination of adaptive and blind equalization techniques, which is more effective for optical signal processing in time-varied band-limited channel. The numerical simulation of Poisson noise OOK optical pulse signal in a band-limited channel using digital equalization techniques is performed, and the results are compared. The semi-blind equalization matchs the channel faster and sustains convergence were identified. In addition, the wavelet de-noise technique is introduced in the de-nosing area of optical signa process. The criteria of choosing wavelet basises is obtained that smooth wavelet soft threshold method is better. The corresponding numerical simulation is also conducted.

基于RS编码及网格编码调制的光PPM通信纠错技术

分析了RS（Reed-Solomon）纠错码和网格编码调制（Trellis Coded Modulation，TCM）技术在光脉冲位置调制通信中的应用．在此基础上，提出了以RS码作为外码，以网格编码调制技术作为内码，用于光脉冲位置调制通信的新编码方案，能以几乎不减少通信速率的优势，提高传统RS码系统在时变带限光信道中的通信性能．模拟研究了在不同空间光信道条件下，传统RS码的符号正确传输率和误码率，并对网格编码调制的编码增益、RS码与网格编码调制级联时的编码增益进行了仿真研究，证实了本方案的有效性．

上转换效应对Er3+-Yb3+共掺磷酸盐玻璃被动调Q 激光输出的影响

To study the effects of upconversion in Erbium, a set of rate equations that simulates the performance of the passively Q-switched Er:Yb:glass laser with a Co²⁺:MgAl2O4 saturable absorber was set up. The dynamics of the Er³⁺ excited state and the effect of upconversion on the passively Q-switched laser are obtained through numerical simulation of the model. It is found that the impact ratios of upconversion effect on the peak power of the passively Q-switched laser pluse and the repetition rate are both decreased with the increase of pump power.